I replaced my front axle pads but the driver's side brakes seem to be dragging on the rotor making a very loud squealing noise when im driving. When I parked it in my driveway it was really hot and smoking. It doesn't happen to the passenger side. I pushed back the Pistons easily to get the brake pads in there so that wasn't a problem. But I must admit I changed them when my brakes were grinding.
View 13 RepliesWent and got new tires on the supercrew. Went going through parking lots or simply driving i hear a loud squeal like brake pad squeal. I put brand new wagner ceramics on the truck. Also if i turn to the left the driver side rear sounds like brakes are dragging against the rotor. Whats goin on with this. The squeal will happen between 10 mph to 20 mph and the grinding noise will happen if I am cruising or turning to the left. It goes away when i apply the brakes.
View 1 RepliesI changed over to summer tires today on my 1999 4wd F350 diesel . While the front tires were off of the ground, I tried rotating the wheels by hand to see what the resistance was like. I was surprised at how stiff they were. It would take three fingers to rotate the wheel and as soon as I stopped applying pressure the wheel stopped turning. I pulled the rims off and found that the calipers appeared to be contacting the rotors and causing resistance.
My last rig was a 1960s 4wd F250 that had calipers that could be adjusted manually. I kept these adjusted so the calipers were almost touching the rotors. I could spin the rims with one finger and the wheel would turn for 30 seconds or so until coming to a stop. Is this normal?
Truck is 2007 6.0L 4 door F-250 FX4
So this started after some High water encounters around my area. All freshwater. Went to the store and then i notice the truck pulling Left and got home and checked brake temps and the driver front and rear were over 400*F passenger side was 150* or less. No trailer no load in the bed. I decided to clean everything. Pads are worn but still have life.
Rotors showed some signs of where the pad is dragging Not bad though just a small area close to the top hat. I cleaned pads, carriage, and clips and reinstalled everything with some anti seize on the edges of the pads where the clips are and at the same spots on the carriage.
Thought it was ok but the after more water and a day or two sitting the same thing happened again. It is only the drivers side and it's both front and rear. I am stumped on this one. Two calipers going bad at once? I need to tow a boat on Monday So I have got to fix this.
Took the truck out the other night, got to town felt the slight drag but nothing alarming, got out of the truck and could smell it, rear drivers side rotor glowing red, pass side not glowing, pressed park brake then released, driver side freed on its own, pass side sticking, replaced pass side rotor and pads, found nothing out of the ordinary... Ford F250 4x4, 2005 ....
View 14 RepliesFront driver side brake squeals on a stop and release. This is the only side that produces this noise. Brake clearance is still very good and this noise has been off and on since i bought the car in December. Car has about 25k miles on it and will be replacing brakes at 30k.
Brake issue - YouTube .....
I have a 2004 xlt xtracab F150 and for the last week my drivers side brake has been dragging and the first time it happened it got REAL HOT and after I let it cool down it did release and then 2 days later it did it again but with a one mile slow drive to work did not get that hot. I am assuming that I will have to replace the caliper but is there anything else I may have to change?
View 5 Replies2013 Platinum. See sig for details. 37,000 miles. 1 owner. Truck has been basically parked since June. However I take it out for a quick spin every 3 week for 10 miles or so. Currently has storage insurance on it.
When backing out of the garage the brakes are grinding and squealing bad. Also getting feedback through the steering wheel for the first couple miles which leads me to believe it's one or both the front brakes.
I have a 2012 F-150 4x4 super crew all factory with 54,000 mi. I've noticed a new noise/hum at slower speeds, more frequent now. The noise doesn't sound like its from the front or back specifically. I pulled the front wheels this evening and the front rotors seem pretty tight, how easily should they turn with vehicle off for about 30 min? I started it and pushed and released the brake and quickly tried to turn them, very tight, after a minute or two they relaxed a little, another 5 min they seemed tighter? I sharpie mark on both inside and outside of the rotor and turned it past the pads and they are both squeezing equally ruling out binding of the slider bolts.
View 3 RepliesI have a 2011 Sonata with 40k miles and am hearing what sounds like a dragging ... medal touching medal .... brakes dragging sound coming from the passenger side mainly when the car is cold. Could this be a possible wheel bearing going out???
the car is lowered about an 1.5 inches and and sit on a staggered wheel set. 18x8.5 up front and 18x9.5 in the rear. Just want to know if I should be worried.
So, I just returned home from a 7-day caribbean cruise to find my drivers side rear brake dragging...hard. I know it can happen to any car but it's aggravating none the less. I guess I'll limp the 2 miles to the dealer on Monday morning...
View 2 RepliesI noticed my rear brake smoking on the truck really just the rear driver side. I had replaced the pads and caliper and rotor a very long time ago. What I think happened is the parking brake got hung up somehow. The wheel was extremely warm and the reason I noticed it was not only the smoke but I felt some sort of wobble or almost out of alignment issue.
When I got home I noticed the smoke and extreme heat. I removed the caliper and the pads look still "new" and evenly worn. I did bleed the caliper just to make sure no air, I even put a spacer in the caliper and my wife applied the brake and they closed appropriately. Then I was trying to get the rotor off and no success. I did adjust the parking brake but I am not sure if you move it up or down to loosen it up?
I have used PB Blaster to try and loosen it up, rubber mallet while I turn it (although it does not turn easily at all), I sprayed it inside where the adjuster is hoping it would seep down between the shoes and the hub. I heated the hub up with a little torch - no success. I was thinking of using a wood piece as a butter and hammer from the inside out on the rotor but fear that will warm the rotor itself.
My front dust shield on the driver's side is falling apart and scraping against my rotor. On the passenger side the dust shield is long gone.
My question is do I need the dust shields? Is there any issues without having them?
In a perfect world I'd like to replace them, but I have a feeling that this is going to be one of those dealer only items that's severely overpriced.
Seeing as I have the passenger side shield missing, and I never noticed anything before hand I'm thinking this is an item that might not be necessary.
2011 f250 6.2. put it in the shop to have the rotors turned, and front brakes while they were under there. Now it pulls to the right whenever you apply the brakes. Can smell brakes on the left front after a short drive time. Replaced that caliper and it's still doing the same thing. I'm stumped at this point.
View 9 RepliesLast night I noticed when I got out of the car my drivers side headlight was off while my passenger side light stayed on for about 20 more seconds.
At first I thought I just needed a new bulb, but tonight I saw both headlights are working when the car is on or when I turn the headlights on manually, but when I shut the car off the drivers side goes off immediately and the passenger side turns off in about 20 seconds.
I really like my auto-off after a little bit instead of it turning off immediately.
I haven't changed anything recently. Other than that I can't see any other problems. I swapped out my 08 headlights for 2014 headlights about a year ago and haven't had any problems.
I installed my hks ssm yesterday,it sounded great except for a clunking noise every time i pass by an uneven road...i found out that the hks pipe was hitting "the round thing next to the shocks" ... that's why the oem muffler had a little round stopper.. I tried to wrap it with a little exhaust wrap thinking it would fix it but it did'nt, just wondering if there's a DIY or something for this problem.
View 11 RepliesI was told it is my sway bar end link? My friend says it is probably my sway bar end links, not positive yet though! I just picked up my car Friday, so I'm new to the Lexus world, always wanted one of these cars.
View 4 RepliesSo I found out this afternoon that I have a leaking sunroof. Water has been draining into the rear driver's side passenger area and has soaked my carpet under my seat. And had standing water under my rear seat in the tray next to the fuel pump access.
I found that the drain tubes can become clogged allowing for water to spill over or seep out. And sending some compressed air up the tube will clear it. But I do not know where the tube exits.
I unfortunately cannot pull the interior apart the weekend because I have drill. So it will have to wait until next weekend to gut her again. I will also pull the headliner to check the condition of the tube.
Getting wind noise from the A pillar drivers side at highway speeds?
I'm getting what I feel is excessive wind noise almost like my window is cracked open. I'm sure this is something the dealer would be able to fix under warranty correct?
My 97 f150 had been sitting for a while and after a few miles I could smell brakes and the left front rotor was hot. So I removed the caliper to see if I could free it up. When i push 1 piston in with a C clamp the other one comes out and visa-verse but I cannot push both in with 2 C clamps. When I push the brake pedal they both come out. Its like there is a check valve in the line. How should I go about trouble shooting this?
View 1 RepliesFirst it was the RH now after replacing the rotors, calipers and new shoes. The LH is now doing it. It doesn't stop the truck just gets hot, the wheel, and u can smell it. The truck is a 97 f150 ext cab 2wd short box, had since new and has over 200,000 miles and going strange until now. I want to get 300000.0 before I let her go. Had to replace a rear axle brake line years ago, and do not think the lines were bleed right, the brakes never work just right.
View 4 Replies