Golf IV R32 :: Clicking Sound Coming From Pulley / Belt Side Of Motor
Nov 2, 2013
I just started hearing this clicking/ticking sound about two days ago. It is definitely coming from the pulley/belt side of the motor and is more pronounced from under the car. I've tried to see what happens when I turn the A/C on and it still continues like normal. At idle its spaced 3 seconds apart with 3 consecutive clicks/ticks.
As I raise the RPM its spaced closer but still has 3 pronounced clicks that I can hear until the exhaust drowns it out. Tension on the belt seems to be good and its in good condition. The car runs better than it did a year ago with MPG actually going up a few about a week ago (cleaned the MAF, new filter, new tires).
I did have a P0103 code 2 weeks ago due to an over oiled K&N filter but I've done the work listed above since then with great results. The car runs great right now but I'm a stickler for the little details, like obnoxious noises (especially ones that are potentially bad).
View 18 Replies
Advertisement
Recently my GTI has been ticking, but it is only between 1 and 2 thousand rpm. After 2k it runs fine and doesn't make the sound. Local tuner suggested an oil pressure problem (not using the proper oil) but I am using the proper oil. It has been like this for over a month now and nothing has come of it. It is coming from the belt side of the motor and sounds like plastic ticking. Could it be a belt?
View 7 Replies
I have 1997 F250 LD since i bough it has been doing this chirping sound coming from the serpentine belt and the pulley area but when the truck has been working for 15 - 20 min it goes away
This is apart from the from the problem before I think the fan clutch is broken because when I start the truck I can hear the fan going at the same speed of the engine is that normal ? even when the truck is cold
View 3 Replies
I heard a clicking sound coming from my motor. I change the old and start if up and i put it in r to back it up some then I put in D to get it off the curve then I lost all power and the car wont start. I have just 120560 miles on it....
View 3 Replies
I have 2001 saturn l200 about 150000 miles.. On cold days i hear a clicking sound coming from motor. When I push on gas pedal the clicking get little larder as soon the car warms up its stops clicking. I had the timing replace. Battery check. New oil. Oil pressure check....
View 14 Replies
I have a 2001 saturn l200 about aweek ago i hard clicking sound coming from my motor. So I change the oil and I put it r and back it up some and then I put in it in d then I lost all power and how it wont start. Someone told me its the timing then I take a look at the chain wen you try to start it the chain jumps up and done.
View 2 Replies
I've noticed lately that my mileage and performance of my 2012 GLS has gone down. I can hear a "clicking" sound from the right side of the motor when the engine is slightly under load almost like a cam shaft that's operating without oil. I've done all the obvious things like check fluid levels and the such. My car has about 130,000km or 80000 miles on it.
View 5 Replies
It has developed a weird squeaky belt or pulley sound. It starts after few seconds of start up and goes away after driving few kms. It also goes away immediately for few kms. When I spray WD-40 on generator/alternator. Once in a while the sound decreases by itself and goes away only when I press the gas pedal and comes back during idling/braking. The belt is almost like a new. The car drives great without any issue.
View 1 Replies
I recently had a good amount of work done to my Mk4 R32. Last night on my drive home from the stealership I ended up with a passenger headlight out and a very loud clicking/ticking noise which seems to be coming from the Serpentine belt area. After closer inspection it looks like the tensioner lines are't lined up which means my belt and tensioner need to be replaced? I'm not sure, but I have a video and this picture.
View 7 Replies
So from reading around a lot, it seems like the chirping is from the belt tensioner or idler pulley. That said, I've not been able to find anything definitive. I tried to do the water bottle squirt test (from Gates' youtube video) and either I did it wrong or the chirp did not go away implying the issue is not the belt. While I was looking in, I could see the tensioner shaking some.
If my tensioner should not be moving, do I just need the pulley or the pulley and the mount?
- Pulley [URL] ....
- Pulley and mount [URL] ....
Also, if the above items will fix the chirp, which brand would be best?
2007 RX 350, 113K.
Chirping gets worse as it heats up. Seems to happen independent of ambient temperature. Purchased a year ago so unsure of the history of part changes.
View 8 Replies
I was sitting at the stoplight in neutral when the light turned green. I pushed in the clutch and put the car in first then all of a sudden a huge CLUNK like when you take out the starter bolt without supporting the trans or motor. Then while letting out the clutch about halfway all hell broke loose. It sounded like a bunch of marbles rattling like crazy in the trans. I pushed the clutch back in then it stops until you let it back out again. The car still moves forward and reverse but with all that noise. The sound seems like it's coming from under the driver side motor mount. When I put my hand on the tranny I can feel the vibrations very well. Does this sound like the throw out bearing?
View 3 Replies
What is the cause for a clicking sound coming from Left hand side wheelwell area when I make semi tight Left hand turns from a parked/stationary position?
View 4 Replies
There is a clicking sound coming from the front passenger side of my dash. I have narrowed it down to being a problem with the Air Outlet Servo Sub Assembly. How should I go about correcting this dilemma? If I choose the option to waste another perfectly good weekend on taking apart my only means of transportation (except for my bicycle), how should I go about doing this to avoid creating anymore havic on what seems to be a perfectly good car?
View 3 Replies
Vehicle has been in the shop several times within one month( Battery test, replace accelerate idle switch, rear end replace) latest dilemma is with a constant clicking sound coming from under/ near dashboard on passenger side . No interior lights. All this occurs before I turn over the ignition. On some occasions if I enter the vehicle and don't hear the constant clicking sound. Whola, the vehicle starts every time. I disconnect the battery cable when coming in over night. 1997 112,000 miles.
View 12 Replies
One of my belts squeaks. I've tightened one of them as far as it goes I think. The other one is the one with the alternator. Do I tighten the pulley bolt on the alternator to add tension to that one?
View 4 Replies
I've just bought a 1996 celica GT. It has very low mileage and is in great general shape for it's age. There is one thing that annoys me and it's a clicking sound coming from the rear passenger side wheel when going over bumps (I hear it a low speeds as tire noise take over after I guess). I was wondering if I should be looking for different signs when I jack it up? Worn bushings? And is there a way to reproduce the sound. I've read about the rear bushing being a problem on these cars... is it true?
View 5 Replies
I replaced my rear brake pads this weekend. I used oem pads and used the shims with CRC lubricant. I also compressed the brake calipers and made room for the new pads. I also tried to take off one of the rotors but it would not come off even with putting screws in the rotor.
Everything seemed fine and brakes were strong but when I went for a test drove there is a clicking sound at low to medium speeds come from the rear passenger side. I checked the retainer pins and they are on correctly.
What the problem may be? I would like to spin the wheel but the parking brake is on. Is it okay to take off the parking brake while jacked up if I block the wheels??
View 7 Replies
I have a 2002 Accent that has this clicking sound coming from what sounds to be the left hand side under the hood. The click sounds like two marbles colliding. The car runs ok otherwise, but I would like to know about that sound.
I took a video, but its kind of hard to hear it. But if you listen close enough, you can hear it.
2002 Hyundai Accent click noise in engine - YouTube ...
View 4 Replies
2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
View 4 Replies
I started hearing a constant clicking sound coming from behind the radio (higher, towards the dashboard). The clicking is pretty loud and is present while the engine is on and when its off with the ignition on. Its also heard whether radio is on or off or the climate control is on or off. It is NOT heard from the outside with the hood up. What this could be?
View 5 Replies
I have a small clicking sound coming from my intake manifold. I recently installed a boost gauge and it did it once after that... I shut the car off and I didn't hear again until 1000 miles later and its back, why it would be clicking like this but its annoying
View 6 Replies
