Got my OZ wheels on, with a new set of TPMS sensors. The old sensors stayed with the OEM wheels for winter tires. How do I reset the system to recognize the new sensors? I have a VAG-COM kit, is this required or is there a method to do this through the MFD?
View 2 RepliesMy understanding, and it seems logical to me, that if you rotate the tires and do not reset the TPMS, the pressure and alarm would come from the wrong location. I have been told that the TPMS sensors are, serial number unique and the car needs to know what serial number is at what location.
Anyway, for a do-it-yourself guy to rotate the tires and have the alarms come from the correct location??
[URL] ....
Car is year old, 20k. Replacing tires because of bubbles. I expect to run new tires for about 3-4 years. Do I need to replace the TPMS sensors?
View 2 RepliesSwitched my wheels at Discount Tires/America's Tires and for some reason my TPMS warning light won't go away. It's been more than 24hrs and I've driven over 100 miles, even put the tires to 42psi but still the warning light won't go away. The shop did rebuilt the TPMS due to the wheel change but it's nothing out of the ordinary so I am not sure what's going on here.
View 2 RepliesI have a 2003 chevy impala that won't start it does not recognize park or neutral but it recognizes reverse drive and 321 I'm thinking it's the safety neutral switch which I think is in the transmission. I can jump the solenoid and it will start.
View 1 RepliesI purchased a set of Scion FRS wheels. I assume these have TPMS sensors installed. I found the reset button under the dash and followed the directions in the manual. The light still hasn't gone off.
Is there a different method to get the TPMS sensors to relearn? Or did I make the wrong assumption that stock FRS wheels have sensors.
The dealer tells me my batteries in my low tire sensors are bad. The low tire light on the dash won't go out. So I need to replace the TPMS sensors in my '06 type 5 Prius. I know I can pick them online much cheaper than at the dealer. My question is, is there some reprogramming that will need to be done. I'm assuming it will be some convoluted sequence with buttons on the dash similar to turning off the backup alarm, etc.
View 3 RepliesMy 2007 ES350 had a problem with the TPMS where it would flash for the first minute and then stay solid. After checking all 5 tire pressures and resetting the system by using the button under the drivers side dash, I determined that it was probably a bad sensor. Seeing as how they are 7 years old, this seemed reasonable. (I also checked to make sure the passenger side button for the second set of tires was not pushed).
I just had new tires installed at Costco, and brought 5 new sensors for them to install. They supposedly did whatever sensor registration magic is required, but I am still having the same issue. The light blinks for the first minute then goes solid.
What is interesting is that when I try to reset using the button, the light flashes slower (about 1 per second) 3 times, then goes faster (about every half second or so) for the rest of the minute. Is this some code that the system is trying to display?
Also, is there any trick to getting this system re-initialized that I can pass on to the Costco techs when I take it back up there?
Ever since I bought my 04 V8, the TPMS warning light has been on due to dead sensors and a disconnected controller (G model controller), and I had just learned to live with the alert and the icon on the display for the time being. Last weekend I installed a 6 button cruise control switch and recoded per Michael's instructions. The switch works fine and everything was good. After a couple of drives with the new switch I noticed that the TPMS was not giving me the usual failure message or the fault icon anymore. If I hit the Vehicle button I still get the same fault message in the J523 screen but no warning in the cluster, and no warning upon startup. Ran a VCDS scan and the errors for the TPMS module not being there are still present as they always were.
View 4 RepliesI just purchased a 2014.5 Camry and winter is around the corner. I was going to buy a set of oem 17in SE rims and put snow tires on with out the tpms sensors. The question I have to ask is once the light comes on can you disable the traction control. Reason I ask is because on my 2011 accord it forces the traction control on and is sucks. Snow tires without the sensors.
View 5 RepliesI have a 2004 vw toureg 3.2l v6 and i have two questions. first is where are the brake pad sensors located in the pad or outside of the break pad? Second question is TPMS light is on due to a dead battery in one of the tires how do i kill the whole system?
View 1 RepliesI took the car to be inspected today (for extended warranty purposes) and asked for the mechanic to run the car through their code reader and print out all error codes. They did and this is the error code it gave for TPMS (FYI- They couldn't reset the error display either, and I've done the 'learning' procedure several times as suggested in these forums, but it doesn't work and the display eventually shows Tire Monitoring Pressure Fault) NONE of the tires show in the TPMS screen. I have no flats, nails, and all the pressures are up to level.
So here is the actual code from the Phaeton:
CODE001:
01325 Type pressure sporadic monitoring
Open contr.unit-j5-0 circuit 2
So what I am wondering is whether the Module has gone bad or perhaps the sensors? What the above means?
I have been having countless warnings of check tire pressure, 'defective wheel on board'... I had one of the sensors changed before this but had the car packed for a while.. Now this warning keep coming.. My mechanic says I should check my pressure bring it up to spec and reset the monitor.. How do i do this reset got an 04' touareg...
View 1 RepliesNo luck using the search option. Can I reset (get the faulty wheel onboard light to turn off ) the system myself through the learn sequence? Haven't been able to achieve that result yet.
View 4 RepliesI own a 2012 Camry and i just upgraded from the 17 inch to the 18 inch sport wheels. Do the tmps sensors have to be recalibrated because i get no readings. I thought the car should pick up on its own and show me tire pressure. The wheels came from a 2013 Camry.
View 6 RepliesAbout four days ago my TPMS warning light started blinking. Same tires and sensors have been on there for quite some time. The service book says to take it to the dealer, but I instead stopped by Discount Tire (where I purchased the tires) to see if they could look and figure out which sensor was acting up.
When he ran his sensor, none of my four sensors showed up as broadcasting at all! Now I know that all four of my sensors did not just randomly go out at the same time.
This will be my first winter using a dedicated set of winter tires and wheels on my 09 Camry. The set doesn't have TPMS sensors. Will the TPMS light constantly flash or just stay lit when the system doesn't detect the sensors? I could live with the light always lit but if it flashes it will be annoying.
View 14 RepliesGot 62K on my OEM Michelin LTX-AT2 tires. Very happy with the wear. Going to get them replaced in the next month with the same thing.
Question is, what is the expected life on the TPMS sensor/batteries in the wheels? Should I be replacing those at the same time? I put about 20K miles on per year, so tires last around 3 years. If TPMS is some multiple of 3, then I am ok, otherwise I will replace them when it goes in for new tires.
Any real world experience on battery life?
2010 Camry 4 cylinder XLE. Manual, page 385, shows reset button at glove compartment. It is not there. I'm guessing it's under the dash somewhere, where only a contortionist can see or get to it.
View 6 RepliesTPMS light comes on. Properly inflated all four tires, then attempted to reset the TPMS system. The procedure says to hold the button until the light blinks three times. Having done this in the past, I know that the light should stop blinking when the reset button is released. Now, the light continues to blink after releasing the reset button. When in regular drive mode, the button is continuously on.
View 2 RepliesMy friend bought two new tires for her car, and had all the wheels rotated. When she went to the toyota, they said they need $100 bucks, just to reset my TPMS sensor.. which is something so simple. There are few videos on YouTube that details how to reset the TPMS sensor...
So I followed all the steps. I bought a tire pressure sensor (*a nice digital one), I put air in the tires (30 on all 4), i put the car ignition on ON, put the parking brakes on, and pressed the TPMS switch, saw the three blinks,.. and I thought it would stop coming after that... But Nope. It started right back on and started blinking.
Now I am not sure what to do? Car is a 2007 Camry.