I have an 2002 GT with a 3.8 in it. Two wires broke on my harness that plugs into the shift solenoid so it will not shift out of park.
I got a new harness and wired it how it was wired before but it is not working when I plug it back in. Is there a way to test the new harness to make sure it works?
Where does the 3rd brake light wiring harness plug into on a 2000 GP ? It's just hanging down and I don't see where it plugs into. I'm talking I'm the trunk area.
View 1 RepliesWhen I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 RepliesI am looking for step by step instructions with (pictures or video I know sounds corny if not oh well) on how to remove the wiper motor and crank arm. Need to get these taken care of, cause my wipers are stuck in the vertical position. They still work fine just need to be replaced. 2002 Grand Prix GT
View 1 Replies2002 Pontiac Grand Prix GT. It's got a NA SII 3800 3.8L engine. So far we have put $337 into trying to fix it. What happens is:
Go to start it.
Turn key to On.
Turn key to start.
It either cranks over a bunch of times and never starts or it starts and dies or it starts and is fine. Every time it wont start after cranking a bunch you give it GAS and it revs up real good and starts fine. Idles at around 1200 RPM. This poor car. There has never been anything wrong with it. Replaced the catalic convertor once and the battery once. We took it in and they replaced the Cam sensor and the Crank sensor to try and fix it because they said the fuel pump registered fine.
My son had the car and put the window down and it would not go back up. Had to drive 13 miles in below zero temperatures to get home. After searching online and doing some checking on the vehicle we found that the Driver's PW switch was dead. Went and got a used switch and replaced it and the window works find. SO, the husband goes to start it and the battery is dead so he put a charger on it and it did start but it stalls right away. It will stay running if you have your foot on the gas but as soon as you let off it stalls. If it idles at all before it dies it it does so erratically.
View 10 RepliesHaving an issue with my 2002 GP GT. I started it, but then it died after a couple of seconds while the "Security" light was flashing.
I actually had both original keys with and tried each to no avail (same thing: starts, but engine kills after a few seconds). I checked the PassKey III fuse and even replaced it - still no luck.
Called two different dealer service departments and they suggested turning the key to the "ON" position and leaving it for 15 minutes. I tried this 3 times and still the same issue.
I understand this can be a VERY expensive repair as I've read it requires replacing the ignition module and perhaps the Theft Deterrent Module. How to at least temporarily by-pass or reset the system so I don't have to get it towed (of course it's no where near my place).
2002 Grand Prix, 3.8L na motor, 187K miles. It was running perfectly until 4 days ago. initially, odd gauge stuff and flashing air bag light, then very, very slight engine skip with the tach gauge flipping around. 2 days ago, harder than usual starts ( a couple of seconds cranking instead of instant starts ), 1 day go, longer cranking in the morning, worse stuttering at highway speed. Afternoon, very hard start, stuttering right away, and then it would hardly start and quit after seconds. Gauges flipping and relays buzzing under the dash.
I had it towed home. Moving the key to run I didn't hear the fuel pump running. Checked the pressure at the rail, zero pressure. I removed the relay and jumped it to run the pump at high pressure. Fuel pump ran, pressure was 50-60lbs. Reinserted the relay, tried to start it and no change. I couldn't hear the pump running. Removed the relay and jumped the pump again, left it running and tried starting the car. Also no start.
I'm thinking it may have something to do with the ignition switch, PK3 system, BCM or PCM although I'm not sure which way to go with testing. I'm going to re-check the fuel pump and then start taking ignition switch out.
Just took off the throttle body of my 2002 GT to clean it. Had all of the sensors off (IAC, MAF, TPS). Put everything back together and it fired right up but immediately went to 3000 rpm and acted like it would keep climbing.
Thought I was very careful putting everything back together. Obviously the throttle is open but there is no play in the throttle cables. Could it be a sensor?
We had 3 windows stop working but the drivers window locks and mirror adj all work. the 3 passenger windows don't work on the doors or the master switch. just bought a new master switch thinking it was the lock out on the master switch, well no change!! windows still don't work ?
View 3 RepliesMy 2002 GT 3.8 with 157,000mi has recently and randomly been losing total electrical power after starting the engine. Engine fires like a champ then after 2-3 seconds will completely die- no engine, no lights, no radio, no locks, nada. The key will be stuck in the ignition and can remove it after playing with it. After a time that I haven't been able to determine, electrical power will be restored after I reinsert the key. Sometimes she will stay running after restarting: sometimes not. But she never hesitates to start.
After the first occurrence she ran fine for 3 days but did notice the driver information center would flicker. It never went completely dark, but go from bright to dim- which has previously never happened.
The car has been parked outside and it has been raining quite a bit- I did notice a few times there has been water on the passenger side floor. I had this problem years ago and it was supposed to have been fixed at the shop.
Also of note: I've had the known GP ignition lock issue where the key will not release for the past 3 years. Just been using a pen to manually release the lock from the bottom of the steering column. Don't think it's a battery problem as it is less than 2 months old.
One day, I was on the highway and my Pontiac's speed started dropping. I looked at the temperature gauge, and the temperature was really high. I flushed the coolant system, and changed the gasket. Also the mechanic said that the oil might be leaking after they changed the oil. I paid like $700 for something that has nothing to do with the problem (I paid for a spark plug, ignition wires, fuel filter, and an oxygen sensor). After they changed the oil, oil started leaking all over my driveway, which didn't happen before. It also looked like coolant was leaking out. None of this happened before I got my oil changed with these guys.
After I changed the gasket, the car was running smoothly. But today, the same thing happened again, and I don't know if it's the thermostat, or water pump, or oil leaking, or coolant. The mechanic always suggests to fix something that doesn't have to do with the problem. I don't have much money on hand, so I need to only fix what has to do with the temperature rising, and I need my car to run.
I just bought a new 2001 Grand Prix. I am not completely car savvy, but I know a few things for a lady.
The battery won't hold a charge.
and the computer diagnostic tester thing says the Headlamp Relay is malfunctioning.
I have a 95 Grand Prix 3.1L and I can't turn my key. You can put it in and take it out, but it won't turn whatsoever. It's stuck in my driveway and I've tried just about everything to get it to turn.
View 1 RepliesI'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
Thought my transmission was slipping. So I changed the tanny. been driving it for a few days and now it doing the same thing. Is it possible that it a different problem with the same symptoms?
View 4 RepliesI have a 2000 Grand Prix with a 3.8L engine that will not start. When I turn the key to the run position, the headlights and the dash lights come on, but when I turn the key to the start position, the lights go dim and nothing happens. No sound from the starter. I checked the battery and the starter and they are good. I installed a new positive battery cable. Still works the same. Not sure what else to check.
View 13 RepliesWhen you are accelerating anywhere from half to full throttle it may cut out at any given time. The RPM will drop down, it may bounce up and down for a bit and recover, or it will drop all the way down and stall. If you let off the gas it may or may not recover. If it stalls so far from the tests I have done if you never shut the key off it will never restart again. If you shut the key off and wait from 5 to 10 minutes it will all of a sudden restart normally like nothing ever happened. If you try to restart it immediately even if you shut the key off and back on it will not start.
When it does not start when I am attempting to start: Fuel pressure according to my gauge is between 55 and 60 psi. Inline spark tester shows that it is getting a spark. Engine sounds normal while cranking so in other words compression sounds normal. I have an LED test light rigged up showing when an injector fires, and it does show electrical activity going to the injector when it opens (flashes). Only clue is that it SEEMS dimmer when it wont start, but I have no clue if thats how it normally is on start up. Its only a slight difference from the brightness of a normal idle brightness. I have a snap on scanner hooked up, nothing that I know of looks abnormal in the data and it will not throw codes when this happens.
Parts I have changed or cleaned so far: Changed the fuel filter, crank sensor, cam sensor, ignition module, and MAF sensor. Cleaned the throttle body. When the car is working normally it runs strong, good power, smooth. Starts great normally.
What may be causing my car to harshly shift fron 1st to 2nd and then from 2nd the 3rd. One solution some one had was to replace the:
"TPS (throttle position sensor). The other reason for hard shift is a worn Boost valve and will need to be replaced, or a faulty transmission fluid EPC (electronic pressures control valve). Both Boost valve and EPC are located in the Valve Body and can be replaced with out dropping the valve body, but have to drop the transmission pan".
I did just recently top off the tranny fluid because it was running a bit low but there is no leak....
Last year my a/c worked off and on. so far now its not working at all. Compressor isn't kicking on. i bought a bottle of the EZchill refrigerant to recharge the system. I took the relay out and added 12+ to the pin to kick on the compressor. Even with the compressor running the gauges are in the blue range which is the normal operating range. With the compressor running, the air is cold but when i stick the relay back in the compressor wont kick back on. I tested the relay and its fine. Also the compressor is rattling.
View 8 RepliesLast weekend, I saw fluid under the right side of the car when in a parking lot and found a rather large puddle of almost clear, oily fluid on the garage floor when I got home. I figured it was power steering fluid. I just finished a rebuild a couple months ago but the old power steering pump wasn't changed, so I was guessing a leaky hose or seal.
I quit driving the vehicle. A much smaller puddle, barely more than a spot, appeared. But it was much nearer the front of the vehicle than the PS pump. And the PS pump fluid level is still full.
Not much evidence of dripping fluid in the engine compartment. Is it possible that the new motor mount installed just a few months ago cracked and leaked its fluid already? Don't know how I could verify that without removing the mount. I'm at a loss for the source of the fluid.