I've had my .:R for a while now, gotten used to its little quirks. But one thing that sparks my interest (not really worrisome though) is I have a squeaking noise when the starter motor engages. It definitely squeaks once per revolution for about 4-5 sqeaks, and it's noticeable in and out of the car. Is it a bearing going bad?
View 5 RepliesCar doesn't seem to want to start when warm.
1.8T AWD, 02J swap, no clutch switch (I can start without pressing the clutch).
Cold start, cranks and starts on a dime, after the car warms up and I've turned off the car, say went for a quick grocery run, the car won't start afterwards.
No cranking, nothing. Fuel pump primes, then not a sound. Everything on the dash lights up just fine. No starter motor noise, no clicking.... nada...
Fairly new starter motor pulled from a junkyard donor. Can't think of anything else.
Last time I got stranded in a parking lot, I gave it a few whacks with a tire iron and the car started just fine. Could it be a bad solenoid?
1998 f250 4.6 4x4. In park the starter engages with key on . Ounce running the starter is still engaged in park and neutral. No engagement in the drive gears. Changed the ignition switch and neutral safety switch on the trans. When key is off instrument cluster is still on.
View 3 RepliesMy starter motor in my 2004 Golf 2.0 doesn't engage or spin when it is very cold. By very cold, I mean below 5F.
The battery has plenty of juice, and jumping the battery doesn't work. I turn the key to "start" and nothing happens. When key is in the on position, fans, wipers, etc all work fine. When the car warms up to 20F or so, everything is fine and the car starts.
Here's the funny thing. If I put a little space heater on the driver side floor to warm up the fuse and relay panel, it starts with no issue.
I don't know enough about the interlocks between load reduction, starter motor, ignition switch etc to make a good guess as to which relay (if any) may stick in extreme cold. It's a tough problem to diagnose, because I can only experiment when it gets REALLY cold, when it isn't very fun to experiment anyway. I don't think it's the piggy back harness, because the wipers, horn and fan all work.
Had the Ex (2000 Limited V10 134K) about a month now, doing some reading in the FTE, saw the thread about wire chaffing in the steering column related to the gear shift selector and overdrive. Well, everything else has been chaffed on this truck so far I figured I better look at that too. They are chaffed right at the bottom of the base of the selector, not much wire to work with, might just replace.
I put everything back together and no issues. The next morning, I drove it and no issues until at work, put it in reverse (to park next to the bosses pretty new red Titan, picked that up from You Might Drive and Ex If) and the starter engaged. Got it parked, starter playing with switches for it to repeat, found that with the keys in my hand and turning on the headlight switch on (park or headlight position) the engine would start turning over, turn the key on and the headlights on and the EX starts, started stayed engaged until headlights are turned back off. Reverse only engaged the starter when the engine was running, when not running neutral safety switch kicked in telling me it works.
Searches had me reading in other in another place that there are wires that go from the headlight switch to the steering column specifically heavier guage blue wire with red or pink stripe "I think".
So last night I took the column covers back off and started chasing wires. As I was moving wires looking for the short I kept turning the light switch on and off as I wanted to know if and when I found the short. Evidently, I found it because the headlight switch and reverse stopped engaging the starter. I never did find the actual short. So the chipmunk has been chased from my wood pile but for how long?
I left everything in the column until the problem went away so to speak. I took the turn signal selector out inspected both connectors and wires and went about 6 inches back into the wiring harness, I found nothing, the turn signal selector had no impact on the started engaging.
For the past year I have had intermittent start issues with my LS that occur about 15 percent of the time. Ambient or engine temperature do not make a difference. Sometimes the starter engages but then disengages right away. I then need to depress the start button an additional time or two before it actually starts. At other times the starter engages and continues cranking while the engine sounds like it is trying to start (like it is just barely keeping ahead of the starter speed). That carries on for several seconds and then it starts. Nothing shows on diagnostics and the dealer says I am going to have to wait until there is a complete "no start" before they can trouble shoot. There was a similar issue with earlier 460 models but the Lexus service tech said that problem does not apply to the 2011's. It seems there is a lack of fuel delivery but from what point? And why only intermittent and momentary?
View 6 RepliesMy 2008 F150 5.4l SCrew wouldn't start this evening. The engine turns over and the starter engages, but it won't fire. Oddly enough the starter stays engaged after I take my hand off the ignition! I have to physically turn the key off for it to quit (didn't want to burn out the starter). The culprit may be the wet weather....it's been a lot milder today and we've had some freezing rain that turned to drizzle. My truck has only done this once before (last year I think). I eventually got it to start tho.
View 13 RepliesDuring the cold snap over the last few months, my 1997 Toyota 4Runner has been having starting problems with the following symptoms in this order:
I turn the key and nothing happens.
I keep turning the key from off to start, and the starter eventually engages and cranks 2 or 3 times, but the engine does not turn over.
I keep trying and the starter engages and keeps cranking even after I turn the key off.
I panic, and turn the key on and off until the starter stops cranking.
I try a few more times and the starter cranks and the engine catches, but lugs until I pump a little gas.
Really weird thing. Occasionally, after the above sequence, the emergency brake light stays on even though the brake handle has been disengaged, and it feels like I have no power, then the light goes out and the car runs just fine.
The problem in intermittent. Cold seems to cause it although it doesn't cause it every time. Rain may be a factor as well. Sometimes, I only have to turn the key a few times, and then the starter will engage. I changed the battery after the trouble began, and it cranks well if and when the starter engages.
Up until this I have not had a day's trouble with this vehicle other than a little belt squeaking.
I have a 2004 to 250 super duty 5.4 and automatic trans it has about 233,000 miles on it. Yesterday when I started my truck I could see my reverse lights were stuck on against the garage door in the dark. After I put the truck in drive the lights went out later on I shift at the truck and to park and the starter engaged I put the truck in neutral and it stopped the starter from running after doing that several times the truck now does it even when it's in reverse or neutral. I have to leave it in drive and push the emergency brake on I am in and out of the truck all day long. I did change the shift to blast may I check the screws on the back of the shift to bury thing seems fine.
View 1 Replies2002 Ford F250 V10 Auto... When I put the transmission into reverse, the starter kicks in...
View 8 RepliesCurrently driving a GTI mk7 autobahn 6MT, this is my first manual transmission i have owned.. and have a question about a squeak like noise i hear when the clutch engages in gear 2 and 3.
This does not happen all the time, however i noticed that some / most of the time when i slowly let the clutch out in gear 2 and 3, right after the clutch engages and i let it out the rest of the way, it makes a squeak kinda sound.. almost like springs contract / retracting, i can also slightly feel it in the pedal.
Question is ...is this some what normal? i have never owned a MT car, and cant remember if such a thing happened while driving friends / family MT in the past..
Pulled 3 starters at the junkyard to replace one that has a bad solenoid. Have a 2002 Buick Regal LS with 3800 series II engine. Found some on 3100 engines and one from a 3800. My starter has about 10 teeth on the gear that engages the flywheel. Some of the ones I pulled had smaller gears with only about 8 teeth.
Why the difference? Also one GM Delco starter was slightly longer (about 1/2 inch) than mine and had a small black hollow tube about 1 inch long at the rear of the starter and at the bottom. It fell off when I touched it. Looks like it might be a drain hole in case some water gets in to the starter. What is this really for?
In a matter of weeks, my truck destroyed two sets of flywheels and starters. When the ignition key engages, the engine "jumps back?. Apparently, this causes the starter and flywheel teeth to grind. My mechanic cannot determine the cause of the "jump back". He thought that it might be the timing. His examination and testing, however, proved the engine properly timed.
View 6 RepliesI have a 02 F250 Super Duty XLT with a triton V8 with a automatic transmission . and when I shift into reverse after driving for a while the starter engages . It does not happen all the time . If i start up the truck and shift through or into reverse it doesn't happen . the only time it happens is when i've been driving for awhile and want to back up or park it will only do it once or twice after each drive so trying to get it to happen while in the shop is almost impossible . could this be caused by the transmission range sensor . I just had the code P0705 (transmission range sensor , A circuit input ) come on but the problem has been happening for a few weeks before that code came up .
View 6 RepliesMy truck was stolen over the weekend. Fortunately, it was recovered but they broke the key lock on the steering column and I'm having a hard time getting it started. I can turn the ignition all the way to the start position with my key or a screwdriver but the starter never engages. I'm sure I'm missing something simple but I can't seem to figure it out. Looking for instructions on how to get this started again?
View 14 RepliesI was driving to work and lost all power (during rush hour) I was able to coast to a exit. Had it towed home, when I turn the key the starter engages but nothing after that, the engine will not turn over. I checked the battery and has a full 12 volts.
I removed the belt and front plugs to see if I could manually turn the engine over but it will not budge. How can I tell if this engine is really locked up or if maybe something else is happening?
3.1 V6 engine .....
i dont know if i can i bring this to VW but the back right wheel squeaks when driving sometimes. Like when i start and just roll forward it has a squeak and sometimes when i break it squeaks. It makes me feel poor hearing it.
View 3 Replies.:R have a faint "squeak squeak" noise directly after shutting down?
View 4 RepliesIf I get in my car to hard or even when I'm in the car and rock back and forth while standing still it sounds like the springs squeak, kind of like a spring bed when getting it on. I don't hear it when I'm driving though.
View 8 RepliesI have an 09 GTI that I bought a few months ago and recently I noticed a rubbery squeaking noise whenever I turn my wheel on the right side. It only happens when I'm going slow and only for a short turn of the wheel both ways. I've tried looking at it with the wheel off but I cannot figure it out for the life of me.
View 1 RepliesSo I have the well known starter grinding noise since I bought the car six months ago. Is there really any danger to the flywheel or the starter itself not fixing this? I don't mean from a purist point of view, of course it's not good. I don't really care about the noise. Does it maybe 1 out of 3 starts in the cold. Are things really getting chewed up, or it's really no big deal.
View 13 Replies