Golf VI R :: Enabling Oil Temp Display On MFD?

I was curious what it would take to enable the oil temp display on the MFD in the US Golf R similar to my Mk3 or on Golf Rs in other markets. I'll just mention up front, that to enable this would be (a) a fair amount of cost and work for something of marginal value, and (b) can be done easily with an external gauge instead. That said, here's what I've come up with so far:

The instrument cluster in the US Golf R is capable of displaying oil temperature. This can be enabled through VAG-COM by changing the coding of the cluster to state that a TOG sensor is connected to the cluster. However, since the car is not equipped with the oil temp sensor, no temperature will display and a fault code will be logged.

The oil temp/level sensor is called "TOG" (Temperatur Oelstands Geber or Temperature / Oil Level Transmitter) and is used in many VAG products. It bolts into the oil pan.

To install this, we would need to replace the oil pan with an oil pan from a Golf R which is equipped with a TOG (part#?).

Not sure the part number of the TOG for the Golf R. And example of a TOG part number is 03C907660M, but I'm not sure which version is needed. A couple of misc parts (bolts, cover) may also be needed.

I suspect the sensor would then need to be wired to the instrument cluster (as opposed to the ECU or other controller). I'm not sure what the wiring for the TOG is, but I suspect it might need power, ground and then run a signal wire to the cluster. It appears to be pretty easy to remove the cluster and gain access to the cluster wiring. On other VWs, it hasn't been difficult to add a wire into the cluster connector. But we'd need to know the pin-outs of the instrument cluster to figure out where it should go.

I saw a TOG sensor wiring harness part number of 8D0-971-379B which may or may not be useful.