Hyundai - Accent :: CEL On / Stalling And RPMs Would Not Go Over About 2k
Jun 23, 2014
About 5 weeks ago my 2008 Hyundai accent's check engine light came on. It came on right after I filled up a tank of gas and started running a bit rough. About a year ago the same thing happened, and it turned out to have been because of some bad gas (I ran the tank down, refilled and everything went back to normal). I assumed that was the same thing this time because the gas was from the same location and the problems started right after the fill-up.
I drove it for about a week and then it stalled out completely. Rpm wouldn't go over about 2,000 and if I tried to drive I wouldn't go over about 10mph. I took it into the local shop. Replaced all kinds of fuel sensors, spark plug coils, and the main computer, and I think the fuel pump (all of which got fried). The error codes are all fixed and the car idles just fine. Only problem, when you put it in gear to drive it almost immediately bogs down, rpm stays below 2k (still) and eventually it will totally stall out.
The shop is now saying they think it's the catalytic converter - but they aren't sure. The car idles smoothly now, no error codes. But as soon as you try to drive it barely moves. It feels like there's a governor on the engine or like there's not enough fuel getting through. What to try next.
View 15 Replies
Advertisement
I have a 2004 Hyundai Santa Fe with about 83,000 miles. Lately it has been having issue with the rpm's going low and stalling out while I'm driving. I've taken it to a mechanic and it has not been resolved. He said it does not need a tune up and it's nothing with my fuel. I've also heard it could be a crank shaft censor but he says no. The check engine light has come on sometimes, very quickly but then goes off.. He ran the code but nothing came up. So then what's causing my car to do this?? While the car is running and I'm in park, the rpm's will go from 2 to almost 0 then back up again. While I'm driving down the road it does the same thing and sometimes it completely stalls out while I'm going about 40mph. So incredibly scary. What this could be so I can take it back and get it fixed!!!! I'm so scared to drive it but I have to get to work.
View 3 Replies
2008 Hyundai Account 4door78,721 Miles. I've only had it for a year. Taken it to dealership they performed diagnostic test, no codes. When its cold my car shuts off while driving and is difficult to remain on after starting it. When temperature is about 70 degrees car runs fine. I have tried new battery...didn't work. I have replaced spark plugs.....didn't work.
View 11 Replies
Over the last several weeks my car (2010 Hyundai Accent, 60k miles) started randomly stalling on me. I took it to my mechanic earlier this week and all 4 ignition coils were replaced. Yesterday I accidentally left my headlights on for about 2.5 hours and the car was completely dead. I got it jumped and drove it around for about 35 minutes. I had the battery tested at Autozone and they said it is good. Then last night it stalled in the McDonald's line - I was able to restart it and get home but this morning it is completely dead again. Also twice yesterday after starting up the car the rpm dial wasn't moving at all. The car was accelerating just fine but the rpm dial did not reflect this. Of the several times I drove it yesterday it only did this twice. Someone told me to bring the battery to Autozone to get it fully charged, but does that explain the rpm dial not moving?
View 4 Replies
Three months ago I acquired a car from my brother. It was a 2001 hyundia accent gsi. The car had sat unused for 10 months and because of this I had to put some work into it. It has a new battery, new starter and new engine belts because one snapped upon start up the first times. I have also had the oil changed.
For some reason it is reving really high. At about 100km/hr it revs at about 4000rpm. I have talked to my brother and he said it did not do this before. It is changing gears because I can hear it and watch the rpm's drop before going back up. In 3rd gear at 60 km/hr it revs at about 2100 rpm's.
View 6 Replies
At the beginning December I put my brand new winter tires (general altimax arctics) on the factory steelies and put them on the car gearing up for the snow. Not to long after the install I notice that I was getting a very strong engine vibration starting at 3,000 rpms and it stopped around 3,100 rpms no matter what gear I was in. At first I though it maybe just the cold affecting the engine. Well...
Last week I put my summer rims and tires back on for the 1,600 mile trip to MO and back, and like magic, no more heavy vibrations. Smooth acceleration throughout the normal driving rpm range. I just changed the oil and tranny fluids Tuesday after we got back and with the warmer weather the car is running smooth as silk. Still an awesome car with awesome mileage and couldn't be happier.
View 7 Replies
Weeks ago, I was waiting for someone with my car idling and suddenly it just stalled. The battery power was still on but the engine died. When I restart it, it starts up but then dies after a few seconds. After trying 3-4 times it no longer starts. I had it towed to the repair shop and by the time they went to look at it, it started up just fine. A few days later I was driving (like 1 min from my house) and the car engine died, again the battery was still working. Power steering was gone. I coasted off the road and tried to start it--again it would start up and then die and then after a few tries it no longer starts. I had it brought to the repair shop. Again, it started fine for them but they changed out the battery just to see. I also had fuel cleaner put in the gas tank.
Just to be safe, I brought it to a dealer since my normal mechanic couldn't find anything. At the dealership they ran codes and didn't find any. They said that sometime the lines to the cams or crank get corroded but that mine looked fine. Since it wasn't doing it for them, they didn't have any other recommendations. Everything has been fine for the last few weeks and then I went to start my car last night. It started fine even though it's really cold and hasn't been driven in a few days. While I was scraping the car, I could hear the engine turn off. When I re-started it the same pattern happened--restarted the first few times and then died and then wouldn't even start. I don't even know what to do at this point since it only seems to happen close or at home and not for repair places.
View 3 Replies
2011 Elantra with phantom harsh shifting problem. Yesterday the Elantra began surging and nearly stalling out on acceleration after about 20-25 minutes driving. I was barely able to drive the car home; when pulling into the garage, there was a strong smell of something hot. Temperature gauge indicated normal engine temp; no icons lit on the dash indicating a problem. Surging/nearly stalling and overheating problem and is it related to other Elantra engine, trans, fuel system-related problems? I can’t find anything specific while web surfing today for some clues!
View 12 Replies
My voyager stalls when rpms are low--turns, backing up, stop signs etc.., RUNS FINE WHILE COLD!!!!!
Replaced fuel filter, iac, whats next!??? nothing shows up on computer - no error codes etc etc....
View 1 Replies
I have a 2001 vw jetta 2.0l manual. When the car is running the rpms jump up and Down from about 300 rpm to 900 rpm and I guess that's why the car will stall out every time I press the clutch to stop. Also the car won't run with the MAF plugged in. If the MAF is plugged in it will drive but will not idle the car will just stall.
View 16 Replies
My 2002 Mazda MPV will stall everytime after the rpms go over 2,000 and I let off the gas. I can put it in neutral and it will start back up. Not sure if something is clogged or its electrical? It has 177,000
View 6 Replies
So here's the deal, I bought this 93 Volvo 940 turbo station wagon about a month ago. It was stalling when I got it so I replaced the rotted hoses, fuel filter and cleaned the fuel system. The fuel pump was replaced a little before I got it. 2000 miles later it is stalling again at any speed mostly when the rpms go up and on hills. We are trying to replace the map sensor but can not find it anywhere under the hood. Does this car even have a map sensor and if so where is it located... We are also trying to clean the throttle sensor but cant seem to get it out without taking a bunch of other pieces apart, is there a trick to this. Is there anything else it could be...
View 4 Replies
I have a 2006 Hyundai Sonata that in winter does very strange things, almost ghostly. While driving, headlights flicker on and off, the dash abs and esc warning lights go on, and rpm's shoot up and stay there as if it downshifted by itself. I have to pull off the road and turn the car off.
Further, three different times I shut the car off and then nothing would work, including not being able to start the car. After it sits a while it then seems to reprogram itself and works properly.
I contacted Hyundai, and they only said bring it in and pay to diagnose it. But there appears to be no fix, as many have reported electrical problems for this model on the internet.
View 3 Replies
So I have a 2005 Hyundai Elantra, it is a manual transmission. I was having problems with the rpm's going higher than normal at random times while driving, then I noticed that the fluid in the clutch fluid reservoir was low. I determined that to be caused by a bad clutch slave cylinder that was leaking fluid. So I replaced the slave cylinder and that seemed to fix the problem, but now I am noticing that the car lacks power when I'm going up any sort of hill or trying to accelerate faster than normal.
When going up a hill the rpm's will go up and I have a hard time maintaining my speed. When trying to accelerate fast, as in pulling out in front of someone or similar situations, the car seems sluggish and it seems like I need to shift because the rpm's are high but I'm not going fast enough yet for the next gear.
This sounds like it would be some sort of problem-related to the clutch going bad or could the leaking slave cylinder have damaged the clutch. Or does this sound like more of a different problem, maybe something with a fuel filter or something?
View 16 Replies
I have a 2005 Hyundai Elantra. I recently have been having issues with the transmission. When I'm in fourth gear, I will sometimes feel a sudden jolt, and then the rpms will go up, and the engine will seem to be working harder and be noisier. When I then come to a stop and then try to accelerate again, the acceleration is very slow, as if the car is still in a high gear. When I turn the car off and then on, the car accelerates fine again. Since then, I have put the car into overdrive off, and haven't had any problems. If the problem is in the fourth gear, could I just use overdrive off consistently and not fix the problem? Could that somehow cause more damage or be bad for the engine? I put about 50 highway miles on the car each day. But I only plan on doing so for the next ten months or so, then I will generally only be using it for short trips around the neighborhood.
View 3 Replies
2001 hyundai elantra. Car is almost stalling randomly at stop lights. Low rpms under 500 and stops. Sometimes drops to 100 rpms then shoots up to 500 right before it might stall. Engine light came up got misfire on cylinder 2 and 4 with codes p0440 and u0d00.
View 5 Replies
I have a pretty bad flex pipe leak on my 20th. Would this leak cause a very rough idle almost stalling when I come to a complete stop. The Idle fluctuates from almost stalling to 1000rpms.
View 1 Replies
My families 2001 Nissan sentra often stalls at stoplights, has low power sometimes in the low rpm's and sometimes (though not always) chugs/jolts a bit at low rpms and has trouble "overcoming" that window and getting more power. If I give it more gas the engine seems to get "normal" at around 2500 or 3000 rpm's and then is fine.
We took it in and the mechanic said it was a bad O2 sensor or MAF sensor... can't remember which. We tried replacing the MAF sensor but it still has the problem. We have heard that we may need the computer re-set somehow or made to recognize and sync up with the new part. As we call around this is very expensive just to make a part that is already installed work. Is this necessary? What's the next, cheapest, step.
View 3 Replies
2006 Hyundai Elantra. RPM's go flying everytime it's fired up. RPM's will drop once it's put into gear, reverse or drive and runs just fine afterwards. If it's not affecting how it drives should we just let it be? Is there anything to be concerned about?
View 2 Replies
,I have a 2004 Hyundai Elantra (stick shift) with about 104k on it. Was running absolutely great till about a month ago when I noticed that it was beginning to accelerate quite slowly. If I pushed it and got the RPMs up really high it would still pick up, but still not great performance. Also after pushing it a little hard there was a faint burning or smoke smell. Note, once it is up to speed say 60 or 70 it has no trouble maintaining such speeds. It just takes a while getting up to them. And if I really need to step on it the RPMs sky rocket with no real immediate increase in speed.
View 5 Replies
1992 Buick Park Avenue - Base
This morning my serpentine belt tore and slapped everything for a few minutes and I'll be receiving a new one tomorrow or the day after, but that's not the trouble, I just feel it's related as that is when this problem started. In the last 2 months I have replaced the Cam sensor and interrupter, timing chain and tensioner were in good shape. replaced the ICM, coils, wires, and plugs and used dielectric grease on all connectors, including the cam sensor and new crank sensor, also replaced the harmonic balancer, fuel pump, filter, pressure regulator, PCV valve, alternator, and a new pigtail is coming for the cam sensor as some of the wires had bare spots. This plug is currently taped and shoved out of the way, not plugged in, and has been for a week, so I doubt it's relevant.
This issue is : The car fires up fine, but has great difficulty idling and stalls too often to drive after a few minutes. At higher RPMs it only misses or misfires occasionally. With the serpentine belt off, the car idles much smoother. Tonight I plan to try tightening the harmonic balancer again, running the with MAP sensor unplugged, again with the exhaust O2 sensor removed.
View 2 Replies
