I hit a big pothole and now the driver's side headlight is pointing towards the middle of the car. The lens is still in place. What happened? tell me it's something simple and I don't have to replace the headlight.
View 6 RepliesI think the light on the passenger side is aiming a little low compared to the other. Is it possible to change the aim vertically manually without going to the dealership?
View 3 RepliesDrove ~1500 miles this week, from MN to MA. While driving through PA my left headlight died in the middle of the night while raining. I ended up fixing it after spending an hour at a gas pump for shelter. Also in PA I randomly stopped.
View 14 RepliesI'm suspecting that my motor mounts are going bad, but I'm not 100% sure. I have a video of the engine movement when slipping the clutch and revving the engine with the e-brake on. [URL]............................... I don't need high performance ones, but don't want to spend a ton on OEM ones either.
View 5 RepliesSo as the title states, rear sway install, no issues (so I thought ) go to test drive the car afterward, and the headlights go through the normal sweep, but, they don't come up and level out, instead, they are pointing 10ft in front of the car.
The test drive was otherwise flawless, the R responds well to swaybars, my Mk6 TDi did as well, I just have the rear H&R bar on the softer/street setting for now, but it makes a notable difference just on its own in the soft setting, I'm pleased.
Back to the issue now at hand, I researched and so far came up with there is a sensor on the drivers side LCA on the rear of the arm, and one on the rear subframe that has a push rod type arm (looks like a servo) attached to it and a bracket on the subframe, Is this correct? The sensor in the rear is intact, plugged in, and I traced the wire back to the wheel well and there is no evidence of a ground, pulled or severed wire. I have no scanning equipment and am leery of going to the dealer and letting them plug into the ECM for anything now that I am tuned, not really for warranty, more for I don't want to risk anything being corrupted or altered.
installed my borla exhaust yesterday and no matter how many different way i tried twisting and pulling i couldn't get the tip alined... when i went for a drive it shifted to the passenger side... any other way then adding washers to the driver side hanger to lower the left tip.
View 16 RepliesHave a super annoying rattle from the top vent on top of the dashboard in the middle. I can put my wifes handbag on it in order to stop it. Told the dealer about it the past 4 visits and get different answers every time but no fixes. Passed 15k miles and now they say rattle warranty is over so how hard is it to take the vent off so i can doctor some foam tape or something in there?
View 9 RepliesI have finally installed HID, but I tend to think they pointed too low, or it is just my imagination. Need to change the level after installing HID? Second and most important Question, the thing is that after removing the + from Battery, I have reset the settings now car shows trouble codes for g85 I guess the steering column. That it is not calibrated right, the code applies for ABS and 44-Steering Assist, I might have messed up the options, but I strongly believe it might be fixed without dealership. When the car starts it shows, ESP off and steering column yellow all the time.
View 6 RepliesSo I've driven on various roads (mostly highways) for the past week or so and have noticed that my car drifts slightly to the right a lot. I hate to say that my alignment needs adjusting already, The car only has 2000 miles on it and I'm thinking of taking it over the dealership and trying to get it covered under warranty (along with the door noise). Think I'll have any luck? (for the record, I have never hit any potholes, curbs, etc)
View 24 Replies2nd time for alignment in two weeks. My numbers were WAY different than when I left. Rear toe is out, it was out when I left the first time, but it's out in the opposite direction now. Are those four bolts stretch bolts? Maybe my bushings are shot which are causing the varied numbers??
View 3 RepliesIs an alignment after a spring install necessary?
Getting my H&R springs installed tomorrow and was curious
[URL]
The other day, I was driving along doing about 40. It was a nasty hit and my alignment is now shot to where i have to keep the wheel turned left a couple inches to track straight. Local dealer says 170 for AWD alignment. I haven't even checked the tire for bubbles!
View 24 RepliesI think I have a bad prop shaft CV joint. The car has been intermittently making a metallic clicking noise from the middle of the car. It can happen at any speed, a slow crawl to the highway. The frequency is completely tied to speed over the ground and seems to be once per revolution of the prop shaft. I put the car up on a lift yesterday and slid back the heat shield under the CV joint and bearing in the middle of the prop shaft. There is grease there that looks like it was thrown off of the shaft. Can the CV joint be replaced by itself or am I looking at replacing the entire prop shaft assembly?
View 4 RepliesSo I have a 2001 Jetta Wolfsburg, the wipers work fine, but when I switch them off they stop in the middle of the windshield. Also when I use the spray, the fuse blows every time.
View 3 RepliesNew R32 owner here. TR with 45k miles purchased 11/12. Lovin it thus far minus a few quirks. One that is pretty significant - when I was in a drive through the other day, close to a wall w/ window down, going from window 1 to 2, lifted my foot off the break and let the trans engage w/o hitting the gas. This produced a slight but noticeable click/rattle noise from what seemed to be the middle of the car. Once i left, couldn't duplicate the noise until pulling into the garage when I was stop/going again without using the gas. The tranny is covered for another 15k or so, so want to get it checked out before that, just wondering what in the world it could be.
View 7 RepliesMy dsg has been acting really weird the past week or so. I would be making a left turn with cars speeding at me then randomly in the middle of the turn it seems like the car falls into neutral or something like that lag we get sometimes when down shifting. So basically ill be stuck for a second or 2 with cars coming at me. Or even when going straight today it tossed me forward out of my seat, it felt like the car slammed on the brakes or something. I don't have warranty so dealer is out of the question.
View 23 RepliesHow was it adjusted. My fog lights are pointing too far downward.
View 6 RepliesI recently lowered one of my client's 2008 passat and since then the xeon headlamps are pointing way too low. I did the manual adjustment with the allen key screws but I'm at the maximum on the adjustment so I'm sure there is a way to compensate with recoding the motor. I have VagCom but I can't seem to do a recode. What is the procedure?
View 2 RepliesSo I installed coilovers a short while ago and now I need an alignment bad (obviously), but when I took it to get aligned, I was told my car is too low to drive up onto the lift , so I was wondering if I would be able to adjust my coils to a better height and then after the alignment just drop them back down a bit, it won't be too major of a drop back down but I just want to make sure I wouldn't be wasting my money. There is a place up the road that will do the alignment at my current height but for a pretty steep price considering how low my car is.
View 10 RepliesAnd I have coil overs, I'm not super low but pretty low and every time I get my alignment done they say they can't so anything about the rear having so much negative camber. And it is really eating up the inside sidewalls of my tires like crazy.
View 5 RepliesI just noticed on my front passenger door, when I pull the handle, the top of the door is rubbing against the rubber. It seems to be shifted a little down, especially on the top left corner of the door. What's going on with it. Doesn't open as smooth as the door once did.
View 6 Replies