Golf V R32 :: 2008 Does Not Turn Over Fault Code U0100
Jun 17, 2015
Fault code (U0100 lost comm with ECM/PCM)
Car started a few weeks back. I let is sit while I ordered a new dash, it had a blow dash airbag.
I replaced the dash, taking out the stereo and instrument cluster. I also replaced the battery with a new factory one.
Went to start the car and nothing happened, no cranking, the only thing I can hear is a single click from the starter. All the lights are on in the instrument panel.
Windows, sunroof don't work even in AUX power. Fuel pump does not prime
I searched the forums and tried numerous advice, but to no avail.
I checked the fuses, none were blown, checked the relays, all work.
OBDII reader throws out the code U0100 even though check engine light is not on. I dont have VAGCOM or VCDS but should in a few days.
View 1 Replies
Advertisement
Fault code (U0100 lost comm with ECM/PCM)
Car started a few weeks back. I let is sit while I ordered a new dash, it had a blow dash airbag. I replaced the dash, taking out the stereo and instrument cluster. I also replaced the battery with a new factory one.
Went to start the car and nothing happened, no cranking, the only thing I can hear is a single click from the starter. All the lights are on in the instrument panel.
Windows, sunroof dont work even in AUX power
Fuel pump does not prime
I checked the fuses, none were blown, checked the relays, all work.
OBDII reader throws out the code U0100 even though check engine light is not on. I dont have VAGCOM or VCDS but should in a few days.
View 2 Replies
After running to operating temp, if the car is turned off then restarted (like you would at a gas station, which is where I notice this) the engine will turn and turn and turn but not fire. I have noticed that stomping on the acceleration will cough it into life during this procedure. This doesn't happen every time and I have recently run high octane gas during a long distance trip.
106K miles...
Recent p0441 fault codes and gas cap warning light...
No other problems or codes...
View 4 Replies
My 2004 gen II died on the road last week. I wanted to have information, on what is apparently a rare problem.
View 14 Replies
Driving home today, my prius threw the triangle and all the other warning lights. Scanned with my scan gauge got code u0100. I was only a mile from home so attempted to drive it. Car made it 1/4 mile and then died. I had it towed to the house and checked the grounding wires going to the engine and transaxle. The Tranaxle grounding wire was loose so i pushed it together tightly. The car now runs on main battery only, the ICE does not fire up. All warning lights are still present. Nav screen says problem. 12v is good.
View 15 Replies
I have a 2009 Toyota Corolla (It has a 1ZZFE engine). The car for a long time was a little problem when starting (long cranks and several tries before starting, but no check engine light at all), then, after adjusting the PVC hose for 3 days the car worked perfectly, but one week ago, in the morning when trying starting, it was impossible. I scanned and got a U0100 code, tested crankshaft position sensor and it is ok, tried with the other key but same result, only cranks, no start at all. After scanning, it started briefly and suddenly went off, tried again, and only cranks.
View 1 Replies
I have 2008 mazda B2300 pickup with P1633 fault code. Is this a mazda code (battery overcharge) or ford code (KAM voltage low) since it's a re-badged ranger? Alternator output measured at battery is 14.4 vdc.
View 8 Replies
I got an error code today and I was going to ask you who know . What is this? What should I change to solve the problem and where in the engine is the error ? Is it dangerous to drive with this error?
My car is a Golf IV R32 - 2003.
View 1 Replies
Had the cams installed about a month ago, and haven't had a CEL on in the car since I got it.. has been 100% trouble free.
Drove about 30 mins somewhere tonight with nothing out of the ordinary, and after leaving my friends house about 3 mins down the road the CEL came on.. Car wasn't idling rough, didn't misfire, didn't sound rough at all.. I pulled over and re tightened the gas cap just incase that was the reason (hadn't driven the car in about 3 days) and drove off, made it home with nothing changed. on the way I did a few pulls in all gears, and the car had all its power, no weird sounds from the engine or exhaust.
Got home and scanned, and this is what I got :
Address 01: Engine
Controller: 022 906 032 EG
Component: United R32 G 6404
Coding: 0000132
Shop#: WSC 31414
1 Fault Found
16398 - Bank 1: Camshaft B (Exhaust): Retard Setpoint not Reached (Over-Advanced)
P0014 - 008 - Implausable signal
Readiness:0000 0000
So.. not sure if its anything serious or not, or where to start..
View 13 Replies
Getting a fuel pressure to low fault code. What could be wrong! 2010 GLI....
View 2 Replies
This morning, I wanted to drive to work, but all of my coolant was gone. In the last couple of weeks, I had some errors with my speedometer and had it replaced a week ago, which did not fix my problem (the P0722 sometimes still came up).
Could it be that my coolant leaked over the last weeks and somehow messed with my speedometer, or are those most likely independent errors?
My car is a 2000 Jetta VR6 and at this point I don't want to put too much into it any more. If you need more input, let me know.
View 3 Replies
I bought an 05 golf GL with a 2.0 and 5 speed in January for commuting to work.
Well, recently. I was on my way home from work, I'm an engine tech for Cummins Inc, and I notice my CEL came on and the car stalled multiple times at red lights. So I limped it home, connected my scanner and the fault was "Implausible signal from Mass Air Flow sensor". I cleared the fault code and tried to start the car. Nothing, no crank no start. Just an audible click from under the hood.
I disconnected the battery for 5 min reconnected it and it started fine. Drove it to work the next day, no issues. I tried to start it again and nothing, CEL was on again for the MAF sensor. I pop started it, car ran like hell, rough idle, low power, etc. luckily I have a dualy that I can drive in the mean time.
View 4 Replies
The code the R threw was p0606 which is the Powertrain/ Engine control module? Where these components are in my R? Or how I can go about trouble shooting this problem?
View 9 Replies
Just went out to start the truck (2006 4.2L) and no start...turns over but isn't firing.
I checked codes and got a P1299. She was stone cold and ran perfectly last night - never overheated.
I suspect ground or other wiring...where should I start?
View 4 Replies
1) Are there 2 lights in the head light projector 1 for low and 1 for high? Didn't see the lenses move as high beams go on.
2) do all R's come with LED license plate lights? Mine did and I ordered a set from ECS. So if someone didn't get LED's and they want a set PM me. 20 bucks shipped
3) I'm having trouble searching for the coding on turning off the headlights moving (hate it!) I find myself watching the damn lights and not the road.
4) I'm having trouble searching for the code to have the DRL LED's on full with the headlights on. I'd be nice to get those both added to the DIY post that thread was nice enough to put together.
View 15 Replies
So this seems to be a common code that is thrown when you near 100k miles, I'm at 77k .. This thread seems to be the most organized [URL] ....
"Long story short, there are 5 main reasons this problem can pop up, listed in order of likelihood, least to greatest:
1) Coolant sensor
2) Thermostat
3) Bad fans
4) Coolant mixture
5) Water pump "
My issue is that the only ones I'm (probably) able to rule out is coolant mixture and bad fans. My radiator fans do turn on from time to time, so I thought I'd ruled that out (unless it would throw a code for not turning on at appropriate times?)
I heard of a test to turn on your AC and see if they turn on, but my AC hasn't blown cold air like ever, so I don't know if that affects the test (probably not?)
A couple years ago I had a shop replace the original thermostat with the new one, or was it the coolant sensor, or both (ugh, I don't remember!) That leaves thermostat, coolant sensor, and water pump.
I guess my main question is is there anyway to find out which it is between these 3, without spending so time, money, parts etc? It doesn't seem the coolant sensor is easily accessible for one.
My car has been really slow recently but I also need to change the spark plugs, I'm doing that this week. I cleared the CEL/P2181 code and it returned a few weeks later,
I'm starting to change my mind about this car being easy to maintain/reliable, I'm always on time with maintenance and with only 77k miles on a 2004 car.
View 24 Replies
I have a 2008 Aurion (NZ/AU version of the Camry V6), and I am frequently getting the Check VSC warning on the dash. So then I bought a bluetooth OBD2 adapter, plugged it in and it returned the error codes U0100 and U0101 which is apparently a network issue though I don't know exactly what that pertains to.
View 14 Replies
So I had a P0606 code which points to a PCM/ECU fault. It would come and go and not really cause much of a problem with driving. It did stall once but it started right back up. The light would come on for half a day and go off. Rinse and repeat......
The dealer replaced it today under my extended warranty. Sure enough, the CEL returned today. I haven't had the code read but I can only assume it will be P0606 again.
View 10 Replies
With all DTCs cleared, this fault code would occur without even shifting out of Park. VW replaced both ECMs, fuel filters and O2 sensors and the car ran fine for the next 1400 miles.
At which point, I decided to get a tune - the car drives great (power gain = ~60hp/90tq. However, I am back to the P0173 fault code exhibiting the same behavior. There are no driveability issues, in fact the new tune seems to be a little smoother than the stock tune. Why this is happening again.
Address 11: Engine II Labels: None
Part No SW: 070 906 016 CQ HW: 070 906 016 CQ
Component: V10 5,0L EDCG000AGS 9805
Revision: --H05--- Serial number: hidden
Coding: 0060575
[Code] .....
View 5 Replies
I recieved a smog check and I fail one small problem. but what do this code stands for PO441?
View 1 Replies
Got a cel yesterday, got it checked out it read a P2096 fault code. The car runs fine, cleared the code it came back later in the day.
View 5 Replies
