My 2013 has more turns to lock going right than left. Going right, my steering wheel will go exactly 1.5 turns to the right from center, but only about 1.3-1.4 going left from center. Is it a feature? Never noticed anything like this on any other cars I've had.
View 7 RepliesI can turn the wheel to the right 1.5 turns but only make one full turn to the left before it locks..
View 12 Replies2011 gti. I have about 5300 miles on it and it may be normal or have been doing this since it was new. I just noticed it today. When turning full radius in a parking lot I noticed that it sounded like the brakes were dragging. There is also a slight clicking noise. It does this both on left and right turns.
View 3 RepliesSlight squeal while steering the vehicle to the limit of it's turning radius? I've just begun to notice this recently on my 07 GX... mainly when I'm pulling into a parking spot at slow speeds. Is this normal or should I have it checked out at Lexus dealer?
View 3 RepliesJust bought a 2002 F-250. Truck came with 18" Rims with 275/70/18 tires. The turning radius is awful, almost unsafe. The stock rim and tire size should be 16" rims with approximately 265/75/16 tires. Would the larger rims have that big of an effect on turning radius? I have owned two 2006 F-250's, and they turned nothing like this truck. I have not really gotten into the front end to see if the stops have been adjusted and/or if the tires are hitting.
View 10 RepliesAny way to remove the "beep" sound at redline? i love that it shows the yellow yellow then red but the beep can get annoying.
View 14 Replies'm a former 2004 Jetta GLI owner...looking to get back into the game with a 2013 GTI. One thing I'm confused about is the GPS screen size. Many of the cars I've seen, including my friend's 2013 GLI has the RNS315 with a very small display. On the VW website it shows a much larger display in some of the photos, and I'm pretty sure I've seen a larger display on some of the GTI's I've seen in my neighborhood.
View 3 RepliesI am in need of new radius arm bushings (both sides). How to be able to just unbolt the sway bar, unbolt the shocks, dismount the coil springs so they fall out to the sides and then drop the rear of the radius arms so they could press out the old bushings and insert the new? This is a 2WD and I think the process would be same for an F250 of the same year (2000 - 2004). The reason I ask is because I really, really don't want to have to get down to the king pin level and completely remove the radius arms if I don't have to.
View 2 RepliesMy tires are 245/75/16, is there any benefit in installing smaller 16" tires?, I'm 5'5", I can still get in, but I would like to have it a little bit lower, will that affect mileage, speed etc.? would that even make a difference? if it possible how small can I go without affecting performance?
View 13 RepliesI have a 2003 cavalier ls, The tire size that is on it is 195-70r-14 I am thinking about getting tires which are 175-70r-14 because I was told that the smaller sidewall size would give better bottom end performance (0-40, 0-60, Which is what i'm looking for) However He also said that it would alter my speedometer rating, and the amount of mileage that is put on the car, That it would read that there are more miles on the car that I would actually be putting on. Is there a way to correct the sensor or device which reads the tire revolutions?
View 9 RepliesI can just barely get my truck into my garage. I have about 1/2" each side of the mirrors and yes, they are pushed in, not extended. I looked at sports mirrors from Dorman but not sure of the quality.
View 12 RepliesIs there a way to expand the view on a 2008 GPS to more than a 300 foot radius?
View 1 RepliesI'm new to the 2G and noticed a wheel shudder or jump when turning a tight circle in low temps? I'll try to list out all the info I can:
The shudder was exactly like a 4x4 vehicle in low range/diff-lock when turning on dry pavement.
Going straight or slight turns only, nothing noticeable. ( I was paying attention)
200k miles, just bought the car and haven't changed the WS atf yet.
Temps in the -25°C/-10°F range ....
I have a 2016 F250 XL and I want to put smaller outside rear view mirrors on her. I thought I can't be the first person to want to do this but repeated searches haven't turned up a bit of information.
I have the stock XL black plastic tow mirrors. They are manual extension and manual fold in. No heat, no lights, nothing. I want to go to a smaller, non-towing mirror like comes on stock F150's, chrome would be OK. In about 18 months I will want to go back to my trailer towing setup. I need to be narrow for a while.
inside round thing with 4 notches in it is a smaller diameter than the new hubs. Will theystill work?
View 6 RepliesMy sis drove the Phaeton yesterday and we had to go through some nerve-wrecking parking. The gaps were only a few milimetres across but luckily we made it through the lot in the end. Anyway, we had to do a lot of full steering turns (that is, when the wheel is turned to its maximum) and there's a worrying clicking sound that goes on until the steering is turned back from its maximum radius. Is it a problem or just a minor thing?
View 21 RepliesMy 2005 Infiniti G35 has 144,000 miles, two new rear tires and two good front tires. Sometimes, and I cannot nail down or reproduce-on-demand this situation, my car will suddenly begin to vibrate as if I'm driving over a smaller version of those rumble strips on the side of the road. The vibration continues when I take my foot off the accelerator, and will continue at a slower rate as I decelerate until I stop. Often it seems that when I come to a dead stop and accelerate again, the vibration stops, but other times it will continue as I accelerate.
But what's really odd is other times I'll just be cruising along and the vibration will begin, keep vibrating for a few miles, then peter out and disappear. I haven't totally nailed down whether or not braking affects it, but if pressed I would say that I would use the brakes at least once before it disappears. Also, it only seems to begin once I hit 50-60 mph, but again, it doesn't happen every time I go this speed. Other times this car drives incredible and makes the road feel as smooth as glass.
I haven't taken it to the shop because I'm sure they won't be able to reproduce it.
I trying to find the distance/length of a 2005 4x4 onward front radius arm. I'm fitting a 2004 Cummins nv5600 and transfer case into a 1997 fzj80 Landcruiser. I'm also fitting front and rear diff/axles from a 2008 f350 however don't have the radius arms and late model f250 are extremely rare birds here as Ford don't sell them here. I want the distance from the rear bush in the radius arm(at the chassis) to the front bush (top and bottom) at the diff/axle....
View 1 RepliesI replaced the radius arm bushings on my truck about a year and a half ago and about 6 months later I found that the nylon spacer on the driver's side cracked in half and only half remained on the truck so I replaced it (under warranty) and I found the same thing again today. I torqued it to factory specs and the passenger's side is fine. What gives?
View 4 RepliesWhen I drive in a parking lot or parking garage and start off into a slow, tight corner, I feel a "surge". If I had a locked diff I would understand. I have a Haldex composition controller. I am not bothered about it...just wondering what it could be. Maybe the clutch slipping?? No evidence of that at full throttle acceleration runs in the higher gears.
View 5 RepliesI drive a 2006 Ford F350 4x4 Crew Cab. I think the radius arm bushings on my truck are bad. I get a clunk going over bumps on the left side in the front end.
I'm assuming it is the bushing in the rear of the radius arm, but I haven't taken it apart yet because I want to have the parts in hand. I ordered a bushing, part number 5C3Z3B203AA. But it looks too small when I hold it up to it. What is the part numbers for the radius arm bushings?
Or am I looking at the wrong thing for the clunking in the front end? I just did the ball joints with Moog both sides top and bottom. The shock bushings look alright. I have replaced the front sway bar bushings thinking that was it. What else could it be?