Golf VI R :: EPC Light Keep Staying On
Sep 21, 2014
Yesterday i was on my way to fill 100oct, on my way i encountered heavy rains and big puddles. After 15-20min drive to the gas station i filled her up and setup the 100oct tune, after i noticed the check engine light was on and epc light too.
So i set her back to stock tune and back to 100oct tune and the CEL went away but the epc light wont go away. Why it stayed on? The car still runs good.
View 4 Replies
Advertisement
I have a 03 jetta 1.8t the asr light comes on and stays on and i cant shut it off if i turn the car off it goes off and then like 10 min later it comes on. Why its happening
View 5 Replies
Where to begin, I've checked things i thought could be the issue but aren't. I am having a constant e-brake light on which as you know emits the loud and annoying beep sound. What I've checked and done:
I checked the brake fluid, its fully topped off. I also removed the ebrake switch (the thing under it that when depressed pushes the button and turns the light off) and just crossed the wires to complete the circuit (this does the same as the button essentially) before buying a new one to see if that was the issue, which is doesn't seem to be. I had my buddy run vagcom which turned up no codes that SHOULD make this issue occur. I even popped in a new brake light switch which didn't work.
At the same time of this happening my car is making ZERO boost at all. Is it a coincidence? I don't know... it's just weird they would both happen at the same exact time. Again, no codes are showing up. Checked lines and didn't see any potential boost leaks. What to do.
View 2 Replies
This morning when I fired the car up the check engine light came on. Waited a bit and tried again still there. Waited all day and one last test and it seems to be on for good. The car seems to be running fine as far as I could tell with out really driving it.
The car is not driven hard and has 2.3k mileage. Should I contact APR or the shop that did the install?
This is my first chipped car so I'm a little unsure about what the best approach is here. I'm also a little nervous to drive the car to the shop with the light on.
View 6 Replies
So once I start the car the fans kick on, and stay on, even when off. The car currently has no coolant in it and it is not being ran longer than to simply start it. I am guessing the fan control module is no good? Anything else to look for? The car has a new green coolant sensor and the coolant res. is deleted.
Also, what resistor to remove the coolant level sensor? I would like to rid my dash of that annoying light.
View 22 Replies
I have a 1999 Silverado. I have noticed the AC stays on even if the light is off. Is this normal?
View 5 Replies
05 GMC pickup,service air bag light staying on. What needs to be done with this?
View 2 Replies
I have a 2011 Sonata Limited, and have had no problems with it until now - the low gas light came on while I drove to work with the fuel gauge showing more than half a tank just before that.
I stopped at a gas station and put $10 of gas in just to be sure it wasn't wrong, but started it up again and the light stayed on.
View 2 Replies
Took a little road trip this weekend and now my ESP light won't turn off. I was on the highway in cruise control doing about 70mph, the light flashed, however i was not slipping or losing traction. It has stayed on since even after I shut the car off. No CEL. its a 1.8t FWD
View 7 Replies
What could cause both the ASR and ABS lights to stay on? I thought it had something to do with the crank sensor, because a few things i have seen said that was one of the fixes, but I just put a new crank sensor in, but the lights are still on? 03 GTI 1.8t AWP.
View 3 Replies
I started having an issue with my battery light coming on and staying on so everyone told me change the alternator. So i did. 4 days later the battery light came back on and now i have it in the shop, alternator check came out good, battery check came out good and starter check came out good.
I haven't had any issues with the car before now, i have made several long trips, bought it brand new and have 69,000 miles on it. I love my car, but I am scared to find out what it's going to cost to fix it.
View 3 Replies
I just had a set on HID'S installed in my van but after they were installed i have the burnt out light icon on my dash staying on now is there a way to either pull a fuse to disable it or should i just ignore it and throw a piece on tape over it
Hyperion Bi-Xenon 6000k kit i truly wish i would have done this sooner
View 2 Replies
Recently I have noted the SRS light has stayed on constantly -- I thought perhaps because I placed a heavy box of books on the front passenger seat - and it was telling me that I needed to fasten the seat belt. The light went off initially but not too many days later -- the SRS light came on and has stayed on ever since. I had it "diagnosed" at the dealer and was told that the OPDS sensor has failed. It was explained that this is something "electrical" and if not working properly that none of the airbags will deploy if needed in an accident. However, since the "diagnosis" -- and driving my car home and on an errand or two -- now I see that the SRS light is off. Did the "diagnosis" with the computer actually "reset the SRS light" and is it possible that my OPDS sensor is actually "okay and not in need of an expensive repair"? I would like to know that my airbags are going to work -- in the event of a serious impact - would running another diagnosis confirm that the OPDS sensor is faulty or confirm that "all is working well with the SRS system". I know the dealer doesn't care -- if he takes my car if for a repair that is no longer needed - but I do care.
View 8 Replies
I have a 2001 Volkswagen passat 4motion. Why does my brake lights stay on without me pushing the brakes? it only does it when I have my running lights on but as soon as I turn them off they work.
View 2 Replies
My emissions workshop light is staying on now in my passat. I don't have a Vag-Com cable for my laptop yet so I scanned for codes with the generic code scanner at Advance Auto. It came up with something about the downstream 02's low voltage or something close to that. It has just over 100k on it now... is this a common issue with these cars? Is it usually the o2's that are the culprit or is it usually a Cat problem? I replaced the PCV hoses (those crappy wire loom looking pieces that fall apart under the engine covers) with much nicer fuel hose and barb fittings thinking that they might have been the culprit, but that was before I scanned it, it obviously didn't work. 2000 LX 4-Motion...
View 9 Replies
My 96 Grand Am 3.1 it the SE model. ABS Light is staying on I check all the fuses all are good I check the wires going to the wheels with a ohm meter get a reading of 117 ohms driver side and 110 ohms right side . Need to know if the reading are in specs or not if I need to replace the ABS unit just the control unit (the black box ) or the whole unit that mount on the master cly ? the car has no tags right now so I can't take it to be scan.
View 12 Replies
So today I get in my car and the air bag light is on solid, no blinking. I scanned it with my scanner and it says no codes Any body else have this happen? I got a bad feeling about this light
View 10 Replies
My brake lights are staying on all the time. I changed my brake light switch. This did not work. I took it to the dealer and they could not figure out what was causing this. They felt it could be a wire which might take them 10 hours to trace down @ $95 an hour. I don't understand how a wire could do this.
View 2 Replies
I have a 1.6 8v mk4 Golf, and my fans started staying on all the time. There are 2 coolant sensors on this model, one is the green one, and the other is the black one which seems to be hardwired into the thermostat housing. Anyway, I changed the green one, and that didn't solve it, so changed the whole thermostat, which obviously came with a new sensor build on....Hey, it worked, for 2 weeks, and then the fans started coming on again as soon as you turned the ignition key...and the temp needle doesn't move much, as before.
My suspicions have moved to the sensor wiring loom, that was fiddled with, while changing the thermostat...I hear they can become brittle over time, and so behave as if the sensor is unplugged, i guess.... Do these wires unplug anywhere in there so I can test the loom properly?
View 2 Replies
I have a 2006 camry xle v6 and recently my wife got a oil change and after a week the maint.required light stays on how do you reset this they must have forgot?
View 1 Replies
I would assume that my sensor needs replacement. What it takes to access the sensor? Where is it exactly located before I start ripping apart everything.
View 4 Replies