Golf V R32 :: How To Remove Plastic Pieces Framing The Lower Door Sills
Jan 3, 2009
What is the trick to removing the plastic pieces framing the lower door sills? i dont wanna just start yanking i need to run a wire from the trunk forward.
View 2 Replies
Advertisement
I noticed that I have some light scratches on the black plastic trim on outside of the doors (more than likely done by the place that tinted my windows, ). How to buff these out. They are more like micro-scratches and swirl marks more than anything else. I tried car paint polish in a small corner and it had no effect.
View 6 Replies
How to get the plastic exterior molding on the base of the doors off. I see 2 screws and thats it. Is there a trick to it? I need to replace the passenger side or epoxy one of the clips back on then remount it.
View 2 Replies
Putting in my amp/sub this Friday. I was told to run wires under sills, not through the center console.
So I don't goof up and bust/damage any clips or pins , what is the correct way to remove the sills, both f & r, drivers side?
View 2 Replies
Changing the LED on the JDM side mirrors for the Puddle Light or Illuminated Door Sills. I wanted to go with Black Light inside the cockpit and puddle light and sills.
View 8 Replies
Both my door sills are not working I tapped a wire and now both not working all the fuses are good. Why or where the fuse is located exactly?
View 2 Replies
I have a Blizzard Pearl 2012 Toyota Prius PPP edition, I have owned it since August of 2013 and absolutely love it, the upgraded stiffer suspension is awesome. I can make 60 mph turns on freeway ramps with little to no body roll, it an insane feeling.
Now to my problem, can any of the other PPP owners tell me if all 4 door sills light up, only the passenger side door sill has ever lit up since I bought it, I thought that was the way it was meant to be but after reading on this forum it appears they all light up or at the very least both front doors light up.
I looked closely at the back door sills and they do not to be the same as the front ones as though they might not light up, guess I will have to remove them to check if they have power runnnig to them
View 2 Replies
The blue illuminated sills were already installed when I purchased the car...I just recently noticed that both sides don't light up anymore. I'm not sure when exactly they quit working, but i recently had my battery replaced. I checked every fuse in my car and can't find one that is blown. Is this a fuse problem? or did both sills just decide to crap out together? I checked both connections and they're solid.
View 14 Replies
I have a 2000 Chrysler 300M. Recently I got in the car and shut the door normally, not a hard slam or anything, and the driver side window just shattered to pieces. After having the glass replaced I had my mechanic check out the window regulator thinking that may have have been loose or in some way caused the glass to break. It checked out fine, no problem with the mechanism could be found. I've been using the window since then for about 3 months with no problems. What could have caused this window to crumble?
View 5 Replies
how can i take off the front plastic plate on the front of my touareg
View 4 Replies
I got a piece of cable tie stuck in there.
View 6 Replies
How to remove the plastic engine cover that covers the engine? I'm know some of them are just held in place with friction plugs and only require a good tug, but I've thought that about other things in the past which have resulted in expensive noises.
View 8 Replies
2012 Hyundai Accent
30,000 Miles
Replaced cap
Changed hoses and antifreeze
Leak seems isolated to the upper hose from radiator to filler neck.
Dealership did pressure test and changed clamps with no success.
Not overheating.
I noticed the smell of antifreeze one day and upon inspection came across a small puddle of antifreeze on the lower plastic under body. The car only has 30k on it and decided it wasn't the hoses. I noticed spots of antifreeze around the filler neck and thought it might be the cap. It was a cheap part so changed that out for a new one and still had puddles. I thought it might be the hoses after all and decided why not change all the hoses and antifreeze. Still the puddles are there which only leaves me to believe that it's the filler neck. Unbolted the filler neck for inspection and the inlet/outlet have no issues. I'm thinking it might be where the cap sits on the filler neck. It only seems to happen when it's under pressure. At start up there is no issues. I tried to let it heat up and build pressure to see if I can spot the leak but no joy. I'm guess it happens while under throttle.
View 5 Replies
i need to get to the wires but cant do it looking through the small hole for the fuse box.
View 14 Replies
My umbrella and few other items stowed in prius for some months now has a strong plastic/rubbery prius smell. How do I stop/reduce the smell at the source? There seems to be some discussion on its origin but no mention on how to reduce this.
View 8 Replies
How is the red marker light lens, located on either side of the rear bumper, removed to allow the bulb on the inside to be replaced?
View 2 Replies
I took the plastic cover in front of the radiator off to clean the radiator and condenser. It directs air through the condenser before it gets to the radiator and I was wondering if it would cool the engine without it (if you don't need real cold ac air) . Without it the air can go over the top of the condenser and it is still blocked by the flap that stops airflow above the radiator. Also, I am wondering if the fact that the condenser has nothing in it affects the radiator cooling, and is it bad for the AC system to be empty. (My AC doesn't work)
View 7 Replies
I have a persistent prob with the lock mechanism on the rear door of my mk4 golf, I don't suppose there is a picture tutorial on this subject. I have looked but can only find for the front door.
View 1 Replies
I have a 2010 prius with a misty gray interior. Accidentally when getting out I scuffed the door and on another occasion I scuffed the plastic molding by the gas tank lever.
The scuffs are black marks and they bother me every time I look at them. Is there a way to get them out? I tried rubbing them out with some cleaner on a paper towel but no luck.
View 1 Replies
How do I remove the plastic shelf that is blocking my path to access the cabin air filter? The left side is easily removed by pushing the shelf up but I cannot remove the right side of the shelf.
View 8 Replies
Looking for info about some part numbers? I'm looking for the silver aluminum trim on the driver inside door. Where you rest your left arm. Also the driver black air vent assy all the way on the left where the headlight switch goes.
View 7 Replies