I just installed my new coilovers and I have a weird clunking noise coming from the front passenger side. I havent had to time take the wheel off yet, what the problem is.
View 4 RepliesOrdered my TBE couple of weeks ago, installed last week. I have been running the 100 octane tune for an entire week. Decided a couple of days ago to put it back to stock to see the difference. When I was running the 100 oct, I was pretty much on it the whole time. When I went back to stock I noticed some heat shield noise so I took it back to have them take a look. While on the lift I noticed a lot of soot in three different places.
View 19 RepliesRecently had an aftermarket turbo back exhaust system installed. After driving for a short while, I noticed that between 2500 and 3500 RPMs the noise was very loud. Once I hit the highway (in which the engine almost exclusively hangs around those numbers), it was almost unbearable to sit in the car while having that constant droning sound. I have had and been in cars with aftermarket exhaust systems before and never heard anything quite like this. It is pretty tame below 2500 and once you hit 4000, it sounds quite nice and that horrible drone goes away. I really trust the shop that did the work, so I doubt it was faulty install. Could it be a faulty design or maybe just the one that I received?
This exhaust is from a reputable maker and they designed this system specifically for the Golf R. I did have some other mods done at the same time (Coilovers, Engine Mount Insert, Intake and a Tune). I know the insert may cause a little bit of vibration and hence a little bit of extra noise, but nothing like this. While driving on the highway at 3000 RPMs, I cannot even clearly see the cars behind me through the rear windshield as there is so much vibration from all the noise.
Forgot to mention, this TBE is resonated with a CAT, so even more reason for concern. Would expect it to be quiet by comparison to a CAT-less non-resonated system
I'm getting a clunking noise when i let off the gas immediately when the motor is under kind of a load, for example I'll give it a decent amount of throttle at around 2k-3k lets say and then let off fast and it'll make a CLUNK sound, kinda sounds like metal.almost kind of an axle sound...a lot of movement from the motor also. I am assuming it's motor mounts? I just did a stg2 bfi dogbone little while ago.
View 7 RepliesSo I recently installed a GTI sway bar on my 2010 TDi and was getting a clunking noise. I assumed that it would be the subframe making noise since I've read a lot about that but the sway bar is actually rubbing on the front portion of subframe (the part that bolts to the frame directly above the A-arm). It's hardly touching it but its enough to wear into the bar.
View 4 RepliesAfter doing reading I think my issue might be suspension related. Whenever I engage the clutch at a normal rate I get a rubbing/clunking noise coming from the driver side. I can feel it thru the gas pedal and it sounds like a card in a bicycles spokes. If I engage the clutch extremely lightly I don't get the noise at all. This only happened AFTER I had my H&R Sport Springs installed. Could it be a strut mount? Engine Mount? The car only has 4500 miles on it. I'm extremely confused.
View 4 RepliesIve had a weird annoying clunking noise coming from the front of my car going very slowly you can hear it or just by sitting still turning the wheel. It also appears while braking a clunking noise as the weight shifts.I replaced all control arm bushing, cv joints, and ball joints. The only other thing I could imagine is tie rods so I got under the car and had my gf turn the wheel its not coming from the outer tie rod ends but towards the middle? I am curious if maybe its some time of bushing towards the middle.
View 6 RepliesSo I installed the DG springs today, and it should've been a simple install. Well once all was said and done I took it for a test drive. Every time I go over a bump I hear a loud clunking noise, like somethings loose. What it could be? I'm pretty sure I tightened everything.
View 10 RepliesClunking and grinding coming out of the front especially when i turn the front wheels even in neutral gears ? Really bad noise,all gears go in fine!! even when i drive strait with no gears u feel that clunking noise.
View 1 RepliesAt low speed driving and hitting a small bump I hear a clunking noise in the front on both sides. But when driving at faster speeds and hitting a bump it makes no noise at all. I can't seem to figure out what it is.
View 5 RepliesLately when shifting gears, there's this clunking noise as I let off the clutch. It happens more often than not when I'm in traffic and I upshift without giving any gas on the clutch release. Currently got 13k km on my car.
View 1 RepliesThere is a clunking noise coming from the rear of the car. Not a metal on metal sound. Sounds like its more on the passengers side. I replaced the swaybar linkage ends since they were a little loose and thought it was that. Nope...I have H&R coilovers, they are about 5 years old. Can't imagine they be shot this soon. Had someone drive my car while i was behind the R and the rear wheels aren't dancing at all, a common sign of a blown shock. Push down on the car, shocks still respond like they did from day one. I've put the car up on a lift, both sitting and wheels dangling. With the wheels dangling, I grabbed onto the shocks to see if there was any play in the upper shock mounts, solid. Looked under the whole car for loose plastic covers. Can not see anything loose. I made sure everything inside the hatch, including the battery is sitting snug.
The clunk happens over bumps, with or without the brakes on and is loud enough that if the radio is on, it can still be heard.
I am trying to find origin of clunking noise, but it is difficult to do as there is no visual signs and no excessive movements in any components.
Little bit of details and video. Noise occurs when moving rapidly steering wheel on stationary car with running engine. Not noticeable when at speed. Wheel is not vibrating and cv joints not clicking. Very tiny free movement in steering wheel about 1mm, but I am not sure if that is related maybe a completely different issue there. Mot tester make an advisory note that steering system slightly rough, but its not that useful to find an issue.
[URL] ....
I've been having a problem with a popping/clicking sound coming from my front end for some time now. 2 days ago I replaced the top strut mounts thinking they were worn and this was the source of my problem, however, the noise persists.I have raised the car and have tried to physically move the wheels, up, down, left, right, but I get no play in any direction.
When the sound happens: If I go over small bumps in the road, or depressions, or speed bumps at slow speed I hear what sounds like a metal on metal sound, but muffled, not a clang, but a pop sound. I can induce it by stepping hard on the brakes, as the car lurches forward I get the sound. After stopping, when the weight moves back again I get the sound again.HOWEVER, I do NOT get the sound from acceleration. I have tried putting on the parking break and trying to take off, but I don't get the sound. The sound is their wether or not I'm in gear.
What could this sound be? My possibilities include:T ie-Rods, Axles, Transmission (loose bolts), broken engine mounts, loose subframe, or perhaps my control arm bushings (but they were replaced with poly bushings about 30k miles ago)
I am experiencing a bad clunking noise when going over bumps. Its comming from the passenger rear and I am assuming the springs collapsed. How can i tell for sure? The car is sitting a little lower on the corner. Is it bad to drive the car with the spring in this condition?
View 8 RepliesOk so im going to try my best to explain this. Last week my passenger side motor mount broke the bolt snapped off and my engine fell on the ground and cracked the oil pan, too make a long story short someone put the wrong bolt in it and I fixed it with the right bolt. When the engine fell and the pan cracked i immediately shut the car off and coasted to the side of the road. I checked all bolts on the car to see if anything was loose but nothing was. But now when i start to take off i hear a clunk from the front end and i do not know what it is or could be. It is not the axles there is two brand new ones in it and have been checked. What it could be?
Car is a 2002 MK4 Jetta Wagon 2.0 .....
What I have happening is clunking that can be felt in the pedals and dead pedal at random time. Bad vibration can be felt through the cabin but this is hard to quantify since I already had VF mounts, I'm lowered on PSS9's, have camber plates, etc etc. It just seems to me that the vibration has gotten worse than the "normal" vibration these mods would introduce. Whirring/rotational noise that comes and goes and seems to be right in front of the the driver's seat. It also sometimes seems to go away if I am cruising down the road and I push the clutch in.
Crunching noise (almost like a CV joint which is shot) but this noise appears randomly at various speeds and when driving straight. All of this is pointing me more and more towards a tranny problem which is not what I want to hear but I also don't want to keep driving my car without knowing what is wrong with it. One note is I did install the trans shim, replaced black cap on end of trans in Feb and didn't notice anything out of the ordinary at that time
I have pulled the driver's axle 3 times in the last month and can find nothing wrong with it. I have pulled the suspension apart on the entire front end and found/see nothing. I have pulled, twisted, shaken, etc everything looking for bad or worn parts/bushings and can find nothing.
How to diagnose this creaking/clunking noise in my 03 Jetta TDI. It's only coming from the passenger side, and I primarily notice it at low speed on relatively uneven roads. I can replicate the noise by pushing up and down on the front passenger side corner.
For context, this started after I just recently replaced my front and rear suspension, plus some steering parts. I replace all four struts with Koni yellows, front CA bushings (with R32/TT), ball joints, tie rod ends, front strut bushings and bearings, and passenger side CV axle. In response to the noise, I also just did the front sway bar bushings, which definitely needed it, but didn't change the noise. I also removed the CV axle and re-greased the inner CV joint--to no avail.
Also, when I have the hood open and push up and down on the front of the car, I can see the cup where the top strut nut goes into will go up and down separate and apart from the body. The driver's side stays in line with the body when I try to the same on that side. Also, that cup is tight on the passenger side, whereas it will spin fairly freely on the drivers side. So, this has lead me to think that perhaps I didn't torque either or both of the top or inner strut nuts on the passenger side.
Here's a (fairly crappy) video of the noise/strut cup .....
I'm getting this weird sound when i turn on my car and turn the steering wheel left and right not even a full lock just left and right really quickly or slow there is this annoying clunking coming form both of the front wheels atleast thats what i think it is and it feels as something is loose but i checked most of the bolts.. Recently i changed my front wheel bearings inner cv and outer cv joints on both front wheels.. i changed my ball joints and tie rods everything was change within a 4-5months..
Also the other day as i was driving and i could only hear this 20mph and up this weird clunking and vibration in the floor.. no vibration in the steering wheel just the floor and clunking sound.. i know for a fact i need an alignment and possibly new tires.. but what would the clunking be coming form when driving or just parked in place while moving the steering wheel...
Ok this is for a buddy. He has been getting a weird noise from his drivers side wheel the last two days. The noise does not happen all the time. It usually happens when he goes over bumps. We went ahead and took the wheel off tonight (it was super dark and we couldn't really see) and the clunking is not the strut or sway. With the wheel off we would grab the rotor and move it forward and back (like the wheel is turning) and we get a clunking noise up the axle. Almost like it was loose at the tranny but we could not see. Wouldn't move/clunk much but you could hear it. What this could be?
View 8 RepliesSo i had air-ride installed into my R 2 weeks ago and lately, i've noticed a knocking/thud noise coming from the front wheel well almost. I feel it more at low speeds and when applying the brakes to come to a stop.
View 4 Replies