IS F (2008-2014) :: DVD Not Showing Picture But Getting Sound
Jun 28, 2015
Why when I load the DVD I get sound but no picture?
View 7 RepliesWhy when I load the DVD I get sound but no picture?
View 7 RepliesI have 245 35 20 on the front (lowered 1 inch on Tein Springs) and 275 30 20 (10.5 inch wide) on rear. The front tires are worn extremely bad and showing cord on the insides. The rears are worn on the Insides and middle but not as bad.
View 5 RepliesHave electrical power but only getting a clicking sound. Bad starter?
View 14 RepliesHaving a sound from my exhaust. Basically when the car is rolling along around 25 MPH or so, and my foot is not on the gas, as soon as I gently touch the gas pedal, I get a soft "thump" sound. This basically tends to happen in 5th or 6th gear only.
The previous owner had done a muffler delete on the stock exhaust so I figured there was some sort of back pressure issue because of this.
Finally out of frustration, I sprung for a new Borla Catback exhaust system, hoping to eliminate this issue. While the thump sound is slightly less, it still happens!
Any way to remove the "beep" sound at redline? i love that it shows the yellow yellow then red but the beep can get annoying.
View 14 RepliesI was just driving home and noticed and sort of slapping sound from my rear left tire - I pulled over at a gas station to take a look at it and found no issues with the tire itself (bubbles/flat spots) or any irregular wear, my next best guess is that the wheel bearing has gone bad, is there a way i can test this for the rear wheels without putting it on a lift?
View 13 RepliesI noticed my sound a few weeks ago but wasn't as loud as the videos I've seen. Didn't really bother me. I did notice today that the sound was a lot louder . The only thing that has changed is i had my oil changed over the weekend with mobil 1 5w-30 fully synthetic. Now I don't know if that could factor into the sound getting louder.
I am really hoping its just a cat and i can replace my headers and everything is good. i just got the car with 19k miles on it and do not have a warranty.
I have been worrying about "engine noises" for years and at this point if its something i can't fix without dumping thousands of dollars into it, then so be it. I am just going to enjoy the car too the fullest. Plus, once i get full exhaust, it will work with canceling out the ticking sound.
I just noticed that when I start my car I hear a constant whine sound. When I press on the gas it gets louder. When I'm stopped I hear it whining. What it may be?
View 14 RepliesI have all functions turned on inside menu options. I have Sirius xm subscription and they told me it's not a service they provide for Lexus. So I'm thinking its a service from Lexus, is this true ?
View 14 Replies2008 ISF. Has made whining sound (like a supercharger) off and on since '11 and 30k miles. Clearly coming from accessory belt system.
Having read this forum I assumed it was the tensioner, and finally replaced it last week @ 52k. Spun all pulleys by hand and all felt/sounded fine. Actually the old tensioner seemed fine too, even the belt- no cracks or wear, so I didn't replace belt at first, just tensioner.
Well new tensioner reduced the sound just a little, but still there at times, so I replaced the belt with a goodyear gatorback and that made the whine worse than ever. So I put the old belt back on, and am currently still dealing with some whine,
I don't have another ISF to compare to, but it can't be normal. It's not loud in cabin, my friends don't think anything of it, but I hear it and it's embarrassing.
Since I cant hear or feel an issue with any of the pulleys, is there a logical order in which I should start replacing them? I'm at a loss as for what to do next. I can't pinpoint where noise originates since it only occurs under load while I'm driving, but it's certainly from the accessory belt system.
My truck ('10 4x4 w/5.4l, 65k miles) gave a P2096 this past weekend. Cleared it and drove around for a while. Today it threw the same code. No other codes present, just P2096.
I did look under the truck and it seems pretty easy to get to the two sensors. Is it worth swapping them to see if the code changes to the other side?
Truck idles and accelerates just fine. Fuel mileage seems to be down a bit, but the air filter is very dirty and I will be replacing that this week.
I have seen you can check the sensor by heating it and measuring the voltage. Seems easy enough to do, but do you create other problems from that?
I did notice that the connector to the mass air flow sensor is cracked, probably from checking the air filter. I would think if that was the issue it would be showing some MAF code.
I had my local race shop install my new PPE headers and how I have a rubbing and grinding sound while taking right turns. They have had the car for a few extra days and they say they cant seem to find the cause of the problem. It rattles on a pot hole, it grinds on right turns and sometimes vibrates on highway cruise control driving.
View 14 RepliesWhen do you typically see your fuel light come on? I never need to let the tank run down very far but the other week I was curious about this. The fuel gauge was way less than 1/4 tank left and the range display was ~50kms. When I filled up shortly after it looked like there still would have been at least a gallon in the tank still.
Just feels weird because my last car (Camry) would throw the fuel light when you still had a full 1/4 left in the tank.
My is350 F sport tire pressure sensors. Well I have after market wheels with the stock tire pressure sensors, when they were first installed everything was fine, now about 2 months later now that it is a little cooler. My two back sensors are showing the warning light. it still reads the pressure and shows correct pressure but sensor warning light for both rear tires are on. Why this is? I was thinking the colder weather but why only the rear two and not the front. they go off and on but lately both have been on.
View 3 RepliesSo I got my IS350 F-Sport AWD a couple weeks ago and I'm loving it so far. I just passed the break in period a few days ago . I just had a question about something happened today though. Basically I was on the highway and I was coming off of an off-ramp at about 90 km/h (~55 mph). This was a relatively sharp ramp but I was slowing down as I entered it. Anyway, the car started beeping and I saw a red message in the center of the gauge.
Unfortunately, it was there for a split second and I didn't get to read what it said. Later, after parking the car, I checked the "messages" view in the gauge cluster and there was nothing there. There was also no check engine light or anything on after either. The car seemed to drive normally before, during, and after that. Was it the VSC/TC system? Or is it something else?
I believe this is what I saw. Is it possible for it to have detected the curb coming up and that I was going fast? Does the Canadian F-Sport 3 package even have a PCS? I don't see anything about a PCS when I look at what's included in the package, but I know that it does have the radar cruise control/rear cross-traffic alerts so it doesn't seem out of the question that it could detect the curb.
I installed a rear camera on my truck and when I tested it the picture is upside down. I tried taking the camera apart and flipping it, but to no avail. Only problem with flipping it over is the plastic housing will only let you rotate it down so much. I basically took some pliers and pealed the plastic down so I could get a better view. This is the camera I bought. License Mount Color CCD Rear View Backup Camera Tag
View 12 RepliesYesterday I bought my first mk5 CW R32 2008. It has 51000 km and it is practically new.It has the dsg gearbox.
Now after watching lots of video on youtube, I noticed that mine do not show on the bottom right of the dashboard the selected gear like other do.
Is this an option that i should enable or what?
Town and all shops nearby have a week wait to get the truck in there. This happened once or twice a year ago but I'd pull over, shut it off and when I restarted it everything was fine. I'll be driving and all of a sudden the information display on the cluster will show a wrench signaling something's wrong(see image), then the speedometer will go to 0 and all information in center display will show flat lines. This started up yesterday but is now doing it after about 10min of driving every time I being driving. What's worse is the truck will randomly start shifting or shift extremely hard even when driving at a consistent speed. This was taken while truck was going about 45, but shows 0...
View 5 RepliesThis has going on for a few months now off and on. Whenever drive my F hard I notice this metallic click when i go to shift hard into second. The metallic click seems to be coming from the front of the car. I also get it if I'm around 3600rpm in and stomp on the pedal in first or second. It also happens when I shift into reverse. What it could be??
It also happens when i floor it and let off and do not change gears mainly in first and second. Sometimes i get a double click also.
At first I thought something could have gotten trapped in the engine bay and it only accelerated to a high enough speed to cause an audible noise but seeing as it been 3 or 4 months I don't think its the problem. It does not seem to effect spend and it does not make the click all the time.
Uploading a custom pic to the main start up screen yet? Tech told me that the picture file has to be in a specific folder so that the computer can recognize and pick it up somehow.
View 7 RepliesHow to get the Pandora album picture to show up when it is on split screen with the map? it only shows the album picture if I'm in the Pandora app, but when I split screen it w/ the map I only get the album info, no pic...
View 3 Replies