I dropped off my R almost 10 days ago due to a check engine light and was told my timing is advanced at idle. So they replaced both timing chains and the timing tensioner. What could have caused the timing advance?
Engine is stock and always use 91octane ...
2005 GTI 1.8t Engine ... I changed my timing belt water pump and tensioner yesterday and today I am receiving an engine code: P0011 Intake (A) Camshaft Position Timing - Over Advanced (Bank 1) My friend timed the engine and knew that is was 1 tooth advanced. He told me that is was going to be OK because 1.8t's have a 1 tooth tolerance. I would have redone it but I did not know how. What to do in this situation? Do I need to re time the engine?
View 2 RepliesMy check engine light just appeared like an hour ago. In idle, it sounds like a big flicking V8 Supercharged (I actually feel the car vibrating) and I need to give it a LOT of gas to start in 1st. When I turn the key, it takes a while to start. It is flicking weird. I am dropping my car first thing in the morning, but somebody got that so far?! And the last thing I did before getting the light is reversing in a parking lot and parking my car. I have my car since december.
View 6 RepliesOn my way to work, my check engine light started blinking and car was sputtering (real bad on idle). I ran the code and it came back with misfires codes. I changed the coils/plugs, fuel filter and fuel pump last year. Can the coils be bad already? When I clear the codes the car will run fine for a little while. But after a couple miles CEL will blink and the car will run roughly again.
Car : 2004 Golf 2.0
Codes:
16684: random multiple misfires
16648: fuel injector #2 short to ground
I have a 2014 es300h with 7400 miles. Recently the check engine light came on and the dealer diagnosed an oil control valve and something to do with camshaft timing. They also said something about removing valve covers to clean? Is this a potential sludge issue? They kept he car and gave me a loaner. They also opened a TSA with Lexus. My question is this: is this not incredibly unusual to have this issue with a new car? It almost makes me want to get rid of it before something else happens.
View 7 Replies2001 volvo s40. Diagnostics performed. Error codes for the timing belt and temperature sensor. These were replaced. The check engine light still comes on/stays on.
View 6 RepliesI purchased a build Dec 05 1.3l Yaris several months ago. I recently started to get a check engine light, so I did a scan of the computer and it returned a P0012 error. Though multiple searches, I learned that this is likely due to the Camshaft Timing Control Valve Assembly or possibly the OCV filter.
Further searches haven't been able to reveal which parts I need to purchase to replace these items. I can only find details for the 1.5l engine.
The engine is: 2nz-fe, model: ncp90r-agmrkq
1. I don't even know where these parts are located on the car?
2. What part numbers do I need to purchase to replace?
The check engine light came on in my 05 so took my local shop and they checked the code and said it was the Idle Sensor. They were not able to make the repair. Since then the light went off for a few days then came back on. I now notice the gas motor does not turn off when I stop at a traffic light.
View 14 RepliesNew 2012 Tiguan S with a manual, 800 miles and the check engine light comes. Seems to idle a little rough, at least the idle seems to fluctuate a bit. The real disappointing part is I took it in to the dealer expecting an easy fix within an hour, its now been at the dealer for 2.5 days and they'll have it over the weekend as well. They tried putting several parts in it, still didn't fix it. They called VW who said pull out the new parts, put back the old parts, and apply some software update. Dealer did that, still not fixed.
View 7 RepliesI own a stock 2008 Prius.
My car didn't move for 1-2 months so I needed a boost this morning. I noticed there's the check engine light on and a red triangle.
Also, the car won't go on electric mode.
Filled tank with 8 gallons of 91 octane to top off. One hour later noticed car running rough at idle then check engine light comes on. Could it be the coil pack? Car has been running very well until now, and this Gremlin appears. I don't think it's the gas.
2004 -V8 Treg
52,000 on the odometer
I just bought this used truck, 2005 Chevrolet Silverado 1500 extended cab. I noticed some shaking while in idle when I got it back home. The check engine light came on a day or two later, and I recently had a diagnostic test ran on it at the local AutoZone. It came up that I had a P0135 o2 sensor (bank 1 sensor 1) malfunction and a P0101 Mass Air Flow Sensor signal performance issue. The check engine light comes and goes. I stopped by Walmart for about 10 or 15 minutes and when I got back into the truck, the issues reoccurred. For about a minute, the check engine light actually started blinking! And then went away and started running normal again. Its upper confusing. I bought some MAF cleaner to use on it tomorrow and figured that wouldn't definitely clear up my issues, but I'm still wondering if the MAF sensor is enough to warrant the CEL to blink like that?!
View 6 RepliesWent to the dealer because my idle was running both too low and/or too high, check engine light came on.
1) Replace air intake manifold because air flow flap is faulty.
2) Oil leak out of upper and lower timing belt covers - need to replace gaskets.
3) Missing!!! the high note horn
My check engine light came on today and while driving, the idle (RPM's) were very high. At about 80KMs, it was about 3500 and when I accelerated, the engine would race along with the RPMs. While stopped, idling seems fine. I couldn't get over 80KMs/Hr without the idle going too high.
What it could be? Haven't had time to check codes as it is long weekend and garages are now closed till tuesday.
Im a newbie to the Camry's. Picked up from a relative a 07 Camry for $5k. It has 103K on it.
It has an issue to where it has some codes and the check engine light on with P0018, P0019, P0300, P0302, P0306 codes. They just all cam eup al lof a sudden while driving. Slight miss at idle which is the misfire codes but I can't pinpoint the issue for the P0018 and P0019 codes.
I just purchased my first foreign car ever. it is a 2002 Elantra it idles very rough changed plugs using NGK and wires new fuel filter and ran 2 full tanks of high grade fuel with STP fuel injector cleaner. but had no effect on idle also have no check or service engine light. What to check next?
View 3 RepliesIt came on 2 months ago, took it to dealer, code said "erratic idle", it idled fine, smooth as it always has been, dealer turned of lite, said let him know if it comes on again.
View 2 RepliesSo i have a 2000 ford ranger 2wd 4cyl .190k miles. My issue is the motor has a very rough/shaking idle,abs light on,and check engine light on.it also continues to blow fuses to the tail lights and dash, haha
Ive had it since it was at 40k and has been a great truck,although lately i have really neglected it.ive changed the spark plugs and new wires new timing chain. I would d love to start trouble shooting some of this stuff this weekend if the weather holds up.
The check engine light came on in my 2000 Jetta and the engine power suddenly decreased noticeably. Got worse quickly and was idling rough, like it was about to stall out (but didn't). Took it to dealership, they said spark plugs were the problem and replaced. All seemed normal driving home, but after 10 minutes, same problem: check engine flashing, weak engine (trouble on hills), and a rough idle.
Two questions: what could it be?
and is it safe to drive back to dealership (~10 miles) or might that cause further damage?
The fuel line is fine.
Today after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control light stayed on and right next to it on the left side the "VSC Off" light kept blinking and flashing. I turned off the car and started it several times to see if that did anything and to no avail nothing happened.
While I was driving those lights stayed on and the VSC off light kept on blinking. I also checked the brakes and the brake fluid and they all seem to be fine, I even checked the fuel door as well.
I am not sure what is wrong. I was looking at some of the complaint sites and most people say it happens when you drive through a deep puddle or if it is cold and wet outside. But that didn't make sense because I drove in the snow and those lights never turned on. The only time I used the ETS button is during the snow storms and I drive at low speeds.
I need to know why this VSC off light is blinking? Is it a bad sensor or is the ABS/ETS brake system broken or is it an ECU issue or is it because of an alignment. Since I was told to get an alignment soon.
I've just done an engine swap to my 2000 GTS Celica. The new engine seems to run nice and tight and smooth and everything but I can't seem to bring the idle down. It stays revving at about 2000 RPM and the check engine light is on. The engine is from Japan and only has 35,000 kms. on it.
View 14 Replies