Golf V R32 :: Start Then Going To Stall - Revs Don't Climb Very High At All
Apr 25, 2014
I posted awhile back about my R not wanting to start. It will start, just not turn over right away, but it will start the first time. However, it feels like it's going to stall out because the revs don't climb very high at all (1k at best) when it usually goes just over 1k to start, then drops down to 5-600rpms.
Yesterday, after it sat in the hot sun for nearly 3 hours, it cranked but didn't start right away. It had started right up when I left my house to go to the gym, and I drove it 5 miles to the gym.
Then again, this morning, after it had been sitting outside all night, I went to start it and it just didn't sound right when it started, like maybe fuel wasn't getting to the engine.
The car has 31,500 miles on it, has had all recalls done, and the battery checked out last month. The battery was fine, so it's not the problem. I have been doing some research on this issue, and have come up with the following things to have the dealer check:
-fuel pump
-fuel pump relay
-coil packs
-crank position sensor
-fuel pump fuse
-fuel filter
-injectors
-alternator
-starter motor
-crank angle sensor
-cam sensor
-check all grounds
-check fuses
And to top it off, I just drove it down the road and the sunroof randomly opened on its own. I have never had that happen before! Do you think the two are related at all? I'm just wanting to make sure what to tell the dealer when I drop it off later this afternoon. I ran a vag-com scan last night and there were no electrical or engine fault codes found, so I don't know what is up with it.
View 13 Replies
Advertisement
My GTI is the first FWD car I've had since 1985, so the issue that I'm having may be just me adapting to a front drive platform. Here's what's happening: when I nail the throttle in 3rd or 4th gear, on or about 4K rpm or above, the car feels as if it's hesitating slightly as the revs climb.
It accelerates fiercely (I have the JB1, and I had the Neuspeed Power Module before it, and it's reacted the same way with each mod), and it's almost as if the front end of the car is lifting and struggling for traction (although the traction control light doesn't come on).
Is what I'm experiencing normal FWD behavior? Is it the beginning of torque steer? I only notice this at full throttle--not noticeable at all at partial throttle. Also, it doesn't happen consistently. My car is a performance package manual.
View 21 Replies
I bought this car and I've changed out the Clutch Position Sensor, the black one on the clutch mount. Started to work and start but now it's doing the same symptoms as before. So here is what is going on.
1. Randomly doesn't start, full power comes on, and fuel system turns on, immobilizer works just fine as far as I can tell (key light turns off)
2. Cruise control doesn't work (which lead me to the CPS)
3. High revs between shift, once I push the clutch to shift it revs up high, I noticed that if I stay under 3k it doesn't do it as much, but if I go HAM on it it revs up about 1k rpm more than at shift point. But if I shift nice it revs about 2-400 rpm.
It's been tuned by C2 Motorsports, done by a certified mechanic, that's the only mod on the car, besides suspension. I bought the car and dropped 1100 to fix it to drive right, newish throttle body, and a major vacuum hose, and the tune within a month of getting the car and the tune was to mainly flash the ecu so it wouldn't pull two codes for a leak that wasn't there anymore.
View 5 Replies
When I rev my engine while the car is parked or stopped in neutral it revs up like normal. If I am cruising down the road and drop it into neutral and try to rev up the motor its sluggish and the rpms don't want to climb as quickly.
View 14 Replies
I've noticed something new on my R32 recently. If I let the car sit in neutral with the motor on it's rpms will start to climb slowly. Normally it idles at around 800 rpm but when this happens it will climb to around 1200 rpm and stay there. Usually it takes a couple of minutes but you can slowly see the tach climbing. Also, you can feel the engine slowly revving as well (can hear it).
Now this doesn't happen all the time. I've only experienced it a few times in the past couple of weeks and only seems to happen if the car has been sitting idle with the motor on for at least 10 minutes (it happens when I've been at sonic waiting for an order). I can bring the rpms back to normal if I rev the car up to around 3.5k and let the motor settle back down to idle. What is causing this?
View 1 Replies
Shifting especially at high revs. The noise also seems to happen when shifting to gears 2,3 and 4; not so much 5 & 6. What is the cause?
View 6 Replies
My car now vibrates when slowing down and it only happens between 2-2.5k rpms! Also now the car has been idling higher at a standstill. The car will be fine then it will rev up to 1k.
View 6 Replies
I have a 2005 GTI 1.8T with 203K miles, stock except for a MagnaFlow exhaust. My problem arose about a month ago. When I accelerate aggressively and shift from 4th gear to fifth at about 4K RPMs the engine will jump up to 5K RPMs. Happens while shifting from any gear when accelerating hard.
When I push down on the clutch and take my foot off the gas, I get a jump in RPMs. It's kind of like the boost in the turbo is not getting released. I replaced the stock diverter valve with a Forge DV with the splitter. Had no effect on my problem, but now I have that cool sound when I get off the gas.
Could this be the waste gate on the turbo not opening and releasing the boost when I get off the gas? I'm not very familiar with the intricacies of the Turbo functions and the diverter valve.
View 7 Replies
2003 Escape Limited V6 Auto 4x4 ... I am having issues with poor fuel milage and starting the SUV...
When i go to start the truck it winds over for abit then starts and revs really high?!?!? I did a complete tuneup, plugs, filter, fuel filter, oil and filter... I changed the fuel pump which has the fuel regulator built into it. I have no codes on the dash. Also if i am at a red light and i put it to the floor I MEAN TO THE FLOOR!!! the truck bogs then drives off NO POWER!!!
Im stumped! I dont know what to do and dont want to keep replacing expensive parts... fuel pump, etc...
View 14 Replies
I have 95 ranger 3.0L revs up over 2000rpm at startup then comes down slowly to a little over 1000... Changed the IAC valve still does it... When I let it warm up I unplug the IAC and idles normal and smooth about 750 RPM so I don't think it's a vac leak... What else could it be???
View 5 Replies
I have a 2005 Camry and it was stalling while driving occasionally. It had gotten worse, so I cleaned the throttle body as was suggested. Now, when I try to start it, the engine revs really high then goes back down and dies. This is without putting any pressure on the accelerator. What to do next?
View 1 Replies
So my story starts simple enough; I ran out of gas in my buddy's car, filled it back up, it finally started but ran like >poop< for the first 10 min or so. Finally after coaxing for 10-15 min, she stays coming around. After 30 min or so of driving, I could drive her all I wanted, so long as I didn't let it idle below 12-1500 rpm. If I did that, she'd kill, and stall out. Well I drove her the other day for most the day and it seemed the kinks were worked out. So today when I tried to drive her round the block for a final check, she up and dies, and hasn't started since. I've replaced the fuel filter, checked the intake, and dropped a can of sea foam in to the tank to boot, but no dice.Signs and symptoms seem to mimic a bad mass air flow sensor or possibly a clogged catalytic converter, with the exception that it only shudders and acts congested on low rpm's and doesn't choke out at high revs.
View 15 Replies
My auto transmission is sticky at times. This usually happens after an hour of driving doesn't happen all the time. The gears start to change at high Rpms like 5 to 6k. It's real annoying. Otherwise the tranny is very smooth , like butter . Shifts into all gears.
View 2 Replies
I have a MT '12 Golf 2.5L with around 8k miles. I always park with the transmission in neutral. When I first start it up in the morning, the engine revs high, around 1500RPM, so I can clearly hear the engine inside the car. I start it, it revs up and holds, and when I release the clutch I hear what sounds like a rev, but the tach doesn't move.
I believe the GTI doesn't need the clutch depressed for the entire turn over, but the Golf does, so I have to hold it until the engine is running. It may not be a big deal, but I'm just wondering why releasing the clutch in neutral would make a noise. I don't hear it any other time than at start up.
View 1 Replies
My wife has a 1998 Windstar 3.0
Prior to going out yesterday, I noticed that the van seemed kind of 'jumpy' when idling - the timing was a bit sticky and inconsistent and kept seeming to try and right itself. I stuck the accelerator down and it ran perfect when it was getting gas but started 'stagering' again when I took it off.
So my wife went out to walmart - a 30 min drive (we are in the country) - and all was good till she was turning the corner into the parking lot and the engine stalled. It was your standard stall - power steering went out but all other electrics kept going etc etc.
She sat there for a minute - put it in park - then fired it right back up again. After running into walmart, she just drove home as fast as possible to reduce the length of time it had to happen again.....
So while there are, Im sure, a plethora of possible issues - I was wondering about the IAC value? How could that be responsible for the parking lot though - doesn't it only act when the car is stationary?
The sort of thing was happening about 3 months ago, and I ran seafoam through the fuel - which seemed to work for a while.
View 9 Replies
I have a 2000 Toyota Celica GT-S.
When ever it is idleing and i hit the gas it bogs like its going to stall but then revs up. Difficult to get out of first because of the bog might stall it. My check engine light came on and it said rich fuel as well as oxygen sensor. Do the oxygen sensor would cause this because their are 2 and are expensive if I change it and turns out not to be the prob.
View 14 Replies
My parents are having trouble with there 2008 Santa fe 3.3 L. The transmission won't shift and the rpm's climb really high. Does that mean the transmission is going or is it something else.
View 15 Replies
What's going on with my '93 240. When I first go out to start my car in the morning, it starts up fine. After that, however, is when the trouble begins. If it's hot out, or if I've driven the car that day, there's a 50% I'll have trouble keeping the engine running. The engine will run rich, and chugs on startup, eventually stalling out after a few revolutions. During this time, the engine revs low, don't have a tac so I can't say how low, but definitely below idle.
If hold the accelerator to increase the RPM, the engine will run fine, but once I let off the gas, chances are it will stall out again. Eventually, after doing this a few times, something seems to catch the car as it begins to stall again, as in, just before the car is about to stall, the idle speed kicks up to normal. After that, the car runs fine.
I've had a code for the MAF for a long time. I tested the resistance across the meter, and it indicates the wire is still good. Even at that, I've replaced the MAF, but nothing has changed. Still have the same problem. What could be causing this?
View 1 Replies
My mechanic and friend noticed my axle was starting to fail about a few weeks ago and Ive just been waiting to get it taken care of when I have time. Last night my battery died and I got a jump start. After the jump I get in and drive down the street a little ways and notice the ESP light came on. She was also running a little rough at idle and I started getting nervous. So instead of getting my Micky Dees I turned around and went home. Of coarse this happens at 3am the night before I have to open up at work at 11.. This mourning I get in the car and warm her up to see how shes acting. I decided to still drive her because I had no other option. The MIL light popped on now too and I think its related to my axle failing. So im wondering I guess how much longer I have til this thing completely goes and what would happen if it went while I was driving? Ive never had to replace an axle before or and an issue with one so this is a subject I know very little about. Also is it worth it to get RAXLES for stock?
So after my battery died like I said I got a jump start from my buddy and after I jumped it the car seems to rev at idle now. Freaked me out! Would all the sudden start revving to 2k rpm and then stop. When I drove it to work almost every time I stopped it would rev a little bit but when I gas it it would stop. After doing research there are a few conclusions I have reached. First I read it could be a throttle body sticking? Then I read the jump start could have fried my ecu or it could be a simple as a loose wire to the motor from a bypass valve?
Im not sure if the jump start did anything bad. Its possible its a coincidence still but my car was fine before the jump. Also on a side note my ecu was already flashed when I purchased the car. The flash is from EIP I believe because there is a eip sticker on the battery case. Personally I think the MIL light is related to the axle but the weird idling is what scares me.
View 8 Replies
Happened Friday as I was pulling into the garage. Tried to re-start, would turn over, chugged a bit and back off it went. Had it towed Sat morning. Haven't heard anything back yet...cant be battery, had juice...just 4900 miles on her.
View 9 Replies
It is pretty common knowledge that when we start our cars they initially rev to ~1200rpm for a minute or two and slowly drop down to just below 800rpm. I generally use this as the "warmup" time for the car and try not to drive until the rpms drop. But lately in this cooler weather (<20F) when I start my car the revs do not go to 1200rpm, they start right around 800rpm and don't fluctuate. Why this might be happening?
Last winter I did not pay attention to the revs so I can't confirm or deny that this happened before. But I do notice it only in cooler temps. If it is much above 30F the car will start like normal.
Only engine mods are APR stage 1+; VWR intake and APR HPFP.
View 13 Replies