Golf IV R32 :: Suspension Clunking - Strut Caps Raised A Little Under Load
Dec 6, 2012
Installed fk coils about 5k miles ago. I replaced the strut mounts and the bearing with new oem. I am not "slammed" by any means but a very mild drop. I noticed the strut caps are raised a little under load, can this be the cause of the clunking sound? The strut cap going down on bumps etc? Or could the strut mounts have already failed. Seems a bit premature to me. I guess I'll have to take it apart and take a peek.
View 2 Replies
Advertisement
Setup: WRD Street Advantage Coilover kit. Installed and sit at 24.75" all around. 034 Density mounts and new bearings. 19,xxx mi.
7 weeks ago I installed WRD Street Advantage coils. The install went great, no problems. Drove a week or so and decided to replace the strut mounts with 034's density strut mounts and new bearing to get rid of the creaking sound at low speed. Ordered them and put them on this weekend. After driving it I realized the creaking of the old weaker strut mount was gone. However, I inherited a rough clunking or knocking sound (as if something is loose and moving around), which seems to be coming from my passenger side. This happens at all speeds and not specific to turning the wheel. I unistalled/reinstalled everything in the front 4 times and went through everything with a fine tooth comb, but can't find anything loose. All bolts are torqued to spec.
I even removed the sway bar end links and drove it, still there. So it's not the end links. I also tried using the OEM endlinks which are longer than the ones from WRD to increase the space between the axle and the sway bar, possibly thinking it was hitting and causing the noise. No luck, still there. The only thing I noticed is that with the car on jack stands the strut mount is tight to the body but I still have slight play in the spring and it's perch. Is that normal? I'm assuming under load it's tight again. So the only variable in my situation is the new Density Mounts and bearing, can these cause heightened noises due to the increased heardness of the mounts?
View 20 Replies
Aside from the clutch and gear changing noise, recently I've been noticing something that sounds almost like a rattle when going over bumps, say a series of filled potholes on a highway where they just slightly bump to move your wheel around, it's not that deep thumping you would expect to hear but it sounds like something is loose in terms of the suspension.
Happens on the front and seems like its coming from both sides. To me it sort of sounds like they forgot to tighten something up when they removed the shipping "blocks"/spacers, but I am not exactly sure what to check. I really do not want to visit the dealership at only 600 miles on the clock ...
View 5 Replies
After doing reading I think my issue might be suspension related. Whenever I engage the clutch at a normal rate I get a rubbing/clunking noise coming from the driver side. I can feel it thru the gas pedal and it sounds like a card in a bicycles spokes. If I engage the clutch extremely lightly I don't get the noise at all. This only happened AFTER I had my H&R Sport Springs installed. Could it be a strut mount? Engine Mount? The car only has 4500 miles on it. I'm extremely confused.
View 4 Replies
I have a clunking noise from the right front suspension when going over bumps. I've replaced the Strut bushings that were collapsed, the control arm bushings that had play and the noise is still there. There is no play in the links. There is a slight noise in the sway bar bushings when struck with a rubber mallet. I hate to keep replacing parts chasing down this noise.
View 9 Replies
I am trying to find origin of clunking noise, but it is difficult to do as there is no visual signs and no excessive movements in any components.
Little bit of details and video. Noise occurs when moving rapidly steering wheel on stationary car with running engine. Not noticeable when at speed. Wheel is not vibrating and cv joints not clicking. Very tiny free movement in steering wheel about 1mm, but I am not sure if that is related maybe a completely different issue there. Mot tester make an advisory note that steering system slightly rough, but its not that useful to find an issue.
[URL] ....
View 8 Replies
How to diagnose this creaking/clunking noise in my 03 Jetta TDI. It's only coming from the passenger side, and I primarily notice it at low speed on relatively uneven roads. I can replicate the noise by pushing up and down on the front passenger side corner.
For context, this started after I just recently replaced my front and rear suspension, plus some steering parts. I replace all four struts with Koni yellows, front CA bushings (with R32/TT), ball joints, tie rod ends, front strut bushings and bearings, and passenger side CV axle. In response to the noise, I also just did the front sway bar bushings, which definitely needed it, but didn't change the noise. I also removed the CV axle and re-greased the inner CV joint--to no avail.
Also, when I have the hood open and push up and down on the front of the car, I can see the cup where the top strut nut goes into will go up and down separate and apart from the body. The driver's side stays in line with the body when I try to the same on that side. Also, that cup is tight on the passenger side, whereas it will spin fairly freely on the drivers side. So, this has lead me to think that perhaps I didn't torque either or both of the top or inner strut nuts on the passenger side.
Here's a (fairly crappy) video of the noise/strut cup .....
View 2 Replies
I recently got an MK7, coming from a MK5, and I installed the VWR springs 8 days ago. Since then I've noticed an intermittent clunking sound coming from the rear suspension. I installed springs on my MKV without any issues and again on several other cars, soIi'm familiar with the process. Everything was torqued to spec after the install.
My best description of the sound would be a clunk, not any rattling, clicking, or squealing. The sound is greater in the passenger side rear than the drivers side rear. No issues with anything up front. Sometimes it occurs when I'm turning the steering wheel while backing out of parking spots and driving slowly, other times when I hit bumps in the road, but it is not constant nor does it seem dependent on the size of the bump/pot holes in the road.
What may be causing this? My plan was to give it a week for everything to settle before I tore everything apart to look for any culprit.
View 1 Replies
I had my friend of mine who is a mechanic change my struts out this weekend. I had clunking noises from the right strut Toyota and also a tire place said I needed new struts. So I got them replaced now both sides are clunking see the YouTube video.
View 7 Replies
I purchased my 2004 XC90 2.5T today. it's got 150k miles.
1. there is a clunking sound coming from the driver strut, I'm thinking it is the bushing on top.
2. should i just replace the whole strut assembly? if so is there a diy? and a kit for this?
3. Rear window doesn't stay up, im thinking the sliders on the window are broken?
4. most importantly, whats the best iPod / iPhone hook up for the volvo.
5. also what mods for keeping it clean.
Attached File(s) : IMG_4763.jpg ( 1.44MB )
View 2 Replies
So I installed my H&R lowering springs about 2 months ago and I am very happy about the stance, ride, and handling up until about 2 weeks ago. The car always had a bit of a spring clunk coming out of the driver's side strut tower, but it has become more apparent and pronounced over the last few days. I already tightened the strut nut and shock tower bolts, what else is there to check out?
View 14 Replies
My 2005 4.2L w/ 139,000mi , giving the above warning. Thinking it was a gremlin, I raised the vehicle height and all seemed well until I got onto the 101 fwy here in SoCal and hit the threshold speed to lower the height.
That's when the engine rev'd to 7k RPM's. Initially it quieted in neutral and I drifted to the shoulder with one shift back into D and 7k RPMs for a bit of power. After that, any start and it revs immediately to 7K upon start.
Flat bedded to Santa Monica VW and await Ivan, their Phaeton mechanic to return tomorrow. Service writer Jeff wondered about front suspension but connection to acceleration is a mystery.
View 21 Replies
I busted a spring and apparently a strut. The mechanic said I'd need to replace the front suspension, and offered to do it for 1000$ which I thought was very high. Now I am debating whether to simply get a cup kit or coil overs. I am leaning towards the cup kit to save money. Now I am curious what you guys think regarding the H&R cup kit and where I could get the best deal on them.
View 23 Replies
So I replaced the front strut and the popping is still there. When I removed the old strut it seemed like that would be the problem as there isn't any play in the ball joints and tie rod end.
View 12 Replies
Every time I am on the road I get this flat noise coming from the front like if the strut was out of air or something like that. It is a very annoying sound and only on certain bumps of the road.
View 6 Replies
Any noted 2.0T, B6 experience/solutions for squeaking/creaking suspension noises seeming to originate from shock/strut tower areas? I purchased new in 2009, 37K mi ago. VW dealer service persons think they hear it sometimes. Been chasing this problem for a year or more, mostly notable in cold weather. Condition evident driving on uneven pavement, dips in the road etc. Passengers ask "what is that squeaking".
View 7 Replies
I need the torque specs for the bearing caps and the order to torque them. Can't find the pdf file for the bentley. Looking for a link to the bentley..
View 24 Replies
I bought some coilover for my mk4 Jetta, and the two front coilover just don't seem write, they are sticking way to much from where they need to be at, and they are hitting my hood..
View 24 Replies
My brother who owns a 2003 Passat that is experiencing a chatter or more like a ticking noise upon acceleration while turning. It only does it under load and has gotten progressively worse. To me it feels like a CV Joint although over cobblestones there is vibration in the front rack as if something is loose in the suspension. It only happens on turning and not under hard straightaway acceleration. What are the best places to check for problems tomorrow when I jack it up? The noise is a fast paced creaking tick.
View 5 Replies
I have a new to me 1999 f550 w/ 7.3 and I have installed an aluminum service body with a crane on the passenger side bins. The crane itself weights about 650lbs plus the steel frame it is mounted on (superstructure in the aluminum service body). I'm concerned about the uneven load on the rear suspension. It does sag slightly to the passenger side - guessing 1" - I will measure tomorrow.
1) Should I be concerned?
2) What can I do to correct it? (without just adding weight to counter balance it).
View 7 Replies
I have a quick question about the control arms on the B5. I have an 01 Passat GLX 4motion, the was previously my mothers. She had the upper arms (iirc) replaced around 60k but not all of them. I got the car with 64k from her, and it now has 92k of mostly highway miles. I have a few clunks from the suspension but nothing crazy, and considering the shocks and dampers are probably shot i cant seem to tell if its the arms or the shocks.
View 1 Replies
