I have a 2000 Grand Prix with a 3.8L engine that will not start. When I turn the key to the run position, the headlights and the dash lights come on, but when I turn the key to the start position, the lights go dim and nothing happens. No sound from the starter. I checked the battery and the starter and they are good. I installed a new positive battery cable. Still works the same. Not sure what else to check.
View 13 RepliesI have a 2000 pontiac grand prix (3.8) and when i was driving my car randomly shut off. When i tried to start it again, the car would start, rev a 1000 RPMs then dies a second later. If i pump the gas i can keep it running at around 2000 RPMs until i let my foot off the gas, then it dies After repeated attempts the tow truck was in need. the following day i ran some tests. when starting the car the fuel pressure would stay between 40-50 psi and doesnt drop below that. (excludes fuel pump, filter, etc..)
After running tests the car suddenly started up and continued to run with the rpm bouncing (+/- 100 rpm) i let the car run for 10 minutes and it began running perfectly. This has happened repeatedly in the past 3 days. I have noticed that when letting the car sit while runnig, it will usually die within 2 minutes, however if I am driving. It will sometimes be fine for hours. When attempting to start it by hitting the gas, the car will sometime sputter at 300 RPMs when hitting the gas will do nothing. in some situations i will hit the gas and the rpms will decrease and rise randomly. (letting my foot off the gas, rpms will hesitate before reducing).
When the car dies, i am at times able to get it running after spending 30 min fiddling with it. But half the time it wont start. I have a -P0107 and P0108, codes for high input and output of the MAP sensor. When i unplug the sensor it seems to have minimal effect to the running condition of the car. When i unplug it at times the car will keep a steady rpm while hitting the gas and the car acts no different when i unplug the sensor when the car is running well. I ordered a new MAP sensor which should arrive today so i can see if that is the problem.
I have a 2000 GP GTP. I went over a speed bump to fast one day, and parked my car. When I got back into the car the next morning, I tried to put my car into drive and it wouldn't accelerate or move. So I put it into lower gear, 1st to be specific, and the car moved normally. I drove like that for a few days with no problem. Then days later I did the same thing, went over a speed bump to fast and now the vehicle wont move at all unless I put it in reverse.
View 2 RepliesI have a 2000 grand prix gtp, I am trying to pull the motor so i can change some things up so i can race it. But how to pull the motor or transmission with it.
View 7 Replies2000 Grand Prix GTP has code P1629, car will run for 3 sec with black master key and then die. Security light in dash is flashing when this happens. Tried the 30 minute relearn for PK3 with no luck. It will start and stay running with the grey Valet key which is perplexing to me. As of right now I am siding with replacing cylinder and ignition switch after everything I've read on the subject.
View 13 RepliesCooling Fans and a/c compressor not working-2000 Grand Prix. They both work when I jumper them. Replaced coolant temperature sensor, checked fuses and relays -all good. Not sure what to troubleshoot from here.
View 4 RepliesHaving an issue with my car blowing fuel pump fuses every once in a while under heavy to moderate acceleration. Have replaced inline fuel filter and the fuel pump resister(white ceramic part). Runs fine with normal driving, but when I want to get some horses out of it, it will cut out and stall and once i replace blown fuse it will start back up again, and I'm off and running again.
View 2 RepliesI have a 2000 Grand Prix 3.8 with 65,000 miles. Bought the car new for the wife to drive. The front brake lines rusted out. My wife has a friend who is a backyard mechanic. She had him replace the front brake lines, from the abs block to each front wheel. Well she finally told me that the brake pedal is not right. I went out and sure enough with pressure on the pedal it goes to an inch off the floor. I bled all for lines at each caliper, no change in pedal. I bled almost a full bottle of fluid. You can pump the pedal for 10 minutes and no change in the pedal. I don't think it is air in the line. I changed the pads and rotors on all four corners last fall. The brake pedal was normal then.
View 5 RepliesAfter driving to the store, I parked for like an hour. i came back outside to start it and it just clicks. i bought an starter from autozone, it didn't work. I took that one back and got one from advanced auto, it didn't work either. Again it justs make a hard click when I attempt to start.
View 2 RepliesSometimes get a no-start on my car, turn key, nothing have dash lights and headlights, but they do not dim when i turn key, car will also not start in neutral, Had lock cylinder with vats wires replaced, and neutral safety switch was cleaned and adjusted. I even try using remote start and will not with that. this happens every few days or can go a week before problem starts again.
View 5 RepliesI have a problem with a Torrent. Still have my old GP with over 400K on it. Anyway, son's Torrent wouldn't turn over so he got a new battery and it still won't turn over. I'm getting 12v to the starter but nothing when he tries to start. Have taken starter off to have it looked at tomorrow. In the meantime, anything else it could be? He just spent a small fortune having head gaskets replaced.
View 14 RepliesIt is the 2000 GTP 2 door. It is my sons car and is dead in front of my house. Changed the fuel filter as it is cheap to do. At the check valve there is no pressure in the fuel line. I turned it over with the hose off the filter it did not pump any fuel. I do hear a click or clunk in the gas tank when I turn it over suggesting it is getting power into the pump.
I almost went and bought a pump but do not really want to put the $230 + tax down without checking the resistor after reading around the net.
I'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
My 05 GP randomly decides not to start. it turns over well but no fire . Sometimes even when I just stop for gas when its already warm. if I leave it for a few minutes usually it will start, run a little rough for a minute then run fine till next episode. no faults show up. I was thinking maybe the fuel pump relay was acting up.
View 2 RepliesYesterday my car ran fine. Today it started running rough when my wife drove it. When I started it to see what was going on it ran very rough. I gave it a little gas and black smoke came out of the tail pipe and now it will not start. I can hear the fuel pump running when I turn the car on. I have spare at least at the coil pack to the wires. The check engine light is on but I don't have a tool to read it and I can't start it to go get it read.
View 11 RepliesI have a 98 Grand Prix 3.8 with about 170,000 miles on it. Yesterday I tried to start it, and it would crank but not start. Let me provide some background info . . . We had received cold temps and snow recently and the vehicle is parked outside. The car ran fine the day before in colder temps. Yesterday morning I was scooping the snow next to the car and I bumped into it causing the alarm to go off. The horn honked 4 or 5 times and then stopped. Later when I tried to start it, it would just crank. At first I thought it was the fuel pump since I could not hear it. The fuse was fine. I then noticed the DIC was flashing 0 on all modes.
On another thread I saw that is often due to a loss of data between the DCI and PCM. I thought perhaps I tripped the security system when I bumped into it which is preventing it from getting fuel, and perhaps was also causing the DIC to show 0. A GM service tech said to put the key in the run position for 10 minutes then turn it off, and then do this two more times and that should clear the security system and the car should start. I tried it and it did not work. I am starting to think it may be a bad PCM. Stopped at my local Oreillys to check out their code reader, but they no longer check them out to take home. It must be used there.
Drove 28mi out to dinner and when leaving after, she wouldn't start. Took it to work in the morning, and it ran fine prior to that. It was 15degrees outside, added heat to the gastank thinking the fuel line was frozen. Tryed to fire on, but it would only idle briefly surging while doing so and die, like not enough gas. It did start after I held the key down during this surging process grinding the starter also, should have driven home, but I shut it off like a idiot, as a result, had to tow home. Noticed TCS OFF light was lite up while it was running, then I shut it off, TCS OFF LIGHT went away when I turned key back on to attempt a 2nd restart. After i did that, it wouldn't fire on again. Towed to my house, I do not hear the fuel pump trying to kick on when i turn on the key. Fuel system is dry. Cranked over next day and definitely no gas in the lines. Bled the fuel system, no fuel shot out. Have checked the fuse box and the one under the hood too. Replaced the fuel pump relay but still no go just (this blows)...
View 7 RepliesWe have a 2003 Grand Prix. For the last few years it has this intermittent problem. Sometimes it just won't start and occasionally it will die while stopped at an intersection. I did some digging online and found out what the likely culprit is, but do not know how to fix it. I already spent a lot of money for a mechanic to claim he fixed it, but didn't.
According to online sources [URL] .... the security system TDM is at fault. It stops recognizing the VATS transponder in the key and thinks the car is being stolen. So, it cuts the connection to the engine. Clearly a dangerous situation if you are driving. My 17 yo daughter recently got stuck in a very busy intersection.
The temporary fix is to turn the key to the on position without turning the engine, wait 10 minutes then try starting the car. This is supposed to reset the security system. Now this is starting to not work. Someone suggested bypassing or modulating the TDM signal by adding in a resistor. I really don't feel equipped to do this though. Another solution is to buy a bypass module.
I am a proud owner of '97 Grand Prix GTP, it has always been a great car with really low maintenance for me. A few days ago I noticed a mild fuel smell and I checked the gas cap, the external fuel filter, etc... Then I lifted the hood and I saw that one of the two fuel lines that run between the firewall and the brake fluid reservoir had a seepage leak in front of the factory loom that secures both lines before going over the supercharger and on to the fuel rail. A fuel leak needs to be repaired immediately, so this is where I am so far.
I noticed that the leaking fuel line is actual a rubber/plastic fuel hose that is covered by a plastic heat proof cover that protects the hose. It runs from the firewall to the fuel rail along side another fuel line of the same size (a supply & return line I believe). Just before going over the supercharger they both have quick connect metal ends that meet two metal fuel lines that end up at the fuel rail. My current issue is that this plastic/rubber hose section of fuel line is discontinued and no longer available to order according to my local GM parts dealer. The way I see it, hunting down this part can be Plan A and Plan B can be duplicating this hose by making it with high pressure fuel injection hoses and the appropriate quick connect fittings.
I've been fixing things here and there (hub bearing, struts, etc.). My latest repair is the water pump, it was howling for a few seconds during cold starts; I just replaced it today, hopefully this unit lasts for a long time.
A few days ago, I noticed this hissing noise after I turn the engine off at normal temp. Since there was a leak from the radiator drain, I thought that was it and didn't care about it. I just installed a new o-ring on the drain cock along with the new water pump. Test drove the car and it turns out the noise is still there, is it normal or not, I didn't put much attention before.
The noise can be heard from underneath and above the engine, it kinda seems to be coming from the intake BUT I find it weird since I installed a new upper intake manifold in november of 2013. It's a Dorman unit and I followed all the instructions from the kit and the workshop manual. Lower intake manifold gaskets were replaced back in november 2009 after the engine was rebuilt because of a cracked head (not sure what type did the mechanic use, back then I didn't know much about repairs). It's hard to believe that these gaskets have failed already. I also replaced the coolant elbow almost two years ago after the belt tensioner assembly failed.
I have a 91 pontiac Grand Prix with a 3.1 and the car has NO leaks, however, I have noticed that the transmission fluid level go down and the engine oil goes up. My conclusion is that some how the tranny fluid is crossing over to the engine, is this possible? and if it is, how or where?
NOTE: my car has a tranny cooling line to the radiator but no engine oil cooling lines and the colant is clean. how is it possible?