I have a 1991 Accord that won't turn on the high beams. I can pull the dimmer switch and it clicks and the dash indicator comes on for the high beams but it just keeps the low beams on. I am guessing the dimmer relay isn't working properly but am not sure how to test it. Also where would I buy one? I have checked a couple sites and even a search doesn't bring it up.
View 2 RepliesSeveral months ago some kind of sensor was replaced on my 1991 Honda Accord. This was the case where the fan would sometimes go on after the engine was turned off. And to turn off the fan it was sometimes necessary to turn on the ignition.
What led up to all this was that one time I was driving up a fairly steep incline to a park. When I turned the engine off that is when the fan turned itself on.
Well, I drove up to that park the other day and the same thing happened (after the whatever was replaced). One thing different though, I did detect a faint whiff of what smelled like burning rubber when I exited the car (to check on the fan).
I have a 96' honda accord LX and I have no low beams. Set on low beams I have no lights. Set on high beams sometime it switches to low beams, then 3 or 4 minute pass and it stays on high beams for the duration of the car ride till I turn the car off.
I have replaced the dimmer relay and the turn signal switch. What's wrong with it? A guy at auto zone it could be one of my body control modulators, is this it?
I have a 91 accord I just was leaving to go to the store. I took off like normal when I was putting it in 2nd gear it locked up on me. Now if I leave it in neutral and let off the clutch it will move forward. If I try and put it in any gear it locks up. Is my trans shot or is it something else. I have been hearing clicking sound when I make a right turn. Just bought the car and it's my first Honda I just don't know what to look at first.
View 2 RepliesI do not know how to remove the front right headlight on my 1991 Honda Accord.
View 4 RepliesHave a 91 Honda Accord (automatic) with seems to be an electrical problem.After driving a while the Tac, Speedometer stop working and the radio cuts in and out. The car still runs, just a little rougher; when I turn it off it won't start, acts like the battery is dead. After it sits overnight it starts and then runs fine for a while or until it happens all over again.
View 2 RepliesMy '91 Accord is going strong -- bought it new in '91. A few years ago I removed the AC compressor after it failed and did not want to incur the cost to replace it. As a result the defroster does not work optimally. How to improve the defrosting without being able to run the AC?
View 8 RepliesI drive a 1991 Honda Accord. A few months ago I began to notice that the engine compartment would squeal when I started it on occasion. I went under the hood and determined that both the alternator and steering pump belts could do to be tightened and did just that. That solved the problem.
A few weeks later they begin to squeal again. I apply some belt conditioner and it usually goes away for that particular trip, but the squeal will come back upon the next time I start the car.
I can't tell which belt the squeal is coming from, as they are practically right on top of one another.
Over the past month or so, the squeal has gotten progressively worse. It will squeal at startup until I begin to reach approx 2k RPMs. If I go to idle during driving, it will (maybe 40% of the time) drop down to below 500 RPMs and squeal, and on even fewer occasions the car will sputter and stall out (MAYBE once per day).
The belts appear to have little give now, but I didn't want to OVER tighten them. They also show no apparent signs of wear or glazing. With the winter weather coming, I'm attempting to resolve this as quickly (and cheaply) as possible, so that I'm not banging around under the hood wearing a parka.
1991 Honda Auto trans, 247k miles. We now have the third transmission in the car and it still does not shift into over-drive-4th. Odds seem poor that all 3 were actually bad.What now?
View 9 RepliesI started my car a few weeks ago, and the check engine light came on and the S light on my dash kept blinking. Followed by a difficulty stepping on the gas pedal. I attempted the paperclip way of scanning my OBD1 scanner. When I used it, the check engine light went off, no S light blinking anymore, and the gas pedal worked great! I also changed out my VSS (vehicle speed sensor) but the light came on anyway, and my speedometer can't read at correct speeds. Could the engine light problem be because of misfiring due to spark plugs? I don't want to keep buying parts and stuff unless I'm 100% sure it will fix the issue.
View 10 RepliesWe have a newly acquired Honda wagon, 16 valve, PGM FI, auto trans, that revs while idling. It sometimes does it when cold buy also hot. It increases it's idle to 1500 and drops revs to 1100 about every 6 seconds. Normal idle seems high at 110.
View 3 RepliesI have a 1991 Honda Accord with 280k miles on it.
Question: what would be reasons the engine dies when in operation? I had not noticed anything wrong with the car other than I noticed it may take the automatic transmission a little longer time to shift gears.
While I was on the road, i felt something happening under the hood and noticed the car was losing power. the battery and oil level lights went on and needed to pull the car to the side of the road for obvious reason!
The car was towed back to my house. During the ride back the guy who was towing the car said that the engine turned over when he turned on the ignition.
I did the same thing when I got home and the car started up just fine. Nothing else noticed. The oil level was at normal level. I drove the car a couple times around the block.
The engine is due for a tune up and there sometimes is some vibration. This car has been very reliable. But I obviously can not have situation where the engine dies when on the road!
My son's 1991 Honda Accord was running real rough. The temperature gauge did not budge from cold. I changed out the thermostat. When I tried to start it it started great then coughed and shuddered and then died. It keeps starting and then dying. I took off the IAC and flushed it with mass air flow cleaner. The screen over one of the ports was all crudded up. It cleaned up OK. However then I put it back it improved for a minute and then died again. I have checked for vacuum leaks but found none.
View 8 RepliesI have a 1991 Accord LX wagon that is leaking coolant. I figured it out b/c there is a green fluid pooled on the floor behind the passenger's seat. Why would coolant be leaking there? I bought this car in February and have been nickeled and dimed ever since. I want to sell it and get something else but I want to get the coolant problem fixed first and need to know if this is going to be expensive.
View 5 RepliesI have a BMP 20th and I notice that I cannot turn on my high beams but I can flash them. What the problem could be? I was planning on installing my OEM HIDs tonight but now I am wanting to get this fixed before I put them in.
View 2 RepliesI used to think when I flash it'll turn on the high beam only but that's wrong.
Today I changed the high bulbs 9005 to a brighter pair trying to get a better DRLs, but when I tested the high beam by flashing I realized it turns both low & high beams on at the same time.
I have HID for low beam so that's not a good thing for me to flash. And I think I did it only one time in the past but now I won't do it again. Is it normal?
Anytime I turn the headlights on, the high beams go on too; I cannot switch off the high beams unless I turn off the headlights entirely (I have been driving with the low beams on during the day for the 5 years I have had the car)
I can find no reason for this; I'm inspecting the fuses (with little expectation). The only thing I can think of is the control switch or wiring. I have standard headlamps, not hid.
99 Buick LeSabre ... I only have one low-beam working, the other low-beam bulb went out today ... When I switch to high-beams, the high-beams come on, but I cannot turn them off via the manual light on/off switch on the door panel ... The Twilight Sentinel works properly, and will shut off the high-beams per switch setting ... During the daytime, the high-beams will just stay on till I turn off the car, manual headlight switch won't turn them off ...
View 1 RepliesBasically, my high beams work when flashed (pulling the lever), but they don't work when I want to leave them on (push the lever). It's obvious that it's not the bulbs since they work when flashing. I'd really like to avoid taking it to the dealership since the Lexus dealerships in my area are notorious for overcharging their customers and not doing a good job.
View 7 RepliesI bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 RepliesThe turn signals and high beams do not work on my 1998 ford ranger xlt 4x4. I have replaced the multi function switch, the yellow flasher relay checked all fusses and all are good. What could be the problem?
View 7 Replies