Honda - Odyssey :: 2004 - Hard To Get Ignition Switch To Turn
May 30, 2012
I have recently been having problems getting the ignition switch to turn. There seems to be a negative correlation to warmer weather (the warmer the weather, the more likely I will have a negative experience --- and I will get the switch to turn only with some difficulty). When I have such a failure (in which the switch does not turn), I take the key out, wipe it off with my hand, flip it over and shove it back in. Sometimes this works with one try. Sometimes it takes multiple tries. My fear, of course, is that one of these times it will never work, and I will be stranded. I should add that I do have another key, and that I have had the same experience with this key. I don't really want to spend hundreds of dollars on a new ignition switch... and I especially don't if that is really not the problem.
View 2 Replies
Advertisement
I own a 1997 Honda Odyssey-a couple of weeks ago when I turned the key it wouldn't start....no noise,no clicking however the battery was working. I called Road service for a tow home and while waiting,I kept putting in the key.After 20 min.the car started and I drove home. Since then it's gotten worse. It's a gamble to go any where, never knowing if it will start or not. My husband replaced the ignition switch-that didn't work and now says he'll replace the starter ( if that doesn't work he plans on replacing the entire ignition cylinder). My alarm system hooks into the ignition...
View 4 Replies
My 2002 Honda Odyssey makes a squealing noise when I make a hard left turn. Could it be related to power steering? Is it an urgent problem? I will take a trip next week (~650 miles each way), and need to know if I should address this first.
View 3 Replies
I put my LS 430 key in my RX330 yesterday, I realized as soon as the ignition would not turn. I put the RX key in, and ignition will not turn. I'm assuming that the pins may be locked so I tried a few options.
- I wiggled the key.
- I lubricated the lock.
- I tried rocking the car while trying to turn the ignition.
- I tapped the ignition lightly with a screw driver and hammer, but no luck.
- I turn the steering wheel while turning ignition to make sure its not locked.
I really don't want to get the car towed to the stealer/dealer.
View 8 Replies
I accidentally put the key from my 2008 Honda Odyssey into the ignition of my 2004 Honda Odyssey, and now the key won't come out! How to get the key out? I tried jiggling the steering wheel, jiggling the key, disabling the battery, unlocking the gear shift and putting the car in and out of park, but nothing even remotely loosens the key.
View 2 Replies
'04 RX330: Starting about a year ago, occasionally when inserting the ignition key it wouldn't turn to start. Take key out try again and it would start. Progressively, it seems to be requiring more and more in/out cycles to get the key to turn. It's like the transponder is not recognizing the key FOB. I have two keys, one is a master and other is a sub key, both have the problem. What has to be done to correct it? I'm afraid the dealer will just change some expensive ignition part when there's an easier fix.
View 14 Replies
I just purchased a used 2012 Honda Odyssey with 88k miles. After not driving it for two days I went out and tried to start it. The powered side doors were working just fine, and all the gauges and indicators seemed to be fine and the power locks worked, but it did not start. There was no noise at all. It was as if the car didn't realize I had turned the ignition. I tried a few times, waited for a few seconds, tried again, and the car started like there had never been a problem. When it started, it wasn't weak. It started like new. The problem sounds a lot like mine [URL] .... except that it then started for me. We have been driving the car for less than a week, and as mentioned, I didn't drive it at all for two days, but it has had no problem starting any other time.
View 6 Replies
I'm trying to get friend's 04 F150 4x4 started. I think it might be the ignition switch. Here's what I've done. Turn the Key and nothing happens. Not even a clicking sound from the battery.
-verified the battery had a good charge and that terminals were clean, connections were tight.
-checked the fuses in the passenger side kick panel, none were blown
-Determined there was power to the primary Pos wire going to the starter , but no power being sent to the smaller wire that goes to solenoid at the starter.
-Hooked a jumper wire to the starter solenoid and engine did crank (so starter is good and battery is making good connection)
This is why I'm thinking its the ignition switch.
1) Where is the ignition switch located?
2)How can I test the ignition switch?
3)Could it be the "cylinder lock and keys" that is faulty?
View 5 Replies
Have an 04 ford f-150. igntion getting hard to turn of. not all of the time but still has its moments. thinking of using some graphite to lube it up.
View 2 Replies
I have a 2007 Odyssey. Honda already recalled it once for brake issues. It has 44000 miles and we already changed brake pads once. Now again beakes are filling soft and have to press hard. what should I do?
View 3 Replies
Key Hard To Get In ignition switch, What Lub Should I Use?
View 2 Replies
When the weather gets to below freezing and I start my van in the morning the brake pedal will not push down no matter how hard I push. The first time this happened I was moving and had no brakes for seconds. Luckily no one was in front of me. If I warm the van up just a couple of minutes I can feel it release and then the brakes are fine. I've taken it to the Honda dealer twice and also an independent mechanic and no one can find anything wrong with my brakes. I know I can wait until the van warms up but should this situation be happening? I never experience this in my Caravan or any other vehicle.
View 6 Replies
I have a 2006 Odyssey, 120,000 miles that has really been trouble free. Last year, while on vacation, the alternator went out, and it was replaced. Since that time, maybe a coincidence, I have had episodes where when I turn the key to start up, there is no response. The dash lights come on, but the engine does not even act like it wants to start. I turn the key a few more times, then the engine starts without a hesitation. This went on a few times before I took it in to the dealer. Of course, it did not have a problem starting there, so they checked the battery, and the battery cables. For the past year this has gone on very sporadically. It may go a month between episodes, or it may happen 3-4 times in a week, or even a day. Every time though, it will eventually start. Over the past year we have eventually replaced the battery, and one time we thought the problem was solved when the starter went out. However, the problem continues.
View 1 Replies
Had to replace the ignition switch. after I went to crank it after switching it out, there was a buzzing around the relay control module. Thought that maybe somehow the ignition tripped something in it so bought a new one. IT is still buzzing and car won't turn over. everything lights up on dash. tried to see if there were any codes and the scanner just reads "fail".
View 5 Replies
I was having all the tell tale signs of the almighty ignition switch. No lights, wipers, heater fan. But I didn't have time to change it. The other day went to start it and nothing. I changed the switch I have headlights wipers blower fan now which is sweet. But the car still wont turn over.
View 2 Replies
When I put my key in the ignition, I cannot turn the key. I tried putting a small amount of WD40 in the ignition and turning the wheel back and forth while trying to start, but all that did was make my key greasy and my wheel lock up. I've tried getting a new key made from Lowes and Home Depot, but their keys are too wide and will not fit in the keyholes. The only thing I am down to is replacing the ignition switch completely but I'd rather do that as a last resort because my car has had a big problem every week (alternator gone, new wheels, new master cylinder, new rotors/brakes). I haven't explored yet? And also, if it comes down to replacing the ignition switch, how would I do that without being able to turn the key?
View 2 Replies
I have a problem with turning my key. It will not turn at all. I have taken the upper and lower part of the cover off to expose the switch and removed one screw from the ignition housing, but the internal part of the ignition switch will not come out. How do I completely remove this ignition switch. I have already removed the negative battery cable. It seems this is a continual problem with focuses. Oh, do I need a releasing tool to release the ignition switch.
View 7 Replies
I have a 2000 Staturn LW2 auto, 6cyl. When I try to turn on the car, sometimes the engine does not turn, doesn't make a sound, nothing. When I move the steering wheel, it turns on fine, it has to be in a certain position. Does that mean, the ignition switch is faulty or is it the pin? Is there a test I can do?
View 7 Replies
I am having a little issue with the ignition in my car. I had the typical no headlights/wipers/heater etc. so I ordered up a new ignition switch and when I went to replace it, the switch fit perfectly and had the correct part number but when I put my key in to try and start the car I couldn't even turn the key but when I put the old switch back in it would turn just fine. Also when I removed the old switch I noticed the red wire going to the switch was slightly burnt right at the terminal.
Here is the basic procedure I did:
-Unhook negative battery cable
-remove lower dash/ center console
-remove switch
-install new switch
Whats this little metal piece? I did not see that when I did mine...
View 10 Replies
I'm having a problem with my ignition switch. It won't turn and I have to turn the steering wheel for it to finally work.
View 4 Replies
My 3.0 L Honda Accord won't start the way it should. I've included a video of the situation. I need to figure out what I need to replace. [URL] ....
View 4 Replies
