Just found out I have a problem with my evap system (97 Grand Prix GTP). My SES light comes on intermittently. Not sure what the number of the code is, but my mechanic said it was because the vacuum was too strong (not a leak). He said could be from a kink or clogged hose. What this could be? Are the hoses and canister easily accessible for me to check?
View 10 RepliesWe have a 2003 Grand Prix. For the last few years it has this intermittent problem. Sometimes it just won't start and occasionally it will die while stopped at an intersection. I did some digging online and found out what the likely culprit is, but do not know how to fix it. I already spent a lot of money for a mechanic to claim he fixed it, but didn't.
According to online sources [URL] .... the security system TDM is at fault. It stops recognizing the VATS transponder in the key and thinks the car is being stolen. So, it cuts the connection to the engine. Clearly a dangerous situation if you are driving. My 17 yo daughter recently got stuck in a very busy intersection.
The temporary fix is to turn the key to the on position without turning the engine, wait 10 minutes then try starting the car. This is supposed to reset the security system. Now this is starting to not work. Someone suggested bypassing or modulating the TDM signal by adding in a resistor. I really don't feel equipped to do this though. Another solution is to buy a bypass module.
I have a 97 Grand Prix GTP with 191,000+ miles. For the past couple of months, I have had a loud groaning sound coming from somewhere under the hood when I steer the car in either direction. This groaning is most noticeable at idle or very low speeds and when the car is first started up in the morning. It seems to get less noticeable at higher speeds and after the car has warmed up a while. Over the past few days, at idle/low speed and when cold, there is now more resistance when steering in either direction. Power steering pump or rack and pinion? (Hoping this is more PS pump than rack and pinion). The rack and pinion was replaced in 2009.
View 2 RepliesMy 2004 grand prix gt2 theft deterrent service light is on. So far I have no problems with the car starting or runiing at this point.
View 1 RepliesWhere does the 3rd brake light wiring harness plug into on a 2000 GP ? It's just hanging down and I don't see where it plugs into. I'm talking I'm the trunk area.
View 1 RepliesAbout a month ago I had my SES light go on and I took it to the auto parts store and they said it was a small emissions leak. I am not sure of the code though. I took my car to the shop and they said that a sensor that had something to do with the exhaust was bad or unplugged.
My SES light came back on about about a week ago and I had it tested and it said the same thing. "Small emissions leak" This time I got the code and its P0442. The shop is closed today and tomarrow so what and where the sensor is located? Or if its the same thing?
Having an issue with my 2002 GP GT. I started it, but then it died after a couple of seconds while the "Security" light was flashing.
I actually had both original keys with and tried each to no avail (same thing: starts, but engine kills after a few seconds). I checked the PassKey III fuse and even replaced it - still no luck.
Called two different dealer service departments and they suggested turning the key to the "ON" position and leaving it for 15 minutes. I tried this 3 times and still the same issue.
I understand this can be a VERY expensive repair as I've read it requires replacing the ignition module and perhaps the Theft Deterrent Module. How to at least temporarily by-pass or reset the system so I don't have to get it towed (of course it's no where near my place).
2002 Grand Prix, 3.8L na motor, 187K miles. It was running perfectly until 4 days ago. initially, odd gauge stuff and flashing air bag light, then very, very slight engine skip with the tach gauge flipping around. 2 days ago, harder than usual starts ( a couple of seconds cranking instead of instant starts ), 1 day go, longer cranking in the morning, worse stuttering at highway speed. Afternoon, very hard start, stuttering right away, and then it would hardly start and quit after seconds. Gauges flipping and relays buzzing under the dash.
I had it towed home. Moving the key to run I didn't hear the fuel pump running. Checked the pressure at the rail, zero pressure. I removed the relay and jumped it to run the pump at high pressure. Fuel pump ran, pressure was 50-60lbs. Reinserted the relay, tried to start it and no change. I couldn't hear the pump running. Removed the relay and jumped the pump again, left it running and tried starting the car. Also no start.
I'm thinking it may have something to do with the ignition switch, PK3 system, BCM or PCM although I'm not sure which way to go with testing. I'm going to re-check the fuel pump and then start taking ignition switch out.
So, I have a 2009 IV, and it has about 60,000 miles on it. It's still has it's Toyota Certified warranty.
The check engine light has been going on and off for about 3 months. I hooked up my scan tool, and it says there were a bunch of codes popping up for the evap system. I did the obvious repair and replaced the gas cap (with a Toyota cap), and that worked for a few weeks, but the light came on again.
Since it's under warranty, I took it to the dealer and it turns out the vaccum switch (or maybe pump) for the charcoal canister was bad.
Struck me as a rather strange thing to go bad on a relatively newer Prius.
Anyway, had the water pump recall done while it was there, and hopefully all is good now.
I just bought a new 2001 Grand Prix. I am not completely car savvy, but I know a few things for a lady.
The battery won't hold a charge.
and the computer diagnostic tester thing says the Headlamp Relay is malfunctioning.
I have a 95 Grand Prix 3.1L and I can't turn my key. You can put it in and take it out, but it won't turn whatsoever. It's stuck in my driveway and I've tried just about everything to get it to turn.
View 1 RepliesI'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
Thought my transmission was slipping. So I changed the tanny. been driving it for a few days and now it doing the same thing. Is it possible that it a different problem with the same symptoms?
View 4 RepliesWhen I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 RepliesI have a 2000 Grand Prix with a 3.8L engine that will not start. When I turn the key to the run position, the headlights and the dash lights come on, but when I turn the key to the start position, the lights go dim and nothing happens. No sound from the starter. I checked the battery and the starter and they are good. I installed a new positive battery cable. Still works the same. Not sure what else to check.
View 13 RepliesWhen you are accelerating anywhere from half to full throttle it may cut out at any given time. The RPM will drop down, it may bounce up and down for a bit and recover, or it will drop all the way down and stall. If you let off the gas it may or may not recover. If it stalls so far from the tests I have done if you never shut the key off it will never restart again. If you shut the key off and wait from 5 to 10 minutes it will all of a sudden restart normally like nothing ever happened. If you try to restart it immediately even if you shut the key off and back on it will not start.
When it does not start when I am attempting to start: Fuel pressure according to my gauge is between 55 and 60 psi. Inline spark tester shows that it is getting a spark. Engine sounds normal while cranking so in other words compression sounds normal. I have an LED test light rigged up showing when an injector fires, and it does show electrical activity going to the injector when it opens (flashes). Only clue is that it SEEMS dimmer when it wont start, but I have no clue if thats how it normally is on start up. Its only a slight difference from the brightness of a normal idle brightness. I have a snap on scanner hooked up, nothing that I know of looks abnormal in the data and it will not throw codes when this happens.
Parts I have changed or cleaned so far: Changed the fuel filter, crank sensor, cam sensor, ignition module, and MAF sensor. Cleaned the throttle body. When the car is working normally it runs strong, good power, smooth. Starts great normally.
What may be causing my car to harshly shift fron 1st to 2nd and then from 2nd the 3rd. One solution some one had was to replace the:
"TPS (throttle position sensor). The other reason for hard shift is a worn Boost valve and will need to be replaced, or a faulty transmission fluid EPC (electronic pressures control valve). Both Boost valve and EPC are located in the Valve Body and can be replaced with out dropping the valve body, but have to drop the transmission pan".
I did just recently top off the tranny fluid because it was running a bit low but there is no leak....
Last year my a/c worked off and on. so far now its not working at all. Compressor isn't kicking on. i bought a bottle of the EZchill refrigerant to recharge the system. I took the relay out and added 12+ to the pin to kick on the compressor. Even with the compressor running the gauges are in the blue range which is the normal operating range. With the compressor running, the air is cold but when i stick the relay back in the compressor wont kick back on. I tested the relay and its fine. Also the compressor is rattling.
View 8 RepliesLast weekend, I saw fluid under the right side of the car when in a parking lot and found a rather large puddle of almost clear, oily fluid on the garage floor when I got home. I figured it was power steering fluid. I just finished a rebuild a couple months ago but the old power steering pump wasn't changed, so I was guessing a leaky hose or seal.
I quit driving the vehicle. A much smaller puddle, barely more than a spot, appeared. But it was much nearer the front of the vehicle than the PS pump. And the PS pump fluid level is still full.
Not much evidence of dripping fluid in the engine compartment. Is it possible that the new motor mount installed just a few months ago cracked and leaked its fluid already? Don't know how I could verify that without removing the mount. I'm at a loss for the source of the fluid.
Driving last night and my 08 died after searching I found the ICM fuse was blown. I replaced the fuse and now it has a misfire on cylinder 6. I have changed the coil with no luck. I replaced the plugs and wires about 2 weeks ago and I don't find any problem with the plug or wire. I checked at the coil and there is no spark at all on cylinder 6. I was thinking the ICM is bad but was wanting some opinions.
View 11 RepliesI have an 2002 GT with a 3.8 in it. Two wires broke on my harness that plugs into the shift solenoid so it will not shift out of park.
I got a new harness and wired it how it was wired before but it is not working when I plug it back in. Is there a way to test the new harness to make sure it works?