Golf VI R :: Engine Knocking Under Load - Changing Spark Plugs?
Sep 10, 2016
I got the APR ECU Tune in June along with VW Racing air intake. Car runs great except... the engine is knocking under full load. The guy who did the install heard it right away but I just thought he was trying to up sell me. He suggested new spark plugs.
Well it's two (three?) months later and I've come to accept that I can't drive it in the 91 program anymore (I paid extra for the ability to switch programs - lucky!!). I was switching back and forth between 91 and stock and I can hear the difference.
Are spark plugs the likely fix, and how do I choose the right ones for my Mark VI Golf R? "one step cooler"??
View 12 Replies
Advertisement
I've been doing the 40k service to my R32, and was in the process of changing the spark plugs.
The first three went smooth with no problems, the next three however.... When I pulled the coil packs off, they were covered in rust and corrosion.
The inside of the block leading down to the spark plug (where the coil pack was) also had rust in it. I haven't pulled those three spark plugs out yet. What caused the rusting?
I assume I need to replace these three coil packs, and clean off the existing spark plugs before removing them. Is that a fair assessment?
I haven't had any trouble with misfiring or stalling. The car has been running great.
View 2 Replies
My 2010 prius had been giving low mpg since the last three months. It has now 145K miles.when I bought it a year ago, it had 134K on it. I haven't changed the spark plugs, do they have any effect on low mpg? My mpg is about 39 now,but was 42_45 before.
What are the symptoms for the spark plugs to be changed?
View 1 Replies
2001 LS v8 .... What would cause the car to give off a strong smell after changing the plugs?
View 5 Replies
I got the plugs for my '06. I hope to put them in in a day or 2. My question is: is it necessary to disconnect the 12v battery to do this? I've changed plugs in other cars without doing so.
View 6 Replies
2004, 4L, sohc - Is there any issues or problems changing spark plugs?
View 4 Replies
As I say in my first thread my 2000 4 runner don't start after I change the spark plugs. I don't get any fuel pressure from the fuel pump.
View 2 Replies
I am trying to change spark plugs and wires on my 2001 Impala with a 3.8 liter. I was able to get the boots off of the front plugs OK but I am having trouble getting a good grip on the rear ones. It seems like they have glued themselves to the plugs. Removing the boots?
View 10 Replies
My 2011 f250 has 92k miles, I want to change all 16 spark plugs.
Do the 6.2l plugs have problems breaking like the 3v engines did?
I think I'm going to pull the passenger fender liner to get to the lower plugs in the head.
How does the coil pigtail unclip? I looked at them briefly earlier and it looks like you pull the red tab back, then press down and pull on the pigtail but that did not work and I did not want to break anything.
View 14 Replies
2004 5.4L ... Codes indicate a firing issue on #4 cylinder, figure it's the coil pack. They bought truck used a few years ago and plugs have not been changed since they have owned it. I was going to change plugs while I was under the hood. While checking threads on this engine I picked up on plugs being a major job unless you know the tricks. So what tricks do y'all have up your sleeve to keep from breaking plugs?
View 14 Replies
Right now I am seeing roughly 41 MPG and that is after changing the spark plugs with brand new NGK Iridium's, Air intake filter and did an oil change since it was due for one. I have driven the car roughly 2,500 miles since all of this stuff was done and it just seemed to continue to drop to the 41 MPG mark.
What I have noticed though is that when the motor turns off it shudders and the when it restarts while the car is in park the car will roll back and forth slightly. I have also noticed that the car seems to struggle to get up to the posted speed while climbing an incline and also while the car idles in park or at a complete stop there seems to be a bit of a miss fire. Could that be caused by a bad coil? Because I have tried everything short of taking it to the dealer which I really do not want to do again and be told there is nothing wrong with it when I know there is.
View 19 Replies
So, I changed my spark plugs a couple of months ago and did the pcv valve swap as well. Now I have this high pitched rattling noise, like a tiny chain rattling. It is coming from the engine bay - in the area between the throttle body and the firewall. At least that's where I can hear it.
It does it quickly right after I start the engine (though I am certain it is not a timing chain issue)...I had that fixed a while back. Also it doesn't sound like the timing chain tensioner noise.
I am thinking maybe the pcv valve that I swapped out. I remember reading that a new one should make some noise when you shake it...an old, gunked one would not rattle if you shook it in your hands. Consequently, this noise sounds a lot like if I would shake the pvc valve back and forth very fast.
It happens intermittently on idle....and when I rev the engine, it will also make the noise while the RPM falls back down. Since this happened literally right after I did the spark plug change and the pcv valve, my guess is it's that. Maybe I didn't install it correctly.
View 3 Replies
I just did the plugs and now the check engine light is on?
View 6 Replies
I am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
View 19 Replies
I was having some problems and one of my friends told me to post up here before I went and saw my mechanic. So my car isn't starting (its a 06 r32). Now I've gone through a whole list of things and what I have worked out is that it is the spark plugs not firing (none of them are) although they are all brand new and were working not too long ago.
Battery is fine and fuses look good no warning symbols on the dash so I'm at a bit of a loss as to what it could be. Relays? Coils?
View 5 Replies
I have a 2000 Jetta 2.8 VR6 (the 6-cyl) with 128k miles and I have oil on my spark plugs, only on one bank of the motor (the bank closest to the bumper, if that makes any difference). I am aware that it is most likely a leaking or worn out valve cover gasket, and I have a replacement and am prepared to replace it. What I need to know, and I can't find this exact part anywhere, is do I also need to replace the spark plug tube seals??? The gasket I ordered did not come with any tube seals, I can't find this part on any auto parts website at all, nor have I been able to locate anything useful on this, or any other, website. I know the 1.8 has plug tube seals, and they come with the gasket, but does the 2.8 also require tube seals? I imagine it would, but I just don't know.
View 2 Replies
All the oil leak out of engine after a oil change? and i have oil in the spark plug tubes
View 6 Replies
I would like to have a look at the condition of the ignition plugs in my V8 Phaeton. According to the service plan, it's already time to change them and it also seems that the car has lost some power when accelerating.
Is it even possible to change them with the 'usual' knowledge (knows how to change a tire and so on) or should I better go to a professional.
View 24 Replies
I recently replaced the spark plugs on my 2002 Camry SE V6 (Gen 5). Let me just say that it was INCREDIBLY DIFFICULT to reach the rear 3 plugs as they sit underneath the intake manifold, way to the rear of the engine compartment. To reach those, I had to unplug some wires reaching on top of the engine, then loosen the intake manifold.
Along the way I broke a tiny air valve that sits underneath intake manifold, and replaced it right away, before starting the car.
When everything was put back together, the car started wonderfully, only to notice the engine light come on. I had the codes checked at the dealer and they indicated a malfunctioning Catalytic Converter and A/F Sensor and some other emissions stuff. Later that day, the VCS/TRAC OFF light came on as well. The service guy at the dealer said those typically come on together with the Check Engine light, which sounds like something he pulled out of somewhere!
The car drives well, no hesitation, no weird behavior, but has no traction control, naturally. While loosening the manifold I had to use a little force to flex it out of place. My guess is that it I may have yanked something out place: may be a wire issue, or a sensor.
View 13 Replies
I just replaced spark plugs and now it is running rough and reduced engine power light is on. did not mix up wires or coil packs. did one at a time.
View 13 Replies
I just changed my spark plugs the other day and since then my engine is hard idling and skips and jumps while I'm driving it. I'm being told I either need to change the spark plug wires or the coil packs. So my question is which do I need to change? And is there anyway to test which one I need to replace?
View 12 Replies
