Experienced a chatter in the clutch pedal with the a/c on when clutch pedal is pushed in. To me it feels like the throw bearing isn't disengaging the clutch fully, plus my clutch is kind of high once full disengage unless its normal.
View 5 RepliesMy clutch has been feeling very strange lately, and has had a mind of its own. I have looked underneath myself, and have even taken it in to two transmission speacialists and they can't figure it out. The master cylinder isn't leaking, and the slave cylinder is fine as well.
Here's what is going on with my clutch...
- I will push in the pedal, and there will be ZERO resistance until about 1 inch from hitting the floor, then all the pressure is there, and I am able to shift. However, sometimes I won't even be able to put it into gear because the clutch won't engage.
- Then I will pump the pedal, and slowly I will gain a little more room on the draw of the clutch, and it will feel fine. All the way to the point where a few days later it will be driving like new.
- Then it will start feeling funky again a few days later and the cycle starts over.
I drive a 2003 GTI 20th AE.
I have a 2007 Tacoma 4 cylinder 5 speed. The clutch pedal started sticking about a month ago and has only happened a hand full of times. When the pedal is pushed to the floor it would stick, I thought it was hanging up on the floor mat at first but that was not the case. I went out to move the truck today and the pedal immediately stuck to the floor. Like usual I tapped the pedal kind of on the side to get it to release. the pedal then came back up. But now it wont push back in at all!!! There is only 1/2" of travel on the pedal and stops solid. It's like it is binding up on something. The spring seems to be in place the right way and nothing that I can see obviously wrong.
View 4 Replies1988 Acura Legend, 2.7L 6 cyl., 181,000 miles only do 6,500 miles a year to train station, parked inside, runs great. Last week parked out in hot sun, '90s, for 8 hours. At first, no problem. When did errand and returned to car, pushed clutch pedal and it would not return or allow gear to engage. "Jammed" into 1st, then could not shift, shifted slightly by pulling up on clutch pedal with my foot. Parked overnight, cool, next morning seemed to be fine and crept to mechanic. Mechanic road tested and found no problem and now seems to be working okay. Would parking in sun, high heat cause "clutch cylinder" to "seize" or "freeze"? Is there a "fix"? Also, increasingly hard to get parts for this car.
View 6 RepliesMy first VW was '99 Jetta that had 150xxx miles on the original clutch before it was stolen in '11. I leased a GTI shortly after, and decided to buy it out last year. At 35,000 miles I am starting to get I guess what I would describe as a chatter when slipping the clutch into first and sometimes second. Car is stock, never abused. I tried to reproduce this for a video clip but the problem is sporadic. Never had a clutch go on me so I don't know what to expect, but from what I've seen of people losing their stock clutches after ecu flashes is the car slipping under wot in top gear. I don't have that issue. No other symptoms. No stubborn shifts or anything, clutch still feels the same and rpm's have never flared up on shifts.
View 5 RepliesMy car has a knocking icking noise all the time, I think it is clutch chatter, but not fully sure. This is a 6MT 2011 GTI. It is annoying, but if you turn the radio up.... The annoying sound goes away....
View 4 RepliesSounds actually quieted down and my mechanic is thinking its more the alternator pulley.
View 5 RepliesI have a 2010 5-speed Golf 2.5L. Around 2 months ago after coming back from vacation, i noticed that when shift from 1st to 2nd and from 2nd to 3rd, there is horrible chatter/vibration coming from i assume the clutch/tranny. its been getting progressively worse and its at a point where i can hear the spare change rattle in the cup holder. the car had been sitting for a month, and i sort of "broke it in again" when i got back from vacation, not revving over 3 on the first tank, not over 4 on the second. It does have 100k kms on it, solid mix of highway and city. Is this something easily fixable, i dont have a warranty so i'd have to go aftermarket. Not down to pay two arms and 3 legs for something that could put me back in this situation yet again. if its the clutch id just go aftermarket with something a lot better, or if its the tranny id put a 6 speed in it, really lacking on the highway i believe. Or maybe it's something else.
View 7 RepliesI have 3.8k miles on my GTI, and recently started noticing this clutch chatter when my car is at a stop in neutral with the clutch engaged (pedal out). It goes away when the clutch is disengaged (pedal in). I'm not sure if the noise has always been there or not, but now that I hear it, it's really bothering me.
It doesn't affect driveability, and seems to disappear once the car gets moving. And it's usually not too bad, BUT sometimes the clutch engages in such a way that I get the rattle like in the second video. This is really the noise that makes me nervous. Does this sound like typical clutch chatter or do I possibly have a bad DMF and/or throw out bearing?
Car was taken to dealer today 3/7/14 and a new throw out bearing was ordered. I inquired about the possibility of it being a flywheel issue, and was told they wouldn't know that until they get into the transmission. So for now, car is schedule to have the throw out bearing replaced under warranty next week.
I installed a new clutch, pressure plate, and flywheel at 154,000 and I'm now just over 155,000. I drove it very conservatively for at least 1,000 miles, and had no issues whatsoever.
Now, after sitting for a day, starting off in first gear, I'll get some clutch chatter. Outside of first starting out in 1st, every other gear is solid. And the 1st gear chatter tends to get better as the car is driven longer.
Secondly, it happened today, I'm getting what I thought I experienced before as clutch slippage in 5th gear: I'll lose acceleration as if the clutch is slipping, but the revs won't spike even if I tap the throttle. If I come off for a second and go back on, everything is fine. It doesn't make sense that's it's slipping as it's brand news.
It also seems to happen when it's been rainy or wet, but that could be all in my head.
When pulling away casually in 1st from a stop, I hear a slight chatter noise. Had this since before the tune (stage 1). Almost like the sound a diesel makes at idle but only lasts a second or two. To the best of my knowledge it is an OEM clutch. Had 9k miles when I bought it, now has 25k.
View 24 RepliesAbout 2-3 months ago I noticed that whenever I would push the clutch in and let the revs drop, they would drop below the 800 rpm mark and the car would automatically rev them back up to prevent from stalling. This usually happens when I am slowing to come to a stop, like coming down an off-ramp or to a stop light. Then one night after a 45 minute steady speed highway drive, I pushed the clutch in, shifted to neutral and let the clutch out and coasted to a stop. As the revs dropped, the engine stalled completely and the red alternator warning light came on. While still rolling on the highway, I pushed and held the start/stop button and it immediately started back up.
Over the last 6 weeks, this has become more frequently. It is now at a point where the revs will pretty much always drop below 800 rpm when I slow down and the car usually revs them back. However, I have had six more stall episodes like the one above and it is starting to scare me about driving. I find myself revving the engine when I coast in neutral to slow down to prevent this from happening. This happens either with the clutch depressed and gear engaged and slowing or clutch out and in neutral gear.
The car has never had issues. I am the sole owner. Just coming up on 30,000 miles. I currently have UM tune stage 2, EVOMS intake, APR HPFP, 42DD downpipe with stock cat-back exhaust, HPA short shifter with metal cable bushings, Stoptech Street rotors and pads, VWR springs and RSR clutch, which was installed at about 22,000 miles one year ago. Have serviced it religiously, oil changes every 5,000 miles, did the water pump recall and had no issues thus far.
I moved from high-elevation Utah to New Hampshire last summer. The tune and calibration were all done in Utah prior to the move. These symptoms/issues beginning and getting worse coincided with the cold winter and lots of snow were are having. Could that and the tune having been calibrated at another elevation have anything to do with this?
When I have the clutch depressed and start to let out as I'm either in reverse or in first gear it makes a clatter/chatter noise. It also occurs when I have the clutch depressed and just rev the engine and it's in neutral. Some days it's louder than others. It doesn't matter if the engine is cool or at normal temp.
View 7 RepliesMy car is making an odd grinding noise when im turning under acceleration. I can only hear it at low speeds but it may be doing it at higher speeds and i just cant hear it.
The noise happens when I am turning both left and right and only when accelerating and seems to dissipate as I pick up speed or change from turning to going straight.
Car has 100k miles on it and don't think the clutch has been replaced.
Car is an all stock b5.5 wagon v6 30v 5 speed.
Getting a slight FW chatter on stock clutch setup (02M)? I've noticed it for a while...most of the time I don't notice it, but other times I will be sitting in the drive-through and it will chatter. Goes away when the clutch is depressed.
View 17 RepliesI've been noticing that when I step on it some times my clutch pedal seems to get stiff and if I press on it a couple times its normal again. This has been going on for awhile now and I've just been driving it normal but when I do decide to get on it then the pedal will get stiff..
View 4 RepliesCan switch out the R's clutch pedal for the Audi R8? Was in an Audi showroom yesterday and there was an R8, and it was actually open. It was manual and the clutch placement was perfect, way better than the R. I've got short legs, but the R8's reach was great. The R is a bit long for me.
I know that there is compatibility across Audi/VW platforms, but I'm not sure of the R8. The TT is compatible for sure but I don't know if the clutch pedal is the same or not.
Just as the title states. When I put the AC on in the car my clutch pedal gets some play in it, enough that it messes up shifting and gets jerky. I tried searching, but no results
View 14 RepliesOk so I took my R out to look track to get some 1/4mile passes in. Didn't do anything out of the norm. Took my first pass and noticed that much clutch pedal wasn't feeling right. It wasn't grabbing like it usually does, it was grabbing close to the floor. I took it out of gear and pumped the clutch peddle a few times and then it grabbed like it normally would. I've never had something like this happen in any of my VWs or any other car. What may have happened? I was thinking maybe a slave cylinder issue?
View 7 RepliesI have an 04 Gli with 85000 miles on it. I just had the clutch done with a conversion from a dual mass to a single. When the car is idling there is some chatter coming from the tranny but it stops once i press the clutch.
View 3 Replies92 Celica at speeds of 35 or less brakes feel fine. At higher speeds the pedal sorta chatters with light pressure. If I press harder the pedal is smooth. Is this warped rotors or possibly something loose in the assembly? The car does not pull to either side the brake pedal just vibrates under light pressure at higher stopping speeds.
If it is a warped rotor will I be able to check for it with a mic or caliper? I do not have a dial indicator to check run in or run out. I do use a good machine shop with an machinist that I trust, but I would rather not pull rotors unless I have to.
Now I know this is not just tired mechanic syndrome and is a real problem with the car.