I own a 2006 Kia Sedona which we bought brand new. Now after five years and 40,000 miles (we don't drive it much) it has developed a rattling noise by the top serpentine pulley. I am afraid this is where the timing chain is. I am not even sure if this vehicle has a chain or belt. Could either one of these be the problem?
View 15 RepliesEver hear of a crank pulley failure? Mine did and took out the serpentine belt. I have 63,000 miles on the 07 and it was a big shock to see the pulley in two parts.
View 5 RepliesMy tensioner pulley is making noise.I replaced the rear idler pulley (can't get to the front one), but still have the noise. Mention a DIY for replacing the tensioner pulley bearing. A part number for the bearing?
View 2 Replies2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
My wife calls me yesterday and said she could hear a rattling noise from the engine area, but no other issues presented themselves. Later, I checked the engine compartment for the noise with the engine on and found that the noise was coming from the area of the engine water pump/idler pulley but i couldn't really narrow it much closer. The noise honestly sounds like bearings about to go out. I did see that behind the water pump pulley there was a small buildup of corrosion on the water pump, but no apparent leaks or wetness. The car has the original water pump and idler pulley with 140k. I plan on replacing the water pump, idler pulley and thermostat in the morning. Or is this overkill? I don't want to lose the engine nor do I want my wife to get stranded anywhere.
View 9 Replies2002 Camry 4 cyl. Can the idler pulley alone be replaced on the serpentine belt tensioner? I noticed a very slight side to side play when I had the belt off. No noise from it. When I looked at rock auto, they sell the whole bracket with the pulley.
View 2 RepliesThe nut that holds the pulley in place on the alternator has fallen off, causing the pulley to become loose and now the serpentine belt will not stay on. What is the size and thread type for the nut that I need to replace?
Alternator Pulley Nut for 2004 Camry 4cyl
Been trying to isolate my noisy serpentine belt. Had the belt off and spun everything, only thing I found that made any noise was the alternator. It had a nice churp like a bearing was on its way out in it. So I replaced that figuring my squeak was going to go away. No such luck. Listening to it again while it was idling, I crawled underneath. Almost seems like the churping noise is coming from the Crank Pulley. Is there a bearing on this pulley that goes bad?
View 13 RepliesI have 1997 F250 LD since i bough it has been doing this chirping sound coming from the serpentine belt and the pulley area but when the truck has been working for 15 - 20 min it goes away
This is apart from the from the problem before I think the fan clutch is broken because when I start the truck I can hear the fan going at the same speed of the engine is that normal ? even when the truck is cold
Is it time to replace? There is a noise coming from the belt and when I listen with the hood up my best guess is that it's the tensioner. I'm not sure if it is easy to replace or if that is even the problem. The belt looks fine. It allows me to twist it barely less than halfway so to me it does not seem loose. But in the rain last week got the battery light and lost power steering, power brakes, etc, then it went back to normal and hasn't failed again since. The car has 131,000 miles.
Is there a way to check the tensioner? It's pretty tight in there. Or am I wrong as to what the problem is? The sound is a rubbing/slight clicking sound that is in time with the engine and you can hear it if you listen inside the car when the engine is on. The belt also seems to wander around on the tensioner just a little. One day it was about a mm in too much, a few days later, a few mm out, in relation to the pulley.
I have a '06 sonata 3.3 v6. Let me first describe what was happening to the car before the noise started. When I first started the car and put the ac, the first time turning the steering wheel in either direction the steering wheel would tighten up and the battery indicator light would come on and the fasten seatbelt light would flash even though I had the belt fastened. It would only happen the first time I would make a turn and after that I could turn with no problem. So in recap, it would only happen on the first turn and only when the ac was on. Now when I start the car up there is a noise coming form the pulley/belt area. I wouldn't classify it as a squeaking noise more like a grinding. I've looked at the belt and it seems to be fine. After I start to drive the car the noise goes away. If I start the car again after a drive within about 2 hours the noise doesn't happen when I start it. What this noise could be? and also could the noise and the steering wheel tightening when the ac is on be connected?
View 1 RepliesI have a very slight grinding noise coming from the PS pulley area. Its possibly bearing noise although its hard to say. Is there a specific torque requirement. Any good parts...
View 1 RepliesSo I purchased a 2009 Accent hatchback about 11 months ago and so far its been great. However, recently (as in the past 2 weeks or so) I have begun noticing a strange cyclic noise developing from the engine compartment accompanied with some minor vibrations. Over time it has grown more prominent. I would rather deal with this before it becomes worse (and more costly) if its a serious issue.
Some info: I recently took a trip to North Carolina (from Florida). I also recently replaced the spark plugs before I left, so they are relatively new. The car has about 37k miles. After popping the hood and taking a look, it seems as though the noise is coming from the power steering pump/pulley area. The noise seems to match the rotations. Either way, here's a video of the noise (pardon the moving in the video, I was mainly recording for sound): [URL] ....
It may sound like normal engine operation, but it did not make that cyclic sound for the first 10 months, so it worries me. Perhaps I'm just paranoid.
I have a 2006 Camry 2.4l and I'm hearing a loud noise coming from the idler pulley on cold startups when I put it in gear. I don't hear it when it's in park. The noise gets worse if you turn the a/c on. I have replaced the belt, idler pulley and top motor mount. I took the belt off and cranked it when cold and there was no noise even in gear. I can see the idler pulley moving and can confirm that's the noise but what it causing the belt to make it do that? Could I have bought a defective idler pulley?
View 3 Replies2006 KIA SEDONA was running HOTT had it inspected and pressure tested (radiator shop & mechanic shop) no leaks found. A FEW DAYS AGO wouldn't crank checked oil IT WAS MILKY, drained radiator. Also drained engine oil first a gallon of anti freeze came out then the milky oil. Hopefully optimistic that it's not that serious. Am I wrong? what should I do next.
View 7 Replies I have a 2006 Kia Sedona which has done 57000 miles. For the last 2 weeks I have been having starting problem. When I turn the key there is no 'starting sound', the lights, radio and the AC start working but the engine does not start up at all. After several attempts and after keeping the key in 'ignition on' position the engine fires up and starts running.
It has been happening intermittently and fortunately for me it happened at the dealer and they are saying it is a short circuit in starter motor and the entire starter has to be replaced. It is covered by the warranty but I want to know if thats what is wrong. A friend of mine who had similar problems was saying that he had to replace starter 3-4 times before they discovered that a wire was defective which was not sending enough amps to start the engine. What to do.
So i noticed recently, last month or two, a rattling noise coming from either rear of engine or in dash that only happens when at the higher rpms like 4-6k rpm. It goes away once rpms come down.
I am thinking just something in the dash is vibrating a little. No other issues as far as i can tell.
It is very slight, almost sounds like a plastic food wrapper getting crinkled in there....
Over the last couple of days, my 2009 Sonata V6 has developed what I best can describe as a rattling noise near the engine when I am accelerating the vehicle (noise changes based on throttle input). I only hear the noise with the car in drive, if I shift into Neutral or when I am in Park I don't hear the noise when I rev the engine.
View 6 RepliesLately I have been hearing a rattling noise from the bottom of my car, when it's in park I can barely hear it but I know its there, but when i put it in drive or reverse it gets worse. Could it be that the exhaust heat shield is loose? Or worse? I had my Tranny fluid flused at 142,000 mi i'm at 144,000.
View 9 RepliesI have a 2006 Kia Sedona with about 85k on it. About 2 months ago it began not starting (no engine turn over whatsoever). I took it to the dealer and they could not get the problem to repeat. When I pressed the service manager he told me to "bang on the fuse box" while trying to start it. Oddly, that seems to work. Something about the power relay (I might have the terminology wrong here). Last week my (1 year old) battery died. Another Kia dealership also found nothing wrong with the van but also mentioned the power relay as a possible cause of the period non-starting but didn't think that could damage the battery. Car is yet again, not starting sometimes. Banging on the fuse box as per the first service manager still works but this is not a permanent solution. Don't want to spring for a new power relay (??) since they can't definitively diagnose that.
View 3 RepliesHaving this rattling/clattering noise at start up? Mine is starting to become more and more common... (54k miles).
View 11 Replies