Golf VI R :: Wheel Spin In 1st And 2nd Gear?
Oct 6, 2013
I'm an owner of a 2013 DSG Golf R. Today on my way to work, my car did a wheel spin in 1st and 2nd gear. This is the first time it did this and I don't know what caused it. For those who didn't experience launching a DSG Golf R, here is a little insight. The car would usually launch in 2nd gear in a normal driving mild push on the throttle at speeds over 5 mph. From standstill, WOT, or a strong push on the throttle, it will launch in 1st.
I was on my way to work and as usual I turned off traction control. I slowed down for a speed bump and the car was doing around 5 mph in 2nd gear. I Pushed on the throttle and as always the car downshifted to 1st. However this time it didn't hook up as it used to do; instead, I felt the car spinning its tires, upshifted to 2nd at 4000 rpm and kept spinning. I released the throttle and it went back to normal.
I tried multiple pulls from standstill on my way back to work and the car was normal. What could be the cause of this incident? My car has a stage 1 tune..
View 5 Replies
Advertisement
I just bought an FX4 and pick it up tomorrow. When you are in 2wd does the whole front end spin like the axles? Or does only the wheels spin when you are in 2wd? Reason I am asking it seems like with chevy the whole front end spins in 2wd.
View 8 Replies
I noticed that the turbo sounds kind of weird when it first spins up in 2nd and 3rd gear. Kind of a rattly whoosh noise before the normal whistle. Is it normal? I thought it was the "noise maker" thing, but FWIW the 2011's don't have it.
View 4 Replies
Replaced rear brakes for a 2004 camry. Just decided to change out pads/rotors. Rotors were stuck on, had to use the little bolt holes to thread in bolts and push out the rotor. Time to change pads, pads came off fine but when I put on new pads and tried to put it on the rotor, the gap was too small. Seemed like a stuck caliper. Tried to remove the slide bolts, top slide bolt was fine, bottom slide bolt had a lot of resistance and would not come off the slide. Regreased it, re-assembled it and it had a lot of gap to slide over the rotor.
Reassembled everything, tried to spin the rotor by hand and it was fine. Put on wheel, lugged it down and it wouldn't spin at all. Drove it, seemed fine with no pulling but the one rotor was definitely running hotter (163 vs 113) than the other side after a 5 minute drive.What would cause it to spin freely without the wheel, but not spin when the wheel is lugged down?
View 5 Replies
Just rebuild my civic 2000 b4ra trans. after I install the trans back and the car does not move under all gears. the manual says the fluid should be 6.2 Qt for overhaul and I added an external filter and an external cooler should take another 1 qt (?). I totally added 6 qt and the fluid level is ok. I put torque converter upside to drain and some fluids come out. but did not count how much.
Another weird thing is that I can not push the car down the drive way with slope with engine off and brake down and neutral gear. I jack up the front and give some gas under D4 and the wheel does not spin.
View 19 Replies
I have a 2011 Tiguan 125 TSI with 4 motion and recently have been getting quite a bit of front wheel spin especially on right turns. I can hear/feel the front wheel spin and also the TCS light is coming on. When the road is wet, it gets worse. Is this to be expected? The car is 2 years old and has only 24000kms on it so am a little disappointed with this. What may be wrong?
View 20 Replies
Noticed that both rear wheel hubs don't spin freely, they rub or grind. 2013 Elantra sedan gets about 10% worse MPG than a 2012 Elantra we traded in for it, two identical cars yet 2012 got much better MPG and now we notice a rubbing noise on the 2013.
2013 Elantra has 19000 miles but has always had reduced MPG, markedly worse than the identical 2012 we traded, but dealer could never find a problem with 2013.
Wonder if this rubbing on the wheel hubs is to blame for the lower MPG? I can't think it works. Not sure if its the emergency brake, the power brakes, the wheel bearing or something else.
Is this rubbing noise normal? Rubbing happens with the hub only or even with the wheel attached to the hub.
View 7 Replies
I have a 2003 four wheel drive Kia Sorento. When not in four wheel drive it is rear wheel drive. On two occasions while driving on snow packed roads, I have had the rear loose traction and spin out luckily going into a soft snow bank. I have good tires, was driving about 15 miles per hour on a flat straight road and not applying the brakes. I can't figure out what is happening. So I started to put it in four wheel drive whenever there is snow pack on the roads. Typically I thought four wheel drive was only for "tough" conditions, but I haven't had a spin since using four wheel drive.
View 19 Replies
I seem to be having a issue on take off with my new Super Duty, it has the michelin atx2 tires than come on these trucks. On any hill or grade on take off she just spins and traction control flashes on dash, what the heck? Do I need to pull out the 4x4 switch to engage the e-locker so this thing will move? Seems crazy to have to put her into 4wheel when there is only a inch of snow on the ground... My 6.0 did this sort of due to all the torque it had, but that had those crap Contitracs on it till I swapped them for BFG at..
View 14 Replies
My car is pulling to one right slightly so I did the alignment. But it didnt eliminate the problem. Ｉ jacked up my car and try to rotate the front wheel. I can hear slight noise of the caliper rubbing the disk and the wheel does not spin freely if I stopped rotating it. However, the noise is subtle so I don't know if it is by design or I have a brake drag.
View 7 Replies
I think my fan module might be bad because neither of my fans spin anymore, and my air conditioning doesn't work either. My buddy let me borrow a fan module but it isn't the right one, I just need a picture of the connectors or a part number would be good too.
View 1 Replies
Last night it was just below freezing and the roads were a little damp so I figured I'd see at what point ESP would kick in on a hard 2nd gear pull. Sure enough power cuts off at around 4000-4500 rpm.
Turn "off" ESP, try another hard 2nd gear pull expecting some nice tire squeal but I get nothing and obviously still no traction from 4500-6000 rpm. Was my clutch slipping? Is ESP capable of knowing when the clutch is slipping (I would think it had nothing to do with it)? Maybe it was just damp enough that the rubber was spinning in one place but it wasn't making any/limited amount of noise?
Car: GTI, Manual, Stage 1, Winter Tires.
View 8 Replies
My starter motor in my 2004 Golf 2.0 doesn't engage or spin when it is very cold. By very cold, I mean below 5F.
The battery has plenty of juice, and jumping the battery doesn't work. I turn the key to "start" and nothing happens. When key is in the on position, fans, wipers, etc all work fine. When the car warms up to 20F or so, everything is fine and the car starts.
Here's the funny thing. If I put a little space heater on the driver side floor to warm up the fuse and relay panel, it starts with no issue.
I don't know enough about the interlocks between load reduction, starter motor, ignition switch etc to make a good guess as to which relay (if any) may stick in extreme cold. It's a tough problem to diagnose, because I can only experiment when it gets REALLY cold, when it isn't very fun to experiment anyway. I don't think it's the piggy back harness, because the wipers, horn and fan all work.
View 4 Replies
I bought these wheels last summer from ECS Tuning - Alzor wheels for my Jetta. I haven't driven too much on them since I was deployed to Afghanistan for 9 months. I've been home 4 months. I think I have about 10k miles on them. The issue is that now one of them leaks. I took it in to be checked, thinking it was the tire. There is no rock rash, I haven't hit anything. The wheel leaks from the area that the spoke connects to the wheel base. There is no visible sign of a crack at all so I don't know what the heck is up. The paint looks fine from the spot it leaks from.
View 4 Replies
I have a bad wheel bearing but on the highway my steering wheel shakes. It is only on the highway not down residential streets. I'm pretty sure it is the driver's side wheel bearing. I already balanced my wheels and everything.
View 5 Replies
Noisy steering wheel. It doesn't matter where I position the wheel, I'm hearing clatter when going over bumps or when putting pressure on the wheel. It has no effect on steering. I think it's coming from somewhere inside the adjustment mechanism. I figure the dealer will need to take a look.
View 7 Replies
Background facts:
Tranny swapped from my 4 speed auto to a 1.8t o2j 5spd
13lb. Light flywheel
Powerflex dogbone mounts
Peloquin LSD
The problem: Very hard to get a smooth shift from gear to gear. Trust me, I know how to drive, but I can always feel the car shifting into a different gear if you know what I'm saying. On my friend's bone stock Jetta, I just let the clutch out without gas in between shifts and you don't feel a thing.
On my car, you feel EVERYTHING. People have told me the light flywheel will make the ride more uncomfortable in many ways, especially since the RPMs drop much quicker in between shifts than stock.
View 9 Replies
I am back with the same issue as the last 2 batteries. Ever since the wife has had this car, the last 2 batteries would spin the starter, but it wouldn't run. Bought batteries and it fixed it.
But damn, now her battery is only 13 months old. Is it true that if the battery gets just week enough that the motor is starved for enough juice for it to run?
Last dealer couldn't figure out why she needed a battery when the one she replaced was good. I told them do it anyway, and it worked, last year.
She called the dealer today and their saying its the alternator is pulling it down. I say BS. Its not a dead battery, its a temperamental motor, I guess. I dont know what to do. This is getting old.
View 14 Replies
Shifter seem like it is way too loud going from gear to gear? Just holding in the clutch and rowing from gear to gear...seems way too loud, Seriously sounds like shifting gears in my old 5.0 mustang.
View 1 Replies
My 2008 Sienna DVD player suddenly won't play discs because it doesn't seem to be spinning the disc. Inserting and ejecting the disc goes normally but the nothing happens when the disc is inserted.
View 1 Replies
I read about Prius will not spin its wheels? if it loses traction, it somehow disengages the drive or otherwise does not power the wheels until they stop. Once they stop, the wheels can receive power again.
That's sure going to make it hard to do burnouts in the grocery store parking lot.
More importantly, it could make it hard to impossible to get unstuck on sand, gravel, mud or snow. It could also be hard to take off on a slippery incline.
Sure, this isn't an off road vehicle, but off the road ain't far from on the road and road conditions can get pretty rough.
View 6 Replies
