I just noticed that my black brake calipers look dull. I used my finger to check it and behold, the shine is back. Is there anyway i can clean the brake calipers without removing the wheels?
View 13 RepliesI have a 2010 F-150 Lariat and from the salted snow and slushy roads I have rust stains on the wheels. It is not severe and I dont think the wheels are steel but I would like to remove the rust stains without damaging the wheels.
View 7 RepliesWe had approximately 7000 miles on our 2014 250 when we first heard our squeaking when we applied the brakes. This happened after we had been driving a while. Took it to the dealer to see what was causing the noise. They found out it was the front brakes. They removed both front wheels to find the inner pads wearing at an angle and the caliper piston boots partly melted in middle. They ended up replacing the brake pads and calipers with new and machined rotors.
View 14 RepliesI recently purchased an '08 F-350 4x4 Lariet Supercab 6.4l and was told by the 3rd party inspection that it needs rear brake pads (2mm left). Are the caliper pistons retractable without having the pistons seize down the road? HOw about the fronts? See below.
I ask as on my '06 F-250 XLT 4x2 5.4l the rear calipers seized without even doing a pad change and the fronts seized about 100 miles after a pad change. Come to find out it is a common problem with the '06 and the calipers either have to be replaced or rebuilt when changing pads. Now I've been "told" to expect the same with the '08.
Thought I would share. Been working on the T-reg all day long. I will likely finish tommorow and will post final pics then.
http://forums.clubtouareg.com/...=1550
Modified by PJF at 1:37 AM 4-1-2007
The brake dust on my front rims seems next to impossible to remove. Truck is a 10 F150 4x4 Lariat. What are people using to remove this? I expect to get in and scrub, but don't want to damage the rims as well.
View 14 Replies2006 Sonata with 3.3L V6. How to remove the MAF sensor on this engine? I see it right between the air cleaner and the throttle body input but can't get the electrical connector off for one thing. I bought some MAF cleaner (don't use carb cleaner) and did this on my other car (a Saab) and I cleaned the throttle body butterfly valve at he same time (with Valvoline carb and Throttle Body cleaner spray). It really needed it. I use a lightly oiled K&N filter on the Sonata and I hear it's even more important to clean the MAF sensor it under these conditions. You just blast it with the spray and reinstall.
View 9 RepliesI have a 2010 F-150 Lariat 4X4 and the front wheels get brake dust and rust staining on them. What is the best wheel cleaner to use to get rid of this? I thought about muratic acid but am afraid of damaging the finish on the wheels.
View 7 RepliesI have an 2011 Ecoboost SCAB and the front brake dust is ruining my chrome package wheels. The rears are fine. Ceramic or low dust pads??
View 14 RepliesHow do you remove the center cap on the wheels on the 337? I do not want to damage them.
View 16 RepliesThe left driver's side wheel is "stuck." The car is up on the jack, the lug nuts are all off, but the wheel will not come off.
View 15 RepliesSince I have this car i noticed that the brake calipers (especially the front) are very noisy. This problem is caused by caliper's floating guides that become loose and the entire brake caliper shakes. I asked at a kia mechanic who answered to me to change the calipers support. For my trusted mechanic is useless because, according to him, this type of support have this problem (he tell me that also others car have this problem like older nissan micra) and sooner or later would return noisy.
Some time ago with greasing the floating guides i temporary solved but drying up over time the problem come back.
Fairly recently acquired 1992 525i, 101,000 miles. Love the car and driving feel, don't mind putting the effort in but do not know where to start. She needed some work including both upper and lower control arm bushings. Replaced those over the last couple of weekends. This week the front brake calipers are locking up adding significant drag to the car, overheating the front brakes, smells and feels hot. Rear brakes appear to be fine. Seller had replaced brakes within the last 5,000 miles. I thought maybe he did not 'grease' the caliper guide pins and components, so I tried that and all was well for a few miles then back to the same locking brake calipers.
Is this brake caliper, brake cylinder, master cylinder or ABS related? Do I need to bleed the system? I cannot not imagine how but could replacing any of the front suspension components have had anything to do with this? I read on one thread about an interconnection (power assist) provided by the power steering pump and that 'over filling' the PS reservoir could cause such a problem. I did add fluid to the reservoir recently but the level is between the marks on the cap dip stick.
If caliper, or cylinder related is this DYI? How about the ABS? I have been looking for some good links to address this problem and repair procedures but no luck as yet.
I have two 2002 ford Excursions, both with 7.3, one 2WD and one 4WD. I have replaced ALL brake calipers with lifetime warranty Napa semi-calipers. It is sometimes an intermittent problem, I might have smoking brakes on one wheel (mostly the rears) one day and it will work fine for weeks or months and then do it again. It seems that about 1X per year I end up having to replace the calipers as they seize up and cause the brakes to smoke and cooks the caliper piston boot to a crisp.
I use high temp brake caliper grease (not sure if it is silicone based) and bleed the brake system about 1X per year because I thought the brake fluid was absorbing too much moisture. The slide pins come pre-greased, but I always check and re-grease them. Could I be putting too much grease onto the slide pins, Hydrolock?
I live in high humidity, in the middle of a rain forest near (about 5 miles away) a live volcano, Kilauea, on the island of Hawaii. Our area is very wet and we have acid raid and acid air (H2SO4 volcanic smog in the air) which corrodes everything, corroded pistons getting stuck?
I have not tried other brands of calipers because I cannot afford to keep buying new brands, I just trade in the toasted calipers at Napa for no charge. I have replaced all the rubber brake hoses and i upgraded to DOT4 (not silicone based) blue racing brake fluid that has a very high wet and dry boiling point. I am thinking of investing in stainless steel calipers, but those are pricey.
After coming to a complete stop & starts driving again, I notice that the brakes squeaks a few turns & then stops. It seems that the brake calipers does not fully disengage from the rotors.
2006 Touareg V6 Silver
I've replaced the front brakes twice now on my 2004 2.4L Manual Santa Fe.
Each time the dealership has commented on some excessive rusting of the calipers, and this last time around one had actually seized and they had to cut it off.
When I got brand new ones put on I noticed they were nice an shiny silver. Within 3 weeks there were full rusted...and still are. I don't get it??
2004 Santa Fe .... Is it possible something is dripping from somewhere that is caused this premature rusting?
I was cleaning my brake calipers and noticed that neither of my calipers have pad wear sensor connected to pads.
My 2012 GTi had sensor on the inner pad, but I cannot find one installed on my MKVii GTI. Looking for a photo of the caliper and the location of the sensor?
Tons of information on this and its possible. What? I'm still learning the search feature.
View 1 RepliesGen III 2010, 6800 miles. Silver. Fuzzy dice. Pads are still rattling in the calipers when I hit bump when foot is not on brake. It sounds like hell! ...like major suspension components are loose, although I know they are not. Two Toyota dealers have told me this is normal, and no danger. ...no dealer fix.
View 7 RepliesI have a 99 150 4 wheel drive..5.4 ..auto...110.000 mile.....notice when driving in town in hot weather....when you are on and off the brake petal a lot....stop and go..etc.....the truck starts to hop or bounce....some....I got out ..and notice the right or passenger side front brake seems a lot hotter than the drivers side......but ...when it does that....the steering wheel doesn't pull to one side...when changing pads before ..notice no one side worse for ware than other...thinking it must be sticking brake calipers....they don't do this say on interstate driving even when on and off the petal some...
View 1 RepliesFront caliper replacements--fwd? Person I bought this from said they'd just relined the brakes before I got it. After having it a week, I randomly checked torgue on lug nuts...a whopping 80 ft lbs. So now I have the vibrating rotors. When I back up I hear scraping like a bad set of bicycle brakes against an out of round rim. The pads are pretty thick. I bought new rotors and pads but I wonder if I shouldn't get calipers as well. This X likes to bite me in the butt--something simple is always about 5 times more complicated than anticipated.
View 1 Replies