just installed subs in my R. i tested them and they worked fine. But when I went to drive the car today they didnt work. turned the car off. All of the sudden they worked again. So for some reason they don't work when the car is running. why?
View 8 Replies I am trying to install the amp and subs that I have. The radio doesn't have a rca jack on the back and I don't know which wires I am suppose to splice into.
by the way I just purchased my 2011 Corolla S 2 weeks ago n loving it!
Can't figure out why my led running lights driver side only stopped working. They are original and never been touched.
View 1 RepliesMy radio in 2011 Camry (base) is not working while engine is running (the power comes on but all you can hear is static). Interestingly, it's working just fine when car is not started.
What's even more intriguing, this radio does often work properly while driving and it's happening only in the morning. However, after driving for like 30 mins and restarting the car it won't work anymore.
Got out of car to open garage, car locked itself up with engine running. Had key fob in pocket. Nothing worked from fob. No unlock, open trunk, or sound horn.
View 14 RepliesMy wife has recently been complaining that the AC will work for a while, but then it stops working after running for about 30 minutes. She also reports that, at that time, the air flow (blower speed?) seems to drop tremendously. I have observed the former but not the latter, so I can't say for sure that if it really drops in air flow or if it's just a matter of perception. I put my AC gauges on it and it reports the following:
Static reading is 70/100 PSI
Reading system on is 17/145 PSI
Ambient temperature is ~92 degrees humidity is 65%
Vent reading is ~77 degrees
I can see movement in the sight glass while the vehicle is running. I'd like to add a little refrigerant (if that's what it looks like it needs) just to see if we can make it through the summer. Prior to the AC problems popping up.
My running lights aren't working. My father (who has been working on cars since the mid 1960's and now fiddles with small farm equipment too)- checked every single fuse - on the passenger side panel, and both right and left panels under the hood. All fuses were good. A couple of years ago I had a problem with the brake lights (not the third one) not working and it turned out it was in the turn signal lever. We had tried the fuses, wires, etc. and couldn't figure it out. So I'm thinking that the running lights are something weird like that too. Especially since I can't drive at night without any running lights.
View 2 RepliesI have a 2000 Kia Sportage and the dash lights and running/parking lights are not working. The 10 Amp fuse for the tail/running lights keeps blowing. What could be causing these problems on this year, make and model car and where I should look to find and fix the problem? I am trying to find and fix these problems as fast as I can, but I am not real sure as to where to even start looking.
View 3 RepliesThe Right DRL Not Working on my 2005 Venture. I checked the following, also note the turn signal works and the following are ok.
Bulb
Bulb Socket
Socket harness
All Fuses and relays
When I turn on the headlights the day-time bulb lights...
I have a 2001 Kia Sportage. Manual transmission.
For the past two days, once the vehicle has been running long enough to get hot, it becomes really difficult to shift. I think I'm losing the clutch pedal. For example, when in first gear stopped at a traffic light, the car will stall out with the clutch engaged (as if the clutch weren't pressed down.) With the car moving, it's physically very hard to move the gear shift.
Topped off the break/clutch master cylinder fluid, and it seems ok. Also took a look at the transmission fluid, and it is not low.
Changed turn signal, Now driver side running lights and head light don't work. Never mind it was a blown fuse.
View 1 RepliesWeather got cold last night and froze everything. When I went to start my wife's car she had left the wipers in the on position the night before and I did not notice it. Once I turned the car on, the wipers went to start moving but were frozen. Once I realized it I quickly switched it to the off position, but it was too late. After defrosting everything and cleaning the windshield, the wipers will not work. I thought first it was a blown fuse so I switched it out with a new one, but still no luck. After my engine turned off I could hear the wiper motor running but no moving on the wipers. I have checked the nuts that hold the base of the wipers in place and they are tight. I have a 2007 Prius as well.
View 6 Replies96 Eldorado Code 502 (speed sensor fault).. Speedometer not working and vehicle running in low range.. I replaced the speed sensor on the right side transaxle. No change, what else can I try?
View 1 Replies2009 VW Jetta TDI... Both low beam/running headlights are not working. I tried to check the fuses but, according to my owners manual both left and right fuse slots are empty. I don't think both fuses fell out. Where the headlight fuses are supposed to be?
View 2 RepliesBought car(2008 r32) from US brought to Canada the dealership activated my DRL which are xenons and also low beams.High beams are same xenons but use shutter .Other two lights are inactive .Did the dealership screw up on the VAG COM??Dont think this is normal.Are the two other lights the inactive ones xenon also?How do I fix?What is normal?
View 11 RepliesI have a 2000 monte carlo ss. A few months ago the check engine light came on, the temp gauge stopped working, and after shutting the car off you can hear the fan running for about 10-15mins after i shut it off. I assumed it was the thermostat, so that was the first thing i changed. For the first few weeks everything seemed fine. No check engine light, temp gauge worked...then today suddenly it all started happening again. What could be causing it if the thermostat has already been changed? what should i try next?
View 2 RepliesWhat is the compression supposed to be on a 2000 monte carlo 3.4 It is running hot and the heater is not working
View 3 RepliesA little background information is that I was towing a large gooseneck trailer about a year ago when half way to the destination the lights quit. Not just the trailer but the truck tail lights, turn signals and everything except the headlights. Well after getting there and unplugging everything it stayed the same. Well on the way home without the trailer the lights began working again. All the truck lights acted as it never happened. No blown fuses or anything.
Well things are are going ok since then but I can never get running lights to any of my 3 trailers to work. Turns and brake lights are fine. What gives? All the fuses are fine and the truck running lights work just fine. One thing I have noticed is that on my horse trailer I have the little led lights on the sides operational... I would have assumed these to be the same as the tail running lights.
Is there a fuse or something to check? All other lights work, just book the running lights
2006 f250 4x4 CC
So this is my problem. So my driver's running boards lights weren't working, but my passenger side was, I had ordered brand new lights and bulbs so I decided to start with my driver side. After I had taken out the light itself and the bulb I found out that the connector was corroded and the new bulbs when I put them in wouldn't work, so I cut the wires and sliced new wires together probably very amateurly. I started with the backlight and that one went well then move to the front driver side running board light and after I had plugged in the light they all stopped working along with my power windows, my power seats, the interior dome lights, my mileage on my instrument cluster doesn't show anymore. By the way when I was checking this fuse box I noticed that 35 was blown which is a 10 amp fuse which goes to the instrument cluster, so I replaced it with a new 10 amp and it blew immediately what could be going on.
View 11 RepliesYesterday I replaced the battery in my 2013 F150. Since I did this, both running boards just stopped working. I checked the fuse, it is good. Is there a connector around the batter that I may have knocked loose?
View 11 Replies