I changed my brake light switch, and i had my buddy check it with vagcom and now I am getting a clutch pedal switch fault and I am also getting a clutch mechanical fault in my rear end what the most probable cause of this, could it be the clutch pedal switch causing a mechanical fault?
View 4 Replies03 Jetta. The cruise has not been working. Turning cruise on and off works fine as light comes on on dash. Brake pedal switch was replace about a year ago, and I don't think that is the problem because when this was the car would actually go into limp mode.
Just checked the clutch pedal switch by jumping the plug (This was the blue switch lower on the pedal), and still no cruise function. I'm really leaning toward it being the "set" switch/button on the steering wheel as this just feels kinda broken. Did I test the clutch pedal switch correctly? Any other reason the cruise would stop working?
I'm getting a random 'no start' fault which I think is related to a clutch position switch. The dealer tells me the clutch pivot bushing and master cylinder push rod are worn out, which is causing the switch not to close when the clutch pedal is depressed.
1993 F-350 7.3L Diesel 5 Spd 4x4, Std Cab, 8 Box.
What would make a clutch switch keep going out? I've replaced it 3 times in the past year and at this point I'm pretty sure it's not bad switches. I currently have a UM NA tune with launch control which obviously doesn't work when the switch goes bad.
View 1 RepliesI've been noticing that when I step on it some times my clutch pedal seems to get stiff and if I press on it a couple times its normal again. This has been going on for awhile now and I've just been driving it normal but when I do decide to get on it then the pedal will get stiff..
View 4 RepliesCan switch out the R's clutch pedal for the Audi R8? Was in an Audi showroom yesterday and there was an R8, and it was actually open. It was manual and the clutch placement was perfect, way better than the R. I've got short legs, but the R8's reach was great. The R is a bit long for me.
I know that there is compatibility across Audi/VW platforms, but I'm not sure of the R8. The TT is compatible for sure but I don't know if the clutch pedal is the same or not.
Just as the title states. When I put the AC on in the car my clutch pedal gets some play in it, enough that it messes up shifting and gets jerky. I tried searching, but no results
View 14 RepliesOk so I took my R out to look track to get some 1/4mile passes in. Didn't do anything out of the norm. Took my first pass and noticed that much clutch pedal wasn't feeling right. It wasn't grabbing like it usually does, it was grabbing close to the floor. I took it out of gear and pumped the clutch peddle a few times and then it grabbed like it normally would. I've never had something like this happen in any of my VWs or any other car. What may have happened? I was thinking maybe a slave cylinder issue?
View 7 RepliesPut in a brand new Clutch Masters stage 2 kit with flywheel and throwout bearing. Also installed ecs bleeder block. Got everything back together and bled the system. But the pedal is still sticking to the floor with no pedal feel at all.
View 9 RepliesThis morning I could feel vibration in both the clutch pedal and the brake pedal under normal acceleration. This just happened and is significant enough to make me feel something is wrong. Car has about 5700 miles on it. To be honest, I have never liked this transmission and have zero confidence in it. It feels completely weak, loose, soft, and lacks any feedback except unbelievably notchy shifting. Maybe it's my DieselGeek. I've already had to tighten/adjust it twice in ~2000 miles.
I am not resting my foot on the pedals during acceleration. I can feel the vibration as I go to engage the clutch/apply brakes.
I have a question about an annoying issue that I'm having with the clutch pedal: is it normal for the clutch pedal to knock or vibrate whenever the AC is on? I ask because it only happens when the AC is turned on. The knocking goes away if I fully depress the clutch pedal or only lightly depress it. It seems to only occur in the in-between.
View 2 RepliesSo my clutch has been acting up lately. When it sits for a few hours the clutch engagement point seemed to creep down but over the course of 35 minutes of driving would work its way back up again. Today it was unusually low and wouldn't let me get it into gear. I tried pumping it a few times and realized it wasn't coming back up all the way, I pulled it up and then tried again and it just dropped right to the floor where it now sits. Fortunately I was at work and can hang here until my ride arrives, and will just wait until late tomorrow night to drive it to my shop without stopping...
My guess is I need a new clutch master cylinder. I have plenty of fluid in there although its a bit old so I'll be changing that when I change the cylinder. Could it be the slave cylinder? If so is it a bear to change that? (do I need to drop the trans?)
Experienced a chatter in the clutch pedal with the a/c on when clutch pedal is pushed in. To me it feels like the throw bearing isn't disengaging the clutch fully, plus my clutch is kind of high once full disengage unless its normal.
View 5 RepliesI am having a scratchy type feeling in my clutch pedal when i accelerate in 1st gear or R from Neutral. as im easing off the clutch and applying gas, there is a mild scratchy feeling coming from the clutch pedal. its more a feel and no noise. The car is brand new with 600km, its a 6 spd gti. I just want to see if its normal or whether i should get it looked at.
View 4 RepliesI DD the car. I'd like to be able to start the car without depressing the clutch, so i don't have to jump into the car while in my work gear to start it. Now to my knowledge, there are 2 clutch switches. One at top side near steering column/shat. And another near the firewall.
Correct me if I'm wrong, top side is for cruise and ecu. Bottom side towards firewall is for the starter and such.
My question, is there a way to fool bottom side clutch switch to thinking it is depressed so I am able to start the car without the pedal depressed.
I started having issues with my clutch pedal "dropping out" from under my foot. Not necessarily during a shift. It still works but will stay down towards the bottom of the travel and after either lifting with my toe or pressing it a few times it kicks back up and usually stays up. Is this my clutch dieing? or something hydraulic related? Hoping I don't have to replace clutch. Searched R32 forum for anything similar and couldn't find anything.
View 8 RepliesIf I'm at part throttle and i press the clutch pedal in about 2-3 inches, leaving the clutch still fully engaged, i can feel a really rough vibration in the clutch pedal. it stops vibrating as soon as i let off the gas. and i'm only giving it a little bit of gas, mind you.
If I'm at idle, and i have the clutch depressed all the way and rev the engine, I can feel vibration in the clutch pedal. My 6-speed MK4 did not do this, not in the slightest. Is this normal for MK6 or do I have a problem?
I just finished installing a new clutch kit on my 2003 Jetta Wolfsburg Edition 1.8 and I have absolutely no pressure on the clutch pedal, I am pretty sure I installed everything correctly. How do you bleed the clutch lines, how do you know if the slave cylinder is bad. When i push the clutch pedal it just goes to the floor with absolutely no return.
View 4 RepliesSo over the weekend my clutch pedal stuck to the floor 2 times and would not come all the way up on several occasions. It has since then stopped doing it. I am wondering if I should bleed my clutch or not. Flush and change fluid?
Just concerned it may turn worse.
Going through the drive thru tonight and I heard a weird noise coming from the engine area. Get home and pull into the garage and here a flutter sound when my clutch pedal was pressed down, let go of the pedal no noise. While driving the car around clutch pressure seems fine and no slippage of any kind.
View 2 RepliesMK7 with 15k miles... This morning on my commute into work, I started having some clutch issues. When I would try to go into 2nd gear from 1st at any speed, it would grind when I would let out the clutch pedal. It was like it didn't fully engage and if I pushed the pedal back in and tried to get it in 2nd, it would grind. All other gears were fine. I don't drive the car hard so I don't think I torched the clutch.
Synchros? Shift Alignment if these models have that? Pressure Plate?