Jeep - Cherokee :: 1996 - Starts On Its Own
Oct 11, 2014
Just bought a 1996 Jeep Cherokee Sport 4.0 Auto trans. The other morning my jeep wouldn't start. Power everything works, lights work, back up lights work. Starter had been sluggish so I had it tested. Tested fine. Hook the starter back up and when I attach battery it turns over and runs constantly.
I removed the ignition wire from the starter solenoid and hooked it back up and the same thing happened. So I deduced the starter solenoid was stuck. Bought a new starter and replaced my old. Old starter was tested at autozone and it worked properly there (didn't run without ignition).
I just bought the new starter anyway. Hook up battery and same thing happens--starter turns over. How would just the cable from the battery be able to turn the starter over if it is all good?
View 19 Replies
Advertisement
I have had no problems out of my jeep except my check engine light came on and it was a bad 02 Sensor and I was told I didn't need to replace it. Well I was driving down the highway and all of a sudden my jeep died. The radio cut off my air and I put it in neutral and I tried to start it and it would not crank. I coasted in a drive way and it cranked and them died. Now it acts like it wants to start but it wont. Replaced the fuel filter. I am getting fuel to the fuel rail. It will not start with starter fluid. I took the crank sensor off and it replaced it and it still wouldn't crank. My fuel pump makes a whinning sound. My lights come on..My windshield wipers won't. My radio doesn't work and the inside lights well I couldn't get them to go off before I before my vehicle died on me, about 3 weeks before I just took the bulbs out. Would the 02 sensor make it not start?
View 14 Replies
I live on a boat access only island, so desperate. This jeep has over 230,000 km on it. Runs well, but this year started this thing where it won't start first time crank, but always starts second or third go. Bought new battery last year, so doesn't seem to be that kind of issue.
View 3 Replies
I have a 96 grand Cherokee Laredo, and the other day it just wouldn't start. The jeep will not turn over, so i started checking some things out and determined that it was not getting a spark. Since i replaced the distributor cap recently i figured it had to be the ignition coil, so i replaced that. Still no go, i tested to see if the ignition coil was getting a spark by using an ohm meter, and nothing.
So something is preventing the spark even getting that far. I do not know much about vehicles, and i have to think it is something in the electrical system (like a chip or something),possibly security system, or NSS.
View 1 Replies
1996 Jeep Grand Cherokee Laredo... A week or so ago we started the Jeep up and let it warm up before leaving for work. When we put it into reverse it promptly stalled. It would then crank but not turn over. After letting it sit for a couple hours it then started fine and has run fine since. Today just a few minutes ago I started the Jeep and drove it to the front of my complex to drop my son off to the bus, after getting back into it I went to put it in reverse and it stalled. Once again it cranks but won't turn over. We initially had thought fuel line freeze the first time, but this time it seems odd having been able to drive it a short distance first..
View 6 Replies
I have a 96 Jeep Cherokee, 2wd, 4 cylinder, manual transmission, I have had some work done on it. Recently, I had the clutch redone, then I had a tune-up and the motor mounts replaced.
After the motor mounts were done, I was unable to get the vehicle into gear. My mechanic adjusted the clutch pedal and it was running as long as I did not put it into reverse. I had driven it about 3 miles from my house, parked it.
Came out to start it a couple of hours later and it would not turn over. It wanted to start but no engagement. I had to have it towed to my house where my mechanic could check it out.
Since that time, we have determined that it is not the fuel pump, we changed out the fuel injectors, replaced the coil, replaced the crankshaft sensor and it is still doing the same thing. Have gone through all the suggested remedies.
View 9 Replies
I have 1996 grand Cherokee with 190,000 miles on it. A few weeks ago it stopped running while going up hill.It restarted after 15 minutes and ran for 2 minutes and it did that for few times till I decided to get it towed. Then my mechanic looked on it a few times and finally called me that it would run in second gear and he did not know what is exactly wrong with it. It could be driven home in 2nd gear without any issues.
View 3 Replies
I have a 1996 Jeep Cherokee Sport with 153K miles. I've been on a maintenance kick lately and I'm wondering, is it reasonable to start replacing sensors before they go bad? I've replaced both oxygen sensors over the last few years but what about the others, MAPS, TPS, crankshaft position sensor, etc? The Jeep is running great but I've been driving a lot more for work and just want to keep it that way.
View 19 Replies
(1996 Jeep V8) Dealer lets me take a Jeep home to take it to my mechanic early the next day. First time I looked at it, it coughed a bit of blue smoke, then cleared up. There's 141K on the car. Called around, the general consensus seems to be possible valve guides.
In checking it out last night noticed it was very low on oil. I added a quart and drove it around for awhile. Didn't think to check for any emissions plus I was driving around by myself. This morning I had my wife start it while I stood behind to check for the first-thing smoke. It was there, but also would give a bit of smoke when revved up.
A single bit of smoke first thing on startup doesn't seem that bad, but every time I accelerate is a concern. Plus, does that make sense? Very little smoking when level is low? Should I be suspicious?
View 6 Replies
I have a 93 grand cher with 194,000 miles on it. I have never had a problem until now. When driving the jeep sometimes it stalls and then starts back up again and you keep driving. Or othertimes it stalls when you are stopped and you need to start it back up. I had it at 2 dealerships but they can not find anything wrong because it is an intermittent problem and never happens when they have it.
View 14 Replies
I have a 99 jeep grand jerokee... every once in a while it will just stall....it starts back up right away...no problem....battery is good... could it be the fuel filter? or the cranckshaft positioning sensor? or am i way off?
View 4 Replies
I have a 1996 Jeep Cherokee (sport, six cylinder, 4WD) that won't start occasionally. 98% of the time, it starts up without problem. When it doesn't work the scenario is: put the key in, dash lights up, begin to turn the ignition switch, and suddenly the whole system looses power - no lights on he dash and of course, no cranking of the engine. If I try again immediately, I either get nothing or maybe power until I start to turn the key. If I wait ~5 minutes and try again, it fires right up. This has happened in various weather conditions.
Another problem that might be related is that about 40% of the time, it cranks but won't start in PARK. If I switch to NEUTRAL and try again, it fires right up.
View 5 Replies
My 96 cherokee 4.o is having trouble. the motor is cranking but will not stay running unless i am pouring gas directly into the butterfly valve. it runs great while i am pouring gas into it, but it sputters out and dies once i stop. i checked to pressure in the fuel rail and gas will come out of the valve however the pressure gauge doesn't have any response. it feels like the fuel pump.
View 2 Replies
1996 Grand Cherokee 4.0 liter, 156000 miles, Auto trans, It dies while driving. RPMs drop and it dies. Then starts right back up.
These things have already been replaced
cam shaft sensorcrank shaft positioning sensorfuel filterPlugs/Wires/Distributor Cap
View 19 Replies
Engine shutdown then starts after a few minutes....
Jeep cherokee 4.8L 2000 .....
View 2 Replies
1996 Jeep Grand Cherokee 4L
Problem "Stalls at idle and at hwy speed" sometimes starts right up and sometime will not start. Sometimes it will lose acceleration but engine will still be running and you can punch the gas and it will go again.
It has been in the shop for most of the last 2 months. Driven in 3 times and hauled in twice.
Low mileage 70,000 - has been great until now - serviced regularly.
Did get new fuel pump only about 10,000 miles ago do to starting problem but in that case it just did not start.
Independent shop replaced distributor cap, rotor, coil, fuel filter. No codes and couldn't duplicate problem.
Jeep dealer replaced fuel pump (they said wiring problem), O2 sensor, engine module no help, they asked us to pick up car because it ran fine. It stalled within 2 miles of shop.
We replaced gas cap just in case.
Limped back to shop to replace crank sensor as it was suggested several places. Ran fine for about 45 minutes then back to old tricks. Relays have been checked. Still at shop trying to trace problem. At least nobody is saying they can't duplicate problem as it now stalls all the time.
View 14 Replies
My 1996 Jeep Cherokee A/C system pushes cold air but out of the defroster vents not the A/C vents. Why this is happening? I suspect it is the slide switches for the A/C system but I am not sure and do not want to take the dash apart before I have some confirmation. I have checked the vacuum hoses with the heater/A/C system and they seem fine.
View 2 Replies
My 1996 jeep cherokee is having a problem with the lights when I pull the plunger switch my dashboard blinker lights and high beam light come on but none of my outside lights come on besides my tail lights.
View 4 Replies
The problem is that my headlights on my 1996 Cherokee Jeep XJ switch off unexpectedly. I can get them to come back on for extended periods by fiddling with the control knob in certain ways. This is the kind where you pull out of the knob to turn the lights on, and can rotate the knob to brighten or dim the dash.
If I pull a bit harder on the knob, the lights come on; if I twist this way just so, then off they go; that sort of thing. The fuses are fine and the contacts in the fuse box are clean. High beams work great no matter what (these are controlled from the steering column). I think the problem is at the control knob.
Now, how can I keep my headlights on when I turn them on every time without having to fight the gremlins? I think my next move is to remove the bezels and so on as best I can and get in there with some proper contact cleaner to see it's just built up gunk causing havoc. If that fails, or if that's a bad idea, what's next?
View 6 Replies
It works great for the first 5 minutes and gets icebox cold. I can almost see my breath then the system starts blowing warm air and stays that way. I've had the coolant recharged and the shop tells me there is nothing wrong with it. Of course it works for them.
View 2 Replies
I have a 1987 jeep cherokee with inline 6 and multi port injection.
Sometimes this vehicle only starts when hot
Some times only when it cold
I have recently fixed the fuel leak.
When its hot or cold and not starting if i relieve the fuel pressure at the fuel rail, in most cases it will start immediately. However if fuel pressure relief does not work. I disconnect the vacuum line at the what looks to be the EGR valve or the pressure regulator at the front end of the rail, then usually starts right away.
I have not tested at this time to see if the fuel pump is failing nor have i tested fuel pressure. I am trying to narrow down the problem to one specific part. There is no problems with cranking. There is spark - coil, plug, dist cap have been replaced.
It seems the problem is with fuel delivery of sorts. It was mentioned that sometimes the heat from the engine could be heating the fuel rail to a point which turns the fuel into a gas not allowing it to atomize.
View 3 Replies
