Golf V R32 :: Squeaking Noise From Passenger Side Increase And Decrease With Engine RPM
Feb 7, 2012
Symptoms : You will hear a squeaking noise from the passenger side of the car. It will increase and decrease with engine RPM, and apparently can be heard from inside the car as well. This noise is from the tensioner bearings failing...which, if gone untreated, will then cause the serpentine belt to fail.
If the belt fails, it seems that the battery light will come on, followed by engine coolant temperature spike (overheat).
Bad tensioner sound:
Confirmed failure shortly after this sound:
View 24 Replies
Advertisement
My Santa Fe is doing a pop sound, like a clunk, when I increase or decrease the speed. It is just one time noise every time the speed changes. Like when the "gravity center" changes from the car front to rear or vice-versa.
I notice already that doesn't happen when it's shifting, neither when I go over a speed bump.
It happens in all gears, but is more noticeable up to the 4th gear.
Also, usually I can hear this noise, a little bit lower, when I'm stopped and change the gear from P to R or vice-versa.
My Santa Fe is a 2011 model with 70K kilometres ....
View 18 Replies
Since I got Prius I've noticed that driving at 50mph returns 80+mpg , 90+mpg if I let it gently glide at -1mph per 1 mile. As it gradually slows down, the mileage starts to decrease. By the time I get down to 45 mph the mileage shows around 70mpg,
I get down to 40mph, I'm only getting 50mpg. When I keep my speed between 40 and 45 I get about 52-55 mpg for the day. If I keep my speed between 45 and 50, I get 55-60mpg for the day.
View 19 Replies
The volume control on my stereo stopped working today. The radio turns on, but the volume controls do not increase/decrease the volume. It is stuck at whatever volume it was at before this problem started. When I turn the volume knob, I see the volume level numbers increasing and decreasing in the upper right corner of the touchscreen, but obviously the volume stays put.
2013 Sonata Limited 2.0T
View 17 Replies
Sometimes the volume button on the stereo nor the buttons on the steering button do not increase or decrease the volume. I can turn the stereo on and off - still the same. If I turn the engine off and on - this issue goes away. It's only just started happening in the past few weeks.
View 7 Replies
How do you decrease/increase the sensitivity of the Remote Touch Interface (console-controlled pointer)? I'm really missing the mouse pointer I had on my previous ES, and am sick of overshooting my target in making a selection.
View 8 Replies
Recently my speedometer has been acting wacko...and continues to do so. Two to five minutes into a trip it will slowly increase or decrease in mph's and randomly stop (or continue) as it pleases regardless of how fast or slow I am traveling. Several mechanics checked it and test drove it and no one could figure it out. The devices they used to check the speedometer indicated it was functioning properly.
View 4 Replies
Recently (last three months really), I've been noticing an oscillating squeaking noise coming from the passenger side of the dashboard on my '07 LS460. I've troubleshot the problem and have it isolated to coming on only when the A/C is turned on (recirculated or outside air- doesn't matter). When the A/C is off, the sound goes away.
No other squeaking noises at all coming from anywhere else on the car.
I have a sneaking suspicion it's related to the tensioner belt connected to the Air Conditioner, but I'm honestly not sure at all.
Might this be a more relatively simple belt issue? A/C is running pretty much all the time when the car is on- wouldn't be surprised at all if we've simply worn the belt through.
I found this link outlining a similar problem, but again- I'm not entirely sure I want to go the route of the full tensioner assembly replacement if it's likely just a belt: [URL] ....
View 14 Replies
I have a 2001 Subaru legacy outback station wagon that is making a rotational squeeking/screeching noise from a passenger side wheel (haven't determined which one). I hear the noise when I am going slow, below 20 mph, though I can't tell if it is still making the noise at higher speeds. It stops completely when I apply my brakes. The brakes and tires were replaced within the last 3 months, this noise has been occurring for much longer than that.
View 3 Replies
so yesterday I got out of my car with the engine still running and walked about 3 feet infront of it to open a garage door. All of a sudden a loud whining noise could be heard over the engine. I opened up the hood and could hear that it was coming from the passenger side. I then turned off the car and back on, it was still there, just very subdued, could barely hear it.
Later that day, after I had turned off my engine and all of a sudden, it was a loud whining again that lasted for about 4 seconds and it died away. Quite worried about it being the water pump.
Started my car today, sound hasn't returned and can't replicate it. Going to take it to the dealer tomorrow?
View 2 Replies
I turned on the climate control this morning when I started the car and tried to change the temperature, then for some reason until the car was warmed up the climate control went to lo and seemed like it was locked there.
Once I the car got warmed up, the climate control worked was normal. It seemed like the increase/decrease controls were locked.
View 11 Replies
2004 Prius and I have lots of static in the AM radio. Some days it is worse than others mostly I am unable to listen to it. If the car is in accessory, the static in the AM radio is not there. As I drive the car the static will increase or decrease based on the proximity to the overhead wires. There are days however where the static will be hardly noticeable. I've owned the car since 2006 and have always had this issue.
View 13 Replies
Looking for a suspension diagram that can be shared for this model? I need to fix the squeaking noise from front passenger side and would like to have an overview pic of the suspension system.
View 6 Replies
Having problems with a squeaking or ticking noise coming from the front windshield area on the passenger side? I took off the A-pillar and tweeter speaker cover, and the noise was still there. Pressing on the A-pillar did not work and it's not any of the cords or plastics in there rubbing. It almost sounds like it's behind the A-pillar. Pressing on the dash, windshield, headliner, etc. all have no effect on the noise.
I'm trying really hard to fix this myself because I'm worried about a tech tearing apart the dash trying to fix it. It might end up worse than it is now. I'm thinking this TSB will need to be done (which seems to apply to all Toyotas): [URL] ....
Next on my list to check is the passenger side mirror (make sure it's fastened securely) and also the black liner under the windshield wipers. I also have foam (like the kind you use when installing a window AC) which I may also try stuffing into the bottom of the front windshield (and maybe the top) to see if that works.
If all else fails, the car is going to the dealer I guess. The Camry is such a quiet car that the noise is really irritating in an otherwise quiet interior. Other than this noise, the car is great! Just a little bummed because my 2005 has zero rattles or noises and my gf's old 2009 also had no rattles or noises. The 2015 refresh is nice, though we're still on the fence about the front grille. My relative is waiting for the 2016's to be released later this year and then he will be buying one for his patrol car. The 2015 isn't a full redesign but it looks different enough that he wants to wait for the next MY to come out. He's dreading leaving behind his 5MT Civic but it needs to be replaced. He hasn't had an auto, ever, come to think of it..
It sounds exactly like this, and is at its worse when accelerating: [URL] ....
View 14 Replies
Just like the title says i have been hearing this ringing noise in my 2003 gti vr6 and its driving me nuts. Neither my mechanic or I could find this source of this noise with the stethoscope. It seems to be coming from the passenger side of the engine but strangely only happens when I LITERALLY shake the car or when its idling and revving. The A/C isn't working either if that means anything. First time owner of a VW by the way.
[URL] .....
View 5 Replies
1.8T... Finding the source of a weird clicking noise I keep hearing. Ever since I changed the motor mounts (although I am not sure if this has anything to do with it) after the engine warms up or after some driving, when the engine is idling I hear a clicking or tapping noise coming from the passenger side of the engine bay. It doesn't seem to tied to the rpm; I can rev the engine a little without the tapping going faster, and when a shift between neutral or park or drive the tapping will briefly slow down almost to a stop before going back to its regular pace. After the revs get above 1500 or so it seems to stop.
View 6 Replies
Instead a set of VWR springs yesterday on my GTI. Initially driving it, everything seemed fine. After about 20 miles and taking an off ramp aggressively, I noticed a squeaking noise from my drivers side when I go over bumps. I cannot pin point what may be causing it.
View 11 Replies
So in my 96' 850 my dash is squeaking on the passenger side. If slight pressure is applied to the glovebox or airbag the squeaking stops.
View 1 Replies
I just bought a 2006 Sonata GLS V6 for my daughter to commute back and forth to college.
The car rides like a dream and has plenty of pep, but I had this annoying squeak when you go over bumps. It looks like the upper strut mount has a lot of play in it when you shake the car up and down, so I ordered 2 from Rock Auto. the left side feels and looks solid.
But I just read an article on the upper control arm replacement and wonder if that not my real problem here.
View 2 Replies
My son was hearing a bit of a squeaking on the passenger side. So I decided after some time to pull the front wheel. (most important brake). Well the pad wasn't moving on the outer guides (serviced it as required and lubed to get it moving). But the lower guide pin wouldn't move in/out. Needed to drift it out and it was very well rusted end to end. I put new pads on early as year I am sure and all was fine. I cleaned the pin on my wire wheel grinder. That lower pin had a collar near then end. Turns out its rubber, I thought it was a metal spring collar. Oh well the wire wheel did a number on it. I don't know the significant of that piece nor whether the pin is in the right place since the top one is different. I do these one at a time so its almost impossible I swapped them in the number of times they've been out.
I never seen so much tightening on any vehicle of pads and pins rusting in as on this vehicle. One has to wonder why. My vehicle also seems to have or what sound like a gear slap upon engaging in reverse or forward from front and back which is most notable after sitting and first engaged. Not every time but this is built in 2007 and there is a TSB for some washers. Hyundai Canada does NOT use the same TSB number they have their own. I talked to a dealer about it but he never indicated it would be the cause only its a different number. I am not impressed in this AWD drive power train. It needs a lot of TLC and the slap I hear is typically due to power train engagement play/slack being excessive most likely due to wear somewhere.. Even my rear sound off not a howl but noisy running which doesn't change with road surfaces so its not the tires. Maybe the AWD bearing or unit going. No of this should even remotely close to needed anything for at least another 100-150k at least.
View 29 Replies
After a quick search i came up with it possibly being the endlinks, but my question is how do i tell if they are bad and if its the upper or lower link? after getting under the car neither were loose or anything and the bushings had slight cracks in the rubber it didnt look too bad though. anything else i should be looking for?
View 4 Replies