Grand Prix :: 97 GTP - Loud Groaning Noises From Steering System Under The Hood
Dec 8, 2013
I have a 97 Grand Prix GTP with 191,000+ miles. For the past couple of months, I have had a loud groaning sound coming from somewhere under the hood when I steer the car in either direction. This groaning is most noticeable at idle or very low speeds and when the car is first started up in the morning. It seems to get less noticeable at higher speeds and after the car has warmed up a while. Over the past few days, at idle/low speed and when cold, there is now more resistance when steering in either direction. Power steering pump or rack and pinion? (Hoping this is more PS pump than rack and pinion). The rack and pinion was replaced in 2009.
View 2 Replies
Advertisement
Just found out I have a problem with my evap system (97 Grand Prix GTP). My SES light comes on intermittently. Not sure what the number of the code is, but my mechanic said it was because the vacuum was too strong (not a leak). He said could be from a kink or clogged hose. What this could be? Are the hoses and canister easily accessible for me to check?
View 10 Replies
In my 2004 Comp G I have an extremely loud clunk when braking. The braking clunk does not happen all the time. There is a clunk while having the car in reverse and power braking it. While holding down the brake and revving hard and fast it make the loud clunk every time. It will not do it all the time in drive though. I can not pin point which side it is coming from. It sounds as if it is mostly the right. It almost sounds as if it is coming from inside the trans near the pan area?
I have replaced the lower control arms, sway bar bushings, stab links, struts & mounts, I have solid engine and trans and top mounts, new inner and outer tie rods, all wheel bearings, etc.... (not for this issue, just for performance/wear).
I am torn between thinking it is a cv axle or internal drive train noise.
View 7 Replies
Just replaced power steering pressure hose while engine out as PM. New hose wasn't correct shape so I bent the tubing to fit. I later realized that I bought a hose for power steering without variable assist and the hose for variable assist looks correct.
Is there any harm in leaving the "w/o variable assist" hose in now?
View 1 Replies
I have a 97 GTP. When I am at idle, I get a very loud rattling noise coming from the drive belt area of the engine. The noise goes away when you rev the engine up, but returns immediately when idling. I removed the supercharger belt assembly, and then noise still occurs. This just started tonight out of the blue, and It is extremely loud.
View 14 Replies
I noticed red fluid coming out of a line behind the radiator. The line runs directly into the bottom of the radiator. Is that line the lower pressure or high pressure power steering line?
2001 Pontiac Grand Prix, GT 3.8L
View 3 Replies
My 1999 Astro van recently started making LOUD rattling noises under the hood. No previous problems, ran great up till pulling into my driveway. It does have 160,000 miles on it, but has always been excellently maintained. Towed it to dealership where they told me that "by the sound of it" it would need a new engine. This van is fully loaded, power everything, leather interior, paint job is great, everything works. Breaks my heart that I may have to junk it. So, the big question is, junk it or get a new motor?
View 14 Replies
The wife drove the Excursion (V10) to work today and it ran normal and didn't have any loud noises coming from under the hood. When she started the engine to return home it immediately started knocking. This is not a ping, but a knock. Not a loud heavy knock, but much louder than a ping. It has a fast frequency, seems too fast to be a rod knocking. The frequency is similar to a valve issue, but the knock seems to be too heavy for lifters. Oil looks good. Just changed out 2 weeks ago. Truck is driven everyday.
View 11 Replies
I have a 98 gp gt. I have no power going to the radio, sunroof, steering wheel controls, or power windows in the fuse panel I have virtually ripped this car apart and still no clue why I'm not getting power.
View 3 Replies
I just recently replaced the inner and outer tie rods an got a 4 wheel alignment on my 2005 camry le and now whenever you turn the steering wheel all the way lleft or right, it makes a loud groaning noise, and it sounds like something is scraping kinda? What this could be an how to solve this problem? It is not low on power steering fluid...!
View 3 Replies
I just bought a new 2001 Grand Prix. I am not completely car savvy, but I know a few things for a lady.
The battery won't hold a charge.
and the computer diagnostic tester thing says the Headlamp Relay is malfunctioning.
View 2 Replies
I have a 95 Grand Prix 3.1L and I can't turn my key. You can put it in and take it out, but it won't turn whatsoever. It's stuck in my driveway and I've tried just about everything to get it to turn.
View 1 Replies
I'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
View 4 Replies
Thought my transmission was slipping. So I changed the tanny. been driving it for a few days and now it doing the same thing. Is it possible that it a different problem with the same symptoms?
View 4 Replies
When I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 Replies
I have a 2000 Grand Prix with a 3.8L engine that will not start. When I turn the key to the run position, the headlights and the dash lights come on, but when I turn the key to the start position, the lights go dim and nothing happens. No sound from the starter. I checked the battery and the starter and they are good. I installed a new positive battery cable. Still works the same. Not sure what else to check.
View 13 Replies
When you are accelerating anywhere from half to full throttle it may cut out at any given time. The RPM will drop down, it may bounce up and down for a bit and recover, or it will drop all the way down and stall. If you let off the gas it may or may not recover. If it stalls so far from the tests I have done if you never shut the key off it will never restart again. If you shut the key off and wait from 5 to 10 minutes it will all of a sudden restart normally like nothing ever happened. If you try to restart it immediately even if you shut the key off and back on it will not start.
When it does not start when I am attempting to start: Fuel pressure according to my gauge is between 55 and 60 psi. Inline spark tester shows that it is getting a spark. Engine sounds normal while cranking so in other words compression sounds normal. I have an LED test light rigged up showing when an injector fires, and it does show electrical activity going to the injector when it opens (flashes). Only clue is that it SEEMS dimmer when it wont start, but I have no clue if thats how it normally is on start up. Its only a slight difference from the brightness of a normal idle brightness. I have a snap on scanner hooked up, nothing that I know of looks abnormal in the data and it will not throw codes when this happens.
Parts I have changed or cleaned so far: Changed the fuel filter, crank sensor, cam sensor, ignition module, and MAF sensor. Cleaned the throttle body. When the car is working normally it runs strong, good power, smooth. Starts great normally.
View 8 Replies
What may be causing my car to harshly shift fron 1st to 2nd and then from 2nd the 3rd. One solution some one had was to replace the:
"TPS (throttle position sensor). The other reason for hard shift is a worn Boost valve and will need to be replaced, or a faulty transmission fluid EPC (electronic pressures control valve). Both Boost valve and EPC are located in the Valve Body and can be replaced with out dropping the valve body, but have to drop the transmission pan".
I did just recently top off the tranny fluid because it was running a bit low but there is no leak....
View 7 Replies
Last year my a/c worked off and on. so far now its not working at all. Compressor isn't kicking on. i bought a bottle of the EZchill refrigerant to recharge the system. I took the relay out and added 12+ to the pin to kick on the compressor. Even with the compressor running the gauges are in the blue range which is the normal operating range. With the compressor running, the air is cold but when i stick the relay back in the compressor wont kick back on. I tested the relay and its fine. Also the compressor is rattling.
View 8 Replies
Last weekend, I saw fluid under the right side of the car when in a parking lot and found a rather large puddle of almost clear, oily fluid on the garage floor when I got home. I figured it was power steering fluid. I just finished a rebuild a couple months ago but the old power steering pump wasn't changed, so I was guessing a leaky hose or seal.
I quit driving the vehicle. A much smaller puddle, barely more than a spot, appeared. But it was much nearer the front of the vehicle than the PS pump. And the PS pump fluid level is still full.
Not much evidence of dripping fluid in the engine compartment. Is it possible that the new motor mount installed just a few months ago cracked and leaked its fluid already? Don't know how I could verify that without removing the mount. I'm at a loss for the source of the fluid.
View 2 Replies
Driving last night and my 08 died after searching I found the ICM fuse was blown. I replaced the fuse and now it has a misfire on cylinder 6. I have changed the coil with no luck. I replaced the plugs and wires about 2 weeks ago and I don't find any problem with the plug or wire. I checked at the coil and there is no spark at all on cylinder 6. I was thinking the ICM is bad but was wanting some opinions.
View 11 Replies
