Grand Prix :: SES Light On / Small Emissions Leak - Code P0442
Oct 8, 2006
About a month ago I had my SES light go on and I took it to the auto parts store and they said it was a small emissions leak. I am not sure of the code though. I took my car to the shop and they said that a sensor that had something to do with the exhaust was bad or unplugged.
My SES light came back on about about a week ago and I had it tested and it said the same thing. "Small emissions leak" This time I got the code and its P0442. The shop is closed today and tomarrow so what and where the sensor is located? Or if its the same thing?
View 7 Replies
Advertisement
This began as a troubleshooting exercise for a P0442 code (2002 model) indicating a leak in the evap emissions system. Often caused by simple things like a loose/poorly sealing filler cap. Not this time
It's a neat design, tucked away up in the fender well. Even sports a very effective stone guard (plastic shield) which hides all that tubing from view. But the shield also traps all the road salt and mud and packs it into the crevices between the tubes where it stays from one winter till the next. Even a powerful car wash probably can't dislodge the caked on mess once solidified.
View 1 Replies
So I have had this code P0442 for a long time and I just kept clearing it. The attached picture (at an angle) shows the hole in the small line attached to the fuel neck filler exactly behind where the plastic wheel well cover touches it. Just ordered a new one from rockauto for about 65 shipped.
View 5 Replies
I've gotten the P0442 "small leak - intermittent" code and "service now" warnings on my 2007 2.0T Passat. I have also occasionally gotten the "check gas cap" warning and icon on the dash, but it always goes away quickly. The car runs fine. The VCDS scan shows as follows:
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 3C0 907 115 S HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: --H14--- Serial number: VWZCZ000000000
Coding: 0404010A19070160
Shop #: WSC 24125 444 85663
VCID: 3041CBF8A31AF19890B
1 Fault Found:
001090 - EVAP Emission Control Sys
P0442 - 001 - Small Leak - Intermittent
[Code] ....
If I clear this code, it comes back within a day or two of driving, but not immediately. I have already replaced the gas cap and N80 valve. The other component I'm aware of possibly failing is the check valve. It's just downstream of the N80 valve, circled in red here:.
I put a vacuum on this part, and it had a very slow leak, losing about 3psi (starting from 20psi) every minute. That seems too small a leak for this to be a problem? Is this thing supposed to be absolutely air tight? Since this part is more expensive ($80) and bit more hassle to replace than the N80 valve, I'd like to know more about this before I just blindly replace it.
If this check valve isn't the problem, then what to check? Although the car runs fine, I need an inspection and would prefer to not have to clear the codes and hope for the best just before taking it in.
View 7 Replies
so my girls car is throwing an evap code (P0442) small leak detected. I bought a new oem gas cap and replaced the purge valve solenoid under the hood. that didn't work, CEL still comes on about 100mi after clearing the code.
I have checked the rubber hoses that were attached to the purge valve solenoid when i replaced it and they are fresh, no dry rot or cracks that i can see. The hose on one side goes to a hard line that runs under the car to the back, the hose on the other side of the solenoid runs under the intake to the throttle body. That hose was fine as well. Connections were tight and i even put better clamps on the hose ends that attach to the solenoid. So I have ruled out that portion of the system (under the hood).
I also removed the rear seat to access the fuel pump. All those connections seem nice and tight, I don't smell any strong gas fumes indicating a leak so i don't think the fuel pump gasket is the problem either. Finally, i checked out the hard lines running under the car front to back and I see no apparent or obvious damage. I assume my next step is to pull off the rear passenger wheel well liner and asses the charcoal canister and the LDP connections, correct??
The last thing I will mention is, Idid notice the 2 fuel lines that attach to the fuel regulator are in pretty rough shape, however not leaking any fuel. Are both of these lines actual liquid fuel lines? I am thinking one of them is a vapor return which may be part of the EVAP system. If it's dry-rotted and leaking vapors could that be the culprit??
View 2 Replies
Threw this code p0442 evap emission control small leak. I see its a popular code to have....
View 14 Replies
Got an engine light on today and had it checked at Advance Auto. It is P0442, "small leak in Evaporative emission control system". One article I read said to remove and retighten the gas cap, clear the code then see if it occurs again. If it does then replace the gas cap with a new OEM cap, and try clearing the code again to see what happens, as a first step in the troubleshooting process. I retightened the gas cap, but don't know how to clear the code and turn off the engine light.
View 3 Replies
I have a oil leak that I can't seem to find the source of. The head gasket corner (driver side firewall corner) has oil on it. (3.8 SC). Or maybe the intake valley gaskets are leaking but it doesn't appear so (and the intake was done within the last 20k miles). The back side of the oil pan (toward rear of car) is wet and the oil seems to be dripping off the transmission pan somehow.
Another thing is the knock sensor between the block and transmission seems wet, not sure if the oil is coming from above that or not, would the knock sensor leak oil or coolant? (or nothing)...
View 6 Replies
When I got my 60K service last weekend, the dealer called me and explained that I had a "very small internal leak fro an emissions canister that was leaking into the intake/manifold". He said something like that. He also said that it doesn't do anything to the performance of the car, but that the leak will increase over time and will throw a MIL.
View 6 Replies
1997 Grand Prix GT N/A. 175,000. I keep getting this code about once every two weeks. I'll clear it and doesn't come back until then. I've had passengers in the back seat smell gas so I'm suspecting the vapor canister. Would a leaking canister set this code off? I checked all the vacuum lines to the purge solenoid and seem fine. Is the canister in the drivers side rear wheel well? I need to get in there and check if it's leaking. I'm having no driving issues however my gas consumption seems to be a bit more than usual. I checked the FPR and no fuel contamination.
View 2 Replies
2000 Grand Prix GTP has code P1629, car will run for 3 sec with black master key and then die. Security light in dash is flashing when this happens. Tried the 30 minute relearn for PK3 with no luck. It will start and stay running with the grey Valet key which is perplexing to me. As of right now I am siding with replacing cylinder and ignition switch after everything I've read on the subject.
View 13 Replies
I bought my 2001 Grand Prix with a 3.8 liter (non supercharged) earlier this year. Within the first month, the check engine light came on with a P0410 code. Took it to the shop here at the auction that I work at to get repaired. He ran the diagnostics on it and found that the air pump wasn't working. He pulled it out and it was full of water, due to the air inlet being so low. So, he replaced the air pump and re routed the air inlet so that it was higher up into the engine compartment. That same night, the light came back on, so I brought it back in the next day. The relay failed and popped the fuse. Replaced both, and the light was off for a full day.
Got ready to take it in for its emissions test today, and the light came back on again. The air pump is not working, again. Turns out that the previous owner had replaced the air pump twice (once with aftermarket, and once with an OEM unit) because of the water build up and freezing the first time. I am not aware of any GM service bulletins, but there has to be something that is taking out these pumps. The only things not replaced on the secondary air system is the lower check valve and solenoid. So, what could be causing the pumps to fail prematurely?
View 4 Replies
My CEL came on and I took it in to dealer. They replaced the EVAP line and purge valve. My CEL came on again that same week and supposedly it detected a small leak (sporadic, same code as previous), they ran test and did not detect any leaks. They finally told me that I might have to replace the canister if CEL comes on again for same code.
View 3 Replies
1997 Grand Prix 3.8 N/A 181,000 ... I have been getting a misfire only on cylinder 4 which has become more frequent. It "only" happens after the car has warmed up and I turn it off for a few minutes, for instance going in to pay for gas. When I start, it immediately starts to miss but as soon as I hit the accelerator it evens out and runs great, every time. I replaced plugs and wires two years ago with stock.
Upper and lower intake manifold gaskets were replaced around 110,000. All three coil packs have been replaced with original GM packs. I replaced my EGR valve last year due to the original was sticking. My throttle body was cleaned about four years ago. I've seafoamed through brake booster and the rest in gas tank.
I'm stumped that it corrects itself right away by giving it gas. The SES light always come on but goes off on it's own after a few cycles.
View 4 Replies
I have a 1993 Dodge Grand Caravan. I found a small leak in my fuel rail. Can I buy a repair kit for this or do I need to find a new fuel rail? If so where to find a rail for a van this old?
View 2 Replies
My 2004 grand prix gt2 theft deterrent service light is on. So far I have no problems with the car starting or runiing at this point.
View 1 Replies
Just found out I have a problem with my evap system (97 Grand Prix GTP). My SES light comes on intermittently. Not sure what the number of the code is, but my mechanic said it was because the vacuum was too strong (not a leak). He said could be from a kink or clogged hose. What this could be? Are the hoses and canister easily accessible for me to check?
View 10 Replies
I have a 2009 ford f150 4.6l 3v v8 standard cab with about 53k miles on it.
Recently the check engine light came on so i went to autozone to have the codes pulled for free, it says i have a small evaporative leak.
They said may be the gas cap, but the thing is, i have a quick fill cap that came in stock with truck so the gas cap isnt even needed.
I've looked under the hood, and noticed that there is little pool of oil on top of the valley of the engine on the passenger side of the engine, could it possibly be the PCV hose that is bad and be related to the evaporative leak code? or its unrelated and i have a bad gasket for the valve cover?
It isn't affecting the performance of the engine,.. yet. I have a road trip for my work coming up very soon and i wanted to try to fix it before then.
View 3 Replies
Where does the 3rd brake light wiring harness plug into on a 2000 GP ? It's just hanging down and I don't see where it plugs into. I'm talking I'm the trunk area.
View 1 Replies
Having an issue with my 2002 GP GT. I started it, but then it died after a couple of seconds while the "Security" light was flashing.
I actually had both original keys with and tried each to no avail (same thing: starts, but engine kills after a few seconds). I checked the PassKey III fuse and even replaced it - still no luck.
Called two different dealer service departments and they suggested turning the key to the "ON" position and leaving it for 15 minutes. I tried this 3 times and still the same issue.
I understand this can be a VERY expensive repair as I've read it requires replacing the ignition module and perhaps the Theft Deterrent Module. How to at least temporarily by-pass or reset the system so I don't have to get it towed (of course it's no where near my place).
View 14 Replies
I had a check engine light cane on. I took it for it to get checked and they gave me this code- P0457 EVAP small leak detected. ECM has detected a large leak in the EVAP System during a system monitor test.
The paper said I had a leak in the Evap canister or hose. I took the truck to a mechanic and was told I had Bad oxygen sensors. Can Bad/Dirty oxygen sensors make this error code come up?
Exactly where the oxygen sensors are? I was told they were behind the mufflers but I didn't see any and the diagram I found was not accurate.
2002 Ford Ranger XLT v6 extra cab.
View 2 Replies
