I have tried all the tricks on the internet and still can't get the key unlocked, so I am ready to just replace the part. Is this something my son can do or is it very complicated?
View 1 RepliesI have a 2000 jeep grand cherokee that yesterday the key got stuck in the ignition and i cannot remove it. At the same time i used to have to press the brake to shift from park to any gear now it just moves freely without using the brake.
View 14 RepliesI replaced the ignition key lock cylinder on my 2000 Pontiac Grand Am SE. I performed the re-learn process by cranking the engine over, then releasing to the ON position for about 9 minutes. During the 9 minutes the SECURITY light blinked the whole time, then at the end it went solid for a few seconds, then off. On the next cranking cycle I was able to start the engine and thought all was good. But now when I open the door the car beeps as if the key is left in the ignition and the automatic locks are disabled with the door opened.What is the problem and how do I fix it?
View 1 RepliesI bought my 2000 F-250 CCSB a while ago and it came with 2 keys - one for the ignition, and one for the doors/tailgate - may not seem like a big deal, but it annoys me to no end.
From my understanding, the truck had previously been stolen and had the driver's side lock punched, and then something happened to the ignition lock to where it had to be replaced - hence the different key. I finally got around to replacing all the locks so that I'd only have one key. I started with the doors, then moved to the ignition (which I thought would be the easy part). I've replaced several cylinders before and I know it should be simple, but for the life of me I can't get the cylinder out!
I push the detent, turn the key to run, wiggle and pull.... nothing. I can feel the detent push in, and the cylinder will move a little, but it won't come out. I'm not sure if this is something that just happens sometimes and there's a fix for it, or if I'm in a unique circumstance and my column was somehow damaged during the theft and that's what's causing it.
I have a 1996 Jeep Cherokee (sport, six cylinder, 4WD) that won't start occasionally. 98% of the time, it starts up without problem. When it doesn't work the scenario is: put the key in, dash lights up, begin to turn the ignition switch, and suddenly the whole system looses power - no lights on he dash and of course, no cranking of the engine. If I try again immediately, I either get nothing or maybe power until I start to turn the key. If I wait ~5 minutes and try again, it fires right up. This has happened in various weather conditions.
Another problem that might be related is that about 40% of the time, it cranks but won't start in PARK. If I switch to NEUTRAL and try again, it fires right up.
My Jeep will not start. I can put the keys in the ignition and try to start it and nothing will happen. No sounds, clicking, nothing. The battery is fine, I replaced it with a new one, made sure it was charged and nothing happens when I try to crank it. The interior lights dont come on when I open the door but if i turn them on, they come on but they are very dim. Automatics locks dont work, horn doesnt work. I tried to jump start it with the new battery in with my other car. It tried to turn over but wont come on. It just sounds like the battery is dead when I try to turn it over. The vehicle in question is a 98 Jeep Grand Cherokee Laredo.
View 5 RepliesHad been having problems with ignition on my 1995 Jeep Cherokee Sport. Key was loose and eventually wouldn't stay in "on" position without being jerry-rigged (don't ask). Replaced the Ignition Control Switch and the Key cylinder today and car won't start. Checked fuses and they look fine.
Used this video as a guide and it installed perfectly. [URL] ......
I live on a boat access only island, so desperate. This jeep has over 230,000 km on it. Runs well, but this year started this thing where it won't start first time crank, but always starts second or third go. Bought new battery last year, so doesn't seem to be that kind of issue.
View 3 RepliesThis past week when I went to leave work my jeep would not start. It would turn over once, and then die....but if I kept my foot on the gas and kept the RPM's up it stayed running. So, I drove it home with one foot on the gas and one on the brake so it wouldn't stall out on the road. The next 2 days the same thing happened when I went to leave work. It starts fine the rest of the time, even first thing in the morning when it's cold..
View 1 RepliesLast fall I had my mechanic replace the broken air compressor on my 2000 Jeep Cherokee with a by pass. I didn't have money to replace it at the time and I still don't. I want to pick up one at a junk yard. How to do this? Where and how to learn more about maintaining and repairing my vehicle.
View 14 RepliesI have an '89 Jeep Cherokee and it idles way to high. In park it idles at from 1500-3000 after being warmed up. In drive it idles at 1300-1500. It idles at 2000 at 35 mph. We've replaced the O2 censor, the throttle positioning censor, the coolant temperature sensor, and a few other parts. None of this worked.
View 14 RepliesIn the really cold weather after I start my Jeep and it goes in Drive and it's driven for several miles when I go to put it back into Park the shifter gets hung up. It will go into all of the other gears except for Park. If I wait a while it goes back in but it can still feel like it's not smooth.
View 2 Replies2000 jeep cherokee brake lights will not work.changed the bulbs, brake switch, checked fuses, ripped the effin panels out and checked wires and grounds, ripped up rugs found the mouse nest-no mouse, no chews in wires. the parking lights work, hazard lights work?
View 2 RepliesI have a 99 explorer and the Ignition Lock Cylinder went out. I have ordered the parts and plan on changing it out myself. i was just wonders about any do's or don'ts.
View 1 RepliesEngine shutdown then starts after a few minutes....
Jeep cherokee 4.8L 2000 .....
My 2000 Jeep Grand Cherokee Laredo won't start...It cranks strong but won't turn over..I can hear my Fuel Pump kick on from the back of the Vehicle but it won't kick on listening from the engine compartment??I checked all fuses.I had a tune up a couple of months ago..My check engine light was on before the tune up and my mechanic said that the tune up corrected the problem the car was coding out... I've been told to check the ALARM by turning the alarm on and off and also unlocking the car Via the driver door.. This didn't work.. I've been told to check the Fuel cut off switch(RESET BUTTON) for my make and year but can't seem to locate it...
View 1 RepliesI have a 2000, Jeep Cherokee 4.0L. The check engine light, keeps coming on, and the scan tool, shows P0300, P0301, P0302, P0303. Misfires in #1, 2 & 3 cylinder.
I replaced the Coil Pack & all spark plugs with genuine jeep parts from the dealer. What might be wrong or other things to check?
I have a 2000 Jeep Cherokee 4.0L with about 180,000 miles on it. I'm currently in the middle of a road trip, and today my car's been stuttering as I've started it up. After the car sits idle for a while, it stutters as I turn the key ("chug-chug-chug-chug-chu-chu-chu-chu-fail" is about how it goes). When I take the keys out and put them in again for another shot, it manages to start on the second or third try.
It runs OK once the engine gets going, and after I've been driving for a while I can turn it off and on again, without any problem. My main questions are: (1) Is this likely an issue with the starter, alternator, or something completely different? and (2) just how serious is it? If I can get the car running can I make it another ~1500 miles, or should I try to find a dealership before making it back home?
Brooklyn mechanic says "every Jeep Cherokee 2000 6 cyl. 4x4 has this problem--number 3 cylinder mis-fires because it can get too hot". When I return from the country to the city, unload Jeep at the apartment, then, after about 15 minutes, re-start Jeep, it bucks and rumbles and misfires with no power from motor. I pump the gas pedal, and after about a minute it settles down.
Country mechanic has done smoke tests, looked all over for any compression leak, replaced gas cap, put insulation tape over #3 cylinder, and reported that this problem is in the "data bank" of Cherokee problems, where ever that data bank is. The question is, can one live with this problem, or will it cause more problems? Why does the motor settle down after pumping the gas pedal for about a minute? I've had the starter coil replaced recently, as I was told it can get fried from too much mis-firing.
My wife's 2000 Jeep Cherokee has a failing A/C system. Last year it was blowing warm air in the middle of the summer so I took it to a local mechanic who recharged the freon and it was fine through the rest of the summer. This year it is blowing warm again so we took it in for another recharge and it only lasted a few days. The mechanic said there is a leak at the evaporator coil(?) He said the entire dash needs to be removed to repair and it would run about $1000 to fix. This seems a bit steep. Any thoughts or experience with this issue?
View 1 RepliesJeep 2000 Cherokee
So I have this thumping noise, almost sounds like something is loose.The noise occurs for a few seconds when I accelerate from a dead stop and then goes away, it returns when I slow down and almost come to a complete stop.The noise also goes away when I put her into 4wd.The thump/rattle sounds like it is coming from the center counsel area and directly under the floor board in the driver seat.My car changes gears smoothly up and down while driving.
I was told it might be a transfer case problem and that it might need to be rebuilt, which makes me worry.