Grand Prix :: 2002 Starts Then Dies - Idles At Around 1200 RPM
Nov 12, 2008
2002 Pontiac Grand Prix GT. It's got a NA SII 3800 3.8L engine. So far we have put $337 into trying to fix it. What happens is:
Go to start it.
Turn key to On.
Turn key to start.
It either cranks over a bunch of times and never starts or it starts and dies or it starts and is fine. Every time it wont start after cranking a bunch you give it GAS and it revs up real good and starts fine. Idles at around 1200 RPM. This poor car. There has never been anything wrong with it. Replaced the catalic convertor once and the battery once. We took it in and they replaced the Cam sensor and the Crank sensor to try and fix it because they said the fuel pump registered fine.
View 6 Replies
Advertisement
My son had the car and put the window down and it would not go back up. Had to drive 13 miles in below zero temperatures to get home. After searching online and doing some checking on the vehicle we found that the Driver's PW switch was dead. Went and got a used switch and replaced it and the window works find. SO, the husband goes to start it and the battery is dead so he put a charger on it and it did start but it stalls right away. It will stay running if you have your foot on the gas but as soon as you let off it stalls. If it idles at all before it dies it it does so erratically.
View 10 Replies
I replaced the thermostat in my 2000 3.1L Grand Prix SE yesterday. I had to remove the throttle body to get access to it. After putting it all back together, my car now idles around 3000rpm in Park or Neutral. It drops to around 2k when driving which is still a little high. I can definitely feel it taking off faster and it seems to buck a little bit here and there while driving. I did hear a loud hissing sound when I first started it up right around the throttle body area. I don't hear the hissing sound anymore, though. It justs sounds like it's running a lot harder. So my question is, would a leak around the throttle body (I did not use a new gasket and it's possible that the gasket wasn't properly seated) cause these symptoms? On the plus side, my car seemed to heat up super fast!
View 2 Replies
We have a 2003 Grand Prix. For the last few years it has this intermittent problem. Sometimes it just won't start and occasionally it will die while stopped at an intersection. I did some digging online and found out what the likely culprit is, but do not know how to fix it. I already spent a lot of money for a mechanic to claim he fixed it, but didn't.
According to online sources [URL] .... the security system TDM is at fault. It stops recognizing the VATS transponder in the key and thinks the car is being stolen. So, it cuts the connection to the engine. Clearly a dangerous situation if you are driving. My 17 yo daughter recently got stuck in a very busy intersection.
The temporary fix is to turn the key to the on position without turning the engine, wait 10 minutes then try starting the car. This is supposed to reset the security system. Now this is starting to not work. Someone suggested bypassing or modulating the TDM signal by adding in a resistor. I really don't feel equipped to do this though. Another solution is to buy a bypass module.
View 1 Replies
I have a 2004 grand prix gt, within the last couple of days, it seems to loose power on acceleration and the motor completely dies at times. After waiting 10 seconds or so it will crank but may die again or just feel like it is loping. The problem is getting worse quickly. I have replaced the fuel filter. This did not stop the problem. I thinking it may be the fuel pump. If it is the fuel pump is there any way to verify this to be sure it is the problem before replacing it?
View 3 Replies
I have a 2000 pontiac grand prix (3.8) and when i was driving my car randomly shut off. When i tried to start it again, the car would start, rev a 1000 RPMs then dies a second later. If i pump the gas i can keep it running at around 2000 RPMs until i let my foot off the gas, then it dies After repeated attempts the tow truck was in need. the following day i ran some tests. when starting the car the fuel pressure would stay between 40-50 psi and doesnt drop below that. (excludes fuel pump, filter, etc..)
After running tests the car suddenly started up and continued to run with the rpm bouncing (+/- 100 rpm) i let the car run for 10 minutes and it began running perfectly. This has happened repeatedly in the past 3 days. I have noticed that when letting the car sit while runnig, it will usually die within 2 minutes, however if I am driving. It will sometimes be fine for hours. When attempting to start it by hitting the gas, the car will sometime sputter at 300 RPMs when hitting the gas will do nothing. in some situations i will hit the gas and the rpms will decrease and rise randomly. (letting my foot off the gas, rpms will hesitate before reducing).
When the car dies, i am at times able to get it running after spending 30 min fiddling with it. But half the time it wont start. I have a -P0107 and P0108, codes for high input and output of the MAP sensor. When i unplug the sensor it seems to have minimal effect to the running condition of the car. When i unplug it at times the car will keep a steady rpm while hitting the gas and the car acts no different when i unplug the sensor when the car is running well. I ordered a new MAP sensor which should arrive today so i can see if that is the problem.
View 4 Replies
When I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 Replies
I have an 2002 GT with a 3.8 in it. Two wires broke on my harness that plugs into the shift solenoid so it will not shift out of park.
I got a new harness and wired it how it was wired before but it is not working when I plug it back in. Is there a way to test the new harness to make sure it works?
View 6 Replies
I am looking for step by step instructions with (pictures or video I know sounds corny if not oh well) on how to remove the wiper motor and crank arm. Need to get these taken care of, cause my wipers are stuck in the vertical position. They still work fine just need to be replaced. 2002 Grand Prix GT
View 1 Replies
Having an issue with my 2002 GP GT. I started it, but then it died after a couple of seconds while the "Security" light was flashing.
I actually had both original keys with and tried each to no avail (same thing: starts, but engine kills after a few seconds). I checked the PassKey III fuse and even replaced it - still no luck.
Called two different dealer service departments and they suggested turning the key to the "ON" position and leaving it for 15 minutes. I tried this 3 times and still the same issue.
I understand this can be a VERY expensive repair as I've read it requires replacing the ignition module and perhaps the Theft Deterrent Module. How to at least temporarily by-pass or reset the system so I don't have to get it towed (of course it's no where near my place).
View 14 Replies
2002 Grand Prix, 3.8L na motor, 187K miles. It was running perfectly until 4 days ago. initially, odd gauge stuff and flashing air bag light, then very, very slight engine skip with the tach gauge flipping around. 2 days ago, harder than usual starts ( a couple of seconds cranking instead of instant starts ), 1 day go, longer cranking in the morning, worse stuttering at highway speed. Afternoon, very hard start, stuttering right away, and then it would hardly start and quit after seconds. Gauges flipping and relays buzzing under the dash.
I had it towed home. Moving the key to run I didn't hear the fuel pump running. Checked the pressure at the rail, zero pressure. I removed the relay and jumped it to run the pump at high pressure. Fuel pump ran, pressure was 50-60lbs. Reinserted the relay, tried to start it and no change. I couldn't hear the pump running. Removed the relay and jumped the pump again, left it running and tried starting the car. Also no start.
I'm thinking it may have something to do with the ignition switch, PK3 system, BCM or PCM although I'm not sure which way to go with testing. I'm going to re-check the fuel pump and then start taking ignition switch out.
View 3 Replies
Just took off the throttle body of my 2002 GT to clean it. Had all of the sensors off (IAC, MAF, TPS). Put everything back together and it fired right up but immediately went to 3000 rpm and acted like it would keep climbing.
Thought I was very careful putting everything back together. Obviously the throttle is open but there is no play in the throttle cables. Could it be a sensor?
View 3 Replies
We had 3 windows stop working but the drivers window locks and mirror adj all work. the 3 passenger windows don't work on the doors or the master switch. just bought a new master switch thinking it was the lock out on the master switch, well no change!! windows still don't work ?
View 3 Replies
It's a 05 Kia Rio. I've recently put a bit of work into it due to a few issues which were fuel related, namely replacing the fuel filter/pump. It also has brand new spark plugs. That solved the issue that originally put it on blocks for a few months and it ran fine for the past few weeks.
Today I went outside to drive to work and got the symptoms in the title. I know it's not a spark issue because it does start, and I used it on accessory to air up my tires this morning.
I'm just not sure where to go next. I've done a bit of searching and have found recommendations for checking the grounds and the distributor cap.
While running at rough idle, depressing the accelerator makes it die faster, rather than keeping it running. It rained last night and this morning. It's about 70 outside instead of the 80-90 it's been the last few weeks. No check engine light, but I've only tried to start it about 10 times.
View 2 Replies
My 2002 GT 3.8 with 157,000mi has recently and randomly been losing total electrical power after starting the engine. Engine fires like a champ then after 2-3 seconds will completely die- no engine, no lights, no radio, no locks, nada. The key will be stuck in the ignition and can remove it after playing with it. After a time that I haven't been able to determine, electrical power will be restored after I reinsert the key. Sometimes she will stay running after restarting: sometimes not. But she never hesitates to start.
After the first occurrence she ran fine for 3 days but did notice the driver information center would flicker. It never went completely dark, but go from bright to dim- which has previously never happened.
The car has been parked outside and it has been raining quite a bit- I did notice a few times there has been water on the passenger side floor. I had this problem years ago and it was supposed to have been fixed at the shop.
Also of note: I've had the known GP ignition lock issue where the key will not release for the past 3 years. Just been using a pen to manually release the lock from the bottom of the steering column. Don't think it's a battery problem as it is less than 2 months old.
View 4 Replies
One day, I was on the highway and my Pontiac's speed started dropping. I looked at the temperature gauge, and the temperature was really high. I flushed the coolant system, and changed the gasket. Also the mechanic said that the oil might be leaking after they changed the oil. I paid like $700 for something that has nothing to do with the problem (I paid for a spark plug, ignition wires, fuel filter, and an oxygen sensor). After they changed the oil, oil started leaking all over my driveway, which didn't happen before. It also looked like coolant was leaking out. None of this happened before I got my oil changed with these guys.
After I changed the gasket, the car was running smoothly. But today, the same thing happened again, and I don't know if it's the thermostat, or water pump, or oil leaking, or coolant. The mechanic always suggests to fix something that doesn't have to do with the problem. I don't have much money on hand, so I need to only fix what has to do with the temperature rising, and I need my car to run.
View 4 Replies
I just replaced the water pump and put it all back together, now it won't run well enough to drive. Checked vacuum system, all sensor connections, hoses, gas cap, changed fuel filter, I can hear the fuel pump kick in, reset system with battery disconnected and have looked at everything I can think of so far.
Now - starts fine, idles about 10 seconds and then begins to idle rough and dies. If I use the throttle I can often keep the idle up, but then backfires or acts like no fuel and again dies. Used fuel cleaner and made sure there was plenty fuel in tank.
I am looking at replacing sensors at this point but which one first?? They get a bit expensive real quick.
View 5 Replies
I have a 2002 Nissan Quest. It starts fine, idles great. But, when I try to accelerate, the car bogs, hesitates, misfires and I get p0300 random misfire, p0325 knock sensor. I get no dtc when it is just idling. The fuel pressure is fine, regulator works good, the cam sensor is clean, the coil tests good, the compression is good, as are the wires, cap and rotor.
View 2 Replies
My Auto 2.4 850 SE (38600miles) does this lately:
- idles at about 1200 rpm, and takes long to settle to its 850 position, even when warm;
- when I engage Drive, idle drops to very low, car vibrates as if engine wants to switch off, then rises again as I give gas and pull away.
Why this is the case, and what I could do to remedy this? (About 2 months ago, idling was going really nuts! I removed the flame trap and fresh air hose: it was full of oily gunk and I gave all components a good clean up with carb cleaner and then replaced them, and then idling all fine after that).
View 11 Replies
My 2012 idles after start up on a warm day at 1200rpm which seems high to me. Should it be lower?
View 1 Replies
Truck starts right up. Will die if I dont give it some gas for about 5 seconds of so. No check engine lights. I did leave the hood open yesterday adn the auto sprinklers came on. I completely forgot about it. I check the air filter before I started it and its dry so I dont feel its water intrusion. I shot a quick burst of carb cleaner in the IAC and then reinstalled it. No joy. When running it will idle and runs fine. If I unplug the IAC it stumbles and almost dies. Any way to test the IAc, TPS or MAF sensor ? I hate just throwing parts at them without diagnosing them properly.
View 14 Replies
