Got a 2001 jimmy. When I'm traveling down the freeway at speeds of 60 mph or more, the suv shifts from 2wd into 4 wheel drive on its own. I have to stop and you can tell its in 4wd as it makes the whirring noise as i go to stop. Servo, actuator?
View 4 RepliesI have a 2001 GMC Jimmy and I am having an issue with the blower motor. Speeds 1 and 2 do not seem to work. Speeds 3 and 4 work fine. This is the manual climate control not the automatic. I searched and it seems everyone usually has a problem with the high speeds & not the low speeds...
View 9 Replies2001 Jimmy 4wd, 115,000 miles; Recently I noticed a strong vibration when in 4WD, no vibration in 2wd. I found that the rear joint (at the transfer case) of the front drive shaft has play in it. I am assuming that this is the problem. It has the appearance of a CV joint. Is that joint rebuildable or do I need to replace the shaft?
View 1 RepliesThe prius I bought with 200+ K buzzes so loud especially on the freeway. There are no engine lights on and it drives great aside from the sound.
View 3 RepliesI just got a 2004 hyundai santa fe 2.7l 2wd model with only 92k miles that I just bought off of Craigslist anyways when im on flat ground and cruising through town the transmission shifts perfectly. However when i went up an incline to get on the freeway it shifted hard around 40 mph but after i got back on flat ground again I got caught up in bumper to bumper traffic and once it cleared it shifted perfectly all the way to freeway speeds of approximately 70mph. Then after getting off the freeway and picking my friend up when i went to get back on the freeway (another incline) it shifted hard again around 40mph.
View 15 RepliesI'm at a loss here, I bought a salvaged 2001 Prius at an insurance auction and fixed it up. After driving it for about a year the car suddenly dies on me in the middle of the freeway and i had to pull it over. the car hasn't started since. I can get it to turn on but the engine won't turn, and whenever I turn the steering wheel more than 45 degrees it makes this electrical sound the wheels jerks back to the original position and the PS message beeps on. I brought it to a dealership and they said it was a problem with the transaxle but they weren't sure.
View 8 RepliesMy 2001 Chevy Malibu overheated on the freeway the other day. I bought hey thermostat but I don't know if it is the water pump or not. Is there any way to tell without going through the elimination process?
View 2 RepliesThe master waning light came on while I was commuting on the freeway. There was no MIL. I've seen this a month or so ago and, as before, since nothing seemed wrong, I kept going. The last time this happened the warning went away after a day or so. This time it is sticking around. As before, there seems to be no problem with the car -- 80 mile commute, no loss of power, same gas mileage as before. I have a generic ELM327 OBD reader. I tried reading codes but there were none (at least none that it could read since there was no MIL).
Any second source for the Prius Mini-Scanner (or have one they want to sell)? Or, can a regular OBD scanner be trained to read the special prius codes?
I have a F150 2001 6cyl. Other day was doing 75 on freeway and lost all power. I replaced fuel filter, and pump is humming good (was replaced 4 years ago) checked the Inertia Switch and checked all relays, but truck still wont fire. I checked spark first and that's good.
View 2 RepliesI just picked up a 2004 Sante Fe with 150K for my daughter. "she loves it" I love to work on cars so didn't mind the mileage. I have shifting issues so I replaced the input/output sensors, when I started driving it it was back to what seemed normal with a little hesitation between shifts, now it's back to lunging while in 3 or 4th gear. Strangely to me the shiftronic works great without issues.
View 2 Repliesi have a 2001 saturn l200 2.2 about 160000 miles..sometimes when i drive the car it shifts hard and sometimes it shifts smoothly..i did have new transmission fluid and new filter put in..i did have transmission scan for codes and there was no codes..i do have a engine code came up it was Crankshaft Position Sensor..cud a Crankshaft Position Sensor cause a car to shifts hard sometimes...
View 4 RepliesI have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 RepliesMy nephew's car is a 2002 Hyundai Elantra GLS manual. His RPM's hang when he shifts and it is a pain to shift.
I took it to the dealer and had them do TSB#04-36-011 Delayed RPM drop between shifts. This TSB supersedes TSB 01-36-025. Here is a link for the newest TSB : [URL] ....
The TSB Basically tells them to erase ECM adaption values. Then, you update the ECM with new FUEL cut-off logic. When we drove off the dealers lot the delay was not better, just different.
After driving it for a day or two we saw improvement. Now when you push in the clutch the RPM's go up slightly for a second to burn off the gas then the RPM's drop faster than before.
So a friend of mine has a 01 Passat 1.8 T (Automatic). He is having some reverse issues. It shifts into reverse with a hard clunk then the second you touch the gas it clunks into neutral. The odd part is if you put it in reverse and stay off the gas it will idle back in reverse... But the second you touch the gas nothing. I'm finding it hard to believe the transmission is gone because every other gear is beyond smooth (I mean like brand new car smooth).
View 4 RepliesI have a 2002 Elantra GLS with the 4 speed auto and in the mornings or after sitting in lot at work for 9 hours, the trans shifts hard from second to third (almost as if it has a shift kit) and slips a little from third to fourth. The TPS was changed once and that seemed to eliminate problems at the 26K mark. I have 109K on it now and at around 80k took it in to the dealer with the receipt for the same complaint and what was done the first time. Dealer kept overnight and said there were no problems. I do know from having a performance TH350 built that the harder a trans shifts (up to a point) the longer it will last due to less friction on clutches and bands.
View 6 Replies2001 Elantra shifts to overdrive only after running 3000 rpm for a mile. Then at other times it shifts to overdrive ok. fluid is ok Sometimes putting the shifter into neutral with the car rolling and putting it back into drive will get it to upshift.
View 1 RepliesI have a 2003 Santa Fe 3.5l FWD 155k miles. Car has been incredibly trouble free until now. When the transmission up-shifts from 2nd to 3rd there is a hard jolt. All other up-shift and down-shift points work smooth. Occasionally will shift smooth just after I start the car or if I am accelerating hard. The rough shift happens whether I am in D or use the "manual" shift control. This coincidentally(?) started just about the time I had a battery die hard and an O2 sensor fail. Both have been replaced. Changed the AT fluid and no difference. No engine codes, but I think the AT codes don't show there? What might be going on? Any chance the battery failure had anything to do with this? Seems odd that battery, O2 sensor and transmission all start acting up at the same time.
View 5 RepliesIts a 2005 Elantra i dont know the sub model, but they said the heat will be working just fine, then out of no where it stops, at first i thought it was the issue's i've seen on here before about a bad blower, but its still blowing it just goes from hot to cold, and then it will shift back again after x amount of time.
View 4 RepliesI've got an 01 Ford Escape 4 cyl 5spd awd, it idled low when its warm, revs between shifts and if you put it in nuetral and let the clutch out when you're moving it revs to 3500rpms and just sits there until you stop or push the clutch back in. I've replaced the iacv and the pcv valve, elbow and hose, and the tps. What to look at next?
View 4 Replies2001 7.3 auto, 2wdr, 291,000, Transmission sometimes shifts hard from 1st-2nd, 2nd-3rd. Problem started after I found trans dip stick tube broken and loss of fluid. Anything I can do without going to a shop. I've replaced the Broken Tube.
View 2 Replieswhile cruzing in overdrive with no load on the motor, the rpm goes up and down about a 100 rpm and it feels like the torque converter is going in and out of lock steadily. Is it even the transmission? anything else I could look at? runs great and shifts fine otherwise.
View 1 Replies