Intrepid :: 1998 2.7L Engine - O2 Sensor Location
Mar 7, 2011
i need to know what locations are these sensors at bank 1 sensor 1 and bank 2 sensor 1 what i`m asking is it at the front of the engine or the rear its a 2.7 liter engine.
View 1 Replies
Mar 7, 2011
Advertisement
Dodge - Ram :: 1998 Pickup Dies On Turns - Oil Pressure Sensor Location
Our 18 yr old grandson has a 1998 Dodge Ram pickup that dies when he turns. Was told that
1) either the wiring harness to the oil pressure sensor is rubbing OR
2) the oil pressure sensor needs to be replaced -
QUESTION: Where is this located? Is it hard / expensive to replace?
Golf/GTI VI :: 1.8 TSI Engine / Map Sensor Location
I am a newbie Golf owner and have little trouble. I am not sure where is the map sensor located in my 1.8 tsi engine. I've been googling and have not found pic or technical drawing to be 100% proof which one is it.
View 2 RepliesDodge - Intrepid :: 1995 - Powertrain Control Module Relay Location
I just need to know where the powertrain control module relay is in my car...
View 2 RepliesLexus GX 2004-09 :: Check Engine Light On - O2 Sensor Location
I have an 04 gx with a check engine light on I had the code read at auto zone. That tells me o2 sensor bank 2 sensor 1. I have already changed the sensor they said it was and still have the code. What is the correct location of this sensor?
View 2 RepliesMazda - Protege :: 1998 - Engine Block Drain Plug Location?
I'm in the process of changing the coolant on my 98 Mazda Protege LX. I have the radiator drained and rinsed out. Now I want to get the rest of the coolant out. Where the engine block drain plug is on this car? My Haynes manual shows a picture of the location but It's of a different model.
View 12 RepliesIntrepid :: 2002 SE - Transmission Range Sensor Replacement
I am looking to verify that replacing the Transmission Range Sensor on my 2002 SE is the correct action for me to take. My symptoms include:
1) Fuse 17 keeps blowing intermittently but frequently. It has never blown in a middle of a trip. Have not determined if it is blown at end of trip or right at start of next trip.
2) All gears are highlighted (have boxes lit up on all gears) when I am in park or neutral. The correct gear is highlighted when in any of the drive gears including reverse. This symptom is constant and has been for a few months now.
Intrepid :: 1998 Dodge Smokes When Pull Out
I have a 98 Dodge Intrepid and it smokes when I pull out. I was told it may be the valve seals. Is this true? Could it be the rings? It doesnt seem to smoke when I go up hills just when I pull out.. Is there an easy fix?
What are some problems I can expect with this car? I have 107,000 miles and am wondering when can I expect the timing belt to fail? What are some things I may have to fix?
Intrepid :: 1998 - Motor Will Not Turn Over / No Start
We have replaced the pcm : Still no motor turn over -no start !
New Battery and cables !
All-- fuses and relays-- were checked and are ok !
No ignition to the starter - motor will not turn over !
Jumper wire from control center starter relay -then motor turns over !
We are at a Loss here - Could it be the ignition switch? Neutral safety switch ?
Intrepid :: 1998 Dodge Starts Spewing Black Smoke And Trying To Stall Out
Working on a 1998 intrepid got the codes po134 po171 po154 and got all the codes taking care of except 1 po134 which it says its a oxy sensor just took it for a test drive after about 10miles it starts spewing black smoke and trying to stall out, then it clears right up after that.
View 2 RepliesDodge - Intrepid :: 1996 - Throttle Position Sensor Signal Wire Producing Voltage
Background: Check engine light indicated a problem with the throttle position sensor (unfortunately, don't have the exact code). The TPS on my model ('96 Dodge Intrepid 3.3L) is the non-adjustable type. There are three wires going to the TPS -- a power source, a signal wire, and a ground. The TPS acts as a potentiometer and depending on the throttle position, sends a voltage signal down the signal wire to the computer.
Here's my question/issue: After disconnecting the TPS, I tested the three wires with a multimeter. Power source (5V) and ground were fine. But I'm getting a voltage reading of about 4.35V on the signal wire. It's my understanding that with the TPS disconnected, I shouldn't be getting any voltage on that wire. Does that sound correct? If so, what would be causing me to get a voltage reading there? I'm assuming some type of problems with the wires, maybe an exposed wire on the signal wire somewhere?
GMC - Sierra :: 1998 - Engine Coolant Temp Sensor Wires?
So I got a 98 GMC sierra and the ect sensor that is on it only had one wire running to it. Obviously the previous owner tried to make something work. I bought a new ect sensor and pigtail to rewire it but can't find the ground wire anywhere. Looking for a wiring diagram?
View 14 RepliesFord - Explorer :: 1998 - Engine Swap - Sensor Interchange?
What is the difference between the 2 wire & 3 wire cam sensors. I am installing a 98 4.0 in my nephews Explorer-engine build date of 12/98. The replacement engine build date of 5/98. There have been quite a few differences during this process and thought I had them worked out but the old engine had a 3 wire cam sensor and the replacement has a 2 wire. I have already changed the harness over due to other differences but my main question is will I have to swap the synchronizer or will the sensors interchange? The synchronizes look different as does the cam sensor.
View 1 RepliesMitsubishi - Mirage :: 1998 - CEL Codes For Fuel Trim Bank / Oxygen Sensor Bank 1 Sensor 2 And Cylinder 1 Misfire
I own a 1998 Mitsubishi Mirage with about 190,000 miles on it. The engine light has started coming on and I get three codes:
P0170 Fuel Trim Bank 1P0136 Oxygen Sensor Bank 1 Sensor 2P0301 Cylinder 1 misfire
Read more: [URL] ....
Suburban :: 96 - Location Of Speed Sensor
I need figuring out the speed sensor on my 96 ,k1500 series,5.7,4*4,automatic.. Where is it located...
View 1 RepliesPhaeton :: 2004 - O2 Sensor Location?
Are these easily accessible? I have to replace both sensors in my 04 4.2 and was curious if they are easy to replace. I could not find and detailed info. Also any tips when replacing these and purchasing 2 sensors?
View 3 RepliesTacoma :: 1997 - Location Of MAP Sensor
Where is the MAP sensor located on a 1997 toyota tacoma.
View 2 RepliesCamry :: 2007 - ECT Sensor Location?
I have a 2007 Camry Hybrid with ~150k miles, 4-cyl engine and last week the water temp gauge starting fluctuating erratically...going from extremely hot to cold and vice versa. It eventually tripped the check engine light and autozone said it was p0117 - Engine Coolant Temperature (ECT) Circuit Low Input. At one point the engine was really shaking the whole car. I haven't driven the car as a result.
I have ordered a new ECT sensor and it should arrive this week. the problem is I can't find where the sensor is located... I have looked all over this forum, google, the internet, nothing. I have looked in a Chilton's manual but it doesn't have a diagram.
Phaeton :: Outside Air Temp Sensor Location?
Where is the ambiant outside air temp sensor located on the Phaeton? I know it is located under the outside left or right mirror (based on model year) on a Volvo but not sure where it is on the Phaeton. No problems, just curious.
View 6 RepliesPassat (B6) :: Outside Air Temp Sensor Location
Where it is?? Body shop didn't connect it after repairing my bumper and I would rather not have to take it off again..
View 3 RepliesPassat (B7) :: Location Of Coolant Sensor?
Looking for the location of the coolant sensor.
I'm pretty sure I have a faulting coolant sensor. Light comes on with a message in the MFI indicating coolant is low, but when I check, its at the maximum line on the overflow reservoir. So I assume the sensor is not accurate/faulting.
Spoke to my service advisor who said the sensor is attached to the reservoir and you buy it all as one item, sensor and reservoir combined.
I've also seen threads that indicate it's a stand alone sensor toward the back of the engine compartment.
Need to confirm either of these as being accurate locations for the sensor? Is there more than one?