Golf IV R32 :: Front Passenger Wheel Chirping With Rotations
Dec 11, 2012
I've been having issues regarding my front passenger wheel chirping with wheel rotations. It comes and goes with bumps in the road and seems to happen more frequently while gradually turning left and never/barley happens while turning slightly right. It is NOT the wheel bearings, and I suspect it is due to a possible bent spindle. More info in a separate thread : [URL] .....
That issue, while incredible irritating, is being pushed to the wayside.
My more pressing issue has only started over the few weeks. With the windows up and radio off I could hear a whining/whirring noise during the last couple yards of a complete stop. This seemed to be coming from the engine bay more than a wheel well. Uneducated guess would be brake booster? No clue there . . .
Now I'm hearing a creaking/binding/light popping sound that occurs with wheel rotation (both wheels). It is what I would imagine a poly bushing binding and releasing would sound like, or the crunching/creak of stopping hard in snow and slush. It is not a constant sound, but rhythmic slowing with wheel speed. Is this an issue with the caliper guide pins or bushings? I've greased them and properly torqued them about 3k miles ago during my last rotor/pad replacement. It is the only bushing I can think of in our brake system.
There is zero vibration, pulling or negative feel to the braking performance, just this binding/creaking sound.
View 7 Replies
Advertisement
2004 Passat 1.8T Tip GLS FWD ... Stock wheels w/ Dunlop Sport SP5000 tires ...
A high pitched chirping noise comes from the front passenger side wheel ONLY when turning left and ONLY when it's below 40F. Goes away once it warms up.
Wheel bearing?
View 8 Replies
The chirping sound happens when I go over bumps but not all the time. If I take a short little ride to the store at low speeds it won't happen but as soon as I get driving in the city or on the highway it sounds like a bird on crack back there, really loud as I go over any type of bumps. I searched and learned that it could be the wheel rubbing the caliper but its not that. There is nothing leaking back there and no visible signs of damage or wear. Brakes have plenty of pad left and rotor is good, i check the tire well also and everything is tight.
View 2 Replies
I just noticed today that my passenger front wheel is sticking out further than my driver side wheel. I did a brief search and had a hard time finding anything.
I've read about shifting the subframe, but that only seems to adjust a few millimeters.
Pics of ball joint issue and difference in wheel tuck:
Notice the shift in the ball joint mounting on the passenger side. The driver side was replaced at the time of alignment.
View 20 Replies
So I just jacked up my car to check out how bad the bushings are on the control arms and the tire rod. They're bad. So I'm going to get the suspension stage 1 refresh kit from ECS.
Well I went to spin the passenger side wheel and I noticed that I can tilt it back and forth slightly, I checked the other side and couldn't do the same thing. I just got both wheel bearings replaced by a shop and I'm hoping its not the hub. This is just a CV joint or bushings or if it's actually the hub???
View 2 Replies
I'm not sure if my car is an R32 but it is a mkIV GTI V6. There is a small radiator in front of the front passenger wheel and air is ducted from the front air scoops into the radiator. What is it cooling? I searched for a transmission radiator but nothing came up. I can only speculate that it is to cool engine oil or transmission oil. Is that correct and if so what is it called?
View 2 Replies
I noticed today that when im sitting still and i turn the wheel the car raises up a noticable amount in the front on the passenger side, Im not sure if the drivers side was moving or not. I have never noticed this before but maybe i just wasn't paying attention? FYI I have coilovers, I'm not sure that matters or not.
View 5 Replies
So for the last few weeks, I've been noticing small specks of grease on the inner portion of my front passenger side wheel. I initially chalked it up to some sort of weird road grime or maybe I ran over something, etc. But it consistently has come back after a week or so goes by between washes (notice it each time I go to clean my wheels each week). Upon further inspection, it looks to be coming from the end of the boot on the tie rod. Its not "wet", but more of a sticky/dry grease that's seeped out and picked up grime/dirt. So it's definitely a very slow/minor amount. And the 3 other wheels definitely don't have the grease on them.
Hard to get photos and its dark out right now, but there's not much to see. Just a few small "globs" of grease that stick to the wheel barrel over the course of a week. Again, not a major amount by any means, but definitely doesn't seem normal.
I have an appointment scheduled for a tire rotation and head unit software update this Friday, so I'll be sure to have them inspect everything down there. Really curious as to what could have caused this, and what the fix might be.
View 5 Replies
4000 miles on my CW Golf R - zero problems until this morning. WILD, Loud sqealing, screeching metal on metal or maybe stone on metal sound coming from front passenger wheel. at first i was positive it was a pebble caught b/t the inside rotor and heat shield - i took the tire off and nothing there.. Also only really does it when I turn RIGHT.
View 13 Replies
Tire Rotations Between Oil Changes?
View 15 Replies
Concerning my recently purchased '99 GMC Sierra 1500 2wd 4.8L...
There is a seemingly undiagnosable, not that noticeable, rubbing noise that seems to come from the front passenger wheel - one rub for every revolution of the wheel. It is fairly subtle and can be felt (subtle) in the steering wheel between 30mph and 45mph. I don't think a lot of people would notice it and anyone that did would probably just turn up the radio at this point. After all, this truck has a very solid drive train and runs amazingly smooth for its age and mileage (172K)
Here are the repairs I have made that you might be about to suggest:- New front bearing/ hub assemblies on both sides within the last year. No play in any of the wheels.- New tires from Firestone within last month.- New tie rod ends and alignment. - New rotors, pads, and flex lines on front. Refurbished caliper on passenger side front.- New pads, calipers, and flex lines on rear. (one of the calipers had seized and I thought I had finally found the problem... not.) (one of the flex lines was the wrong part and was rubbing up against the rim... I thought that was the problem... not.)
Here are the things you are about to suggest I check:- Transmission, rear axle bearings, etc checked out by my trusted transmission shop. - Wheel well shields are firmly attached.
Things I haven't yet fixed : tail pipe bracket, evap emission solenoid assembly, blower fan resistor thingy, crappy door latch.
View 4 Replies
I got 66,000 miles and I am getting a rattle/popping noise when driving on roads that are bumpy. I thought it might be a strut going bad but somebody told me it might be a Lower control arm rear bushing....
View 2 Replies
I'm getting a loud clicking noise on my front passenger side around the wheel or axle. Once I press on the accelerator it starts. It goes faster and faster as the speed of the car increases.
View 5 Replies
I have decent mechanical ability and recently took off both front wheel knuckles to have the wheel bearings pressed out and new ones back in. I own a 2006 Mazdaspeed 6 with 106,000 miles. I didn’t have much problem getting the wheel hub knuckles off and back on and after they were reinstalled with all bolts tightened, I took the car for a test drive and right away knew something was very wrong. I heard the sound of the drive-shaft CV joint boot twisting and there was a serious lack of power. The engine speed did not correspond with the vehicle speed. Continuing a little ways, small metal noises could be heard from the passenger side wheel. The only indication I had of some problem from that side was during the reinstallation of the drive shaft into the wheel hub. The CV joint dust boot was fully extended and didn’t compress like it should. I put the car back on jacks, took off the wheel and saw that the drive-shaft boot was all twisted. It was obvious that power was going through the drive-shaft past the first CV joint, but no power was making it past the second CV joint to the wheel.
Knowing that something was seriously wrong, I had it towed to Firestone down the road. The mechanic removed the boot and said that the drive-shaft had broke. I also inspected this and saw that the drive-shaft was not connected at the wheel hub. The morning of, the car was working just fine without problems. The tool I used to remove the drive shaft from the wheel hub was a Seven Ton Reversible Puller which I rented from O'Reilly's Auto store. The drive shaft was so stuck on, that I had to use an impact wrench to turn the bolt. Could the highly forced removal of the drive-shaft from the wheel hub shatter the CV joint on the drive-shaft?
DSC00261.jpg800x600
View 8 Replies
Every time I drive on a wet road I can hear my front passenger side wheel going though the water and the driver side makes no noise. What, if any, could be the problem?
View 4 Replies
My car has recently developed a chirping noise that seem to originate in the passenger side of the engine bay. It is very audible when the car is engaged in drive and at low rpms. At higher rpms it seems to go away. I have a 2002 1.8t with 90k, tip, tb job was done at 75k, right after I got the car couple of years ago.
View 1 Replies
I was under my car the other day and i noticed this dent in the rear of the subframe, just in front of the passenger side rear wheel. I didn't see damage anywhere else. Is this something I should be concerned about?
View 3 Replies
I have a 2005 Camry XLE. Since past few months I have started hearing a strange grinding / thumping noise from the front passenger side wheel. It can be clearly heard at slow speed and almost sounds like the wheel is lopsided and is rubbing against something. As the car picks up speed, the frequency picks up and the sounds disappears eventually.
So, I figured it must have been because the car had hit a curb few months ago and must have bent the rim. I had the wheels looked at while getting rotation and balancing done and was told that there is no rim damage. The sound went down a little after rotating the wheels but is still there. The mechanic doesn't think that it is the bearing because the sound disappears after moderate speeds. So, trying to figure out what could be causing the noise?
View 14 Replies
I recently had my 20k mile service done which included a tire rotation. Perhaps my understanding of a tire rotation is incorrect but I noticed the rear passenger side wheel was moved to the front passenger side. If the tires were left on the original rims as is, that means it was simply moved from the rear to the front. Is this right? The reason I noticed this is because I have a little curb rash on my rear passenger side rim which now is up front.
View 10 Replies
I have 2002 BMW 325xi (all wheel drive). For about 2-3 months now there is a squeaky noise coming from passenger side front wheel. It sounds like a really bad and rusty coil spring but the weird part is that that noise only appears in warm weather. It has nothing to do with how much distance I drive. If it is 70 odd degrees or warmer outside, the noise starts. In warm weather, the car does not have to be running/moving to hear the noise. I can just push down the passenger side front and hear the noise. I took to a mechanic and he wants me to replace tie rods, control arm and struts. basically the whole suspension system on the front for this noise (in other words, he does not know what exactly is making the noise, so replace everything)
View 5 Replies
I have an 04 WRX, I've upgraded the suspension (1.5" - 1.75" drop front and back respectfully) and have a full set up of strut tower braces. Recently when accelerating from a stop, I get a clicking noise from the passenger front wheel area, I hear it all the way through first, second, and most of third...the sound is probably present after that but my exhaust drowns it out. My first choice of problem is that the CVs have gone, the car has 140k on it...
View 2 Replies
