I have a 97 GTP. When I am at idle, I get a very loud rattling noise coming from the drive belt area of the engine. The noise goes away when you rev the engine up, but returns immediately when idling. I removed the supercharger belt assembly, and then noise still occurs. This just started tonight out of the blue, and It is extremely loud.
View 14 RepliesI have a 2002 Corolla with a 1.8Liter 1zzfe engine.
I can hear a loud "rattle" at 1950 rpm from the drive belt area whether I'm driving down the street or if I rev it up while parked in neutral. It's not a tapping sound, more like a sheet metal rattle but I can't locate an loose sheet metal.
I thought it might have been the drivebelt tensioner. The plastic bushing on the small bolt cracked to pieces and I simply replaced it with a stack of washers. That's the bolt at the top of the piston that screws into the valve cover. I replaced the tension but still hear that rattle. I tried to locate it with a stethoscope but no luck.
I am a proud owner of '97 Grand Prix GTP, it has always been a great car with really low maintenance for me. A few days ago I noticed a mild fuel smell and I checked the gas cap, the external fuel filter, etc... Then I lifted the hood and I saw that one of the two fuel lines that run between the firewall and the brake fluid reservoir had a seepage leak in front of the factory loom that secures both lines before going over the supercharger and on to the fuel rail. A fuel leak needs to be repaired immediately, so this is where I am so far.
I noticed that the leaking fuel line is actual a rubber/plastic fuel hose that is covered by a plastic heat proof cover that protects the hose. It runs from the firewall to the fuel rail along side another fuel line of the same size (a supply & return line I believe). Just before going over the supercharger they both have quick connect metal ends that meet two metal fuel lines that end up at the fuel rail. My current issue is that this plastic/rubber hose section of fuel line is discontinued and no longer available to order according to my local GM parts dealer. The way I see it, hunting down this part can be Plan A and Plan B can be duplicating this hose by making it with high pressure fuel injection hoses and the appropriate quick connect fittings.
I've been fixing things here and there (hub bearing, struts, etc.). My latest repair is the water pump, it was howling for a few seconds during cold starts; I just replaced it today, hopefully this unit lasts for a long time.
A few days ago, I noticed this hissing noise after I turn the engine off at normal temp. Since there was a leak from the radiator drain, I thought that was it and didn't care about it. I just installed a new o-ring on the drain cock along with the new water pump. Test drove the car and it turns out the noise is still there, is it normal or not, I didn't put much attention before.
The noise can be heard from underneath and above the engine, it kinda seems to be coming from the intake BUT I find it weird since I installed a new upper intake manifold in november of 2013. It's a Dorman unit and I followed all the instructions from the kit and the workshop manual. Lower intake manifold gaskets were replaced back in november 2009 after the engine was rebuilt because of a cracked head (not sure what type did the mechanic use, back then I didn't know much about repairs). It's hard to believe that these gaskets have failed already. I also replaced the coolant elbow almost two years ago after the belt tensioner assembly failed.
Where the fuse that controls oxygen sensors on a 1997 pontiac grand prix 3.8L engine? i read some where it is under hood fuse panel, but what is the marking for the fuse?
View 2 RepliesRattling noise in the belt area of the engine...
View 3 RepliesI have a 1999 Pontiac Grand Prix. The needle on the temp gauge will float up and down after about five mins. of drive time...after a short period of time, however, it will settle around 200 degrees or so. (The heater will not blow warm air while the needle is floating.) The only time the needle starts to rise is when the vehicle is stopped in traffic, but even then, it never gets into the "red." The car never overheats and I have yet to see any coolant on the driveway.
View 1 RepliesIn my 2004 Comp G I have an extremely loud clunk when braking. The braking clunk does not happen all the time. There is a clunk while having the car in reverse and power braking it. While holding down the brake and revving hard and fast it make the loud clunk every time. It will not do it all the time in drive though. I can not pin point which side it is coming from. It sounds as if it is mostly the right. It almost sounds as if it is coming from inside the trans near the pan area?
I have replaced the lower control arms, sway bar bushings, stab links, struts & mounts, I have solid engine and trans and top mounts, new inner and outer tie rods, all wheel bearings, etc.... (not for this issue, just for performance/wear).
I am torn between thinking it is a cv axle or internal drive train noise.
I have a 97 Grand Prix GTP with 191,000+ miles. For the past couple of months, I have had a loud groaning sound coming from somewhere under the hood when I steer the car in either direction. This groaning is most noticeable at idle or very low speeds and when the car is first started up in the morning. It seems to get less noticeable at higher speeds and after the car has warmed up a while. Over the past few days, at idle/low speed and when cold, there is now more resistance when steering in either direction. Power steering pump or rack and pinion? (Hoping this is more PS pump than rack and pinion). The rack and pinion was replaced in 2009.
View 2 RepliesMy 2008 F150 rattles (from engine area) when I let off gas while in traffic or in a drive-through. It almost feels as though it's going to stall. Drive thru, parking lot, traffic are all examples. "Stop and go" push the gas to move forward and quickly let off gas. I let off the gas there is a large rattle coming from my engine. Not sure if it's miss-firing or if it's an exhaust leak or a timing chain issue. I'm having trouble trying to figure this out because it does not happen all the time and have been unable to re-create when I go to the mechanic.
View 4 RepliesMy 1999 Grand Prix GT has been having problems. Here's what it does:
*Turn the key, it cranks but wont turn over.
*Turn the key, it will turn over but dies immediately.
*Turn they key, it will idle smoothly for a few seconds - minutes and eventually die.
So far I have replaced my Fuel pump and filter.
Drove 28mi out to dinner and when leaving after, she wouldn't start. Took it to work in the morning, and it ran fine prior to that. It was 15degrees outside, added heat to the gastank thinking the fuel line was frozen. Tryed to fire on, but it would only idle briefly surging while doing so and die, like not enough gas. It did start after I held the key down during this surging process grinding the starter also, should have driven home, but I shut it off like a idiot, as a result, had to tow home. Noticed TCS OFF light was lite up while it was running, then I shut it off, TCS OFF LIGHT went away when I turned key back on to attempt a 2nd restart. After i did that, it wouldn't fire on again. Towed to my house, I do not hear the fuel pump trying to kick on when i turn on the key. Fuel system is dry. Cranked over next day and definitely no gas in the lines. Bled the fuel system, no fuel shot out. Have checked the fuse box and the one under the hood too. Replaced the fuel pump relay but still no go just (this blows)...
View 7 RepliesThe grand prix is stalling at different times when driving, I cleaned mass air flow sensor. still has same issue, car stalls and have to put in neutral and start while driving.
View 6 RepliesJust took off the throttle body of my 2002 GT to clean it. Had all of the sensors off (IAC, MAF, TPS). Put everything back together and it fired right up but immediately went to 3000 rpm and acted like it would keep climbing.
Thought I was very careful putting everything back together. Obviously the throttle is open but there is no play in the throttle cables. Could it be a sensor?
I am getting a thumping noise from front tires,can't really tell which side? as i turn to left it seems to stops until i straighten wheels.
View 2 Replies1997 Grand Prix 3.8 N/A 181,000 ... I have been getting a misfire only on cylinder 4 which has become more frequent. It "only" happens after the car has warmed up and I turn it off for a few minutes, for instance going in to pay for gas. When I start, it immediately starts to miss but as soon as I hit the accelerator it evens out and runs great, every time. I replaced plugs and wires two years ago with stock.
Upper and lower intake manifold gaskets were replaced around 110,000. All three coil packs have been replaced with original GM packs. I replaced my EGR valve last year due to the original was sticking. My throttle body was cleaned about four years ago. I've seafoamed through brake booster and the rest in gas tank.
I'm stumped that it corrects itself right away by giving it gas. The SES light always come on but goes off on it's own after a few cycles.
I just changed my fuel filter and now I am having issues with the idle/accelator. When I get the car going to a speed of 40mph for example, I let off the gas and the speed barely drops. Then when I went down a side street about 20 mph, I let off the gas and the car just kept going. The idle was initally high, but then dropped down to it's normal 800rpm.
The only thing I touched under the hood was releasing the pressure from the fuel pressure regulator before the fuel filter change. I just removed the idle control unit and cleaned it but that didn't work.
2001 Pontiac Grand Prix GT/3.8L
I'm having this weird problem with my car, 90% of the time it will start to run rich, until it reaches normal temp, to the point that I can smell it coming out from the exhaust. LTFT is at around -15% and it seems to go down after cruising for some time but will go back to negative at idle. My first suspect was the FPR so I checked it and found no gas smell on the vacuum hose, then I decided to run the engine with the vacuum hose disconnected and see if any fuel would come out, 5 minutes later and it was still dry.
There is a chance that the MAF sensor is bad, I'm 90% sure it is, because it will sometimes read 2.9-3.1 gps at idle and according to the rule of thumb of 1gps per liter of displacement, it shouldn't go that low but I might be wrong about it; I disconnected the MAF and the smell was still there, today while driving it was reading 5.45gps (A/C was on) and the smell was still present; car also feels sluggish from time to time only at normal operating temperature (which I assume is because of it running rich).
There is also a vibration felt through the steering wheel only while idling in gear at all temps. Today when I got home and after I turned off the engine I heard a noise like water was running. It was coming from the car so I tried to find where the noise was coming from and it's from the fuel tank. I removed the fuel cap and lots of air came out (or sucked in?). I reinstalled the cap and pressure started to build up almost immediately! I have a video, which I'm sharing, so you can see what I'm talking about; I was even able to hear the fuel tank expanding because of the pressure inside, not sure if you can hear it towards the end of the video (when I put the phone under the car). [URL] .....
It also happened today that I was cruising and the engine hit the rev limiter after I stepped on the gas (WOT) to overtake another car. I immediately removed the foot from the pedal and gave it less gas and it acted normal, no slipping from the transmission at any other time. There is one more thing that I'm not sure about it. Every morning, the engine will sputter for 1 or 2 seconds after starting it but it will be fine for the rest of the day. I once tried disconnecting different sensors from the engine and the only one that seemed to make a difference (it didn't sputter) was the TPS.
Things done so far:
- I replaced the EVAP purge solenoid (P0441 was present) back in february.
- Rubber pieces at charcoal canister also replaced, old ones were rotted to the point my hands would look black just by rubbing against the hoses.
- Upper intake manifold was also replaced by me in november last year.
- New NGK spark plugs and OEM spark plug wires last december.
- Cleaned the MAF sensor with MAF cleaner, no dice. Used brake clean, no change. It's a reman Cardone from autozone, which tells us it's 90% sure it's broken.
- New Duralast MAP sensor back in 2010 because a mechanic broke the original.
- 10qts transmission fluid and filter replacement 2 weeks ago.
- Fuel pump was also replaced back in 2009 maybe, can't remember the exact year. The old one would start making some kind of a hissing noise after prolonged driving.
NO DTC'S PRESENT. I once checked Mode $06 data with a mid-level scanner I have (AutoXray EZ-scan 6000) and saw a test had failed, I think it said something about the MAF and EGR. IHaven't connected my fuel pressure gauge tester. Since I can smell it running rich, I didn't think it would be necessary. I'm thinking that there could be a problem with the EVAP system that's causing the excessive pressure in the tank but I'm not sure what that could be. Is there any chance that the pressure is also causing the rich mixture?
I'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
I have a 2000 Grand Prix with a 3.8L engine that will not start. When I turn the key to the run position, the headlights and the dash lights come on, but when I turn the key to the start position, the lights go dim and nothing happens. No sound from the starter. I checked the battery and the starter and they are good. I installed a new positive battery cable. Still works the same. Not sure what else to check.
View 13 RepliesI have a 91 pontiac Grand Prix with a 3.1 and the car has NO leaks, however, I have noticed that the transmission fluid level go down and the engine oil goes up. My conclusion is that some how the tranny fluid is crossing over to the engine, is this possible? and if it is, how or where?
NOTE: my car has a tranny cooling line to the radiator but no engine oil cooling lines and the colant is clean. how is it possible?