Golf V R32 :: PRNDS Flashing Now Engine Won't Start / Odd Codes
Feb 12, 2010
When I was driving home from work today PRNDS started to flash and i stopped my car and turned the ignition off, when I tried to start my car again nothing happens, Engine is not starting and the PRNDS flashed on the mfd. I had my laptop with me and plugged in vag-com to see if the error codes was the same people gets when mechatronic is failing but they was different and car should start even with bad mech.
The error codes i get is:
18149 - Clutch Pressure Adaptation: Limit Reached
P1741 - 001 - Upper Limit Exceeded
Fault Status: 01100001
18149 - Clutch Pressure Adaptation: Limit Reached
P1741 - 002 - Lower Limit Exceeded
Fault Status: 01100010
28775 - No Communication with Gear Selector Module
U0103 - 004 - No Signal/Communication
Fault Status: 01100100
00194 - Ignition Key Removal Lock
008 - Implausible Signal
Fault Status: 01101000
My car is in my garage and I have checked all of the fuses and removed/replugged the main contact to my mech box.
View 24 Replies
Advertisement
I only put about 1k miles on it since I bought it and I started it today and my oil light was flashing along with the PRNDS indicators. I turned it off then turned it back on and everything was fine no flashing lights.
View 11 Replies
So I get in the car to drive back home, and after i start it wont engage gear, PRNDS flashing, cant get the key out, total drama. Called the dealer. I will tow it back to the origin where it came from. What it is. Shift solenoid failure... But f..ck knows with these things. It only took me 4589785115 times to get the key out...
View 18 Replies
On my dash the prnds lights flash constantly. The car shifts fine and the paddle shifters work too.
View 2 Replies
This morning i went to start my car and threw a flashing engine light. common sense says its a misfire. i know it's probably smart to check my spark plugs first but here's my dilemma. if it isn't the plugs and turns out to be my ignition coil, where the hell is that even located? I have an 04 Jetta 2.slow engine
View 2 Replies
My 2.0T CEL flashes on start up for about one minute as the motor shakes and sounds like an exhaust leak, then it levels off and runs fine and light goes off. No codes recorded. I have changed plugs and coils and PCV valve.
View 5 Replies
Car was taking 3-4 seconds to turn over when I started it one night. After that, flashing CEL and then CEL stayed. Car idles ridiculously rough, thought it was just a coil pack but seems to be a lot more. What is going on with my car?
Performance mods:
APR intake (stage 1&2)
SPM track edition turboback
Stage 2 revo software
R8 coilpacks and NGK plugs put in 9-10k miles ago
Have 52k miles on the car if that matters
View 24 Replies
I never had a single problem with that great car, now at 164,000 km, but got my first check engine warnings last friday, with the VSC OFF flashing, as well as the stabilitrak and check engine signals being lit. The car was still running fine, so I disconnected the battery this weekend and erased the codes. But this morning (2 days only later), the warnings are back. I went to a local garage and they retrieved the following codes: P043F, PO43E, P2402, P2419, P2401 and P2402. What do I do with this?
View 19 Replies
I have a 2008 MK4 2.0 with only 53,000kms. At 40,000Kms I put new OEM spark plugs.
Just recently, every morning when I start the engine is sputtering and rough running. The engines want to die but I give a little gas, and run rough like it is only firing on two or three cylinders.
When it gets to the normal operating coolant temperature it runs without any problem and I can use the AC. Its only give me this problem on the first start of the day.
Does not have any MIL light on the instrument panel. I scan it with VCDS-Lite and do not found any fault codes. The only thing that's come to my mind is to change the Green Coolant Sensor.
View 3 Replies
1999 Toyota Corolla
Error codes: P0301 ... P0304 ... P0300 ... P0420
Symptoms: Car had short touch of the shakes in the morning, parked it for 8 hrs, drove half a mile, and it got the shakes bad and seems like it wants to stall out and the check engine started flashing. After a minute it went back to normal, and then the whole thing happened off and on the last half mile home.
Background: I was told the catalytic converter was in bad shape last time I took her in so I'm assuming that's it. Friend of mine suggested driving it hard to burn out impurities in the cat, but I'm worried about damaging the engine. Going to replace the sparks and spark wires (they're about due anyways).
View 1 Replies
This morning I started my car and it was idling a little rough. The the Check Engine light began flashing - I immediately turned off the car and consulted this forum and my father the mechanic. After talking with my Dad and telling him that the car had sat for a week, he thought the issue was probably NOT the catalytic converter and thought it was probably related to the car sitting and possibly getting moisture in the gas. I started the car again (the roughness at idle seemed to have gone away) but the check engine light/malfunction indicator light (MIL) did not flash, it did come back on after a few seconds, but as a solid light . And as we've all read, it's OK to drive with a solid MIL.
I took the car over to Autozone and had the codes checked - P0300 (multiple cylinder miss fire) and P0301 (cylinder 1 misfire). I asked them to clear the codes. I has just put in new NGK spark plugs last month, so I didn't think it would be the plugs. I looked at a new coil pack for one of the cylinders. I decided to see if clearing the codes alone would work and drove home. No issues so far, no MIL, no rough idle, no hesitation (fingers crossed).
When I called the stearleship - they recommended I have the car towed, but would not speculate as to what the flashing MIL could be (catalytic converter or bad coil pack(s))...
View 3 Replies
Kia rio 2006 130461 today I went and got gas right when I pulled out light began to flash and car shaking went to auto zone codes p0302 and p0326. I had knock senor changed 2 months ago . What could be the problem the guy said I just need a tune up . Is this true ? Is my car safe to drive car not shaking now and no changes in function of my car. There no way I can any one to look at it for couple begin tomorrow sunday.
View 19 Replies
My R ran just fine two days ago. I went out to start it this morning and I get all crank. No turn over not even a pop. Now, it is 3 degrees outside right now. I've started my car many times in the cold with no issue. Weird thing is all of the lights on the gauge cluster all flash at the same time. I have a code for a secondary o2 but that obviously is not the case. And yes the fuel pump did prime when I opened the door.
View 7 Replies
I have a 2009 VW GTI 6spd (42k miles) that has been misfiring at idle for about a month now. I can feel the engine shaking and see the CEL flashing at 900 RPM and eventually an EPC light comes on and makes the car run very sluggish. The EPC light turns off if the i turn the car off and back on. The car runs fine and without any misfires after start up which has me stumpted as to what it could be.
I've taken it to San Tan VW in Gilbert, AZ 3 times.
1st time they said it needed a 40k mile service to correct the misfire which included oil change, fuel filter, air filter, spark plugs, fuel injector clearner and a tire rotation They said spark plugs was causing the misifre so i replaced the plugs but the misfire was still there.
2nd time they said the injectors have carbon build up and recommended to run 2-3 bottles of fuel injector cleaner + octane booster per tank for about 2 tanks and that will fix the issue. That didnt work either.
3rd visit they came to the conclusion that it had massive amounts of carbon and needed a "walnut blast". They recommended to look else where for cheaper labor rates on the blast.
Also, need to understand why the car only misfires at 900 RPM if there is carbon deposits at all times.
View 16 Replies
I test drove a R32 today and had a question about a throttle hiccup. I tried searching but didn't come up with much...
I drove about 5 miles in traffic at 35-45 mph, eventually traffic cleared out, and the speed limit bumped up to 55. While accelerating from 40-55, probably half throttle opening, the cel started flashing and the engine began to stutter. I stopped the car, turned it off, and it started back up fine. On the way back, the situation repeated, but simply letting off the gas stopped it, and the cel stopped flashing.
Relevant info: 35 degrees F, 55k mileage, car behaved fine under small throttle openings. My best guess is the air flow or o2 sensors are gummed up from sitting at the dealership, but they're supposed to look at it and call me tomorrow. Does this sound like a common thing?
View 10 Replies
Throwing 2 codes -
P0172: too rich
P1176: post cat 02 reached limit
Last time it turned on it had horrible air flow, it felt as though it was choking. definitely not a misfire. occasionally after spirited driving the engine would die after I came to a complete stop then worsened to cutting off when I put the clutch in at high rpms. also have a slight loss of power. I also recently added a 3" tbe and changed coil packs.
View 4 Replies
I have a 2001 prius. It has around 105k miles on it. i bought it when it had 86k. I've had 0 issues with the car other than replacing the 12v battery in the trunk and its always run like a champ. Today though, i went to start the car and it started up as normal. I left the keys in the car for a second to get out and talk to my wife.
When i happened to look in through the window though i saw that the cars fuel gauge was all of a sudden flashing. The entire bar. (when i started it originally it had 5 bars of fuel) I got back in the car to investigate and noticed that the engine had turned off. All the power was still on with no triangle of death/turtle or anything else. only the flashing fuel gauge was on. I tried restarting it multiple times to no avail. The power will come on fine, and the dash will appear as normal. The motor just will not start.
I thought it might be fuel so i went and added a gallon just in case, but still no luck. Problem usually have lights that come on or the triangle of death.
View 19 Replies
I had my car shipped (probably 8 days without being driven) and it has a flashing P when they try to start it, and the engine doesn't come on. Nothing happens if they try to shift to D but they say they can get it into Neutral and then roll the car.
View 4 Replies
The past two days when I went to warm up my car, when I got back in it to leave I noticed the engine coolant light flashing. I checked the book and it just says if its flashing to contact the dealer. I have already done so for my next maintenance anyway. It has been around 10 degrees out both times when i started it. 2012 GTI with 9300 miles. Also, if you turn the car off, and start it back up, it does not come back on..
View 16 Replies
Yesterday I purchased an 04 Jetta 2.0 with 179k. It was super cheap and pretty clean. Needs work but I bought it to fix it and daily it. Anyway. When I initially went to look at the car, It started right up. after test driving it, I turned it off to make a deal with the guy. Then started it back up to pull on the trailer. Towed it home, Started right up again to get off the trailer. All was good.
This morning I go out, scan the codes (with an obdII scanner, not vag-com), get the codes, then erase them. Just to get a fresh start at the issues. I go to start the car, and it wont start. Turns over but doesn't fire. Could erasing the codes have done something?
Here's the codes that popped up in case they're important to this situation. P0043, P0102, P3081, P0113. I did scan the codes again after I erased them and it wouldn't start. P0043 is still there.
View 6 Replies
Today after driving my roadtrip to work my car started surging! It happened leaving the light after i had gotten of the exit! Around 5500-6000 rpms and the engine light came on and started flashing. This went on for about 10 sec then the engine light went off and no more surging. Car had a half tank of gas also. Just a note i also have EVOMS intake.
View 8 Replies
