Grand Prix :: 2003 3.1L SE - Idles High Around 3000rpm In Park Or Neutral After Thermostat Replaced
Jan 19, 2014
I replaced the thermostat in my 2000 3.1L Grand Prix SE yesterday. I had to remove the throttle body to get access to it. After putting it all back together, my car now idles around 3000rpm in Park or Neutral. It drops to around 2k when driving which is still a little high. I can definitely feel it taking off faster and it seems to buck a little bit here and there while driving. I did hear a loud hissing sound when I first started it up right around the throttle body area. I don't hear the hissing sound anymore, though. It justs sounds like it's running a lot harder. So my question is, would a leak around the throttle body (I did not use a new gasket and it's possible that the gasket wasn't properly seated) cause these symptoms? On the plus side, my car seemed to heat up super fast!
View 2 Replies
Advertisement
2002 Pontiac Grand Prix GT. It's got a NA SII 3800 3.8L engine. So far we have put $337 into trying to fix it. What happens is:
Go to start it.
Turn key to On.
Turn key to start.
It either cranks over a bunch of times and never starts or it starts and dies or it starts and is fine. Every time it wont start after cranking a bunch you give it GAS and it revs up real good and starts fine. Idles at around 1200 RPM. This poor car. There has never been anything wrong with it. Replaced the catalic convertor once and the battery once. We took it in and they replaced the Cam sensor and the Crank sensor to try and fix it because they said the fuel pump registered fine.
View 6 Replies
Sometimes get a no-start on my car, turn key, nothing have dash lights and headlights, but they do not dim when i turn key, car will also not start in neutral, Had lock cylinder with vats wires replaced, and neutral safety switch was cleaned and adjusted. I even try using remote start and will not with that. this happens every few days or can go a week before problem starts again.
View 5 Replies
I have a 97 grandam 3.1 The engine idles rough but runs fine when you give it the gas. It shows no codes.
View 6 Replies
I have a '98 F150 4.2l with 230k miles on it. A couple of days ago when starting, I noticed that the engine kept racing instead of idling down like it normally does and the weather here in Arkansas has approached the 80 degree mark. The engine also doesn't idle down when shifting (I have a manual tranny). Where to start? I don't have any codes stored other than two for bank 1 and bank 2 running lean but they popped up many miles ago. I'm thinking either a vacuum leak or throttle control. I checked the operation of the cable and the throttle valve and they appear to be fine. Maybe the idle air control?
View 4 Replies
Just took off the throttle body of my 2002 GT to clean it. Had all of the sensors off (IAC, MAF, TPS). Put everything back together and it fired right up but immediately went to 3000 rpm and acted like it would keep climbing.
Thought I was very careful putting everything back together. Obviously the throttle is open but there is no play in the throttle cables. Could it be a sensor?
View 3 Replies
One day, I was on the highway and my Pontiac's speed started dropping. I looked at the temperature gauge, and the temperature was really high. I flushed the coolant system, and changed the gasket. Also the mechanic said that the oil might be leaking after they changed the oil. I paid like $700 for something that has nothing to do with the problem (I paid for a spark plug, ignition wires, fuel filter, and an oxygen sensor). After they changed the oil, oil started leaking all over my driveway, which didn't happen before. It also looked like coolant was leaking out. None of this happened before I got my oil changed with these guys.
After I changed the gasket, the car was running smoothly. But today, the same thing happened again, and I don't know if it's the thermostat, or water pump, or oil leaking, or coolant. The mechanic always suggests to fix something that doesn't have to do with the problem. I don't have much money on hand, so I need to only fix what has to do with the temperature rising, and I need my car to run.
View 4 Replies
I just changed my fuel filter and now I am having issues with the idle/accelator. When I get the car going to a speed of 40mph for example, I let off the gas and the speed barely drops. Then when I went down a side street about 20 mph, I let off the gas and the car just kept going. The idle was initally high, but then dropped down to it's normal 800rpm.
The only thing I touched under the hood was releasing the pressure from the fuel pressure regulator before the fuel filter change. I just removed the idle control unit and cleaned it but that didn't work.
2001 Pontiac Grand Prix GT/3.8L
View 2 Replies
My 05 f250 v10 runs rough at points and sometimes quits when driving. I find it too that I can't rev it in park or neutral and sometimes when it is cold I can. I was wondering if it was a tps or something with the intake...
View 6 Replies
We have a 2003 Grand Prix. For the last few years it has this intermittent problem. Sometimes it just won't start and occasionally it will die while stopped at an intersection. I did some digging online and found out what the likely culprit is, but do not know how to fix it. I already spent a lot of money for a mechanic to claim he fixed it, but didn't.
According to online sources [URL] .... the security system TDM is at fault. It stops recognizing the VATS transponder in the key and thinks the car is being stolen. So, it cuts the connection to the engine. Clearly a dangerous situation if you are driving. My 17 yo daughter recently got stuck in a very busy intersection.
The temporary fix is to turn the key to the on position without turning the engine, wait 10 minutes then try starting the car. This is supposed to reset the security system. Now this is starting to not work. Someone suggested bypassing or modulating the TDM signal by adding in a resistor. I really don't feel equipped to do this though. Another solution is to buy a bypass module.
View 1 Replies
My 2001 Hyundai Santa Fe has recently started idling very high when put in park or neutral. While in drive the engine idles above 1K and you need to keep your foot on the brake to keep from moving forward. If you shut down the vehicle while idling high, the car will not start right away. It needs to cool down for 10 -15 minutes before restarting. It will run fine for awhile but will go back to revving up again.
View 7 Replies
I'm having trouble diagnosing a high RPM in park and neutral on my 2004 Santa FE 4WD 2.7L. Idle's great in drive and reverse. Occasionally when I start the car up it will shoot up to 3000 RPM until I shift into drive or reverse with a heavy thunk. Then it drives fine. When I shift back into park when I'm done driving, it will shoot back up. To avoid this, I just shut the car off in drive and then shift to park.The weird thing is, sometimes it doesn't happen at all. Sometimes it starts right up and shuts down with perfect idle. However, once I give it some throttle in park in these instances, the idle will jump back and forth between 1500 and 2000 and won't die back down to 800 where it should be until I shift into drive or reverse. Not sure what's going on.
I've replaced the idle air control valve, purge valve solenoid, and camshaft position sensor, but to no avail. I also replaced the throttle position sensor a few weeks ago, but that didn't seem to do anything, so I took it back. I'm wondering if I maybe didn't do the correct installation procedure. I still have the old grey TPS for what it's worth. Should I change this? I've also played with the tension in the throttle cable, but I don't really know how to get it exactly within specifications. I definitely removed some slack. I just checked for vacuum leaks using the cigar method with a hose from the PCV valve with the throttle body sealed with saran wrap, but I couldn't find anything. My method was shoddy, and I don't really know what I'm doing, so I wouldn't rule out a vacuum leak by any means.
View 1 Replies
I'm trying to find out what I need to check or replace to get my 2000 Excursion to idle at normal rpm's in park and neutral.
View 11 Replies
I replaced the fan clutch and thermostat on my 1999 5.4. Do I need to "burp" the system or anything?
View 1 Replies
I am trying to solve a mystery on my mom's truck. It's an '06 4.2L F-150 STX with about 133k miles. It had a check engine light on until today- I cleaned the TB and changed air filter yesterday, and both were filthy. Code vanished later on while driving.
I want to check the PCV because the truck idles high and rough in any setting from park to OD, stopped or moving. Worse when stopped though. Entire coil pack has already been changed due to previous misfire problems. This feels similar to a misfire but without the acceleration hesitation. It has also had a recent oil change, and fuel/oil filter change as well.
There is only one hose connecting to the intake on this truck, and it appears to be a vapor line of some sort to the valve cover, but isn't a PCV cause it's just a hollow tube. There is nothing else coming out of the TB at all, except for the throttle control cable. I don't even seen any nipples or connections or holes where a PCV hose or valve should go. I thought it was on the passenger side, under the TB... but there is nothing here at all. I'm stumped.
I am beginning to think the truck just does not have one at all, which I know for a fact is impossible. I have traced every line on this motor from top to bottom, and I do not see it. Should have a heater on it I assume? What else can make the truck so rough? I don't buy it that "it's just that way". That is complete, lazy, BS. I have had/driven many trucks; 4x4s, supercrew, diesels, jeeps, dump trucks... I have NEVER had a truck run as badly and roughly as this one does. Heck, a twin-turbo 700HP diesel doesn't run this roughly.
View 3 Replies
I bought a 2003 Pontiac Grand Am a month ago, I have already replaced the power steering pump, the water pump, plugs and wires, new battery. It was running fine I drove it last night, but the radio has said loc since I bought it. Then today I got in it and tried to start it and it won't start. It turns over like it is going to start but doesn't. I tried the 10 minute reset thing. That didn't work.
View 1 Replies
I just bought a new 2001 Grand Prix. I am not completely car savvy, but I know a few things for a lady.
The battery won't hold a charge.
and the computer diagnostic tester thing says the Headlamp Relay is malfunctioning.
View 2 Replies
I have a 95 Grand Prix 3.1L and I can't turn my key. You can put it in and take it out, but it won't turn whatsoever. It's stuck in my driveway and I've tried just about everything to get it to turn.
View 1 Replies
I'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
View 4 Replies
Thought my transmission was slipping. So I changed the tanny. been driving it for a few days and now it doing the same thing. Is it possible that it a different problem with the same symptoms?
View 4 Replies
When I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 Replies
