So after doing wheel bearings in the car. both front and back. I'm still getting the "wheel-bearing hum" sound if you will. Don't know how this can be possible with all brand new wheel bearings and hub in the front passenger side. other hubs were fine. I do need tires which will be ordered soon/ alignment im sure.
View 5 RepliesI just had front and back brakes replaced and there is noise coming from front (I think it's the front)? Any way my brother says its the wheel bearings and that my mechanic should have "caught" that they were bad. I've gone to mechanic for almost 10 years and trust him. Never had wheel bearing problems before so not sure what to think. And if it is wheel bearing can u ballpark cost to fix in Illinois ?
View 10 RepliesI have a 2013 Elantra, new in January, 6600 miles on it, and I took it in to the dealership today because it was making funny noises this week from the left front wheel; the noise gets faster as I drive faster. The left front tire has a bubble in it, and they're telling me the wheel is bent and the bearing is cracked, so they'll need to replace the tire, wheel, hub, bearing and do something with the alignment AND it's not covered under warranty because it is "impact damage." Is this even possible on a new car like this? For the bearing to be cracked without a big accident? I don't remember hitting a pot hole or running over a curb. Shouldn't this be covered under normal use? I'm concerned that I'm being ripped off
View 16 RepliesMy girlfriend owns a '92 Plymouth Acclaim. We noticed a few weeks ago that there was a clunk/rattle noise coming from one wheel, and since it mostly happened while cornering, thought it might be CV joints or maybe suspension. She brought it to her mechanic who inspected the brakes and found that the rear shocks were bad, but sent her away without fixing anything. The other day, on a long drive, the rattle suddenly intensified, morphed into a loud grinding noise, and then the wheel fell off.
I think I'm going to have to confront the mechanic. The bearings apparently hadn't been repacked in some time, and were surely the cause of the rattle noise. I'm less concerned with the fact that he might have overlooked an obvious problem as much as neglected to properly service the vehicle.
Are brake techs supposed to check, then tighten wheel bearings or repack them if needed?
I just bought a used hyundai santa fe sport 2.0t. i noticed it is fairly loud inside compared to my 2011 sonata. I don't know if im hearing tire noise or maybe a wheel bearing type noise. It's coming from the rear and gets louder as I go faster. I'll admit O am paranoid and probably making this sound worse than it is.
View 12 RepliesI think it is cv joint not sure. [URL] .....
View 2 RepliesHave a whirring/wheel bearing metallic rubbing noise at 70-80 mph, 6th gear (manual transmission). It's hard to pinpoint the location but it's from the engine area! I heard about water pump failures but thought I'd hear that all the time not just at speed... MKVI GTI ...
View 15 RepliesChanging wheel bearing on mk4. makes noise when i turn to the right. what side is bad? i like working on my own car but this might be out of my hands.
View 12 RepliesSo my front right Wheel bearing is making noise and its a used Knuckle so its w/e. Guess ill use tonight to do all my bushings and fluids n stuff.
View 6 RepliesI have a Mk6 GTI 2010 and recently there has been some noise coming from the rear of the car and the noise changes with speed and sounds similar to a wheel bearing.. So I jacked up the rear and found that there was play in the passenger rear wheel.. The bolt holding the hub together was tight..
View 2 RepliesI replaced all the bearings and put in a rebuilt transmission and still have bearing like noise , seems like the front, directly increasing with speed . Same in neutral, no change with turning or breaking. Getting worse over the past few months.
View 1 RepliesI have a bad wheel bearing but on the highway my steering wheel shakes. It is only on the highway not down residential streets. I'm pretty sure it is the driver's side wheel bearing. I already balanced my wheels and everything.
View 5 RepliesSo on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 RepliesMy girlfriend and I just bought a 2011 a few weeks ago. We test drove it a couple times ourselves, and had our mechanic take a look at it and drive it also. Everything looked and sounded good. Not sure how much it matters, but it's a Certified Used as well.
A couple days ago, returning from a 45-minute drive which included some short stretches of gravel road, I noticed an oscillating sound. It's definitely not a noise that was there when we bought the car. Unfortunately, my cell is apparently bad at capturing audio, so hopefully my description will be enough.
The noise is very faint, almost inaudible, at low speeds. Between 30 and 35 mph it gets much louder, peaking at about 33. There's some vibration through the accelerator pedal also. Above 35, it fades pretty quickly and I can't really hear it at 50. The sound itself is 3 beats on, 1 beat off, about every second. There's a slight difference in pitch between each beat.
If that isn't enough to go on, let me know and I'll give the recording another shot and upload it if the noise is audible.
I took my car in for what to me sounded like a wheel bearing noise. Dealer thinks the culprit is brakes need to be replaced. In addition to needing brakes I was told i need a throttle body service (service agent says it's needed every 15k for carbon buildup) and also a fuel tank vent filter ("needed every 2 yrs") are these legit repairs I should perform or is this a dealer shake down?
View 15 RepliesAlright a few weeks ago I had right wheel bearing replaced...noise still there... Had tires balanced, rotated, checked for capping. The dealer hears the noise but can't tell where its coming from.
The sound is classic wheel bearing Whoop Whoop Whoop and I can control it when I turn to the wheel right and left. This will be the fourth time its in the shop.
I have a noise I think maybe the front end but not sure it sounds like a wheel bearing noise it's becomes faster as I accelerate it does not increase in noise and by the time you get to 20 mph it disappears, it also disappears when ou tap the brakes or barely push the brakes I had the brakes inspected it's good had the wheel bearings check out even though they said it's a sealed bearing unit they did their test and the wheels made no noise...My car is a 2005 Camry 4 cyl.
View 11 RepliesGot a "wheel bearing noise" emitting from my 2007 Sonata with a 5spd manual. I've replaced front and back wheel bearings with no noticeable change in the noise. I then rotated the tires with same result ...no noise difference. Lastly after much reading I was convinced one or both of my cv axles were at fault so I replaced both of them and unfortunately the moaning roaring noise is still very much there. The only thing I can think of at this point is that one or both of the transmission's CV support bearing is bad. I've depended on this car for a long time and it has given me great service but with 170K miles on the clock I'm afraid the tranny is going to give out and strand me in possibly a unsavory part of town..
View 4 RepliesSo just to sum it up. Past few days I had been hearing a grinding/clicking noise from my left front tire. I had an accident on that side a few months back. Went to the mechanic and they said it is most probably the wheel bearing and possible the hub also.
They took it apart and changed the wheel bearing. After two days of getting the wheel bearing changed the noise is back. It is not nearly as loud but it is definitely there.
What it could be? Could it be the hub itself? I have a 07 Sonata with 100k+ miles on it
So my ranger was having a textbook wheel-bearing noise at around 50mph....when I turned to the right the noise went away implicating a passenger side wheel bearing.
So I replaced both of the hub bearings on the pass side and noticed that the front axle shaft u-joint right behind the spindle was really bad and was going to change it but couldn't get the spindle off so I said screw it.
Took it for a drive and the noise is still there. Could a worn u-joint possible replicate a wheel bearing noise? I am used to them making a clicking/popping noise while turning when they're bad, but not a whirring sound.
1993 ranger 4x4 manual locking hubs.
I have a 2006 VW Golf with 140,000 miles. Last week took it to the shop to have a wheel bearing replaced. Mechanic also replaced the wheel hub. When I left the shop I discovered a new problem that had not previously been there. Now the Anti-lock brakes are kicking in at the very end of a soft stop on smooth, dry roads and even in my garage. This happens about 20% of the time, but never during a hard stop. I took it back to the shop on Monday and mechanic could not find anything and was perplexed. The question is whether the ABS sensor could have been damaged during repairs and is the car safe to drive?
View 14 Replies