I've been noticing that when I step on it some times my clutch pedal seems to get stiff and if I press on it a couple times its normal again. This has been going on for awhile now and I've just been driving it normal but when I do decide to get on it then the pedal will get stiff..
View 4 RepliesI have a 2002 Celica GTS with 80,000 miles. The clutch pedal pressure was very stiff. I had a 2001 GT, and it had a very soft and easy clutch. I just removed and rebuilt the clutch slave cylinder, using the CSK 2426 rebuild kit. The slave cylinders on 2000 to 2005 Celicas are all the same. After bleeding the cylinder, the pedal pressure is very much improved. It still takes some effort, but not like before.
View 1 RepliesI've test driven a used 2003 (155K) I'm considering purchasing. But the clutch is so stiff, especially compared to my 93 Accord. What makes a new clutch, pressure plate a throw out bearing so hard to engage?
View 9 RepliesMy 1970 Nova has a very stiff clutch pedal. Is it possible to adjust the tension on it? It's getting to the point where it makes my foot sore to drive the thing- very annoying. It has a 3 speed on the floor gear-shift.
View 11 RepliesI've got a 2000 F250, 5.4L 4x4 with the ZF5 5-speed transmission. Three years ago I replaced the complete clutch assembly, pressure plate, throw-out bearing, etc, and had the flywheel re-machined. Put it back in and all has been well. Only has about 15k miles on it. Earlier this week I went to drive it and all of the sudden it started getting harder to shift and by the end of the trip the clutch will not disengage at all when I push the pedal in.
Furthermore the pedal is much harder to push than it always has been. Checked the reservoir and it's fine. After some searching it seems to most likely be an issue with the master and/or slave cylinder either needing to be bled or replaced. Further reading revealed that bleeding and recommends just replacing the whole system, so I've priced that out. Was it a master/slave issue? Anything else I should check in case it isn't?
This problem just started the other day. I park in a very slightly inclined garage and now when I get into my car in the morning, the brake pedal is so stiff the brakes barely engage and the car will actually roll until the engine turns over. All other braking behavior is completely normal while driving and it only occurs if the car has been sitting overnight. Doesn't seem to happen if it just sits for a few hours.
View 19 RepliesIt's been a while, but my clutch has been really stiff for a while now. I don't think it was always this stiff. My mother has the same car and her clutch is really "light" and is very easy to press in. While mine is about as stiff as my friends corvette.... Is it just normal in that all clutches feel different or could something be wrong?
View 2 RepliesCan switch out the R's clutch pedal for the Audi R8? Was in an Audi showroom yesterday and there was an R8, and it was actually open. It was manual and the clutch placement was perfect, way better than the R. I've got short legs, but the R8's reach was great. The R is a bit long for me.
I know that there is compatibility across Audi/VW platforms, but I'm not sure of the R8. The TT is compatible for sure but I don't know if the clutch pedal is the same or not.
Just as the title states. When I put the AC on in the car my clutch pedal gets some play in it, enough that it messes up shifting and gets jerky. I tried searching, but no results
View 14 RepliesOk so I took my R out to look track to get some 1/4mile passes in. Didn't do anything out of the norm. Took my first pass and noticed that much clutch pedal wasn't feeling right. It wasn't grabbing like it usually does, it was grabbing close to the floor. I took it out of gear and pumped the clutch peddle a few times and then it grabbed like it normally would. I've never had something like this happen in any of my VWs or any other car. What may have happened? I was thinking maybe a slave cylinder issue?
View 7 RepliesJust bought a 1995 GMC Sonoma. Needs some TLC but the brake and clutch pedals are unusually hard. They are still 100% operable, but they are both pretty stiff. Any trial and error ideas I should try to attempt to resolve this issue? Yes, fluids are topped off.
View 1 RepliesPut in a brand new Clutch Masters stage 2 kit with flywheel and throwout bearing. Also installed ecs bleeder block. Got everything back together and bled the system. But the pedal is still sticking to the floor with no pedal feel at all.
View 9 RepliesThis morning I could feel vibration in both the clutch pedal and the brake pedal under normal acceleration. This just happened and is significant enough to make me feel something is wrong. Car has about 5700 miles on it. To be honest, I have never liked this transmission and have zero confidence in it. It feels completely weak, loose, soft, and lacks any feedback except unbelievably notchy shifting. Maybe it's my DieselGeek. I've already had to tighten/adjust it twice in ~2000 miles.
I am not resting my foot on the pedals during acceleration. I can feel the vibration as I go to engage the clutch/apply brakes.
I have a question about an annoying issue that I'm having with the clutch pedal: is it normal for the clutch pedal to knock or vibrate whenever the AC is on? I ask because it only happens when the AC is turned on. The knocking goes away if I fully depress the clutch pedal or only lightly depress it. It seems to only occur in the in-between.
View 2 RepliesSo my clutch has been acting up lately. When it sits for a few hours the clutch engagement point seemed to creep down but over the course of 35 minutes of driving would work its way back up again. Today it was unusually low and wouldn't let me get it into gear. I tried pumping it a few times and realized it wasn't coming back up all the way, I pulled it up and then tried again and it just dropped right to the floor where it now sits. Fortunately I was at work and can hang here until my ride arrives, and will just wait until late tomorrow night to drive it to my shop without stopping...
My guess is I need a new clutch master cylinder. I have plenty of fluid in there although its a bit old so I'll be changing that when I change the cylinder. Could it be the slave cylinder? If so is it a bear to change that? (do I need to drop the trans?)
Experienced a chatter in the clutch pedal with the a/c on when clutch pedal is pushed in. To me it feels like the throw bearing isn't disengaging the clutch fully, plus my clutch is kind of high once full disengage unless its normal.
View 5 RepliesI changed my brake light switch, and i had my buddy check it with vagcom and now I am getting a clutch pedal switch fault and I am also getting a clutch mechanical fault in my rear end what the most probable cause of this, could it be the clutch pedal switch causing a mechanical fault?
View 4 RepliesI am having a scratchy type feeling in my clutch pedal when i accelerate in 1st gear or R from Neutral. as im easing off the clutch and applying gas, there is a mild scratchy feeling coming from the clutch pedal. its more a feel and no noise. The car is brand new with 600km, its a 6 spd gti. I just want to see if its normal or whether i should get it looked at.
View 4 RepliesI DD the car. I'd like to be able to start the car without depressing the clutch, so i don't have to jump into the car while in my work gear to start it. Now to my knowledge, there are 2 clutch switches. One at top side near steering column/shat. And another near the firewall.
Correct me if I'm wrong, top side is for cruise and ecu. Bottom side towards firewall is for the starter and such.
My question, is there a way to fool bottom side clutch switch to thinking it is depressed so I am able to start the car without the pedal depressed.
I started having issues with my clutch pedal "dropping out" from under my foot. Not necessarily during a shift. It still works but will stay down towards the bottom of the travel and after either lifting with my toe or pressing it a few times it kicks back up and usually stays up. Is this my clutch dieing? or something hydraulic related? Hoping I don't have to replace clutch. Searched R32 forum for anything similar and couldn't find anything.
View 8 RepliesMy girlfriend now encountered a brake problem twice: In those situations she needed to brake but the pedal was really stiff, did hardly move and the car did not brake. Only long hard pushing finally succeeded. The second time she nearly got into an accident because of this so we took the car to the dealer then who found nothing and said the brakes are ok. I drove the car the first 5k miles and never had such a problem.
View 20 Replies