So I have had this code P0442 for a long time and I just kept clearing it. The attached picture (at an angle) shows the hole in the small line attached to the fuel neck filler exactly behind where the plastic wheel well cover touches it. Just ordered a new one from rockauto for about 65 shipped.
View 5 RepliesI've gotten the P0442 "small leak - intermittent" code and "service now" warnings on my 2007 2.0T Passat. I have also occasionally gotten the "check gas cap" warning and icon on the dash, but it always goes away quickly. The car runs fine. The VCDS scan shows as follows:
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 3C0 907 115 S HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: --H14--- Serial number: VWZCZ000000000
Coding: 0404010A19070160
Shop #: WSC 24125 444 85663
VCID: 3041CBF8A31AF19890B
1 Fault Found:
001090 - EVAP Emission Control Sys
P0442 - 001 - Small Leak - Intermittent
[Code] ....
If I clear this code, it comes back within a day or two of driving, but not immediately. I have already replaced the gas cap and N80 valve. The other component I'm aware of possibly failing is the check valve. It's just downstream of the N80 valve, circled in red here:.
I put a vacuum on this part, and it had a very slow leak, losing about 3psi (starting from 20psi) every minute. That seems too small a leak for this to be a problem? Is this thing supposed to be absolutely air tight? Since this part is more expensive ($80) and bit more hassle to replace than the N80 valve, I'd like to know more about this before I just blindly replace it.
If this check valve isn't the problem, then what to check? Although the car runs fine, I need an inspection and would prefer to not have to clear the codes and hope for the best just before taking it in.
so my girls car is throwing an evap code (P0442) small leak detected. I bought a new oem gas cap and replaced the purge valve solenoid under the hood. that didn't work, CEL still comes on about 100mi after clearing the code.
I have checked the rubber hoses that were attached to the purge valve solenoid when i replaced it and they are fresh, no dry rot or cracks that i can see. The hose on one side goes to a hard line that runs under the car to the back, the hose on the other side of the solenoid runs under the intake to the throttle body. That hose was fine as well. Connections were tight and i even put better clamps on the hose ends that attach to the solenoid. So I have ruled out that portion of the system (under the hood).
I also removed the rear seat to access the fuel pump. All those connections seem nice and tight, I don't smell any strong gas fumes indicating a leak so i don't think the fuel pump gasket is the problem either. Finally, i checked out the hard lines running under the car front to back and I see no apparent or obvious damage. I assume my next step is to pull off the rear passenger wheel well liner and asses the charcoal canister and the LDP connections, correct??
The last thing I will mention is, Idid notice the 2 fuel lines that attach to the fuel regulator are in pretty rough shape, however not leaking any fuel. Are both of these lines actual liquid fuel lines? I am thinking one of them is a vapor return which may be part of the EVAP system. If it's dry-rotted and leaking vapors could that be the culprit??
Threw this code p0442 evap emission control small leak. I see its a popular code to have....
View 14 RepliesThis began as a troubleshooting exercise for a P0442 code (2002 model) indicating a leak in the evap emissions system. Often caused by simple things like a loose/poorly sealing filler cap. Not this time
It's a neat design, tucked away up in the fender well. Even sports a very effective stone guard (plastic shield) which hides all that tubing from view. But the shield also traps all the road salt and mud and packs it into the crevices between the tubes where it stays from one winter till the next. Even a powerful car wash probably can't dislodge the caked on mess once solidified.
I have 2 issues and wonder if they are related. I don't have a CEL but I'm getting a P0442 DTC with my code reader - EVAP system leak detected
Also, my ESOF doesn't work. The hubs will lock manually. Can this be related?
I've already cleared the code and it came back. My ESOF hasn't been working for a while but I just haven't had the time or motivation to look into it until now.
I tried the HVAC Test and there may be a slow leak in the system. I can get the vents to switch from defrost to face vents but it switches halfway back to defrost, both are on at the same time for 20 seconds, then it recovers and goes back to the face vents.
My 4wd relays seem to work as well.
About a month ago I had my SES light go on and I took it to the auto parts store and they said it was a small emissions leak. I am not sure of the code though. I took my car to the shop and they said that a sensor that had something to do with the exhaust was bad or unplugged.
My SES light came back on about about a week ago and I had it tested and it said the same thing. "Small emissions leak" This time I got the code and its P0442. The shop is closed today and tomarrow so what and where the sensor is located? Or if its the same thing?
My 2009 F250 5.4 was throwing code P0442 - minor EVAP control system leak.
The first time it happened, the guy at the parts store checked it out, reset it, and said if it comes back, try replacing the gas cap.
The second time it happened, same thing.
I bought a Stant cap at my local parts shop, and had them reset it again. I don't like the Stant cap since it does not fit the retainer correctly, but it sealed fine.
However, the same code came back.
It took a smoke test to identify a leak from the vent tube on top of the fuel tank. The tube was replaced today.
If the code stays gone for a few hundred miles, I'm going to switch back to the original gas cap. I want to make sure the leak is gone before I change anything.
Got an engine light on today and had it checked at Advance Auto. It is P0442, "small leak in Evaporative emission control system". One article I read said to remove and retighten the gas cap, clear the code then see if it occurs again. If it does then replace the gas cap with a new OEM cap, and try clearing the code again to see what happens, as a first step in the troubleshooting process. I retightened the gas cap, but don't know how to clear the code and turn off the engine light.
View 3 RepliesGot a CEL tonight while driving. Originally I was driving and the light came on saying that my gas cap was loose. I corrected the problem when I got home and tightened again. The light stayed on however. I ran a scan with the OBDII and it gave me a code for EVAP- Very Small Leak .
I was reading around and some people suggested the MAF. Which would make sense because I recently had all of that stuff off and gave the engine a deep cleaning while it was exposed. I just don't see how the MAF could relate to the code my car is pushing?
Wife's car had a check engine light this morning, code is PO456, small evap leak, I took gas cap off cleaned the filler neck and solenoid the gas cap seal, and reset the light. I filled her car up on Sunday (2011 Sonata 2.4 80000 miles). Where to go next if light comes back on? Purge valve ?
View 9 RepliesMy 2007 Sonata continues to throw a P0456 code, small evap leak detected, gas cap is tight, getting ready to check the evap hoses. The question I have is the evap system covered under the emissions warranty at all ?
View 4 Replies2009 santa fe 67000 miles. Replaced fuel senders approx a month ago. All was fine. On about the 3rd fill up the cel came on. Code was for small leak evap. checked the gas cap, no problems. Replaced the purge valve and disconnected the battery while doing so. Cel light went off and stayed off thru one tank of gas. Filled up again and thought I detected a little fuel smell shortly after and cel came on again. I only smell fuel when its full and down to just before 3/4's. The light came on right before 3/4's. My husband is beyond frustrated and wants to smash the car lol. Once I get him calmed down where should we be looking for a leak and how to fix it? We can't afford a dealership bill right now and of course it's due for inspection next month.
Code was p0456
The only answer I got in the DIY section is to check around the fuel senders again but I'm leery to do it as I can't see how there would be a leak there, the covers go on SO hard even with that tool.
It all started with a fuel cap loose light (it wasn't) after a day or two the MIL came on and got this code I reset it but I'm sure it'll come back since there's probably a real leak. What can I check myself to find this leak?
View 11 RepliesThis is the code i pulled from Vag. Its not the gas cap...
VCDS Release 805.0: Generic OBD2
Mode 03: Emission related fault codes
Address 10 (Engine): 1 Fault Found:
P0456 - EVAP System: Very Small Leak Detected
2004 VW touareg v6 - engine light on - autozone diagnosed as code P0456. Possibly gas cap, so I replaced with aftermarket gas cap from auto zone. Light still on. What can I do or replace to fix problem. I read something about a N60 or N80 valve. Is this something I can buy and replace myself. Most of my mechanical experience is related to working on a 85 CJ7 with an inline 6cyl or Chevy trucks. If the N valve is a easy fix, any instructions and pictures of how to do this.
View 1 RepliesCEL came on after a couple of driving cycles showing code P0456 (evap emission control system very small leak detected)............. car drives fine has good gas mileage.....
View 13 RepliesI had a check engine light cane on. I took it for it to get checked and they gave me this code- P0457 EVAP small leak detected. ECM has detected a large leak in the EVAP System during a system monitor test.
The paper said I had a leak in the Evap canister or hose. I took the truck to a mechanic and was told I had Bad oxygen sensors. Can Bad/Dirty oxygen sensors make this error code come up?
Exactly where the oxygen sensors are? I was told they were behind the mufflers but I didn't see any and the diagram I found was not accurate.
2002 Ford Ranger XLT v6 extra cab.
I've been getting a P0442 periodically from my 97 850 wagon (base, no turbo). I've replaced the gas cap, the electrical part of the ignition switch, and all the deteriorated rubber vacuum-hose couplings I can find under the hood, but I'm still getting the code. I want to inspect the hose couplings at the evap canister, but there doesn't appear to be any way of getting to them other than removing the canister from under the car. Is there any other access to these?
Also, I've got VIDA running on my PC, and even though I've given it the VIN, it shows me the wrong evap canister in the parts diagrams. It shows the cylindrical canister, but my 850 has the rectangular canister. Where I can view accurate diagrams showing the evap components in this car?
I drive a 2003 Jeep Liberty Sport, with the 3.7 liter V6. It has roughly 97,000 miles on it.
In the year or so that I've owned it, the jeep's check engine light has come on several times. Every time I've had it checked, it's the same issue - a small evap leak, code P0442. Typically, they'll reset the computer, and I'll drive it for two or three months and eventually, the code will come up again.
Oftentimes, I'm told it could be caused by a loose gas cap. I'm aware of that and I try to make sure it's nice and tight every time I fill up. I've also looked at it, and there are no visible cracks or holes in the cap itself. But, the problem still occurs.
So, What this could be besides a loose gas cap, could cause an intermittent small evap leak?
I have a 2004 Toyota Corolla- the CEL has been on for months- the code is for small evap leakI have tried cleaning rust from filler neck at gas cap- no change. I have had a smoke test done with no leak found.
View 5 Replies