So I washed my R yesterday, and then when I started to drive to the store and my car started to sputter and it would let me rev. I think I may have gotten water into the exhaust...but I'm not to sure what really happen.
View 4 Replies2011 stock gti. Was fine yesterday before work, then after work I noticed it sounded a little bit louder, and I hear the exhaust growl when I let off the gas. Car feels a little bit different too. Slight vibration under my feet it seems.
No codes or anything. I also noticed this morning when I pulled into the driveway over the little lip at the front of the driveway the exhaust made a sort of sputtering sound.
I installed the non-resonated exhaust, but I noticed that some air/water condensation is coming out of the small pipe that join the cat and non resonated part of the exhaust.
I double checked the position of the small part and is very deep inside the other tubes, plus I checked the clamps too.
I have a 2005 Subaru Legacy wagon with 190k. The exhaust(original) has a tiny hole in a pipe that looks like Y and splits to the two mufflers.
Can some thing like this get repaired or do you have to replace the entire exhaust?
I feel as though my APR turboback has an exhaust leak.
There is a loud hissing noise that overwhelms the exhaust, turbo and engine noise. What it is. Sounds like a loud hissing when then turbo begins to kick it. Not normal, and it slowly has gotten worse and more noticeable.
I have a feeling its the downpipe, but I can't check it myself. When i give it gas and the hood is open (at a standstill obviously), the engine compartment smells like exhaust fumes.
Could be playing mind games with myself. What do you all think? Any way to surely test and see? I am taking it to dealership on Tuesday to double check.
How to get rid of that stupid buzzing noise from the exhaust every time it shifts in higher RPM, It freaking sounds like a Honda and it is driving my crazy. I did the Exhaust flap mod but it didn't go away.
View 24 RepliesI was in my first torrential downpour in the R yesterday and when it was at its worst the exhaust suddenly went from flapper-modded to extremely loud, from what sounded like the center point of the car, almost as if the exhaust joint came loose, but once it had a minute to dry after the rain stopped it went away.
View 3 RepliesIve been noticing my R32 getting progressively slower the past few weeks. Disappointing as I was hoping the cooler weather would be making it feel a bit faster. Started off with just a little power loss now it feels like the car just does not want to go anywhere. I'm think clogged cats as the exhaust is sounding now (very metallic and raspy) but wanted to check if there was anything else I should check into first. Car has 83K. Any other symptoms to check for? There is no CEL or codes.
View 10 RepliesThis is what my ticket reads, vehicle operating at manufacture standards. Tech road tested vehicle at highway speeds. Tech compared vehicle to demo vehicle. Demo vehicle was road tested at highway speeds. Both vehicles have exact same wind noise. I have also had water leak into the car from same area, for this they said the door seal is deformed & ordered a new one. The carpet in the back where the spare is located is also separating from the material it is glued to.
View 3 Replies2005 jetta. On the highway when I hit about 75mph I hear this loud humming coming from either the engine or the exhaust, I'm not sure. It disappears immediately once I cross about 82mph. What could this be? Why such a specific range?
View 2 RepliesRecently had an aftermarket turbo back exhaust system installed. After driving for a short while, I noticed that between 2500 and 3500 RPMs the noise was very loud. Once I hit the highway (in which the engine almost exclusively hangs around those numbers), it was almost unbearable to sit in the car while having that constant droning sound. I have had and been in cars with aftermarket exhaust systems before and never heard anything quite like this. It is pretty tame below 2500 and once you hit 4000, it sounds quite nice and that horrible drone goes away. I really trust the shop that did the work, so I doubt it was faulty install. Could it be a faulty design or maybe just the one that I received?
This exhaust is from a reputable maker and they designed this system specifically for the Golf R. I did have some other mods done at the same time (Coilovers, Engine Mount Insert, Intake and a Tune). I know the insert may cause a little bit of vibration and hence a little bit of extra noise, but nothing like this. While driving on the highway at 3000 RPMs, I cannot even clearly see the cars behind me through the rear windshield as there is so much vibration from all the noise.
Forgot to mention, this TBE is resonated with a CAT, so even more reason for concern. Would expect it to be quiet by comparison to a CAT-less non-resonated system
Finally got the car started after over a year of acquiring parts and labor. Cylinder 5&6 had misfires due to faulty injector harnesses. That issue has resolved. But I am getting a pretty distinct exhaust leak noise coming from the manifold area and i cannot figure out where it is coming from. We smoke tested it and still can't find the leak.
Things we checked:
-Head to manifold (all nuts tight)
-Manifold to turbo (all nuts tight)
-Turbo to downpipe (2 vbands both tight)
-Wastegate (2bolt manifold to adapter tight and vband adapter to wastgate tight)
-(2) O2 sensor plugs on the maniold (tight)
-All turbo hardware (tight)
-manifold and downpipe have no cracks
Picture:
Video:
[URL] .....
So I just bottomed out really hard and I pulled over to a gas station to check out my car to see if I busted anything. I noticed on the way to the gas station that for the first two times I hit the brakes hard there was a clunking noise but now it went away. Onto the leaking part though, there are two hoses that run just along the inside of the frame on the passenger side just behind the wheel and one of the lines is leaking a lot of water. What these lines run to/from? I'm going to get the car on the lift tomorrow.
View 2 RepliesOk, probably about 1/3 times i start my 96 f150 4.9 with true duals, the left pipe has a higher pitched howling noise, its a steady tone whether I rev the truck up or not it just gets louder. It will do it for about 6 seconds and then stop. The truck doesn't run badly because of it, but i took her to autozone to get her scanned and they said that the oxygen sensor on the first manifold bank has a slow response on startup. Is that what causes this strange noise, I don't even know how it would make it, it sounds much different from the engine. The right pipe doesn't do anything.
View 9 RepliesI have a noise coming from the front of the engine. The noise stops once the the thermostat opens and the water pump starts circulating coolant.
View 1 RepliesThe car is a 2011 GTI 2dr w/6 speed, 12,000miles, cat back exhaust and that's it. Recently when I get into my car in the morning when it is cold (social not that cold) and either put it in reverse or just take off from first the clutch makes a really loud whining noise. Generally, it will go away after a few minutes but sometimes it doesn't go away even after the car is warmed up.
The thing that is weird to me is the clutch isn't slipping at all, even on a hard pull. I know that VW's clutches don't have reputation for lasting that long but I would be pissed if they said it was my fault seeing I drive it nice 9 times out of 10. On another note, I had my leaking water pump replaced a couple weeks ago, ever since then after the car warms up something is making a loud noise that sounds exactly like when your ears are ringing. I popped the hood and it sounds like it coming from the rear of the engine bay but its really to hard to pinpoint exactly where.
Noticed a louder sound to my exhaust. Cuts out when ice shuts off. Haven't got a good look at the whole exhaust system from underneath but did see water drip out from the engine side of the resonator when the car was warming up. The sound is coming from about midpoint between the taiI pipe and the engine. I suspect the weld at the resonator junction is breaking. Is this common? 2008, Canada, 130000 km.
View 7 RepliesLight did not come on for a while then it finally did. I replaced all plugs & that did nothing, almost made it worse. Put a scanner on it & it reads bank one lean, misfire. i unplugged all the coils one at a time on the drivers side & didn't notice any drop in rpms. On a side note, the exhaust leaks a bit of water out of the tailpipes a bit at idle.
View 3 RepliesI just purchased a 2003 F150 Supercrew 4.6 that had been wrecked, but somewhat repaired. I knew the owner said it had a blown head gasket. It has water in the oil (small amount asi it is lightly milky) and water starts dripping from the exhaust after it has run for a few minutes. I did not run it long, but throttled it up to warm the engine. It started dripping soot filled water from the exhaust connections. I bought it to put a 4bt in it anyway, but want to sell the motor with the ability to tell the buyer the skinny on it. I drove it on the trailer and off with no apparent loss of power noticeable.
View 2 RepliesI've noticed that potentially my heat shield or whatever guard that is 1 step toward the front of the car from where the inlet pipe connects to the exhaust system may be the reason for my rattle at 2k and 3k rpms. i think its a heat shield but I am not sure. the thing is it seems properly mounted, nothing is cracked/broken/or loose. But when I do try and wiggle it it does make a slight creaking noise that sounds similar to the rattle I get. So I could foresee this as being my issue.
But, is there anyway to fix this rattle w/out just taking off the part? i figure its there for a reason and it looks like its held on in 2 places. But they're not nuts they almost look like spot welds or something. 1 on each side. What to do?
Something to get you all in here:
I have the 3.5 V6 Automatic 2010 95k miles. I have read places that say any fluid SP-III will work, then others that say any SP-IV. To my understanding, SP-III is not correct, and the fluid will need to meet SP-IV, is this correct? (Additionally, all the auto-part stores said Mecron SP-6 which is not easy to find).
Also, I have a mystery water leak, it is solely water dripping onto the exhaust just between the firewall and the engine. This happens for about an hour after the car is shut off; its getting cold here in Germany and haven't been running the A/C so that is not the issue.