Woke up this morning Drop 200 yards before I got a dash notification saying "STOP CHECK COOLANT" Turned off car, turned back on. and noticed never appeared. Showed up to work (temp never went up past half) and check the fluid and its not low. What can cause this.
View 16 RepliesI've got some problems going on with my 2001 VR6 Jetta. I was driving home from my way to work this evening and all of a sudden the indicator light came on and told me to stop and check the coolant level. Within about three minutes the car was already up to about 200. I pulled over to a gas station and the coolant reservoir was completely empty. So I began to pour coolant in the reservoir and fill it up I notice I was pouring a lot of coolant so I went to the hood looked on the driver side below the bumper and water/cool was pouring out everywhere. I inspected as many radiator hoses as I could and did not find any cracks. The water seem to be pouring out from around the thermostat housing. My question would be since I don't know whole lot about cars would they crack thermostat housing because you need to have this problem?
View 24 RepliesThis morning I went to my car started it for 10 seconds the light on my dash said stop and to check coolant, I got a ride to get some coolant filled it up, drove to work than drove home after work and the coolant level is at the same place I filled it up as this morning. What happend that it was gone last night than fine today? 03 vw gti vr6 24v ....
View 6 RepliesIt's been pretty cold the last few days and tonight when I was coming home the car told me to stop and check the coolant.. and servicve manual....what does this mean...I have read to check the coolant level (pink G12 stuff)...the resevoir is full....could something be frozen??
View 7 RepliesWhen I got the STOP check coolant level message on my 2002 Passat glx. I pulled over as soon as I could and then I began to over heat. The coolant level was good, actually it was a little high. The check engine light also was blinking. I replaced my water pump about 70K miles ago.
View 4 RepliesAbout a month ago, I started my car and the computer started beeping saying STOP! check coolant...so i did....it was on empty...this was rather weird to me because i remember seeing it on normal like a week ago....so i added the coolant to the max level in the tank.....Two weeks later it was on the MIN level line....so i added some again....then a week later it decreased a little again.... it would seem that its a leak....however i do not see any wet spots under the car...it seems that the coolant disappears due to driving the car... Could it be the coolant? Also, how does G12 coolant differ from regular coolants sold in auto stores?
View 24 RepliesStop check coolant light came on dash tonight. Scanned the car no code. Did a search pointed towards coolant temp sensor. Car had it replaced by vw estimate of 30,000 miles ago. I tried to see if its green top sensor appears the very bottom ring is green but top is black maybe vw's is different than ecs? Planning to do water pump, belt kit from ecs anything else i should be looking at?
View 1 RepliesI recently performed the MDI update, and now whenever I connect something to the USB, I get a "Check Medium" error message.
View 10 RepliesHow does one clear the computer to prevent the display "Check Coolant Additive" from appearing every time I start the truck. I know that a chemical test is needed to determine the status of the coolant.
View 2 RepliesYesterday i removed my bumper and unhooked my battery and reinstalled it a few hours later. Now have a "Stop Engine Press Top" error on the screen and the oil light is flashing. I also noticed that the oil temp gauge is not moving.
View 1 RepliesI'm having some problems with my 05 1.8T GTI. I've had a check engine light for about 3 months and finally got a diagnostic tool (VAG V-checker). Right now I have one code 17748.P1340 Camshaft position sensor-G40/engine speed sensor -G28: incorrect allocation.
I researched a little bit and talked with some of the guys at the local VW dealership. From what I learned this could be related to (obviously) faulty camshaft position sensor and/or faulty engine speed sensor. So I've replaced both of these sensors and even cleaned the Mass Airflow sensor.
I cleared the code and after driving about 5 minutes the code came back. Also I recently had a P0300 and P0304 cylinder 4 misfire default code. So I've changed all of the ignition coils too since I heard they were recalled a while back.
Well i was over in eastern washington for the night for a friends 21st bday, when i went to start up my car this morning the check coolant light came on and i checked and it was about at the bottom of the bottle. Never had this happen before, filled it back up but curious if this has happened to people before? kinda ridiculous that a car with less than 5k is already low on coolant takin it in for my 5k svc tomorrow or the following monday guess ill have to have them check it out.
View 6 RepliesFor the last several days, most of the times I've started my car I've had the Red "Check Coolant Level" message on the MFD - accompanied by a tone / chime.
The first time it happened, I was a tad below Min, so I added a 'glug' of G13 to push it back up into the normal range. Everytime I've checked it since, the level is in the normal range.
So how is the level "sensed"? I had a new coolant reservoir put in about 18 months ago, so my "hope" is that it's not actually that (though those are really cheap).
Is there something else I should be cleaning / renewing? Maybe as simple as the electrical connection on the reservoir?
Turned my car on this morning and heard a long loud beep, i look at the car at its saying "Check coolant level low - Check owner's manual"
Turn the car off (engine still cold) pop the hood and coolant reservoir is almost bone dry, way below min level. Check underneath, no apparent leaks, no puddle, etc. Turn car back on, no warning light, drive to dealer, the service advisor looks at it and says there should be no way it's that low that soon.
He said in the morning its common for it to be low but after the engines warmed up it should be higher (and it was) but still below min level. He thought that it was strange and topped it off. Said to keep and eye on it and it will gradually gone down since its 40% water and when it slowly evaporates the level should go down.
So not sure if i have a leak or my car came with low coolant from the factory or something else even, but check your coolant levels
Had my car since the end of december 12, now after a drive to San Diego from Las Vegas I experienced a check coolant light beeping this morning. I didn't check the fluids the day of leaving but 3 days before and everything was all good. Checked the levels and it looked like there was barely any in the tank. After I picked up some coolant from the local dealer thinking maybe I just needed to put more in don't know why I didn't have them look at it then I should have. As I unscrewed the cap after letting it sit for a while I saw coolant surface in the tank.
I thought that was weird but I said oh well let me put a bit in since it looked like it was just duno if this will sound right storing more inside the engine? Let it run for a bout 20 mins and took off. from the dealership when I didn't get the warning anymore. went driving for some bit and got the same warning when I was heading back to my hotel. now I was tripping :|. I parked the car and let it sit in a spot with n spots of oil came out and found a decent sized puddle after letting it sit for some minutes. wiped a bit of it up with a paper and it seemed kind of dirty but reddish, and it seemed greasy like.
A few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
So as i pull into the laser wash today i realize that my coolant is running extremely hot. So when i pop the hood and find that there is no coolant and the globe. So I release the cap until it started steaming and bubbling up. With all the excitement i got a tad emotional and punched a hole in a wall inside the car wash (painful) Upon a second look i realized that a problem i have had before had been keeping my radiator fan from running
I am also dealing with a problem involving the climate control draining power. If the AC or heat is on the car's idle bounces around and causes a loud whining sound. Also, the radiator fan does not seem to want to stay on for more than a second. I have been discussing this problem on a different thread
While enjoying a brisk drive returning from PA to CT this past weekend the five-inch dash display between the tach/speedometer (which was doing a nice job with route guidance) asked me to stop and shift into "P" intermittently. At 85mph I thought it best to ignore the request plus I didn't want to stop and ruin my MPH average. Upon arrival in CT and letting the car rest for a few hours the display is functioning normally. Have been asked to shift into "P" while making mile markers disappear quickly? The trip was so comfortable and effortless that maybe the car was playing with me out of boredom?
View 18 RepliesGot a check engine light with a P2601 error code this morning - Coolant Pump Control Circuit Range/Performance.
View 3 RepliesSo I received the P1121 and took it to the dealer. They told me I also had a P3000. I called another dealer and they said the P3000 could be caused by the P1121 not giving it enough coolant. So I brought it back to the house, bought the valve listed in the forums, and I spent all day changing that + the coolant. I drained the coolant and between the reservoir and the radiator cap itself I refilled about 4 QT, and I saw that my inverter coolant was just below the low line, so I filled it up to the full line. Afterwards, I tried to get the coolant to flow, and it seems like I won't flow. The check engine light immediately came back on and the car said, "Problem." So I immediately shut it off and let it set for a few days. How do I get it so that the coolant starts flowing again. I haven't seen any of the levels move whatsoever on the radiator.
View 8 Replies