Grand AM :: 2000 SE Rough Idle And Sounds Like It Might Die
Jul 29, 2014
I have a 2000 pontiac grand am with a 2.4 L engine it is automatic transmission. Th issue is i just bought the car from a lot thinking it was an easy fix. What happens is when i start the car it goes from a 1k idle to a 500 or lower and sounds like it might die or if i am at a stop light and decelerate too fast it also feels like its going to die and has a few times unless i keep the gas pedal pressed down. I read the codes at my local store they said it was a engine misfire, o2 sensor the front one, and the map sensor.
My farther works at a pull and save which is a lot to pull used parts from cars hes brought a used ignition coil, used boots , i bought new spark plugs and nothing was fixed there. we have replaced the maf sensor and the map sensor both with used parts neither fixed the problem. I am at my wits end here i cannot afford to take it to the shops around here and am trying to get this fixed to get back and forth to work. I may have left out parts that have been replaced, also as far as lights are concerned the check engine soon light is on .
View 12 Replies
Advertisement
My grand am has a gnarly idle issue. It stalls to turn on and once on it has a very rough idle. When I put the car into drive it stales then just turns off. Drained the heck out of my battery so I was thinking it was an alternator issue but I did a quick test and my alternator seems to be working fine. I did manage to drive my car but once in motion, gears wouldn't shift which has me leading to thinking it can be a transmission issue.
Specs:
2000 grand am
3.4L V6 SE model
automatic
View 1 Replies
I have a 3.1 that has a rough idle motor runs fine when you get it above an idle no codes show up.
View 2 Replies
2001 Grand am 2.4. Runs fine when the engine is cold but when it warms up the idle is rough. When throttle is added from idle, RPM's drop, it hesitates, then either stalls or goes. Car runs just fine when there is a load on the engine (highway speeds). Sometimes it will even stall coming onto off ramps off the freeway. It intermittently shifts hard. SES light is on p0108. Have replaced the MAP sensor and checked for vacuum leaks, still have the light and the same problems.
View 7 Replies
2000 Grand Am GT with 3.4 and 150,000 miles. Car keeps throwing code P304 - cylinder 4 misfire. The main issue is the light and needing to pass emissions test. It has just recently had new plugs, wires, and injector #4.
The fuel pressure regulator was replaced about 3 years ago because it was leaking fuel, enough to smell while driving the car with windows rolled down. Shortly after the fpr was replaced, the acceleration problem seems to have started, either by coincidence, or improper installation. The light/error has been occurring for quite some time, about the past year or two. About a year ago, the car was also throwing a random misfire code. I am not positive if both codes were being thrown at the same time, and when exactly the P304 started.
The crank (or cam) sensor was replaced and worked with the issue for a short while (removed codes/light for maybe a few months?) Before the sensor was replaced, the car would stumble at very slow speeds, 0-10 mph. Also replaced Idle Air Control valve last year. The car would sometimes surge on semi warm starts (not cold, not 190-200) between 500-1000 rpms. The surge would be worse when I had the blower running or the rear defrost on, down to 200 rpms at times.
Currently, the car runs perfectly fine for me, except when trying to accelerate on highway ramps. Its firing somewhat when you step on the pedal, but lags and takes longer than normal to accelerate up to speed for merging with traffic. Drove the car after new injection and said it runs fine while driving, but the misfire seems to be mostly or only occurring at idle.
View 14 Replies
I just installed glow plugs, ucvh, stage 2 rosewood injectors, t500, ipr and gear head tunes. I have out 97 miles on the truck since all this was installed and the truck seems to run okay but has a rough idle and sounds like there is a mis? What should I look into first?
View 12 Replies
2000 Ford Taurus w/ 233,000 miles. Yep, it's been good to me, and I've been good to it! However, the romance may be over now. There is a not so pleasing sound of rocks in a rock tumbler when the car is in idle, or in drive waiting at stop lights. Doesn't matter if I just started the vehicle or it's been running awhile. Noise is definitely coming from the engine and not at the rear of the vehicle (just had the muffler replaced - noise was present before and after). I'm also burning through oil. No tell tale puddles under the car though.
View 19 Replies
I have a 2003 Pontiac Gran Am GT 3.4 and i just noticed yesterday when i start my car now it sounds like i have one lifter that is fairly loud, it goes away about 10 minutes after its running. It did it for the first time when we were at the inlaws yesterday, after a few hours of sitting i went out to warm the car up and heard it. Then in the evening after sitting for a few hours i went out to warm it up and did it again. is it possible to be dirty and need something ran though the engine like seafoam?
View 3 Replies
4 cyldr has very rough idle along with engine shake. Just started doing this. I replaced the cam sensor a few months ago and all has been well. But it started running so rough, almost like it jumped time. I was disconnecting sensors to see if motor idle changed and when I unplugged mass air flow sensor on air filter intake tube, nothing changed. Could this cause such a dramatic idle ?
View 2 Replies
I have a 2000 Accent with about 150,000 miles on it. Recently I have noticed that when my car is sitting in an intersection, the car appears to idle roughly. I would't exactly say that the car is idling rough, cause it stays at a consistent RPM while in drive or park, but the engine gets louder and the steering wheel starts to vibrating. When I slightly step on the gas, the vibration goes away. Also, when I put my car in park or neutral, the car quiets down and the vibrating stops.
I was wondering if it could be the throttle position sensor, or maybe a broken motor mount, but I haven't had a chance to look into it it. I did replace the purge control valve last week, which slightly improved the vibrations.
View 14 Replies
I have a 2000 jetta 2.0, and the idle seems to rough and when I start the car it seems like I might stall.
View 9 Replies
I have 2000 ford windstar with 3.8 engine. I have been reading up on the idle problems with these vans. However, most responses are in regard to the engine stalling and/or it trips a code. My does not do this. Sometimes the idle is rough and other times everything is smooth. I am thinking it may be an egr valve or dpfe valve.
View 5 Replies
I have a 2000 focus ZTS with about 190,000 mile. Near the back of the valve body near firewall I have a loud suction of air sound. I've checked all vacuums and they are good. I was told it's the air control valve but not sure. The car idles rough at all times and when I turn it off is the sound sounds like it's draining out.
View 2 Replies
2000 Sierra 1500, 5.3L engine. When he starts it in the cold (below 40 degrees) at first hits 1000rpm, then immediately drops to 400-500rpm. The idle is rough and wants to die if he tries to drive it. However after 10-15 minutes and the eng warms up, its fine no problems at all. There is no codes, so the scanner we had didn't tell us anything. He had cleaned the TB and intake system with cleaner, no dice. He also disconnected the IAC while it was idling rough, that didn't change the way it ran at all. We would like to toubleshoot it more before we start throwing parts at it.
View 1 Replies
I have a 2000 Alero w/ 2.4 103,000 miles auto. I have been trying to fix a problem for about 3 months. It all started one night when i got stuck in my backyard in about a foot if mud. I thought i could drive it out, but when the wheels would spin and traction control would limit the rpms. After getting out the car would skip every now and then going up an incline at highway speeds in 4th gear (drive) then it would skip while idling. I could get it to run smooth if i hit the pedal and made it shift to 3rd. I drive this car daily and the problem has got worse slowly. Now its hard to crank and when it does there is a small amount of white smoke with strong gas smell while the motor spudders for about 10 secs.
It will finally "clear" up and still misfire every few secs or just cut off. Gas mileage is terrible between 15-18mpg. The engine light and trac off light has only been on twice. Both times the code was for random misfire of multiple cylinders. I have put plugs, boots (wires), distributor, 2 fuel processor regulator, seafoam, all octanes of gas, pulled injectors (looked ok a little dirty but still could be one) and I have ordered ignition control module. Its getting hard to drive and even harder to sell. It has just started the white smoke and gas smell and i think its that's the pressure regulator, but the skipping and rough idle....
View 8 Replies
Here's what is going on with my 2000 Dakota V6 3.9L V6:
After sitting for at least a couple of hours, the truck will crank but not start. After 3-5 tries, the truck does start but idles roughly at a very low RPM for 10 seconds or so and then stalls. I turn the key one more time and it starts up great and idles and drives normally. This behavior is very consistent. I have only driven it about 5 miles after it started doing this, because on that trip, the engine stalled while I was driving. Occasionally the MIL comes on and gives P0443 as the code. Question is, can the evap purge solenoid cause this behavior if it is going bad? I have inspected the vacuum lines, and they seem ok.
One more note: When this first started, I was pretty sure it was the fuel pump. Replacing that has not fixed the problem, and the fuel pump relay is good.
View 1 Replies
I have a 2003 santa fe I just replaced the cat. in it because it was running so poorly. Now that I've replaced the cat it seems to be worse. The car idles real rough, and cant get it to go over 2000 rpms. No engine light. Had the codes checked and all came out fine. I pulled out the plugs and replaced with new. The car in park ran great until I put it in gear then went back to the same no power, rough idle and cant get more than 2000rpm with out a stall. Stalls but dose not die. Disconnected the pre o2 sensor no change.
View 2 Replies
This is what my car is doing after it warms up. It will do it then stop, then do it again and so on. I am pretty sure when the motor is under load it runs a little rough but is hard to tell. The car has 178,000 miles on it. timing belt was done at 113,000. I just replace the plugs and wires changed the oil and the air filter 1,000 miles ago. and it will still do it. I am at a loss as to why it keeps doing this. I have tried injector cleaner, sea foam and engine restore. What would cause this? The check engine light is not on. i replaced the crankshaft positioning sensor about 40,000 miles ago.
Its a 2003 hatch with the 1.6 5 speed .....
View 8 Replies
I'm an Accent 2000 gs owner and since a few days i had this problem. It has a bad idle and looks like it will stall... need to give some gas to stay alive.
Bad acceleration too, it misses some gas. (puffing, rumbling, shaking a bit). After accel, it's ok until the next red light.
Now I can't even drive cause it's worse. (too difficult to accelerate). Is it a sensor?
View 8 Replies
Symptoms:
- Check engine light: misfire on all cylinders, and "lean fuel trim at part throttle".
Started with changing leads and plugs without improvement. Then I found the tank ventilation seemed to be clogged, as there was a massive vacuum when opening the filler cap. Checked the canister and replaced a couple of corroded lines. Also used compressed air to blow through the canister and lines up to the Evap-purge valve. Seemed to be OK afterwards (no vacuum), but still misfires.
Changed the Mass Air flow sensor, and it seems the misfires got better, but instead I have some other issues:
- Hard to start when cold. Starts up fine for a second then sounds like it's getting to much fuel and dies. Possible to keep it running if pumping the pedal or holding it at higher revs.
- Rough idle when warm. (Same as before I changed the MAF and plugs/ leads.)
- Drives and runs ok when out on the road.
- Pulled the cable to the Idle Control Valve without any change in idle...?
- Got flashing engine light and "misfire cylinder 4" when giving full throttle on low revs and seond gear up a steep climb.
What could cause this?
- Temperature sensor?
- O2-sensor?
- Idle control valve?
- Coilpack?
View 26 Replies
I have a Hyundai-Accent 1.5 GL, Auto, year 2000 car. I bought this 4 months ago and ever since it has been giving the check engine signal. However, running conditions of the car has been normal and therefore, I didn't worry about the check engine signal. Now, the engine is rough idling for few seconds when I start the car in the morning, and then it comes back to normal.
View 12 Replies
