Golf IV R32 :: If Rev At Start Up Car Will Idle At About 1100 RPM
Mar 5, 2014
Recently, my car has been having issues starting. It will start if I get a boost, but will be dead if I turn it off again. Also, while I'm driving, the airbag, ABS, and traction lifts all come on, and eventually my radio will shut off, but after a few minutes the radio will come back on and the warning lights will go off. When i first start the car it idles as it should but if I rev it will idle at about 1100 RPM. What might be causing all of this? Battery? Alternator? Or EPC?
View 7 Replies
Advertisement
So my car started doing some weird things. at idle and only at idle it will go up and down between 1100 and 1500 rpm. No throttle input no clutch input or brake input. I do have a CEL on but when I read the code it gives me 01314 on brake electronics setting. I'm using a vchecker pro. I go into all the engine brake airbag and trans menus and do clear fault codes and this fixes it but id like to know what the actual problem is.
View 1 Replies
Audi A3 3.2 owner here from Fortitude and have rough / lumpy idle issues? While at a stop in neutral w/a cold or warm engine, it seems a little rougher than one would expect. If you rev it to 1000-1100 rpm the whole car shakes.
Engine Mounts worn?
APR Software causation?
Cam Followers or faulty coils?
Do I need a heavier duty front and top engine mount?
Wondering if CAI and Exhaust along w/ the APR ECU tune is causing it or if I'm just being paranoid.
View 7 Replies
My girlfriend has a 03 celica gt with around 126k on it. most resent it has had a problem of high idle its sits anywhere from 1100rpm to 2000rpm. I replaced the the tps sensor figuring it was the problems it seemed to get more consistent with the new tps it now sits at 1100 but it may still be high I don't drive it a lot. And I forgot to mention no engine lite. I've herd its not common with toyota. I also looked for vacuum leaks as well but found nothing.
View 5 Replies
VW Passat b5 1.9 TDi AVF engine ... When I start my car in cold the idle keep moving from 800 to 1100 rpm. and sometimes when i start the engine in hot it revs till 2000 rpm. I never scanned with vag com? I think G62 sensor problem???
View 2 Replies
I noticed on 5 different occasions so far this year that my idle speed will increase to around 1100 rpms when sitting at idle for more than a few min. Last summer it did it while running a/c, and today it did it with cold weather. The rpms are usually at 550, what happens is the pcm will decide to increase idle speed for no reason at all. Start driving it, and the next time at idle it will stop doing it, a couple times it went down to 550rpms, then went back up to 1100rpms. I recently changed the spark plugs, the air filter is clean, and runs good. I have a code scanner, no pending codes. I have 53k miles. I wonder what could cause this?
View 6 Replies
Morning are getting colder engine runs at 1100 to warm up OK I understand that. But after running around town and engine is warm, I checked again, still at 1100 RPM. Shouldn't it be lower or is that what the batteries need?
View 1 Replies
2009 Corolla LE... IDLE will fluctuate from 600 to 900 while at a stop light. It will keep rev up and then rev down to the point where it feels like the car is about to turn off and then it will rev back up again. I use Shell 89 Octane fuel. I have tried everything with the car.
I have cleaned the MAF, the Throttle Body, changed the engine air filter, using only 0W-20 Synthetic oil (change every 3.5 to 4k miles). Have added Fuel Injector cleanered to the fuel: Have tried BG44k, Red Line SL-1, Techron Concentrate. Added Liqui-Moly Ceratec to the engine oil to reduce friction.
Now Changed the Bank 1 Sensor 2 for Oxygen sensor.
Drained the Transmission fluid, dropped the pan, changed the transmission filter and refilled it with the Toyota ATF.
Changed Spark Plugs and used the Toyota OEM Iridiums.
Reset the ECU.
Tires at 35 PSI.
View 7 Replies
I noticed a slightly higher RPM at idle (1100-1200) with outside temps in the mid 50's after a 15 mile trip. I dont recall what it usually is, it just seemed to revving higher. What would say normal RPM's are on a warm engine.
View 8 Replies
I have a 1997 Ranger with a 3.0 v6 with a super high idle.
It idles at 2500 RPM when the IAC is plugged and a steady 1100 when unplugged. I have replaced the IAC twice now (dropped the first replacement. long story) and and have also checked for vac leaks with no results.
After about 2-3 minutes of idling at 2500 on a cold start it will drop down to 1100 (same as when IAC is unplugged), but after a 10 minutes or so drive it will idle steady at 2500 with minimal if any dropping in RPMs. This is driving me crazy not only because it sounds horrible but also because of the fact it's burning through fuel like it's going out of style.
I have checked the MAF sensor and it looks brand new (not the original owner) along with the O2 sensor. I have been meaning to check the TPS voltage to see if it's working correctly but without a working multi-meter it's making it difficult to do anything.
I'm at a loss with this right now and because of all the previous repairs i have done to it and the others that still need to be done i don't have the biggest budget to fix this problem nor the money the truck is using in gas.
View 14 Replies
For last 3 months I have faced to a problem. My 2009 2.0 TSI, misfiring in cold start (in Summer!). When engine is cold (particularly in the mornings) in FIRST start, RPM goes to 1100 and engine works hard and car badly shakes. If I continue, engine light flashes. But if I just after first start, turn off the engine and restart it again, RPM comes back below 1000 and engine works well!!.
During first start a strange noise comes from the below of the car (Check...check...check...) but in second start everything is OK.
KM is 100k. I red the code and it usually shows P0302 (Misfire in cyl 2) and sometimes P0301 and P0300. I recently change all spark plugs (ngk) but problem had started before sparks change.
I switched the coils to see if misfiring follows the coil but negative.
I know it can have different reasons, PCV, carbon build up, EGR,..... but as it goes just after SECOND start I think it should be an electrical problem.
View 5 Replies
I do what's written in the book (hold brake, turn ESP off, S-mode) but when i press the throttle I cannot go over 1000-1100 RPM - after a slight vibration the clutch seem to disengage and the engine goes idle. What am I doing wrong or is my version without LC?
The car is 2009 Golf 6 1.4 TSI 160hp DSG.
View 5 Replies
I have Golf MK4 1.6 16V BCB '02 and problem while engine is running on idle. Engine works at 1100 rpm (doesn't matter is it cold or warm engine) all the time.
Dashboard turns CHECK ENGINE and EPC lamps and says : "engine workshop". At the beggining of problem VAG-COM diagnostic found this error:
17953 - Throttle Valve Controller: Malfunction
P1545 - 35-10 - - - Intermittent
But after I've changed my old throttle body with new one VAG-COM diagnostic haven't reported any error (no permanent error) and idle issue stays.
While engine is running and Check engine and EPC lapms are turned on diagnostic reports this error:
17961 Barometric/Manifold pressure signals: Implausible Correlation
P1553-35-10 ----Intermittent
After engine is turned off diagnostic doesn't report any error!
Beside of changing throttle body, I've changed ECM, MAP sensor, temperature sensor, EGR valve, . Also checked intake manifold and hoses if is it leaky (doesn't leak anywhere), and timing belt is ok and checked complete wiring installation!!!
View 3 Replies
So last night my battery died, and nobody around me had jumper cables.....so I was forced to bump start the car
It worked, but now the idle is really rough. At a stop in neutral the revs stay between 800-1800 sometimes. When I'm up shifting, every time I left off the clutch the revs jump about 200 rpm and now I have a CEL.
What could have happened?
View 8 Replies
My mechanic and friend noticed my axle was starting to fail about a few weeks ago and Ive just been waiting to get it taken care of when I have time. Last night my battery died and I got a jump start. After the jump I get in and drive down the street a little ways and notice the ESP light came on. She was also running a little rough at idle and I started getting nervous. So instead of getting my Micky Dees I turned around and went home. Of coarse this happens at 3am the night before I have to open up at work at 11.. This mourning I get in the car and warm her up to see how shes acting. I decided to still drive her because I had no other option. The MIL light popped on now too and I think its related to my axle failing. So im wondering I guess how much longer I have til this thing completely goes and what would happen if it went while I was driving? Ive never had to replace an axle before or and an issue with one so this is a subject I know very little about. Also is it worth it to get RAXLES for stock?
So after my battery died like I said I got a jump start from my buddy and after I jumped it the car seems to rev at idle now. Freaked me out! Would all the sudden start revving to 2k rpm and then stop. When I drove it to work almost every time I stopped it would rev a little bit but when I gas it it would stop. After doing research there are a few conclusions I have reached. First I read it could be a throttle body sticking? Then I read the jump start could have fried my ecu or it could be a simple as a loose wire to the motor from a bypass valve?
Im not sure if the jump start did anything bad. Its possible its a coincidence still but my car was fine before the jump. Also on a side note my ecu was already flashed when I purchased the car. The flash is from EIP I believe because there is a eip sticker on the battery case. Personally I think the MIL light is related to the axle but the weird idling is what scares me.
View 8 Replies
I recently got my Mk7 1.8T manual brand new and have been wondering about the long cold start idle. It usually takes around a minute or two before the revs drop below 1000. Coming from a '04 Mercedes and '11 TDI Jetta, I can say those cars the idles dropped much faster. Is this normal with the golf?
View 11 Replies
just got my R32 a year and 3 months ago and love it. I came across my first issue though a couple months ago, when i start my car on cold starts before it would of course go to the cold start mode at over 1,000 rpm's before going back down after 30 seconds and depending on the weather i'd let it warm up anywhere from 5-15 minutes.
Well a couple months ago my car wouldn't do its normal cold start routine, i'd turn it and it made its loud pitch as if it was going to do the cold start and it just immediately went down to regular idle skipping the warm up, it did this for a week before i got it checked out. I went to a shop by me and he said that it might be a thermostat sensor so i replaced it and nothing. So he then pulled my throttle body off cleaned it did the whole calibration thing or whatever its called that you have to do when unplugging them and it went back to normal!!! Well after a month (two weeks ago) its doing it again. Then he told me it might be that the throttle body has some condensation frozen and isn't allowing the throttle to open like it needs too.
I live in a suburb 20 minutes north of chicago and i don't drive the car if it snows, i keep it in my garage. I have a CAI installed on the car that i put on back in March of 09 and a flapper that i just permanently opened with an IV clamp. So i don't have any big modification on the car...yet
View 14 Replies
So I got a check engine light... did a scan and it said something about, "Cold Start Idle-Control System" and then it also has misfires on all of the cylinders and that it is running too lean.
I automatically went to check the intake, took it apart and the rubber coupler that connects the MAF sensor to the stage 2 pipe has a rip in it.
Now I'm freaking out thinking that maybe water... dust... dirt... has gotten into the engine.
View 1 Replies
I have a 2003 2.0 gas Jetta (181k miles, automatic.) that won't rev over 3k, starts rough, idles rough and wont stop setting a P0341 cam position sensor code.
The car was not running when I got it, I replaced the coil pack and it ran but not over 3k. Cleared codes, it sets the P0341 immediately.
Had timing belt, water pump, tensioner and cam pos sensor replaced. Still, sets p0341 code, starts rough, idles rough and wont rev over 3k.
The throttle servo makes a little noise when actuated, shop thinks this is my demon - suggests replace throttle body. This car is for my son who will be taking it to college soon.
View 3 Replies
I'm having a little issue with my 03' vr6. I've had the car for almost 2 months now, which it's pretty new to me, since about the time I got it, the car would sometime roughly idle on start, just for a few seconds, maybe for 10-15 seconds, and then it'll go back to idling at 600-800 rpm and being normal.
This has happened maybe 5 times since I've owned the car, and since then I've changed the battery, and cleaned my MAF. The other day when I started my car it (the rough idle on start) lasted for maybe 30 seconds, so it kinda scared me a bit.
Also there is no check engine light. Other than the weird idle on start, the car feels responsive, quick and there doesn't seem to be lack of power. This is the only mk4 gti I've driven fast in, so there may be lack of power and I just don't know it.
View 2 Replies
I have an 03 vr6. I'm getting codes p0300, 0303, and 0304. I changed the plugs and the coils and still has changed nothing. In the morning when I first go to start the car it has a rough start and idles rough. But after letting it warm up it is fine. It drives perfectly fine, no misfires. None of this started happening until the car ran hot a few weeks ago. Did a compression test and everything came up fine. So would could my issue be? I'm at a loss here. I was thinking fuel issue but if it was a fuel issue, wouldn't it run rough all the time?
View 15 Replies
