Grand Prix :: 2004 - RPM Will Drop All The Way Down And Stall
Jul 23, 2015
When you are accelerating anywhere from half to full throttle it may cut out at any given time. The RPM will drop down, it may bounce up and down for a bit and recover, or it will drop all the way down and stall. If you let off the gas it may or may not recover. If it stalls so far from the tests I have done if you never shut the key off it will never restart again. If you shut the key off and wait from 5 to 10 minutes it will all of a sudden restart normally like nothing ever happened. If you try to restart it immediately even if you shut the key off and back on it will not start.
When it does not start when I am attempting to start: Fuel pressure according to my gauge is between 55 and 60 psi. Inline spark tester shows that it is getting a spark. Engine sounds normal while cranking so in other words compression sounds normal. I have an LED test light rigged up showing when an injector fires, and it does show electrical activity going to the injector when it opens (flashes). Only clue is that it SEEMS dimmer when it wont start, but I have no clue if thats how it normally is on start up. Its only a slight difference from the brightness of a normal idle brightness. I have a snap on scanner hooked up, nothing that I know of looks abnormal in the data and it will not throw codes when this happens.
Parts I have changed or cleaned so far: Changed the fuel filter, crank sensor, cam sensor, ignition module, and MAF sensor. Cleaned the throttle body. When the car is working normally it runs strong, good power, smooth. Starts great normally.
View 8 Replies
Advertisement
2004 GTP. I have recently replaced the condenser, drier, compressor......
My issue is that my compressor only works when jumped. I checked the relay and 10 amp fuse located in the engine bay fuse box and both seem fine. I replaced the pressure switch and put a new pressure switch connector on it. I got it to take a full charge by jumping the compressor. It blows very cold when jumped. The outside temperature on the dash is reading correctly.
View 14 Replies
I have a 2004 Grand Prix GT. What all the fuse under the hood labeled Battery Main 4 supplies power to. Both my HVAC fan and the HUD display won't work. What I should start checking.
View 1 Replies
In my 2004 Comp G I have an extremely loud clunk when braking. The braking clunk does not happen all the time. There is a clunk while having the car in reverse and power braking it. While holding down the brake and revving hard and fast it make the loud clunk every time. It will not do it all the time in drive though. I can not pin point which side it is coming from. It sounds as if it is mostly the right. It almost sounds as if it is coming from inside the trans near the pan area?
I have replaced the lower control arms, sway bar bushings, stab links, struts & mounts, I have solid engine and trans and top mounts, new inner and outer tie rods, all wheel bearings, etc.... (not for this issue, just for performance/wear).
I am torn between thinking it is a cv axle or internal drive train noise.
View 7 Replies
I have a new car now, 2004 Grand Prix GTP Comp G, got it at 88k and it now has 167k. Nearly no problems other than routine maintenance, but here I am with an issue I can't seem to figure out.
A few weeks ago, I blew a tire on the highway, ended up getting 2 new tires put on the front and moved the fronts to the back. Tires were then rebalanced and the alignment straightened out.
The guys at the shop said the front tie end rod needed replaced, but I'm pretty sure they were trying to make extra money off a new customer because my bill was going from tires/alignment to tires/alignment, bearings, tie end rods, and speed sensors.
Now, on to my issue. When I'm driving on the interstate, I notice a humming sound that seems to come from the front passenger wheel between 68-80mph. Soon as I go over 80 or under 68, it's gone. I noticed that the noise lessened when I veered to the right, so I assumed it was the bearing.
Took the car to my usual shop, had the bearings checked, got the front driver bearing replaced under warranty. Mechanic said the passenger bearing seemed fine. Got it on the highway again today, noise is still there.
3.8SuperPacer
2004 Grand Prix GTP Comp G with Ram Air
1998 Grand Prix GTP 40th Anniversary Daytona 500 Pace Car Edition
View 8 Replies
The engine cranks and turns over when I turn the key, but won't stay running unless I give it some gas. My mechanic doesn't know what's wrong with it, but I haven't starting having him replace parts. What's going wrong. Could it be the fuel filter? fuel pump?
View 9 Replies
I recently bought a 2006 STX with the 4.6 engine. Occassionally, when stopping at a light, the engine will stall. I took it to the dealer where I bought it and he put it on the computer and found that once on a test drive the RPM's dropped to 490, but it did not stall. He said everything checked out fine and thought it might be a carbon build up, since the truck only has 27,000 miles on it and was driven only around town. He suggested a couple of tanks of higher octane fuel and a fuel additive to remove the carbon.
View 10 Replies
My 2004 Grand Prix has a intermittent start no start condition. If I turn the key on and the radio and dash work it will not start or even turn over. Most times when trying to start it the only light that turns on is the check engine light. Some times I have to turn the key off and then to the start position a dozen times before the starter will engage. Then it runs normal and can be driven but the entire dash does not work except for the check engine light. At this time the radio and information display do not work either. Everything else works as it should. I cleaned the battery connections and installed a new battery. I also tried a new Ignition switch. Checked all my fuses and they seem to be good. Cleaned the ground below the battery and the two on transmission. I can always get it started but it would be nice If I could tell how fast I am going. Maybe try bcm next.
View 6 Replies
I just bought a new 2001 Grand Prix. I am not completely car savvy, but I know a few things for a lady.
The battery won't hold a charge.
and the computer diagnostic tester thing says the Headlamp Relay is malfunctioning.
View 2 Replies
I have a 95 Grand Prix 3.1L and I can't turn my key. You can put it in and take it out, but it won't turn whatsoever. It's stuck in my driveway and I've tried just about everything to get it to turn.
View 1 Replies
I'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
View 4 Replies
Thought my transmission was slipping. So I changed the tanny. been driving it for a few days and now it doing the same thing. Is it possible that it a different problem with the same symptoms?
View 4 Replies
When I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 Replies
I have a 2000 Grand Prix with a 3.8L engine that will not start. When I turn the key to the run position, the headlights and the dash lights come on, but when I turn the key to the start position, the lights go dim and nothing happens. No sound from the starter. I checked the battery and the starter and they are good. I installed a new positive battery cable. Still works the same. Not sure what else to check.
View 13 Replies
What may be causing my car to harshly shift fron 1st to 2nd and then from 2nd the 3rd. One solution some one had was to replace the:
"TPS (throttle position sensor). The other reason for hard shift is a worn Boost valve and will need to be replaced, or a faulty transmission fluid EPC (electronic pressures control valve). Both Boost valve and EPC are located in the Valve Body and can be replaced with out dropping the valve body, but have to drop the transmission pan".
I did just recently top off the tranny fluid because it was running a bit low but there is no leak....
View 7 Replies
Last year my a/c worked off and on. so far now its not working at all. Compressor isn't kicking on. i bought a bottle of the EZchill refrigerant to recharge the system. I took the relay out and added 12+ to the pin to kick on the compressor. Even with the compressor running the gauges are in the blue range which is the normal operating range. With the compressor running, the air is cold but when i stick the relay back in the compressor wont kick back on. I tested the relay and its fine. Also the compressor is rattling.
View 8 Replies
Last weekend, I saw fluid under the right side of the car when in a parking lot and found a rather large puddle of almost clear, oily fluid on the garage floor when I got home. I figured it was power steering fluid. I just finished a rebuild a couple months ago but the old power steering pump wasn't changed, so I was guessing a leaky hose or seal.
I quit driving the vehicle. A much smaller puddle, barely more than a spot, appeared. But it was much nearer the front of the vehicle than the PS pump. And the PS pump fluid level is still full.
Not much evidence of dripping fluid in the engine compartment. Is it possible that the new motor mount installed just a few months ago cracked and leaked its fluid already? Don't know how I could verify that without removing the mount. I'm at a loss for the source of the fluid.
View 2 Replies
Driving last night and my 08 died after searching I found the ICM fuse was blown. I replaced the fuse and now it has a misfire on cylinder 6. I have changed the coil with no luck. I replaced the plugs and wires about 2 weeks ago and I don't find any problem with the plug or wire. I checked at the coil and there is no spark at all on cylinder 6. I was thinking the ICM is bad but was wanting some opinions.
View 11 Replies
I have an 2002 GT with a 3.8 in it. Two wires broke on my harness that plugs into the shift solenoid so it will not shift out of park.
I got a new harness and wired it how it was wired before but it is not working when I plug it back in. Is there a way to test the new harness to make sure it works?
View 6 Replies
I have a 2000 GP GTP. I went over a speed bump to fast one day, and parked my car. When I got back into the car the next morning, I tried to put my car into drive and it wouldn't accelerate or move. So I put it into lower gear, 1st to be specific, and the car moved normally. I drove like that for a few days with no problem. Then days later I did the same thing, went over a speed bump to fast and now the vehicle wont move at all unless I put it in reverse.
View 2 Replies
I have 02 GT 3.8L with 130k on it. When I accelerate it shakes extremely bad and when I let off the gas it stops. Is that a broken or worn CV joint or something else. And if it is should I replace both sides?
View 2 Replies
