IS F (2008-2014) :: Aeroworks CF Splitter Installation - How To Remove The Bumper
Sep 21, 2014
Finally got the Aeroworks CF splitters and spent some time to install it. Took me about 3 hours but I also took the time to put on some adhesive velcro for protection. And re-sealed one of my headlights
First I took off the bumpers. follow this guide
How to remove the bumper from a Lexus IS250 / IS350 to install Lite-Eyes CCFL Halos / Angel Eyes - YouTube
Then the rest is easy. Make sure to clamp or put a bucket under the washer fluid hose if you have the headlight cleaner option. Fitment of these splitters are almost 100%. right side was perfect, left side has a slight gap but its like 1mm ... very small.
Just line it up, and drill 3 holes on the bottom and 1 on the side. The splitters came with screws and some fasteners. Easy to install. I put some 3M adhesive tape as well just in case . I stuck some Heavy Duty industrial velcro strips on the underside in case i rub.
View 14 Replies
I recently purchased a Rear Bumper Protector for 2010-2014 Toyota Prius for my 2014 PIP. I thought I had it in the correct position when I removed the adhesive strips to install it but realized the next day that the curvature is not lined up properly causing a gap in between the bumper and the protector. My stomach sank when I realized this error.
View 8 Replies
Looking to have it installed? I bought it but I haven't installed it yet...
View 2 Replies
I need to remove the bumper to replace the reflectors for some lead breaking lights, so I'll also need to find the rear break lights cables to jump this leds.
View 14 Replies
I will be installing a Euro-type of hitch to my car and for that the rear bumper needs to be removed.
View 8 Replies
Do I need to remove the rear bumper to replace the rear bumper reflector?
View 8 Replies
Installing some fog light HID's and was wondering how to remove the front bumper.
View 7 Replies
I have took off the screws in below pictures. But the bumper seems still stick on the car body. Any screws are missing? Or other issue?
View 4 Replies
As owner of the Phaeton diesel v6, 3.0D... I need to remove the bumper in order to have full access to the headlight unit.
View 4 Replies
The red ones that are in the rear bumper, Do I have to take off the whole bumper?
View 22 Replies
How to twist or pull the factory connector stored in the rear bumper, for hitch install. I see a small gray clip somehow attached to the barrel connector, but it doesn't seem to want to release.
View 4 Replies
I was hoping there were instructions on how to remove the 2010 RX350 front bumper cover somewhere? We had a little fender-bender, and I was planning on trying to replace some of the items myself. I'm handy, but always prefer instructions over trial/error!
View 6 Replies
I have a newbie question on how to remove the rear bumper? Do I disconnect the sensors first or remove the bumper and disconnect the sensors.
I read this thread : [URL] .....
But was not sure which bolt to remove? Is it all 4 on each side or 2 toward the rear of the bumper?
View 10 Replies
I am installing a set on a '12 F350 for a customer. I already had to go buy an additional hardware in order to get the back bumper on correctly...and now I'm looking at the front bumper and I swear I don't have the parts I need to install it. It appears to be missing some brackets. There were NO instructions with them (apparently a chronic problem with Road Armor) and I can't possibly imagine it bolting to the flimsy brackets that hold the factory bumper (fairing would be a better word for it) in place.
View 6 Replies
I have a 2012 Camry and was wondering how to remove the rear bumper cover? Someone backed into me so I have a shallow dent I want to pop out of the plastic.
View 6 Replies
So i've been searching for ways to remove the bumper/door chrome trim to change to black but cannot find anything about the b5 or 5.5. What i'm trying to do is get the chrome to black but cannot figure out a safe way to remove them to either wrap in black vinyl, paint or just replace with black strips. I'm not trying to completely remove them just get the chrome to black. Its an 03
View 10 Replies
So I'm trying to remove the rear bumper cover on a '15, but it has been a royal pain. I went in thinking that the procedure would be similar to what it is on the '14, but it is way more involved. The biggest issue I'm having is removing the large plastic triangular side bracket. It has these weird T-nuts fastened to the body, which you cant remove, and the whole thing looks like it would need to slide upwards to get it off, but you wouldn't have enough room because the shape of the body just gets in the way.
View 1 Replies
How are you going to remove the chrome strip on the rear bumper. Mine got damaged and I need to replace them with a new one.
View 5 Replies
I have a '12 Elantra Limited and I'm planning to smoke the rear bumper reflectors. How to remove them?
View 20 Replies
How is the red marker light lens, located on either side of the rear bumper, removed to allow the bulb on the inside to be replaced?
View 2 Replies
Thinking about getting a used Camry. Is there any issues with any of the years in the seventh generation Camry? What are some of your likes and dislikes of your car? For example I have been told that on the sixth generation Camry you have to remove the bumper to change the turn signal bulb. I have never had to deal with this, just what I have been told.
View 14 Replies
