When I am accelerating heavy and then slow down as it is engine braking i get a strange vibration. It seems to come from the drive line i just looked over the car today there is nothing loose all suspension is tight drive shaft looks good and the rubber u joint looks good too. I noticed it after I put in the resonator delete but I didn't think that it could cause it.
View 2 RepliesMy '05 F350 PSD has developed a pretty bad vibration most noticeable above 40mph but only under acceleration. As soon as i hit speed and let off the gas its gone but if i accelerate again to pick up the speed i lost its back. Haven't looked into it too much yet as i was busy all weekend and drove the Expy but I did get down there and don't have an obviously bad u-joint or carrier bearing. I'm also gonna see if i popped off a driveline weight or something.
View 8 RepliesI've a little over 60k on my '12 Golf TDI and I think it's time to replace the brake rotors and pads (a lot of vibration and pulsing under moderate to heavy braking). I'm looking to replace front and rear rotors at the same time, but have a question about the rear rotor size:
Websites like Tirerack & Partsgeek give several options for the rear rotors - 256mm, 260mm and 272mm.
Just bought my R a few months ago and love it so far. I've recently encountered a slight buzz or vibration. I'll get down to the nitty gritty and not bore you with long drawn out information. Basically under heavy acceleration the driver side vibrates/ buzzes down by the floorboard. Now this only happen under heavy acceleration. I even did a test in 1st gear. Heavy accellerate under 2k RPM's, 3k RPM's, 4k RPM's and the vibration happened under these heavy acceleration periods. It's almost like there was also a loss of power during this vibration/ buzz, which leads me to believe it might be the clutch.
I took off the prop shaft and drove in FWD for a few weeks. The vibration was still prominent. Took of both front driveshafts and inspected those and they seem perfect but THE VIBRATION IS STILL HERE. Could this be the clutch?
So I cant figure out where this is coming from. It only happens when the car is in low RPM. Like starting from a stop or going slow in very low RPM I hear plastic rattling constantly. I went in the back and the only thing that is making similar noise is when I tap on the plastic cover of the rear hatch under the window.
View 3 RepliesJust had a hub get stripped a few weeks back and had to replace the whole hub assembly. Now just a few weeks later, I started developing this strange rubbing, almost scraping sound when backing of the garage in reverse and the diving speeds of like 5-10 mph. It has to be wheel related becuase the sound goes in and out as the wheel goes around.
Put the car up on jack stands , checked fender plastic underneath the wheel wells, dchecked the dust sheild on the rotors, checked the tires out, even spun the rotor around with my hand and I couldn't replicate the sound?
Just Started about 5 days ago and was only noticeable at slow speeds every other day, then today it seemed worse and I can almost hear it when driving 25-35 mph and I'm also starting to feel it in the steering and body of the car as a vibration.
I just want to get this car back running smooth... Just put new suspension on as well, new strut bearings, but I had to reuse the strut mounts because the dealership was out of mounts. Don't think the suspension has anything to do with it, but you never know. How to upload a video... I can see if I can somehow record the sound.
Hear a vibration kind of noise coming from the engine when accelerating in 4-6 gear at a lower RPM? It ONLY seems to happen in sport mode with the soundakator on. Normal mode it doesn't. I thought maybe flutter but I'm not flooring it in low RPM/high gear... even just halfway throttle.
I should say I have a JB1 and K&N drop-in installed.
I purchased my .:R last summer with just over 100k miles on it. Two prior owners, car was fully stock and in great condition except for one thing:
Humming/vibration ("brrrrr" sound) coming from the back of the car when turning at a slow speed with the wheel fully cranked, e.g. moving out of a parking spot. It only occurs when moving, and with the wheel fully or almost fully turned in one direction.
The guy I purchased it from brought it to a local VW dealership when he noticed this and they (obviously) did not find anything wrong with the car, and blamed it on the tire wear.
So I changed all four tires. Still made the noise.
Haldex oil had been changed by the original owner but not by the second owner (who owned the car for two years prior to my purchase). So I had the Haldex oil changed and my mechanic said it was dirty AND at a low level, and might be the source of this problem. The noise did diminish for a bit, but it is still present.
So, I'm afraid my transmission or differential are fried from running on too little oil. It does not affect anything but it is definitely worrying me.
So I got my Haldex fluid and DSG fluid changed two weeks ago. When I picked the car up I noticed a vibration when I was making tight turns. Last week I called the dealer and told them. They said to drive it a bit more to see if it works it self out. But now after getting back from H2Oi, it still is doing it but not as bad.
Its a vibration you can feel and a rumble you can hear when making a tight turn at slow speed. Like turning into a parking space or turning at a stop sign. What would this be? I searched but couldn't find an exact answer.
Upon moderate to hard acceleration I hear an intermittent spinning-like vibration noise from the rear diff area...is that normal?
View 1 RepliesWith the mornings getting colder now, I'm wondering if I should try to start driving using ICE so the engine is warm when I have to accelerate quickly when merging with fast traffic.
View 14 RepliesHonda civic 2008 and I notice that while I accelerate the car at the first time I hear the heavy engine sound while comparing to the other carall the oils have been changed recently.
View 4 RepliesI purchased a 2006 Ford F-150 XLT, 5.4 3V Triton. Last Thursday my check engine light came on, so I came to this forum and found out how to retrieve the code with out a OBD. It came up as a 0301 Misfire cylinder 1-10?
I went to the dealer and they said it was cylinder one, sold me a new plug and coil pack and they installed it for a nice $$$. On my way home it started to sputter again when you give it heavy throttle, I called they told me that I should change all the plugs and Coil packs, kinda makes sense but to have all 8 plugs and coils go at once it only has 83km on it.
Have a trusty 05 stx 4.6 4x4 automatic 44,000 orig. miles/owner ext cab pick up. Just lately I thought I picked up at tree branch or something make a noise very similar to pulling a hung up branch or something.. Stopped, looked under truck (everywhere) no dice! Then did some research.. Noise went away when not giving it gas or gliding in nuetral just when light or heavy accelerating! Where do I begin??
View 7 Replies2003 F150 XLT 7700 4x4 5.4 Triton. While accelerating normally from a stop the transmission? shifts into 2nd with a heavy jerk. All other gears normal. It doesn't do this under hard acceleration or under very gentle and slow throttle application. Is this a COP issue, a transmission issue or just a driving style thing?
View 7 RepliesMy 03 Passat is going in for 40k service this week. I think they're going to tell me I need new brakes and rotors (felt some pretty heavy vibration during braking in the Tennessee hills). I was thinking of changing the front brakes myself. My mechanical abilities are modest, but I've done the brakes on my 94 Ford Ranger before.
1. Is this an easy task?
2. What parts will be needed?
So this vibration/ cluncking seems to be from between the front seats and mostly during off the line acceration, and from all I can find it's the flex disc, but my flex disc shows no signs of damage. Can these discs go bad without looking bad or is this possibly the hanger bearing on the driveshaft?
I am also looking for any other possibilities for the cause of this vibation/ clunking as there sounds like something is hitting the bottom of the car but there are no impact marks to show me where the issue is
B5 Passat wagon coil over installation Vibration happens during acceleration.
View 6 RepliesIf you have an intake and are under heavier acceleration, do you get any vibrations in the car while getting that growl sound?
I have the intake pipe zip tied so that it is away from the brake lines but I'm trying to figure out if the vibes are coming from just the sound frequency or something or if it's something else.
Question about my 2012 Hyundai Santa Fe SE. The car has 25,000 miles on it, and just recently like in the last 1,000 miles I have notice when I use the AC, or even the air without the AC the engine reacts very poorly like it is under extremely heavy load. The car shakes and vibrates.
I completely understand that in AC mode, the compressor kicks in, but this to me seems excessive. The car vibrates and the idle drops substantially. AC on is worse that no AC.
In addition, idle or under 35 is worse that HWY driving. The vibration is so pronounced that I sometimes wont turn the AC or air on as the vehicle feels like it is going to rip itself apart.
This is something new and never vibrated this much before the 25,000 miles. Anything I should look into or have the Hyundai Dealer look into? What I may be over looking? Would more stout battery work?
My 2001 Outback has developed a problem in the last few days. When I move the car from a dead stop, I go through a brief period of heavy vibration coming from the back of the car, exactly as if I am running over a rumble strip. It occurs as I am accelerating away from the stop just after the clutch is totally let out. Once I get to a high-enough velocity, I no longer feel it. However, if I maintain a very low velocity I can feel some vibration but not quite as pronounced as it was coming from a dead stop.
I have been able to make this happen in 1st and 2nd gear, I have not tried in 3rd, 4th and 5th. It does not happen in reverse. I tested the clutch by putting the car up against the back wall of my garage, revving the engine and putting the car into 4th and 5th gear and the car stalled, as it should. The clutch did not slip. This clutch has about 60,000 miles on it. The previous clutch was replaced at about 85,000 miles. The problem has been getting worse steadily during a just completed a 700 mile holiday round trip. Could this be the clutch? Could it be something in the transmission?